Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “model physics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,675 records · Page 93
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

NASA low-speed centrifugal compressor for 3-D viscous code assessment and fundamental flow physics research

A low speed centrifugal compressor facility recently built by the NASA Lewis Research Center is described. The purpose of this facility is to obtain detailed flow field measurements for computational fluid dynamic code assessment and flow physics modeling in support of Army and NASA efforts to advance small gas turbine engine technology. The facility is heavily instrumented with pressure and temperature probes, both in the stationary and rotating frames of reference, and has provisions for flow visualization and laser velocimetry. The facility will accommodate rotational speeds to 2400 rpm and is rated at pressures to 1.25 atm. The initial compressor stage being tested is geometrically and dynamically representative of modern high-performance centrifugal compressor stages with the exception of Mach number levels. Preliminary experimental investigations of inlet and exit flow uniformly and measurement repeatability are presented. These results demonstrate the high quality of the data which may be expected from this facility. The significance of synergism between computational fluid dynamic analysis and experimentation throughout the development of the low speed centrifugal compressor facility is demonstrated.

Hathaway, M. D.↗
NASA NTRS1991

Surface effects on hydrogen permeation through Ti-14Al-21Nb alloy

Hydrogen transport through Ti-14Al-21Nb (wt percent) alloy is measured using ultrahigh vacuum permeation techniques over the temperature range of 500 to 900 C and hydrogen pressure range of 0.25 to 10 torr. Hydrogen permeability through the alloy can be described through two different mechanisms depending on th temperature of exposure. In the 675 to 900 C range, the process is diffusion-limited: the permeability has a weak temperature dependence, but the diffusivity has a strong temperature dependence. Below 675 C, the permeation rate of hydrogen is very sensitive to surface controlled processes such as the formation of a barrier layer from contaminants. A physical model explaining the role of surface films on the transport of hydrogen through Ti-14Al-21Nb alloy was described.

Sankaran, Sandara N.↗
NASA NTRS1991

Foil perforation particulate impact records on LDEF MAP AO023: Incident mass distributions

An array of multiple foils varying from 1.5 to 3.0 microns exposed on Long Duration Exposure Facility's (LEDF's) geocentrically stabilized exposure platform provides perforation distributions which relate to particulate flux mass distributions and impact velocity in LDEF's orbital reference frame. The application of physical modeling enables a preliminary separation into orbital and interplanetary components, both of which have differing velocities and hence penetration effectiveness. Thin foil hypervelocity calibration data and parametric penetration formulae developed to relate target hole diameter to projectile dimensions are critically examined and a new formula offered for the ballistic limit situation. Incorporating projectile density, target density, and target strength and dimensional scaling from submicron particulates to centimeter scale data, it contrast very significantly with previous formulae in the interpretation of space impact data. Perforation flux distributions for the leading, trailing, and space pointing faces and associated mass distributions for the two populations are presented.

Mcdonnell, J. A. M.↗
NASA NTRS1991

The NASA Lewis integrated propulsion and flight control simulator

A new flight simulation facility was developed at NASA-Lewis. The purpose of this flight simulator is to allow integrated propulsion control and flight control algorithm development and evaluation in real time. As a preliminary check of the simulator facility capabilities and correct integration of its components, the control design and physics models for a short take-off and vertical landing fighter aircraft model were shown, with their associated system integration and architecture, pilot vehicle interfaces, and display symbology. The initial testing and evaluation results show that this fixed based flight simulator can provide real time feedback and display of both airframe and propulsion variables for validation of integrated flight and propulsion control systems. Additionally, through the use of this flight simulator, various control design methodologies and cockpit mechanizations can be tested and evaluated in a real time environment.

Bright, Michelle M.↗
NASA NTRS1991

Energy transfer processes between Tm(3+) and Ho(3+) in LiYF4

The spectroscopic properties of the crystal LiYF4 doped with Thulium (Tm) and Holmium (Ho) ions are studied. The basic processes are discussed that regulate the transfer of energy between these two ions in this crystal. In this system Tm is considered the donor ion and the Ho the acceptor ion. Spectral data were obtained on three samples available: LiYF4:Tm(3+) (0.5 percent), LiYF4:Ho(3+) (1 percent), and LiYF4:Tm(3+) (5 percent), Ho(3+) (0.2 percent). Spectral data, which include absorption, luminescence, excitation, and the response to pulsed excitation in a wide range of temperatures, allowed to look at the energy transfer processes by considering the kinetic evolution of the emission of the two ions (donor and acceptor) involved in the process and the basic spectroscopic properties related to them. This inclusive approach has led to the validation of the physical model.

Oezen, Goenuel↗
NASA NTRS1991

Preliminary calibration plan for the Advanced Particles and Field Observatory (APAFO) magnetometer experiment

Prelaunch and postlaunch calibration plans for the APAFO magnetometer experiment are presented. A study of tradeoffs between boom length and spacecraft field is described; the results are summarized. The prelaunch plan includes: calibration of the Vector Fluxgate Magnetometer (VFM), Star Sensors, and Scalar Helium Magnetometer (SHM); optical bench integration; and acquisition of basic spacecraft field data. Postlaunch calibration has two phases. In phase one, SHM data are used to calibrate the VFM, total vector magnetic field data are used to calibrate a physical model of the spacecraft field, and both calibrations are refined by iteration. In phase two, corrected vector data are transformed into geocentric coordinates, previously undetected spacecraft fields are isolated, and initial geomagnetic field models are computed. Provided the SHM is accurate to the required 1.0 nT and can be used to calibrate the VFM to the required 3.0- nT accuracy, the tradeoff study indicates that a 12 m boom and a spacecraft field model uncertainty of 5 percent together allow the 1.0 nT spacecraft field error requirement to be met.

Voorhies, C. V.↗
NASA NTRS1991

Indirect measurement of the viscosity of the intergranular glass phase in yttria-sintered silicon nitride

Dense, sintered Si3N4 possesses a residual intergranular glass phase which softens at high temperatures, resulting in degradation of the ceramic's mechanical properties at high temperatures. An important parameter in the determination of the high temperature mechanical properties of sintered Si3N4 is the temperature-viscosity relationship of the intergranular glass. A method for indirectly measuring the intergranular glass viscosity at a given temperature using physical modelling of a two phase glass crystal microstructure and beam bending viscometry measurements of Si3N4 is described. Intergranular glass viscosities obtained by this method are presented for a yttria sintered Si3N4.

Dittmar, Mark B.↗
NASA NTRS1990

Development of pitch angle anisotropy and velocity diffusion of pickup ion shell distribution by solar wind turbulence

The evolution of pitch angle anisotropy in initially isotropic spherical shell distribution of pickup ions subjected to a continuous influence of weak or moderate intrinsic solar wind turbulence is investigated using a physical model which assumes that the wave of the solar wind turbulence is propagating mainly in the direction parallel to the ambient magnetic field. It is shown that, because of the pitch angle dependence of the velocity diffusion process, a significant pitch angle anisotropy of pickup ion shell distribution develops in the early stage of the diffusion process. Although it is smeared out later on, the result can be of significant importance, especially if the pickup ion density is large, because the pitch angle anisotropy can excite collective instabilities and increase the wave level, thus accelerating the diffusion process.

Yoon, Peter H.↗
NASA NTRS1990

Natural inflation with pseudo Nambu-Goldstone bosons

It is shown that a pseudo-Nambu-Goldstone boson of given potential can naturally give rise to an epoch of inflation in the early universe. Mass scales which arise in particle physics models with a gauge group that becomes strongly interacting at a certain scales are shown to be conditions for successful inflation. The density fluctuation spectrum is nonscale-invariant, with extra power on large length scales.

Freese, Katherine↗
NASA NTRS1990

Rotorcraft blade/vortex interaction noise - Its generation, radiation, and control

Recent results are presented from several research efforts aimed at the understanding of rotorcraft blade-vortex interaction noise generation, directivity, and control. The results are based on work performed by researches at the NASA Langley Research Center, both alone and in collaboration with other research organizations. Based on analysis of a simplified physical model, the critical parameters controlling the noise generation are identified. Detailed mapping of the acoustic radiation field reveals the extreme sensitivity of directivity to rotor advance ratio and disk attitude. A means of controlling blade-vortex interaction noise by higher harmonic pitch control is discussed.

Preisser, J. S.↗
NASA NTRS1991

Star formation and the nature of bipolar outflows

This paper presents a simple physical model for the bipolar molecular outflows that frequently accompany star formation. The model forges an intrinsic link between the bipolar flow phenomenon and the process of star formation, and it helps to explain many of the systematics known for existing sources.

Shu, Frank H.↗
NASA NTRS1991

Quasi-periodic structures in the large-scale galaxy distribution and three-dimensional Voronoi tessellation

It has been suggested that the void and wall structure associated with the large-scale galaxy distribution might be qualitatively, or perhaps even physically, modeled by a Voronoi tessellation, and that such structure might account for the surprisingly regular, sharp peaks in the galaxy redshift distributions obtained from 'pencil beam' surveys. Taking cell wall crossings by random line segments to correspond to such redshift peaks, an exact expression is derived for the distribution of spacings of these intersections in a three-dimensional Voronoi tessellation. This result verifies that the spacings are nonrandom and quasi-periodic, qualitatively resembling the observed pattern, even though the cell wall structure is generated from randomly placed seeds. Finally, moments of the spacing distribution are used to show that apparently periodic samples, similar to those recently reported, represent only one to two sigma fluctuations in a Voronoi tesselation.

Ikeuchi, Satoru↗
NASA NTRS1990

Recent advances in hypersonic technology

This paper will focus on recent advances in hypersonic aerodynamic prediction techniques. Current capabilities of existing numerical methods for predicting high Mach number flows will be discussed and shortcomings will be identified. Physical models available for inclusion into modern codes for predicting the effects of transition and turbulence will also be outlined and their limitations identified. Chemical reaction models appropriate to high-speed flows will be addressed, and the impact of their inclusion in computational fluid dynamics codes will be discussed. Finally, the problem of validating predictive techniques for high Mach number flows will be addressed.

Dwoyer, Douglas L.↗
NASA NTRS1991

The NASA Lewis integrated propulsion and flight control simulator

A new flight simulation facility has been developed at NASA Lewis to allow integrated propulsion-control and flight-control algorithm development and evaluation in real time. As a preliminary check of the simulator facility and the correct integration of its components, the control design and physics models for an STOVL fighter aircraft model have been demonstrated, with their associated system integration and architecture, pilot vehicle interfaces, and display symbology. The results show that this fixed-based flight simulator can provide real-time feedback and display of both airframe and propulsion variables for validation of integrated systems and testing of control design methodologies and cockpit mechanizations.

Bright, Michelle M.↗
NASA NTRS1990

X-ray emission from reverse-shocked ejecta in supernova remnants

A simple physical model of the dynamics of a young supernova remnant is used to derive a straightforward kinematical description of the reverse shock. With suitable approximations, formulae can then be developed to give the X-ray emission of the reverse-shocked ejecta. The results are found to agree favorably with observations of SN1006.

Cioffi, Denis F.↗
NASA NTRS1991

Energy coupling in catastrophic collisions

The prediction of events leading to the catastrophic collisions and disruption of solar system bodies is fraught with the same difficulties as are other theories of impact events; since one simply cannot perform experiments in the regime of interest. In the catastrophic collisions of asteroids that regime involves bodies of a few tons to hundred of kilometers in diameter, and velocities of several kilometers pre second. For hundred kilometer bodies, gravitational stresses dominate material fracture strengths, but those gravitational stresses are essentially absent for laboratory experiments. Only numerical simulations using hydrocodes can in principle analyze the true problems, but they have their own major uncertainties about the correctness of the physical models and properties. The question of the measure of the impactor and its energy coupling is investigated using numerical code calculations. The material model was that of a generic silicate rock, including high pressure melt and vapor phases, and includes material nonlinearity and dissipation via a Mie-Gruniesen model. A series of calculations with various size ratios and impact velocities are reported.

Holsapple, K. A.↗
NASA NTRS1991

Cosmological constraints on pseudo-Nambu-Goldstone bosons

Particle physics models with pseudo-Nambu-Goldstone bosons (PNGBs) are characterized by two mass scales: a global spontaneous symmetry breaking scale, f, and a soft (explicit) symmetry breaking scale, Lambda. General model insensitive constraints were studied on this 2-D parameter space arising from the cosmological and astrophysical effects of PNGBs. In particular, constraints were studied arising from vacuum misalignment and thermal production of PNGBs, topological defects, and the cosmological effects of PNGB decay products, as well as astrophysical constraints from stellar PNGB emission. Bounds on the Peccei-Quinn axion scale, 10(exp 10) GeV approx. = or less than f sub pq approx. = or less than 10(exp 10) to 10(exp 12) GeV, emerge as a special case, where the soft breaking scale is fixed at Lambda sub QCD approx. = 100 MeV.

Frieman, Joshua A.↗