Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “TEM”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9

Utilizing TiO 2 amorphous precursors for polymorph selection: An in situ TEM study of phase formation and kinetics

Selective synthesis of metastable polymorphs requires a fundamental understanding of the complex energy landscapes in which these phases form. Recently, the development of in situ high temperature and controlled atmosphere transmission electron microscopy has enabled the direct observation of nucleation, growth, and phase transformations with near atomic resolution. In this work, we directly observe the crystallization behavior of amorphous TiO 2 thin films grown under different pulsed laser deposition conditions and quantify the mechanisms behind metastable crystalline polymorph stabilization. Films deposited at 10 mTorr chamber oxygen pressure crystallize into nanocrystalline Anatase at 325 degrees C, whereas films deposited at 2 mTorr crystallize into significantly larger needle-like grains of Brookite and Anatase at 270 degrees C. Increasing film deposition rate by a factor of 4 results in a 10x increase in the crystalline growth front velocity as well as a decrease in crystallization temperature from 270 degrees C to 225 degrees C. Engineering the amorphous precursor state through deposition conditions therefore provides routes to microstructure control and the accessibility of higher energy metastable phases.

36 MATERIALS SCIENCE↗

TEM Analysis of Additively Manufactured Stainless Steels Prior to Neutron Irradiation

Austenitic stainless steel (SS-316L) is an extensively researched L-PBF alloy and is widely used as a structural material in light water reactors due to its good creep and fatigue resistance at elevated temperatures. SS-316L’s toughness at low temperature makes it a good candidate to assess the performance of additively manufactured components for nuclear applications. However, component performance is a direct function of environment. A component in a reactor environment is subject to unique challenges in the form of heat and radiation fluxes in comparison to most component applications. Furthermore, the present study seeks to understand the pre- and post-irradiation behavior of L-PBF manufactured SS-316L at the microstructural level.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗

TEM-based phase characterization of $\mathrm{U–19Pu–10Zr}$ irradiated in ATR

We report the results of the microstructural examination of the irradiated U–19Pu–10Zr fuel. New insights gained using selective area electron diffraction analysis in a transmission electron microscope provide crystallographic information on the phases previously identified based primarily on the chemical compositions. After irradiation, the microstructure of the fuel separates into γ-(U, Pu, Zr) in the central region with a secondary nanocrystalline UO 2 phase, γ-(U, Pu, Zr) with a secondary ZrO 2 phase in the intermediate, and ζ-(U, Pu) in the outer regions. While the surface microstructural features and porosity indicate separation into three concentric zones consistent with the existing constituent redistribution model, crystallographically the fuel consists of two zones: inner (with γ-(U, Pu, Zr) as a matrix phase) and outer (with ζ-(U, Pu) as a matrix phase). Our results highlight the importance of crystal structure in phase identification and can be used to supplement the existing constituent redistribution model.

extreme environment↗