Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Distributed computation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,621 records · Page 90

The calculated influence of atmospheric conditions on solar cell ISC under direct and global solar irradiances

Calculations of the influence of atmospheric conditions on solar cell short-circuit current (Isc) are made using a recently developed computer model for solar spectral irradiance distribution. The results isolate the dependence of Isc on changes in the spectral irradiance distribution without the direct influence of the total irradiance level. The calculated direct normal irradiance and percent diffuse irradiance are given as a reference to indicate the expected irradiance levels. This method can be applied to the calibration of photovoltaic reference cells. Graphic examples are provided for amorphous silicon and monocrystalline silicon solar cells under direct normal and global normal solar irradiances.

Mueller, Robert L.↗

Theory for synthetic aperture radar imaging of the ocean surface - With application to the Tower Ocean Wave and Radar Dependence experiment on focus, resolution, and wave height spectra

A one-dimensional model for simulating azimuthal SAR imaging of the ocean surface is developed which can admit both the 'distributed surface' and 'velocity bunching' approaches. Computer simulations demonstrate that the time-dependent modulation patterns due to the radar cross section variation and the velocity bunching effects provide optimum focusing around half the phase velocity of the long wave. The results indicate that in the Tower Ocean Wave and Radar Dependence experiment, SAR imaging at L band is approximately linear.

Kasilingam, Dayalan P.↗

CFD simulation of square cross-section, contoured nozzle flows - Comparison with data

Computational analyses have been made of the flow in NASA Langley's Arc-Heated Scramjet Test Facility's Mach 4.7 and Mach 6 square cross-section contoured nozzles, for comparison with experimental results. The analyses, which were performed using a three-dimensional RANS computer code assuming a single species gas with constant specific heats, were intended to provide insight into the nature of the flow development in this type of nozzle. The computational results showed the exit flow distribution to be affected by counter-rotating vortices along the centerline of each nozzle sidewall. Calculated flow properties show general, but not complete, agreement with experimental measurements in both nozzles.

Ostrander, Mark J.↗

A parametric study of three-dimensional separation at a wing/body junction for supersonic free-stream conditions

The problem of three-dimensional separation at a wing/body junction has been investigated numerically using a three-dimensional Navier-Stokes code which employs the MacCormack's time split finite volume technique. An algebraic grid generation technique is used for generating the grid at a wing/body junction. Specific computational results on velocity and pressure distribution in the separated flow region are compared with the experimental results. A parametric study of flow parameters such as Mach number and Reynolds number have been carried out to understand their effect in interaction flow field. The parametric study indicates a strong dependency of the number of vortices at the junction on Mach number and Reynolds number.

Lakshmanan, B.↗

Balancing Loads Among Parallel Data Processors

Heuristic algorithm minimizes amount of memory used by multiprocessor system. Distributes load of many identical, short computations among multiple parallel digital data processors, each of which has its own (local) memory. Each processor operates on distinct and independent set of data in larger shared memory. As integral part of load-balancing scheme, total amount of space used in shared memory minimized. Possible applications include artificial neural networks or image processors for which "pipeline" and vector methods of load balancing inappropriate.

Baffes, Paul Thomas↗

The cleanroom case study in the Software Engineering Laboratory: Project description and early analysis

This case study analyzes the application of the cleanroom software development methodology to the development of production software at the NASA/Goddard Space Flight Center. The cleanroom methodology emphasizes human discipline in program verification to produce reliable software products that are right the first time. Preliminary analysis of the cleanroom case study shows that the method can be applied successfully in the FDD environment and may increase staff productivity and product quality. Compared to typical Software Engineering Laboratory (SEL) activities, there is evidence of lower failure rates, a more complete and consistent set of inline code documentation, a different distribution of phase effort activity, and a different growth profile in terms of lines of code developed. The major goals of the study were to: (1) assess the process used in the SEL cleanroom model with respect to team structure, team activities, and effort distribution; (2) analyze the products of the SEL cleanroom model and determine the impact on measures of interest, including reliability, productivity, overall life-cycle cost, and software quality; and (3) analyze the residual products in the application of the SEL cleanroom model, such as fault distribution, error characteristics, system growth, and computer usage.

Green, Scott↗

Simulation of probabilistic wind loads and building analysis

Probabilistic wind loads likely to occur on a structure during its design life are predicted. Described here is a suitable multifactor interactive equation (MFIE) model and its use in the Composite Load Spectra (CLS) computer program to simulate the wind pressure cumulative distribution functions on four sides of a building. The simulated probabilistic wind pressure load was applied to a building frame, and cumulative distribution functions of sway displacements and reliability against overturning were obtained using NESSUS (Numerical Evaluation of Stochastic Structure Under Stress), a stochastic finite element computer code. The geometry of the building and the properties of building members were also considered as random in the NESSUS analysis. The uncertainties of wind pressure, building geometry, and member section property were qualified in terms of their respective sensitivities on the structural response.

Shah, Ashwin R.↗

Collaboration technology and space science

A summary of available collaboration technologies and their applications to space science is presented as well as investigations into remote coaching paradigms and the role of a specific collaboration tool for distributed task coordination in supporting such teleoperations. The applicability and effectiveness of different communication media and tools in supporting remote coaching are investigated. One investigation concerns a distributed check-list, a computer-based tool that allows a group of people, e.g., onboard crew, ground based investigator, and mission control, to synchronize their actions while providing full flexibility for the flight crew to set the pace and remain on their operational schedule. This autonomy is shown to contribute to morale and productivity.

Leiner, Barry M.↗

Predicted extreme-ultraviolet and X-ray spectrum of a microflare-heated corona

Sturrock et al. (1990) have proposed that a distribution of microflares produces the solar coronal and transition-region emission. This paper presents computed EUV and X-ray emission spectra from that distribution, including the effects of time-dependent ionization. The overall agreement of the predicted spectrum with observations is fairly good, although the predicted emission from the upper transition region is high by a factor of 2. Time-dependent ionization greatly enhances the He II 304-A line, improving the agreement with observation compared with ionization equilibrium models. The predicted effects on temperature-sensitive line ratios of other ions cannot yet be tested against observations due to uncertainties in instrumental calibration and atomic rates.

Raymond, John C.↗

Management of the Space Station Freedom onboard local area network

An operational approach is proposed to managing the Data Management System Local Area Network (LAN) on Space Station Freedom. An overview of the onboard LAN elements is presented first, followed by a proposal of the operational guidelines by which management of the onboard network may be effected. To implement the guidelines, a recommendation is then presented on a set of network management parameters which should be made available in the onboard Network Operating System Computer Software Configuration Item and Fiber Distributed Data Interface firmware. Finally, some implications for the implementation of the various network management elements are discussed.

Miller, Frank W.↗

Aerodynamic design of gas and aerosol samplers for aircraft

The aerodynamic design of airborne probes for the capture of air and aerosols is discussed. Emphasis is placed on the key parameters that affect proper sampling, such as inlet-lip design, internal duct components for low pressure drop, and exhaust geometry. Inlet designs that avoid sonic flow conditions on the lip and flow separation in the duct are shown. Cross-stream velocities of aerosols are expressed in terms of droplet density and diameter. Flow curvature, which can cause aerosols to cross streamlines and impact on probe walls, can be minimized by means of a proper inlet shape and proper probe orientation, and by avoiding bends upstream of the test section. A NASA panel code called PMARC was used successfully to compute streamlines around aircraft and probes, as well as to compute to local velocity and pressure distributions in inlets. A NACA 1-series inlet with modified lip radius was used for the airborne capture of stratospheric chlorine monoxide at high altitude and high flight speed. The device has a two-stage inlet that decelerates the inflow with little disturbance to the flow through the test section. Diffuser design, exhaust hood design, valve loss, and corner vane geometry are discussed.

Soderman, Paul T.↗

The concept of the mechanically active guideway as a novel approach to maglev

A maglev system that is suitable for operation in the United States will have to meet unique requirements which determine the major systems characteristics. Maglev configurations presently developed in Germany and Japan are based on conventional maglev concepts and as such do not meet all of the requirements. A novel maglev guideway concept is introduced as a solution. This concept, the mechanically active guideway, is articulated in three degrees of freedom and assumes system functions which normally reside in the maglev vehicle. The mechanically active guideway contains spatially distributed actuators which are energized under computer control at the time of vehicle passage to achieve bank angle adjustment and ride quality control. A typical realization of the concept is outlined.

Horwath, T. G.↗

Wavelength-Division Multiplexing Of Avionic Digital Control Signals

Proposed wavelength-division multiplexing optoelectronic system aboard aircraft transmits digital control signals from central flight-control computer via optical fibers to multiple distributed processors, actuators, and sensors. In comparison with serial TDM communication systems, this system offers potentially higher data throughput, greater tolerance to transient induced faults, and lower bit-error rates. Also immune to electromagnetic interference at suboptical frequencies.

Patterson, James D.↗

Hyperswitch Communication Network Computer

Hyperswitch Communications Network (HCN) computer is prototype multiple-processor computer being developed. Incorporates improved version of hyperswitch communication network described in "Hyperswitch Network For Hypercube Computer" (NPO-16905). Designed to support high-level software and expansion of itself. HCN computer is message-passing, multiple-instruction/multiple-data computer offering significant advantages over older single-processor and bus-based multiple-processor computers, with respect to price/performance ratio, reliability, availability, and manufacturing. Design of HCN operating-system software provides flexible computing environment accommodating both parallel and distributed processing. Also achieves balance among following competing factors; performance in processing and communications, ease of use, and tolerance of (and recovery from) faults.

Peterson, John C.↗

A distributed Petri Net controller for a dual arm testbed

This thesis describes the design and functionality of a Distributed Petri Net Controller (DPNC). The controller runs under X Windows to provide a graphical interface. The DPNC allows users to distribute a Petri Net across several host computers linked together via a TCP/IP interface. A sub-net executes on each host, interacting with the other sub-nets by passing a token vector from host to host. One host has a command window which monitors and controls the distributed controller. The input to the DPNC is a net definition file generated by Great SPN. Thus, a net may be designed, analyzed and verified using this package before implementation. The net is distributed to the hosts by tagging transitions that are host-critical with the appropriate host number. The controller will then distribute the remaining places and transitions to the hosts by generating the local nets, the local marking vectors and the global marking vector. Each transition can have one or more preconditions which must be fulfilled before the transition can fire, as well as one or more post-processes to be executed after the transition fires. These implement the actual input/output to the environment (machines, signals, etc.). The DPNC may also be used to simulate a Great SPN net since stochastic and deterministic firing rates are implemented in the controller for timed transitions.

Bjanes, Atle↗

Protocols for distributive scheduling

The increasing complexity of space operations and the inclusion of interorganizational and international groups in the planning and control of space missions lead to requirements for greater communication, coordination, and cooperation among mission schedulers. These schedulers must jointly allocate scarce shared resources among the various operational and mission oriented activities while adhering to all constraints. This scheduling environment is complicated by such factors as the presence of varying perspectives and conflicting objectives among the schedulers, the need for different schedulers to work in parallel, and limited communication among schedulers. Smooth interaction among schedulers requires the use of protocols that govern such issues as resource sharing, authority to update the schedule, and communication of updates. This paper addresses the development and characteristics of such protocols and their use in a distributed scheduling environment that incorporates computer-aided scheduling tools. An example problem is drawn from the domain of space shuttle mission planning.

Richards, Stephen F.↗

Two-layer convective heating prediction procedures and sensitivities for blunt body reentry vehicles

This paper provides a description of procedures typically used to predict convective heating rates to hypersonic reentry vehicles using the two-layer method. These procedures were used to compute the pitch-plane heating distributions to the Apollo geometry for a wind tunnel test case and for three flight cases. Both simple engineering methods and coupled inviscid/boundary layer solutions were used to predict the heating rates. The sensitivity of the heating results in the choice of metrics, pressure distributions, boundary layer edge conditions, and wall catalycity used in the heating analysis were evaluated. Streamline metrics, pressure distributions, and boundary layer edge properties were defined from perfect gas (wind tunnel case) and chemical equilibrium and nonequilibrium (flight cases) inviscid flow-field solutions. The results of this study indicated that the use of CFD-derived metrics and pressures provided better predictions of heating when compared to wind tunnel test data. The study also showed that modeling entropy layer swallowing and ionization had little effect on the heating predictions.

Bouslog, Stanley A.↗

Downwash and Wake Behind Plain and Flapped Airfoils

Extensive experimental measurements have been made of the downwash angles and the wake characteristics behind airfoils with and without flaps and the data have been analyzed and correlated with the theory. A detailed study was made of the errors involved in applying lifting-line theory, such as the effects of a finite wing chord, the rolling-up of the trailing vortex sheet, and the wake. The downwash angles, as computed from the theoretical span load distribution by means of the Biot-Savart equation, were found to be in satisfactory agreement with the experimental results. The rolling-up of the trailing vortex sheet may be neglected, but the vertical displacement of the vortex sheet requires consideration. By the use of a theoretical treatment indicated by Prandtl, it has been possible to generalize the available experimental results so the predictions can be made of the important wake parameters in terms of the distance behind the airfoil trailing edge and the profile-drag coefficient. The method of application of the theory to design and the satisfactory agreement between predicted and experimental results when applied to an airplane are demonstrated.

Silverstein, Abe↗