SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Mars Pathfinder is one of NASA s new low-cost planetary missions developed to meet a $150 million cost cap. This paper describes the operations philosophy, requirements, organizational structure, and ground data system.
Discussion of ground support systems for the monitoring and recovery of manned spacecraft
The objective of this paper is to provide the future ISS scientist and/or engineer a sense of what ISS payload operations are expected to be. This paper uses a real-time operations scenario to convey this message. The real-time operations scenario begins at the initiation of payload operations and runs through post run experiment analysis. In developing this scenario, it is assumed that the ISS payload operations flight and ground capabilities are fully available for use by the payload user community. Emphasis is placed on telescience operations whose main objective is to enable researchers to utilize experiment hardware onboard the International Space Station as if it were located in their terrestrial laboratory. An overview of the Payload Operations Integration Center (POIC) systems and user ground system options is included to provide an understanding of the systems and interfaces users will utilize to perform payload operations. Detailed information regarding POIC capabilities can be found in the POIC Capabilities Document, SSP 50304.
By differencing carrier phase measurements from multiple antennas, a global positioning systems (GPS) reciever can determine the attitude of a coordinate frame defined by the antenna baselines. This paper examines the potential role of such a capability within spacecraft avionics. The applications served by current GPS capabilities are identified. Architectural options are considered, and a baseline which satisfies the needs of most applications is defined. The majority of this paper then focuses on the prototyping of this baseline architecture within the Jet Propulsion Laboratory's (JPL's) Flight System Testbed (FST). The test setup is described, and test results are presented. The paper closes with an analysis of the limiting factors in the GPS based altitude determination error budget, a forecast of future capabilities, and a discussion of the advances that will be required to achieve those capabilities.
A ground based, general purpose, real time, digital control system simulator (CSS) is specified, developed, and integrated with the existing instrumentation van of the testing facility. This CSS is built around a PDP-11/55, and its operational software was developed to meet the dual goal of providing the immediate capability to represent the F-18 drop model control laws and the flexibility for expansion to represent more complex control laws typical of control configured vehicles. Overviews of the two CSS's developed are reviewed as well as the overall system after their integration with the existing facility. Also the latest version of the F-18 drop model control laws (REV D) is described and the changes needed for its incorporation in the digital and analog CSS's are discussed.
This paper presents a model for integrated communications within the Space Station Information System (SSIS). The SSIS is generally defined as the integrated set of space and ground information systems and networks which will provide required data services to the Space Station flight crew, ground operations personnel, and customer communities. This model is based on the International Standards Organization (ISO) layered model for Open Systems Interconnection (OSI). The requirements used to develop the model are presented, and the various elements of the model described.
Operating the Mars Exploration Rovers is a challenging, time-pressured task. Each day, the operations team must generate a new plan describing the rover activities for the next day. These plans must abide by resource limitations, safety rules, and temporal constraints. The objective is to achieve as much science as possible, choosing from a set of observation requests that oversubscribe rover resources. In order to accomplish this objective, given the short amount of planning time available, the MAPGEN (Mixed-initiative Activity Plan GENerator) system was made a mission-critical part of the ground operations system. MAPGEN is a mixed-initiative system that employs automated constraint-based planning, scheduling, and temporal reasoning to assist operations staff in generating the daily activity plans. This paper describes the adaptation of constraint-based planning and temporal reasoning to a mixed-initiative setting and the key technical solutions developed for the mission deployment of MAPGEN.
Astrobee is a new class of free-flying robots that operate in the interior of the International Space Station (ISS). In addition to providing a research platform for zero-g free-flying robotics (replacing the Synchronized Position Hold Engage and Reorient Experimental Satellites (SPHERES)), Astrobee improves the efficiency of ISS operations by providing flight and payload controllers with a mobile camera/sensor platform. The Astrobee system consists of three robots, a docking station, and a ground data system. Development began in late 2014, and Astrobee will launch to ISS in late 2018. This paper provides an overview of the capabilities of the Astrobee system, the concept of operations for ISS operations support, and the challenges of operating a free-flying robot within the constraints of the ISS environment.
Astrobee is a new class of free-flying robots that operate in the interior of the International Space Station (ISS). In addition to providing a research platform for zero-g free-flying robotics (replacing the Synchronized Position Hold Engage and Reorient Experimental Satellites (SPHERES)), Astrobee improves the efficiency of ISS operations by providing flight and payload controllers with a mobile camera/sensor platform. The Astrobee system consists of three robots, a docking station, and a ground data system. Development began in late 2014, and Astrobee will launch to ISS in late 2018. This paper provides an overview of the capabilities of the Astrobee system, the concept of operations for ISS operations support, and the challenges of operating a free-flying robot within the constraints of the ISS environment.
An aerodynamic database for the crew access arm during deployment is generated. While initial attempts used data derived from wind tunnel testing, limitations lead to the use of computational fluid dynamics to improve analysis. This computational data compared favorably to the experimental data increasing confidence in both. Further analysis lead to simplification showing the ability to build the database with a single relative wind variable which takes into account both arm deployment angle and wind direction. Eventually geometric simplifications and conservative results lead to the use of simulations of the CAA alone to build the database.Finally these static conditions are then compared to a dynamic simulation where the CAA rotates into position to test the quasi-steady state assumptions used to generate the database. The dynamic case showed an increase in the moment of interest but within acceptable bounds for now.
In recent years, advancements in technology have greatly improved the utility and applicability of Uncrewed Aircraft Systems (UAS) and have highlighted the need for and importance of UAS Traffic Management (UTM). Onboard sense and avoid systems, ground-based sensors, and long- range command and control (C2) systems have significantly expanded the possibilities for UAS beyond visual line of sight (BVLOS) operations. Initially, research on UTM flights focused on their interactions with other UTM operations, but that has since been expanded to include interactions with the flight profiles of Advanced Air Mobility (AAM) and upper Class E Traffic Management (ETM) operations. Recognizing the potential of these systems and the increase in UAS autonomy, the Department of Defense (DoD) is working towards integrating these missions and systems into a unified DoD Federal ecosystem. The Federal USS Synthesis Effort (FUSE) aims to develop a live system that can efficiently combine this wide range of UTM, AAM, and ETM systems, thus enabling expanded operations within a single common operating environment. The goal of the Federal USS Synthesis Effort (FUSE) is for NASA and the DoD to develop a live system that can efficiently combine UTM, AAM, and ETM systems. The most recent endeavor in this effort was a live flight test conducted near Grand Forks Air Force Base in June, 2023, where the FUSE ecosystem successfully demonstrated integrating UTM, AAM, and ETM operations while providing a single, shared COP to users. Additional investigations were made during the test, including assessing the usefulness of the system and its capability to support UAS weighing over 55 lbs.; testing user messaging capabilities and a DoD adaptation of a Federal USS; and assessing user workload, automated vs manual control, and the usability of NASA’s XTMClient.
The Interval Management for Near-term Operations Validation of Acceptability (IM-NOVA) experiment was conducted at the National Aeronautics and Space Administration (NASA) Langley Research Center (LaRC) in support of the NASA Airspace Systems Program's Air Traffic Management Technology Demonstration-1 (ATD-1). ATD-1 is intended to showcase an integrated set of technologies that provide an efficient arrival solution for managing aircraft using Next Generation Air Transportation System (NextGen) surveillance, navigation, procedures, and automation for both airborne and ground-based systems. The goal of the IMNOVA experiment was to assess if procedures outlined by the ATD-1 Concept of Operations were acceptable to and feasible for use by flight crews in a voice communications environment when used with a minimum set of Flight Deck-based Interval Management (FIM) equipment and a prototype crew interface. To investigate an integrated arrival solution using ground-based air traffic control tools and aircraft Automatic Dependent Surveillance-Broadcast (ADS-B) tools, the LaRC FIM system and the Traffic Management Advisor with Terminal Metering and Controller Managed Spacing tools developed at the NASA Ames Research Center (ARC) were integrated into LaRC's Air Traffic Operations Laboratory (ATOL). Data were collected from 10 crews of current 757/767 pilots asked to fly a high-fidelity, fixed-based simulator during scenarios conducted within an airspace environment modeled on the Dallas-Fort Worth (DFW) Terminal Radar Approach Control area. The aircraft simulator was equipped with the Airborne Spacing for Terminal Area Routes (ASTAR) algorithm and a FIM crew interface consisting of electronic flight bags and ADS-B guidance displays. Researchers used "pseudo-pilot" stations to control 24 simulated aircraft that provided multiple air traffic flows into the DFW International Airport, and recently retired DFW air traffic controllers served as confederate Center, Feeder, Final, and Tower controllers. Analyses of qualitative data revealed that the procedures used by flight crews to receive and execute interval management (IM) clearances in a voice communications environment were logical, easy to follow, did not contain any missing or extraneous steps, and required the use of an acceptable workload level. The majority of the pilot participants found the IM concept, in addition to the proposed FIM crew procedures, to be acceptable and indicated that the ATD-1 procedures could be successfully executed in a nearterm NextGen environment. Analyses of quantitative data revealed that the proposed procedures were feasible for use by flight crews in a voice communications environment. The delivery accuracy at the achieve-by point was within +/-5 sec, and the delivery precision was less than 5 sec. Furthermore, FIM speed commands occurred at a rate of less than one per minute, and pilots found the frequency of the speed commands to be acceptable at all times throughout the experiment scenarios.
Vertical distribution of static ground wind loads was directly measured on Mobile Launcher ground support hardware to the NASA Space Launch System (SLS) at 1.75% scale in the Langley Research Center 14- by 22-Foot Subsonic Tunnel. Low-speed wind tunnel testing in the liftoff phase of flight was conducted for the SLS Block 1B family of rockets with their associated ground support systems. Improved methods for measuring and estimating static ground wind loads on the launch tower assembly are introduced in detail. A novel, distributed loads measurement technique is introduced and compared against lower-fidelity, previously utilized methods.
In this paper we review the discovery of cosmic ray effects on the performance and reliability of microelectronic systems as well as on human health and safety, as well as the development of the engineering and health science tools used to evaluate and mitigate cosmic ray effects in earth surface, atmospheric flight, and space flight environments. Three twentieth century technological developments, 1) high altitude commercial and military aircraft; 2) manned and unmanned spacecraft; and 3) increasingly complex and sensitive solid state micro-electronics systems, have driven an ongoing evolution of basic cosmic ray science into a set of practical engineering tools (e.g. ground based test methods as well as high energy particle transport and reaction codes) needed to design, test, and verify the safety and reliability of modern complex electronic systems as well as effects on human health and safety. The effects of primary cosmic ray particles, and secondary particle showers produced by nuclear reactions with spacecraft materials, can determine the design and verification processes (as well as the total dollar cost) for manned and unmanned spacecraft avionics systems. Similar considerations apply to commercial and military aircraft operating at high latitudes and altitudes near the atmospheric Pfotzer maximum. Even ground based computational and controls systems can be negatively affected by secondary particle showers at the Earth's surface, especially if the net target area of the sensitive electronic system components is large. Accumulation of both primary cosmic ray and secondary cosmic ray induced particle shower radiation dose is an important health and safety consideration for commercial or military air crews operating at high altitude/latitude and is also one of the most important factors presently limiting manned space flight operations beyond low-Earth orbit (LEO).
A sensitivity study for the in-ground effect on aircraft wake vortices has been conducted using a validated large eddy simulation model. The numerical results are compared with observed data and show good agreement for vortex decay and lateral vortex transport. The vortex decay rate is strongly influenced by the ground, but appears somewhat insensitive to ambient turbulence. In addition, the results show that the ground can affect the trajectory and descent-rate of a wake vortex pair at elevations up to about 3 b(sub o) (where b(sub o) is the initial vortex separation). However, the ground does not influence the average circulation of the vortices until the cores descend to within about 0.6 b(sub o), after which time the ground greatly enhances their rate of demise. Vortex rebound occurs in the simulations, but is more subtle than shown in previous numerical studies.
This paper examines the requirements and the design considerations of the Synthetic Aperture Radar (SAR) ground data system for the Alaska SAR Facility (ASF) at the University of Alaska in Fairbanks (UAF) for the new era of Radarsat/ERS-2 missions. These include a new data acquisition planning capability to manage more satellites with global planning and to manage more than one instrument mode; a new archive strategy that is cheaper, faster, and better; a product generation system to produce data on demand and to produce data for the varied instruments and modes; and a product verification ability for the new and old products. In response to these new functional requirements, JPL is using a design approach that emphasizes an open systems, client/server architecture based on industry standards and commercial off-the-shelf technology.
A prototype assessment of the environmental impacts of siting and constructing a Satellite Power System (SPS) Ground Receiving Station (GRS) is reported. The objectives of the study were: (1) to develop an assessment of the nonmicrowave related impacts of the reference system SPS GRS on the natural environment; (2) to assess the impacts of GRS construction and operations in the context of actual baseline data for a site in the California desert; and (3) to identify critical GRS characteristics or parameters that are most significant in terms of the natural environment.
This study evaluates the latest Global Precipitation Measurement (GPM) Integrated Multi-satellitE Retrievals for GPM (IMERG V07B) against its predecessor V06B, for studying mesoscale convective systems (MCSs). Both versions are compared using ground-based radar and rain gauge data from five meteorologically diverse regions: the contiguous United States (including eastern coastlines), Amazon rainforest, central Argentina mountains, equatorial Indian Ocean, and northern Australia across multiple temporal (0.5–6 hours) and spatial scales (0.1°–0.25°). An updated global MCS tracking dataset is developed by integrating satellite-observed infrared brightness temperature with IMERG V07B. Comparation of IMERG against radar observations reveals that IMERG demonstrates better performance in capturing the probability distribution and quantitative contributions of rainfall (from no-rain to intense-rain conditions) over tropical oceans than over land, with marked improvements in IMERG V07B for heavy-to-intense rain (> 10 mm h-1). Over land, systematic biases persist: IMERG tends to overestimate light-to-moderate rain (1–10 mm h-1) while underestimating heavy-to-intense rain. Additionally, aggregating IMERG to coarser resolutions (3-hourly or 0.25°) improves consistency with radar observations, outperforming the 1-hourly/0.1° resolution. The new IMERG V07B-based global MCS dataset exhibits consistent statistical characteristics with the V06B-based dataset, despite lower mean rain rates and reduced heavy precipitation contributions. These findings offer valuable insights for utilizing IMERG V07B in global precipitation studies, MCS characterization, and model evaluation.