U-rich U-Mo Solidus, Liquidus, Enthalpy, and Thermal Diffusivity
Several material properties have been studied as a function of composition as part of the USHPRR effort to use U-10Mo for LEU monolithic fuel foils, with special attention to areas where simulation outcomes can be improved. The liquidus and solidus phase boundaries are important for engineering design of processing parameters and for predicting the degree of microsegregation within initial castings. The numerous phase diagram constructions available in the literature differ significantly in their solid/liquid boundary definitions, therefore, an experimental strategy was employed in order to resolve some of the discord. That strategy focuses not on proving any singular point, but instead to provide data with highly characterized uncertainty. The data presented here is the most consistent with the U-rich liquidus and solidus boundaries provided by H. Okamoto (2012), Berche et al. (2011), and Mardon et al. (1959). The recently suggested change in the peritectic reaction temperature (to 1302 K) suggested by Berchè and adopted by Okamoto is also supported, but with lower confidence. The enthalpy of fusion is a basic characteristic of the solidification reaction property for which is required for both research-oriented predictions of behavior and development of applied design strategies for casting engineering. It has been determined that an admixture model for the heat of fusion between U BCC and Mo BCC is a reasonable assumption within the composition region of interest, though limitations of the measurement accuracy impacts the ability to support any trends more detailed than this baseline behavior. A limited number of thermal diffusivity measurements were also performed into the gamma region to provide additional information for solidification modeling and simulations as well as a check on the component properties of thermal conductivity, density, and heat capacity.