SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The requirement of Federal agencies, other than NOAA, for the data and services of civil operational environmental satellites (both polar orbiting and geostationary) are summarized. Agency plans for taking advantage of proposed future Earth sensing space systems, domestic and foreign, are cited also. Current data uses and future requirements are addressed as identified by each agency.
Minimum recombination and low injection level are essential for high efficiency. Twenty percent AM1 efficiency requires a dark recombination current density of 2 x 10 to the minus 13th power A/sq cm and a recombination center density of less than 10 to the 10th power /cu cm. Recombination mechanisms at thirteen locations in a conventional single crystalline silicon cell design are reviewed. Three additional recombination locations are described at grain boundaries in polycrystalline cells. Material perfection and fabrication process optimization requirements for high efficiency are outlined. Innovative device designs to reduce recombination in the bulk and interfaces of single crystalline cells and in the grain boundary of polycrystalline cells are reviewed.
The ability to detect subtle trends in upper stratospheric ozone places strict requirements on satellite-based Solar Backscatter Ultraviolet (SBUV) sensors intended for this purpose. Simulation of the long-term change in backscattered radiance indicates trends in the range 1.0-1.6 percent per decade depending on wavelength for an ozone depletion scenario based on chlorofluorocarbon (CFC) chemistry. The maximum percentage change in the measured quantity, as would be sensed by the Nimbus-7 SBUV experiment and future similar instruments, is roughly a factor of two less than the maximum percentage change in ozone, the quantity of geophysical interest. Furthermore, interannual variations, whose magnitude can be estimated from the SBUV data set, could obscure a CFC-related trend in radiance when viewed over a period less than a decade. Even when such atmospheric noise and possible solar cycle variations are neglected, the detection of an ozone trend of the magnitude predicted for CFC-related chemistry requires a set of radiance measurements that are internally consistent to 1 percent or better over a time span of a decade.
Integrating a clustered, four engine ion propulsion system to the Mariner Mark II spacecraft is shown to reduce total trip time for the five proposed Mariner Mark II missions by fifteen years. In addition, this advanced Solar Electric Propulsion (SEP) system enables rendezvous encounters with five main belt asteroids rather than one. A precursor Advanced Capability Explorer (ACE) technology demonstration vehicle is proposed to investigate SEP spacecraft interaction and control requirements in support of these future mission opportunities. It is shown that the ACE spacecraft could be assembled from existing residual hardware, protoflight equipment and commercially available flight tested components. The ion propulsion system requirements to support ambitious Nuclear Electric Propulsion (NEP) missions are also examined and specific technology development objectives presented.
A variety of instruments will be placed at the focus of the Advanced X-ray Astrophysics Facility (AXAF) telescope, either by moving them into focus through the use of an instrument carousel or by moving the telescope assembly. Focal plane instrument categories under consideration for AXAF encompass high and moderate resolution X-ray cameras, X-ray spectrometers, and polarimeters; some of these instruments may require such consumables as a cryogen, in the case of solid state device cooling, or a gas, as in the case of proportional counters. Attention is presently given to interface requirements impacting on the maintenance that must be conducted over the 15-year service life of AXAF, and, especially, on the 'aspect solution' criteria that must be met to minimize stiffness stability criteria.
Results are presented of dynamic structural analyses of 75 and 300 kW versions of a solar dynamic (SD) power supply for the Space Station (MSS). The SD is being seriously considered as an alternative to solar panels due to lower areal and mass requirements and higher efficiencies. The functioning principle is to use parabolic concentrators to focus sunlight on a heat engine to boil liquids to drive a turbine. Potential problems are foreseen in terms of the torques which would be experienced by the MSS and the subsequent orbital stability effects. The stability would be altered by changing aerodynmaic drag, altered moment of inertia and angular momentum and the altered center of mass location. The problem is exacerbated by the need to first equip the MSS with solar panels while the SD technology is developed. The analysis shows that the attitude control system will need to be redesigned and resized to accommodate MSS growth with either power system. The effects of the rotating parts of the SD system can be minimized, but further studies are required to determine the effects on the pointing accuracy of the SD, which must be 10 times as precise as that needed by a photovoltaic array.
A piloted similator experiment designed to investigate directional axis handling qualities requirements for low-speed and hover tasks conducted by a scout/attack helicopter is described. Included were the directional characteristics of various candidate light helicopter family (LHX) configurations. The test also focused on conventional single main/tail rotor configurations where the first-order effects that contribute to the loss of tail rotor control experienced by the OH-58 series aircraft were modeled. Two types of yaw stability and control augmentation systems were implemented: washed-out yaw rate feedback and shaped control input, and a yaw rate command, heading-hold system. The results of the experiment indicate that rotorcraft configurations with high directional gust sensitivity require more yaw damping to maintain satisfactory handling qualities during nap-of-the-earth (NOE) flying tasks. It was also determined that both yaw damping and control response are critical handling qualities parameters in performing the air-to-air target acquisition and tracking task. The lack of substantial yaw damping and larger values of gust sensitivity increased the possibility of loss of directional control at low airspeeds for the tail rotor configurations.
A piloted simulator experiment has been conducted to ascertain the directional axis handling requirements of hover and below 40-kt tasks of a scout/attack helicopter, with attention to such light helicopter configurations as those being considered for the 'LHX' program. Two types of yaw stability and control augmentation system were implemented: one consisted of a washed-out yaw rate feedback and shaped control unit, while the other involved a yaw rate command heading-hold system. Experiment results indicate that rotorcraft configurations with high directional gust sensitivity require greater minimum yaw damping to maintain satisfactory handling qualities in nap of the earth flight. Yaw damping and control response are critical handling qualities parameters in air-to-air target acquisition and tracking.
The development of an expert system prototype for software functional requirement determination for NASA Goddard's Command Management System, as part of its process of transforming general requests into specific near-earth satellite commands, is described. The present knowledge base was formulated through interactions with domain experts, and was then linked to the existing Knowledge Engineering Systems (KES) expert system application generator. Steps in the knowledge-base development include problem-oriented attribute hierarchy development, knowledge management approach determination, and knowledge base encoding. The KES Parser and Inspector, in addition to backcasting and analogical mapping, were used to validate the expert system-derived requirements for one of the major functions of a spacecraft, the solar Maximum Mission. Knowledge refinement, evaluation, and implementation procedures of the expert system were then accomplished.
The flying requirements of MIL-F-8785(C) are interpreted in terms of command/response configurations, and pilot preference for flight control systems configurations of angle of attack, or pitch rate command, specified independently for the short period and phugoid dynamics, is determined using the Total-In-Flight-Simulator aircraft. The results show that for either command configuration, the short term response applies to the angle of attack response of the vehicle, and that this response must satisfy the omega(n) vs n/alpha requirement. The preference in the long term for angle of attack command indicates that the pilot wants the aircraft to fly in the direction it is pointing, and an attitude hold system is not found to be preferred unless attitude hold results in flight path angle hold.
The requirements for performance, design, test, and qualification of a computer program identified as NICBES, Nickel Cadmium Battery Expert System, is established. The specific spacecraft power system configuration selected was the Hubble Space Telescope (HST) Electrical Power System (EPS) Testbed. Power for the HST comes from a system of 13 Solar Panel Arrays (SPAs) linked to 6 Nickel Cadmium Batteries which are connected to 3 Busses. An expert system, NICBES, will be developed at Martin Marietta Aerospace to recognize a testbed anomaly, identify the malfunctioning component and recommend a course of action. Besides fault diagnosis, NICBES will be able to evaluate battery status, give advice on battery status and provide decision support for the operator. These requirements are detailed.
The advanced solar dynamic system (ASDS) program is aimed at developing the technology for highly efficient, lightweight space power systems. The approach is to evaluate Stirling, Brayton and liquid metal Rankine power conversion systems (PCS) over the temperature range of 1025 to 1400K, identify the critical technologies and develop these technologies. Microgravity fluid management technology is required in several areas of this program, namely, thermal energy storage (TES), heat pipe applications and liquid metal, two phase flow Rankine systems. Utilization of the heat of fusion of phase change materials offers potential for smaller, lighter TES systems. The candidate TES materials exhibit large volume change with the phase change. The heat pipe is an energy dense heat transfer device. A high temperature application may transfer heat from the solar receiver to the PCS working fluid and/or TES. A low temperature application may transfer waste heat from the PCS to the radiator. The liquid metal Rankine PCS requires management of the boiling/condensing process typical of two phase flow systems.
A piloted simulator experiment was conducted to investigate directional axis handling qualities requirements for low speed and hover tasks performed by a Scout/Attack helicopter. Included were the directional characteristics of various candidate light helicopter family configurations. Also, the experiment focused on conventional single main/tail rotor configurations of the OH-58 series aircraft, where the first-order yaw-axis dynamic effects that contributed to the loss of tail rotor control were modeled. Five pilots flew 22 configurations under various wind conditions. Cooper-Harper handling quality ratings were used as the primary measure of merit of each configuration. The results of the experiment indicate that rotorcraft configurations with high directional gust sensitivity require greater minimum yaw damping to maintain satisfactory handling qualities during nap-of-the-Earth flying tasks. It was also determined that both yaw damping and control response are critical handling qualities parameters in performing the air-to-air target acquisition and tracking task. Finally, the lack of substantial yaw damping and larger values of gust sensitivity increased the possibility of loss of directional control at low airspeeds for the single main/tail rotor configurations.
It is noted that future power requirements are increasing for some expanded and new missions within the Air Force and Department of Defense. New requirements are needed in terms of lifetime, survivability, power level and performance. The photovoltaic arrays have a demonstrated record of reliable performance, life, affordable cost, and utility. It is argued that there is a need to push for the research and development resources needed to develop the technology base for these future power system needs.
Water used during current and previous space missions has been either carried or made aloft. Future human space endeavors will require some form of water reclamation and recycling. There is little experience in the U.S. space program with this technology. Water reclamation and recycling constitute engineering challenges of the broadest nature that will require an intensive research and development effort if this technology is to mature in time for practical use on the proposed U.S. Space Station. In order for this to happen, reclaimed/recycled water specifications will need to be devised to guide engineering development. Present NASA Potable Water Specifications are not applicable to reclaimed or recycled water. Adequate specifications for ensuring the quality of the reclaimed or recycled potable water system is reviewed, limitations of present water specifications are examined, world experience with potable water reclamation/recycling systems and systems analogs is reviewed, and an approach to developing pertinent biomedical water specifications for spacecraft is presented. Space Station water specifications should be designed to ensure the health of all likely spacecraft inhabitants including man, animals, and plants.
A preliminary analysis of the Ada implementation of the Advanced Transport Operating System (ATOPS), an experimental computer control system developed at NASA Langley for a modified Boeing 737 aircraft, is presented. The criteria that was determined for the evaluation of this approach is described. A preliminary version of the requirements for the ATOPS is contained. This requirements specification is not a formal document, but rather a description of certain aspects of the ATOPS system at a level of detail that best suits the needs of the research. The survey of backward error recovery techniques is also presented.
This paper reviews the results of several simulation investigations of rotary-wing and fixed-wing VSTOL aircraft performing terminal-area operations that include decelerating approaches under instrument conditions and recovery to either fixed landing pads or a ship. By concentrating on instrument decelerating approaches and the hover and landing, it is possible to compare directly the control and display requirements for similar tasks for aircraft with and without vectored thrust capability. Collectively, the results from these experiments, together with other simulator and flight experiments and operational experience, provide a consistent view of control and display complexity required for similar operational capability in adverse weather for the two types of VSTOL configurations. Some initial data showing influence of the transition corridor on flying qualities during transition are pesented and lead to a general discussion of the problem of operating margin definition.
Orbit perturbations and their effect on polar earth-orbiting space-surveillance spacecraft propulsion requirements for hydrazine, nitrogen tetroxide/monomethyl hydrazine, resistojet, and arcjet propulsion systems are investigated. Estimates of the Delta V and propellant mass required to correct for perturbations for both low-altitude and Molniya spacecraft orbits are presented, and 400-36,000 km orbit altitudes, and 57-90 deg orbit inclinations, are considered. The dominant factors in perturbations to the orbit of low-altitude earth orbiters, resulting from the earth's nonsphericity, are the second zonal harmonic describing the earth's oblateness, and the perturbations due to the earth's north-south mass asymmetry.