Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “attenuator”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Tree attenuation at 869 MHz derived from remotely piloted aircraft measurements

Attenuation due to single trees is experimentally investigated using UHF transmissions at 869 MHz between a remotely piloted aircraft and a ground receiver system located in a stationary vehicle. Single trees of each tree type in full foliage were found to attenuate from 10-20 dB, with an average median value of about 12 dB. Attenuation coefficients associated with path lengths through the foliage may on average be about 1 dB/m, with maximum values closer to 2 dB/m.

Vogel, Wolfhard J.↗
NASA NTRS1988

Chopping-Wheel Optical Attenuator

Star-shaped rotating chopping wheel provides adjustable time-averaged attenuation of narrow beam of light without changing length of optical path or spectral distribution of light. Duty cycle or attenuation factor of chopped beam controlled by adjusting radius at which beam intersects wheel. Attenuation factor independent of wavelength. Useful in systems in which chopping frequency above frequency-response limits of photodetectors receiving chopped light. Used in systems using synchronous detection with lock-in amplifiers.

Leviton, Douglas B.↗
NASA NTRS1988

Measured and calculated acoustic attenuation rates of tuned resonator arrays for two surface impedance distribution models with flow

An experiment was performed to validate two analytical models for predicting low frequency attenuation of duct liner configurations built from an array of seven resonators that could be individually tuned via adjustable cavity depths. These analytical models had previously been developed for high frequency aero-engine inlet duct liner design. In the low frequency application, the liner surface impedance distribution is unavoidably spatially varying by virtue of available fabrication techniques. The characteristic length of this spatial variation may be a significant fraction of the acoustic wavelength. Comparison of measured and predicted attenuation rates and transmission losses for both modal decomposition and finite element propagation models were in good to excellent agreement for a test frequency range that included the first and second cavity resonance frequencies. This was true for either of two surface impedance distribution modeling procedures used to simplify the impedance boundary conditions. In the presence of mean flow, measurements revealed a fine scale structure of acoustic hot spots in the attenuation and phase profiles. These details were accurately predicted by the finite element model. Since no impedance changes due to mean flow were assumed, it is concluded that this fine scale structure was due to convective effects of the mean flow interacting with the surface impedance nonuniformities.

Parrott, Tony L.↗
NASA NTRS1988

Modal attenuation in multilayered coated waveguides

Propagation and attenuation constants of low-order normal modes in a circular waveguide lined with lossy coating layers are calculated using a generalized dispersion equation. It is found that the use of multilayered coating can significantly enhance modal attenuations over a broader frequency range compared to that for a single-layer coated structure. For a cylinder with radius a = 2 lambda, the attenuation constants for the dominant modes are shown to increase by 20 dB per a by adding a lossless padding layer to a lossy magnetic coating. Application of this result in radar cross-section (RCS) reduction is discussed.

Chou, Ri-Chee↗
NASA NTRS1988

Ground-based radiometric observations of emission and attenuation at 20.6, 31.65, and 90.0 GHz

During 1987, ground-based zenith-viewing observations of atmospheric thermal emission were made at frequencies of 20.6, 31.65, and 90.0 GHz. At the locations of the experiments, San Nicolas Island, California, and Denver, Colorado, radiosonde observations of temperature and humidity were also available. The data, after conversion to attenuation using the mean radiating temperature approximation, are processed to derive attenuation statistics. In addition, both clear and cloudy attenuation characteristics are examined and compared with the most recent theories. Finally, the predictability and interdependence of the three separate channels are examined.

Westwater, Ed R.↗
NASA NTRS1988

Ultrasonic attenuation measurements determine onset, degree, and completion of recrystallization

Ultrasonic attenuation was measured for cold worked Nickel 200 samples annealed at increasing temperatures. Localized dislocation density variations, crystalline order and volume percent of recrystallized phase were determined over the anneal temperature range using transmission electron microscopy, X-ray diffraction, and metallurgy. The exponent of the frequency dependence of the attenuation was found to be a key variable relating ultrasonic attenuation to the thermal kinetics of the recrystallization process. Identification of this key variable allows for the ultrasonic determination of onset, degree, and completion of recrystallization.

Generazio, E. R.↗
NASA NTRS1989

Lateral noise attenuation of the advanced propeller of the propfan test assessment aircraft

Lateral noise attenuation characteristics of the advanced propeller are determined using the flight test results of the testbed aircraft, Propfan Test Assessment (PTA), with a single, large-scale propfan. The acoustic data were obtained with an array of ground-mounted microphones positioned at distances up to 2.47 km (8100 feet) to the side of the flight path. The aircraft was flown at a Mach number of 0.31 for a variety of operating conditions. The lateral noise attenuation in a frequency range containing the blade passage frequency of the propeller was found to have positive magnitudes on the propfan side and negative magnitudes on the opposite side. The measured attenuation exhibits a strong dependence upon the elevation angle. The results also display a clear dependence upon the angle at which the propeller and nacelle are mounted on the wing (inflow angle).

Chambers, F. W.↗
NASA NTRS1989

Relaxation behavior of ultrasonic attenuation in YBa2Cu3O7

It is shown that temperature-dependent ultrasonic attenuation data of YBa2Cu3O7 at various frequencies exhibit anomalies at temperatures close to Tc. These attenuation maxima are found to be the result of a relaxation mechanism added on top of an unusual attenuation background. It is proposed that the grain boundary motions induced by the structural distortion and the propagation of sound waves enhances the energy dissipation around Tc. Whether this structural distortion is the consequence of the onset of a superconducting state remains undetermined. It is also possible that either a tunneling effect or the acoustoelectric effect contributes to sound energy dissipation. The temperature dependence of ultrasonic velocity shows a softening around Tc which may be an intrinsic property of high-temperature superconductors.

Sun, K. J.↗
NASA NTRS1990

A Unified Statistical Rain-Attenuation Model for Communication Link Fade Predictions and Optimal Stochastic Fade Control Design Using a Location-Dependent Rain-Statistic Database

A static and dynamic rain-attenuation model is presented which describes the statistics of attenuation on an arbitrarily specified satellite link for any location for which there are long-term rainfall statistics. The model may be used in the design of the optimal stochastic control algorithms to mitigate the effects of attenuation and maintain link reliability. A rain-statistics data base is compiled, which makes it possible to apply the model to any location in the continental U.S. with a resolution of 0-5 degrees in latitude and longitude. The model predictions are compared with experimental observations, showing good agreement.

Manning, Robert M.↗
NASA NTRS1990

Enhanced ultrasonic attenuation of Tl-Ca-Ba-Cu-O at the superconducting transition

Temperature-dependent ultrasonic attenuation measurements have been performed on polycrystalline samples of Tl-Ca-Ba-Cu-O at various frequencies. An attenuation anomaly was observed close to the superconducting transition temperature T(c) (103 K) whose temperature position was frequency-independent. The attenuation decreased exponentially with temperature in the superconducting state for both transverse and longitudinal waves. It was also found that the temperature-dependent sound velocity showed a slope change around T(c).

Sun, K. J.↗
NASA NTRS1991

Calculation Of Pneumatic Attenuation In Pressure Sensors

Errors caused by attenuation of air-pressure waves in narrow tubes calculated by method based on fundamental equations of flow. Changes in ambient pressure transmitted along narrow tube to sensor. Attenuation of high-frequency components of pressure wave calculated from wave equation derived from Navier-Stokes equations of viscous flow in tube. Developed to understand and compensate for frictional attenuation in narrow tubes used to connect aircraft pressure sensors with pressure taps on affected surfaces.

Whitmore, Stephen A.↗
NASA NTRS1991

Estimating Rain Attenuation In Satellite Communication Links

Attenuation computed with help of statistical model and meteorological data. NASA Lewis Research Center Satellite Link Attenuation Model (SLAM) program QuickBASIC computer program evaluating static and dynamic statistical assessment of impact of rain attenuation on communication link established between Earth terminal and geosynchronous satellite. Application in specification, design, and assessment of satellite communication links for any terminal location in continental United States. Written in Microsoft QuickBASIC.

Manning, R. M.↗
NASA NTRS1990

Attenuation statistics derived from emission measurements by a network of ground-based microwave radiometers

Two seasons of thermal emission measurements, running from December 1987 through February 1988 and from June through August 1988 of thermal emission measurements, taken by a multi-channel, ground-based microwave radiometer, are used to derive single-station zenith attenuation statistics at 20.6 and 31.65 GHz. For the summer period, statistics are also derived for 52.85 GHz. In addition, data from two dual-channel radiometers, separated from Denver by baseline distances of 49 and 168 km, are used to derive two-station attenuation diversity statistics at 20.6 and 31.65 GHz. The multi-channel radiometer is operated at Denver, Colorado; the dual-channel devices are operated at Platteville and Flagler, Colorado. The diversity statistics are presented by cumulative distributions of maximum and minimum attenuation.

Westwater, E. R.↗
NASA NTRS1991

A statistical rain attenuation prediction model with application to the advanced communication technology satellite project. 3: A stochastic rain fade control algorithm for satellite link power via non linear Markow filtering theory

The dynamic and composite nature of propagation impairments that are incurred on Earth-space communications links at frequencies in and above 30/20 GHz Ka band, i.e., rain attenuation, cloud and/or clear air scintillation, etc., combined with the need to counter such degradations after the small link margins have been exceeded, necessitate the use of dynamic statistical identification and prediction processing of the fading signal in order to optimally estimate and predict the levels of each of the deleterious attenuation components. Such requirements are being met in NASA's Advanced Communications Technology Satellite (ACTS) Project by the implementation of optimal processing schemes derived through the use of the Rain Attenuation Prediction Model and nonlinear Markov filtering theory.

Manning, Robert M.↗
NASA NTRS1992

Hysteresis effects in instantaneous frequency scaling of attenuation on 20 and 30 GHz satellite links

It has been observed with 20/30 GHz satellite beacon measurements that the ratio of 30 GHz to 20 GHz attenuation changes during some fade events. This ratio displays a hysteresis effect. This effect can be explained by a change in the drop size distribution (DSD) during the event. However, it appears only above approximately 6-8 dB of attenuation at 20 GHz. Instantaneous frequency scaling of attenuation is being proposed as part of an algorithm for uplink power control (ULPC) and the dynamic range of such an algorithm must be appropriately limited to avoid the hysteresis.

Sweeney, D. G.↗
NASA NTRS1992

Wave attenuation in the marginal ice zone during LIMEX

The effect of ice cover on ocean-wave attenuation is investigated for waves under flexure in the marginal ice zone (MIZ) with SAR image spectra and the results of models. Directional wavenumber spectra are taken from the SAR image data, and the wave-attenuation rate is evaluated with SAR image spectra and by means of the model by Liu and Mollo-Christensen (1988). Eddy viscosity is described by means of dimensional analysis as a function of ice roughness and wave-induced velocity, and comparisons are made with the remotely sensed data. The model corrects the open-water model by introducing the effects of a continuous ice sheet, and turbulent eddy viscosity is shown to depend on ice thickness, floe sizes, significant wave height, and wave period. SAR and wave-buoy data support the trends described in the model results, and a characteristic rollover is noted in the model and experimental wave-attenuation rates at high wavenumbers.

Liu, Antony K.↗
NASA NTRS1992

Differential shear wave attenuation and its lateral variation in the North Atlantic region

A digital data base of over 150 seismograms and a spectral radio technique are used to measure SS-S differential attenuation in the North Atlantic region. Differential attenuation is positively correlated with SS-S travel time residual, and both differential attentuation and travel time residual decrease with increasing seafloor age. Models are developed for seismic Q in which lateral variations include contributions from the asthenospheric low-Q zone as well as from lithospheric cooling. The Q models obtained under this assumption are in good agreement with those obtained from surface wave studies and are therefore preferred over those models with lateral variations confined to the upper 125 km. Systematic long-wavelength (1000-7000 km) variations in differential attenuation, corrected for seafloor age, are evident along the axis of the Mid-Atlantic Ridge. These variations can be qualitatively correlated with long-wavelength variations in SS-S differential travel time residuals and are attributed to along-axis differences in upper mantle temperature.

Sheehan, Anne F.↗
NASA NTRS1992

Attenuation behavior of solid dense random media at microwave frequencies

To better understand scattering from nontenuous dense random media such as sea ice and snow, attenuation measurements have been performed on two different types of random media with ka values ranging from 0.5 to 0.7, and 1.5 to 2.1. Experimental results are presented for wave propagation in plane slabs of finite thickness composed of a random distribution of identical, finite scatterers, and a random distribution of scatterers with narrow size distribution. The observed behavior is described in terms of attenuation versus volume fraction, and the behavior of attenuation versus frequency. Results presented are compared to the behavior reported by some earlier experiments where the medium properties are different.

Nadimi, S. A.↗