Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “STALLING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,657 records · Page 92

Application of variable-gain output feedback for high-alpha control

This paper describes a variable-gain optimal discrete output-feedback design approach that is applied to a nonlinear flight regime covering a wide angle-of-attack range that includes stall and poststall. The paper includes brief descriptions of the variable-gain formulation, the discrete-control structure and flight equations used to apply the design approach, and the high performance airplane model used in the application. Both linear and nonlinear analyses are shown for a longitudinal four-model design case with angles of attack of 5, 15, 35, and 60 deg.

Ostroff, Aaron J.↗

Laser anemometer measurements in a transonic axial-flow fan rotor

Laser anemometer surveys were made of the 3-D flow field in NASA rotor 67, a low aspect ratio transonic axial-flow fan rotor. The test rotor has a tip relative Mach number of 1.38. The flowfield was surveyed at design speed at near peak efficiency and near stall operating conditions. Data is presented in the form of relative Mach number and relative flow angle distributions on surfaces of revolution at nine spanwise locations evenly spaced from hub to tip. At each spanwise location, data was acquired upstream, within, and downstream of the rotor. Aerodynamic performance measurements and detailed rotor blade and annulus geometry are also presented so that the experimental results can be used as a test case for 3-D turbomachinery flow analysis codes.

Strazisar, Anthony J.↗

Wind tunnel results of the low-speed NLF(1)-0414F airfoil

The large performance gains predicted for the Natural Laminar Flow (NLF)(1)-0414F airfoil were demonstrated in two-dimensional airfoil tests and in wind tunnel tests conducted with a full scale modified Cessna 210. The performance gains result from maintaining extensive areas of natural laminar flow, and were verified by flight tests conducted with the modified Cessna. The lift, stability, and control characteristics of the Cessna were found to be essentially unchanged when boundary layer transition was fixed near the wing leading edge. These characteristics are very desirable from a safety and certification view where premature boundary layer transition (due to insect contamination, etc.) must be considered. The leading edge modifications were found to enhance the roll damping of the Cessna at the stall, and were therefore considered effective in improving the stall/departure resistance. Also, the modifications were found to be responsible for only minor performance penalties.

Murri, Daniel G.↗

Large-scale Advanced Prop-fan (LAP) static rotor test report

Discussed is Static Rotor Testing of the SR-7L Large Scale Advanced Prop-Fan (LAP). The LAP is an advanced 9 foot diameter, 8 bladed propeller designed and built by Hamilton Standard under contract to the NASA Lewis Research Center. The Prop-Fan employs thin swept blades to provide efficient propulsion at flight speeds up to Mach .85. Static Testing was conducted on a 10,000 HP whirl rig at Wright Patterson Air Force Base. The test objectives were to investigate the Prop-Fan static aerodynamic and structural dynamic performance, determine the blade steady state stressers and deflections and to measure steady and unsteady pressures on the SR-7L blade surface. The measured performance of the LAP correlated well with analytical predictions at blade pitch angles below 30 deg. A stall buffet phenomenon was observed at blade pitch angles above 30 deg. This phenomenon manifested itself by elevated blade vibratory stress levels and lower than expected thrust produced and power absorbed by the Prop-Fan for a given speed and blade angle.

Degeorge, Charles L.↗

Longitudinal stability and control characteristics of the Quiet Short-Haul Research Aircraft (QSRA)

Flight experiments were conducted to evaluate various aerodynamic characteristics of the Quiet Short-Haul Research Aircraft (QSRA), an experimental aircraft that makes use of the upper-surface blown (USB) powered-lift concept. Time-history records from maneuvers performed with the aircraft in landing-approach and take-off configurations (with its stability augmentation system disengaged) were analyzed to obtain longitudinal stability and control derivatives and performance characteristics. The experiments included measuring the aircraft responses to variations in the deflection of direct-lift control spoilers and to thrust variations as well as to elevator inputs. The majority of the results are given for the aircraft in a landing configuration with the USB flaps at 50 degrees. For this configuration, if the static longitudinal stability is defined as the variation of the pitching-moment coefficient with the lift coefficient at a constant thrust coefficient, this stability decreases significantly with increasing angle of attack above 9 degrees. For this configuration, at small and negative angles of attack and high levels of thrust, the elevators and the horizontal stabilizer lost effectiveness owing to incipent stalling, but this occurred only during unsteady maneuvers and for brief time intervals.

Stephenson, Jack D.↗

Low-speed wind-tunnel investigation of the flight dynamic characteristics of an advanced turboprop business/commuter aircraft configuration

An investigation was conducted to determine the low-speed flight dynamic behavior of a representative advanced turboprop business/commuter aircraft concept. Free-flight tests were conducted in the NASA Langley Research Center's 30- by 60-Foot Tunnel. In support of the free-flight tests, conventional static, dynamic, and free-to-roll oscillation tests were performed. Tests were intended to explore normal operating and post stall flight conditions, and conditions simulating the loss of power in one engine.

Coe, Paul L., Jr.↗

Static Wind-Tunnel and Radio-Controlled Flight Test Investigation of a Remotely Piloted Vehicle Having a Delta Wing Planform

At the request of the United States Marine Corps, an exploratory wind-tunnel and flight test investigation was conducted by the Flight Dynamics Branch at the NASA Langley Research Center to improve the stability, controllability, and general flight characteristics of the Marine Corps Exdrone RPV (Remotely Piloted Vehicle) configuration. Static wind tunnel tests were conducted in the Langley 12 foot Low Speed Wind Tunnel to identify and improve the stability and control characteristics of the vehicle. The wind tunnel test resulted in several configuration modifications which included increased elevator size, increased vertical tail size and tail moment arm, increased rudder size and aileron size, the addition of vertical wing tip fins, and the addition of leading-edge droops on the outboard wing panel to improve stall departure resistance. Flight tests of the modified configuration were conducted at the NASA Plum Tree Test Site to provide a qualitative evaluation of the flight characteristics of the modified configuration.

Yip, Long P.↗

Low-speed wind tunnel investigation of the static stability and control characteristics of an advanced turboprop configuration with the propellers placed over the tail

An exploratory wind tunnel investigation was performed in the 30 x 60 foot wind tunnel to determine the low speed static stability and control characteristics into the deep stall regime of an advanced turboprop aircraft with the propellers located over the horizontal tail. By this arrangement, the horizontal tail could potentially provide acoustic shielding to reduce the high community noise caused by the propeller blades. The current configuration was a generic turboprop model equipped with 1 foot diameter single rotating eight bladed propellers that were designed for efficient cruise operation at a Mach number of 0.8. The data presented is static force data. The effects of power on the configuration characteristics were generally favorable. An arrangement with the propellers rotating with the outboard blades moving down was found to have significantly higher installed thrust than an arrangement with the propellers rotating with the inboard blades moving down. The primary unfavorable effect was a large pitch trim change which occurred with power, but the trim change could be minimized with a proper configuration design.

Rhodes, Graham Scott↗

Orbital migration of protoplanets - The inertial limit

The dynamical evolution of a disk and the orbital migration of an embedded protoplanet are examined. It is shown how the migration of a protoplanet due to density wave torques can suppress the tendency for tidal truncation of the disk. A critical mass is determined as a function of the disk properties that represents the limiting mass that can sustain drift without stalling. This inertial limit is derived analytically, using a quasi-steady state theory, and confirmed by numerical experiment. This result contradicts the claim of Lin and Papaloizou (1986) that such a limit does not exist. Orbital mobility of objects due to density wave torques may have played an important role in the early evolution of the solar system.

Ward, William R.↗

Simple analyses of paths through windshears and downdrafts

Quasi-steady analysis and energy-state approximation are employed to study flight paths through windshears and downdrafts. Takeoff flight is mainly considerd while landing flight is briefly discussed. The relation between angle of attack and airspeed is found to be almost independent of horizontal wind and slightly dependent on vertical wind. In slowly-varying windshears and/or downdrafts, quasi-steady flight can be achieved by flying an aircraft at a lower than nominal climb rate; this will avoid stall. In severe windshears and/or downdrafts, energy-state approximation indicates that descending paths save more energy and provide higher survival capability.

Zhao, Yiyuan↗

Numerical study of the effects of icing on finite wing aerodynamics

The sectional and total aerodynamics load characteristics of moderate aspect ratio wings with and without simulated glaze leading-edge ice are studied using a three-dimensional, compressible Navier-Stokes solver. The wing has an untwisted, untapered planform shape with NACA 0012 airfoil section. The aspect ratio of the wing is chosen to be 5. Comparisons of computed surface pressures and sectional loads with experimental data for identical configurations are given. The abrupt decrease in the wing stall angle as a result of the leading edge ice formation is numerically demonstrated.

Kwon, Oh J.↗

Wind-tunnel and flight-test investigation of the exdrone remotely piloted vehicle configuration

At the request of the United States Marine Corps, an exploratory wind-tunnel and flight test investigation was conducted by the NASA Langley Research Center to improve the stability, controllability, and general flight characteristics of the Marine Corps Exdrone RPV (Remotely Piloted Vehicle) configuration. Static wind tunnel tests were conducted to identify and improve the stability and control characteristics of the vehicle. The wind-tunnel test resulted in several configuration modifications which included increased elevator area, increased vertical tail area and moment arm, increased rudder area and aileron area, the addition of vertical wing-tip fins, and the addition of leading-edge droops on the outboard wing panel to improve the stall departure resistance. Flight tests of the modified configuration were conducted at the NASA Plum Tree Test Site to provide a qualitative evaluation of the flight characteristics of the modified configuration.

Yip, Long P.↗

Vortex control for tail buffet alleviation on a twin-tail fighter configuration

Two aerodynamic concepts proposed for alleviating high-alpha tail buffet characteristics of a LEX (Leading Edge Extension) vortex dominated twin-tail fighter configuration were explored in low-speed tunnel tests on generic models via flow visualizations, 6-component balance measurements and monitoring of tail dynamics. Passive dorsal-fin extensions of the vertical tails, and an active LEX arrangement with up-deflected edge sections were evaluated as independent means of re-structuring the adverse vortical flow environment in the tail region. Each of these techniques successfully reduced the buffet as measured by the root-mean-square of tail accelerometer output, particularly at post-stall angles of attack when the baseline configuration was characterized by high buffet intensity. Used in combination, the two concepts indicated significant tail buffet relief with relatively minor impact on the high-alpha configuration aerodynamics.

Rao, Dhanvada M.↗

Angle-of-attack validation of a new zonal CFD method for airfoil simulations

The angle-of-attack validation of a new concept suggested by Summa (1990) for coupling potential and viscous flow methods has been investigated for two-dimensional airfoil simulations. The fully coupled potential/Navier-Stokes code, ZAP2D (Zonal Aerodynamics Program 2D), has been used to compute the flow field around an NACA 0012 airfoil for a range of angles of attack up to stall at a Mach number of 0.3 and a Reynolds number of 3 million. ZAP2D calculation for various domain sizes from 25 to 0.12 chord lengths are compared with the ARC2D large domain solution as well as with experimental data.

Yoo, Sungyul↗

The low frequency oscillation in the flow over a NACA0012 airfoil with an 'iced' leading edge

The unusually low frequency oscillation in the wake of an airfoil is explored experimentally as well as computationally for a NACA0012 airfoil with a glaze ice accretion at the leading edge. Experimentally, flow oscillations were observed at low frequencies that correspond to a Strouhal number of about 0.02. This occurred in the angle of attack range of 8 to 9 deg, near the onset of static stall for this airfoil. With a Navier-Stokes computation, limit-cycle oscillations in the flow and in the aerodynamic forces were also observed at low Strouhal numbers. However, the occurrence of the oscillation is found to depend on the turbulence model in use as well as the Reynolds number.

Zaman, K. B. M. Q.↗

The response of helicopter rotors to vibratory airload

The problems of oscillatory and vibratory loading are examined from the perspective of the rotor's structural response. Blade flap, chord, and torsion responses, from flight or wind tunnel tests of eight full-scale rotors are examined and compared for high-speed flight conditions in the absence of blade stall or maneuvers. Some important similarities and differences between rotors are considered, and it is pointed out that these observations are useful in determining the appropriate tests for development of theoretical prediction methods. Among other things, major similarities were found in the dominant flapping vibratory response which occurs at 3/rev, and the root oscillatory chord bending for the CH-34, the SA 349/2, and the UH-60A; differences noted include vibratory chord bending-moment behavior of the rotors, a difference in the damper-induced behavior of CH-53A root oscillatory chord bending, and unique torsion and pitch link loading behavior exhibited by the AH1-G articulated rotor.

Bousman, William G.↗

A numerical study of the effects of wind tunnel wall proximity on an airfoil model

A procedure was developed for modeling wind tunnel flows using computational fluid dynamics. Using this method, a numerical study was undertaken to explore the effects of solid wind tunnel wall proximity and Reynolds number on a two-dimensional airfoil model at low speed. Wind tunnel walls are located at varying wind tunnel height to airfoil chord ratios and the results are compared with freestream flow in the absence of wind tunnel walls. Discrepancies between the constrained and unconstrained flows can be attributed to the presence of the walls. Results are for a Mach Number of 0.25 at angles of attack through stall. A typical wind tunnel Reynolds number of 1,200,000 and full-scale flight Reynolds number of 6,000,000 were investigated. At this low Mach number, wind tunnel wall corrections to Mach number and angle of attack are supported. Reynolds number effects are seen to be a consideration in wind tunnel testing and wall interference correction methods. An unstructured grid Navier-Stokes code is used with a Baldwin-Lomax turbulence model. The numerical method is described since unstructured flow solvers present several difficulties and fundamental differences from structured grid codes, especially in the area of turbulence modeling and grid generation.

Potsdam, Mark↗

Design and evaluation of thrust vectored nozzles using a multicomponent thrust stand

Future aircraft with the capability of short takeoff and landing, and improved maneuverability especially in the post-stall flight regime will incorporate exhaust nozzles which can be thrust vectored. In order to conduct thrust vector research in the Mechanical Engineering Department at Cal Poly, a program was planned with two objectives; design and construct a multicomponent thrust stand for the specific purpose of measuring nozzle thrust vectors; and to provide quality low moisture air to the thrust stand for cold flow nozzle tests. The design and fabrication of the six-component thrust stand was completed. Detailed evaluation tests of the thrust stand will continue upon the receipt of one signal conditioning option (-702) for the Fluke Data Acquisition System. Preliminary design of thrust nozzles with air supply plenums were completed. The air supply was analyzed with regard to head loss. Initial flow visualization tests were conducted using dual water jets.

Thomas W. Carpenter↗