Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “High Dynamic”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,585 records · Page 88
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Dynamics of Playa lakes in the Texas High Plains

Three small playa lake basins on the Texas High Plains were originally selected as ERTS-1 test sites to attempt correlation of ERTS-1 imagery with the water balance ecosystem and geology/morphology of the lake basins. The 5-mile long large Double Lakes playa complex was also instrumented as an alternate test site. Analysis of bands 6 and 7 of ERTS-1 MSS imagery shows that lake basins as small as 200 m in diameter (+ or - 10 acres) can be reliably classified as being wet or dry, thus supplying the methodology for a rapid, periodic census of surface water. A cost/benefit analysis reveals that the use of MSS imagery for such a census results in a 66 to 200-fold cost reduction when compared to the costs of using other conventional methods.

Reeves, C. C., Jr.↗
NASA NTRS1978

Dynamics of short eccentric plain seals with high axial Reynolds number

Plain seals with high axial flow rates produce large stiffness and damping coefficients that can help stabilize high-speed rotating machinery. When the shaft is eccentric in the seal, a Bernoulli effect low-pressure region occurs on the large-clearance side of the shaft. A fluid-restoring force tends to center the shaft and reduce vibrations. This work extends the previous theory for short plain centered seals to large eccentricities using a perturbation analysis. Surface roughness effects are also included. An analysis of seals used in the Space Shuttle main engine hydrogen fuel turbopump indicates the desirability of plain seals over the labyrinth type. Experimental results confirm this.

Allaire, P. E.↗
NASA NTRS1979

High power thyristors with 5 kV blocking voltage. Volume 1: Development of high-voltage-thyristors (4.5 kV) with good dynamic properties

Using neutron irradiated silicon with considerably lower spread in resistivity as compared to conventionally doped silicon it was possible to produce power thyristors with breakdown voltages between 3.5 kV and 5.5 kV. The thyristor pellets have a diameter of 50 mm. Maximum average on-state currents of 600 to 800 A can be reached with these elements. The dynamic properties of the thryistors could be improved to allow standard applications up to maximum repetitive voltages of 4.5 kV.

Lock, K.↗
NASA NTRS1988

Polar vortex dynamics

Recent work with high resolution, one-layer numerical models of fluid flows resembling those in the real stratosphere has suggested that: (1) the interiors of strong cyclonic vortices like the Antarctic polar vortex may be almost completely isolated laterally from their surroundings - perhaps even completely isolated, under some circumstances; (2) by contrast, material near the edge of such and isolated region can easily be eroded (or mixed one-sidedly) into the surrounding region; and (3) the erosion characteristically produces extremely steep gradients in isentropic distributions of potential vorticity (PV) and of other tracers, possibly down to horizontal length scales of a few kilometers only. Such length scales may occur both at the edge of the main polar vortex and in smaller features outside it, such as thin filamentary structures, produced by the erosion process.

Mcintyre, Michael↗
NASA NTRS1989

Dynamic loading on impact surfaces of a high subsonic elliptic jet

The feedback resonance in a high subsonic velocity range was investigated for the case where a small aspect ratio (2:1) elliptic jet impinged perpendicularly on a flat plate. This resonance was observed for Mach numbers greater than 0.7 for plate locations between 4 and 9 major radii downstream of the exhaust plane. At the predominant resonant conditions, the loading region and sound source terms were found to be concentrated along the major axis direction on the impact surface.

Wat, J. K.↗
NASA NTRS1991

Pressure-coupled vaporization and combustion responses of liquid-fuel droplets in high-pressure environments

The dynamic responses of liquid-fuel droplet vaporization and combustion to ambient pressure oscillations are examined. The analysis is based on the complete sets of conservation equations for both gas and liquid phases, and accommodates detailed treatments of finite-rate chemical kinetics and variable properties. With a full account of thermodynamic phase equilibrium at the droplet surface, the model enables a systematic examination of the effects of ambient flow conditions on the droplet behavior. The responses of hydrocarbon fuel droplets in both sub- and super-critical environments are investigated. Results indicate that the droplet gasification and burning mechanisms depend greatly on the ambient pressure. In particular, a rapid enlargement of the vaporization and combustion responses occurs when the droplet surface reaches its critical point, mainly due to the strong variations of latent heat of vaporization and thermophysical properties at the critical state.

Yang, Vigor↗
NASA NTRS2002

Satellite and Model Analysis of the Atmospheric Moisture Budget in High Latitudes: High Resolution Precipitation Over Greenland Studied from Dynamic Method

Observations of precipitation over Greenland are limited. Direct precipitation measurements for the whole ice sheet are impractical, and those in the coastal region have substantial uncertainty but may be correctable with some effort. However, the analyzed wind, geopotential height and moisture fields are available for recent years, and the precipitation is retrievable from these fields by a dynamic method. Based on recent Greenland precipitation from dynamic studies, several deficiencies in the precipitation spatial distributions from these dynamic methods were evaluated by Bromwich et al.

Bromwich, David H.↗
NASA NTRS2002

Dynamical Studies of the Middle Atmosphere Using High Resolution Doppler Imager Observations

This report summarizes the activities of NASA grant NAG5-11068, "Dynamicai Studies of the Middle Atmosphere Using High Resolution Doppler Imager Observations." The High Resolution Doppler Imager (HRDI) on the Upper Atmosphere Research Satellite (UARS) has been providing direct measurements of the Earth's horizontal wind field in the stratosphere, mesosphere and lower thermosphere. Mesospheric temperatures, ozone, and O((sup 1) D) densities, and stratospheric aerosol extinctions coefficients, are also retrieved. The goal of HRDI is to measure the vector winds in the stratosphere (10-40 km), mesosphere, and lower thermosphere (approximately 50-120 km) during the day, and the lower thermosphere at night (approximately 95 km) to an accuracy of 5 m/s. The horizontal wind vector is measured by observing the Doppler shift of rotational lines of molecular oxygen along two lines of sight. In addition to winds, temperatures and volume emission rates are determined in the mesosphere and lower thermosphere, from which ozone and O((sup 1) D) concentrations can be derived, and aerosol scattering coefficients are determined in the stratosphere. UARS was launched on September 12, 1991, into a 585-km circular orbit inclined 57 degrees to the equator HRDI was activated September 28, 1991 and following a period of checkout and adjustment of the instrument parameters, scientific observations began November 2, 199 1. HRDI operated nearly continuously from launch until April 1995. At that time the UARS solar array drive failed, forcing the instruments to time-share the available power. From July 1995 to July 1996 HRDI operated approximately 50% of the time. At that point, one of the three spacecraft batteries failed and from then until September 1998 the duty cycle was less than 20% per month, At that time it was determined that HRDI could operate during each daytime pass, which increased the daytime duty cycle to close to l00%, while nighttime operations were limited to about a week per month. In the fall of 1999, the second tape recorder failed requiring a real time contact with a TRDSS satellite to retrieve that data. This resulted in about 60% data collection efficiency. Finally, in the summer of 2000, the second star sensor failed requiring the spacecraft attitude to be controlled by a three axis magnetometer and sun sensor. This resulted in a loss of attitude knowledge but operations continue with the anticipation of correcting the attitude. A new method for determining the tide and mean structure from satellite data in conjunction with a new tidal model has been devised. For brevity, it shall be referred to as the TMAT or Tide-Mean Assimilation Technique. Most previous methods of tidal analysis are based on various ways of slicing the data set.

Skinner, Wilbert↗
NASA NTRS2005

MASS CONTENT AND DYNAMICAL STATE OF 3 OPTICALLY SELECTED HIGH-Z CLUSTERS

As part of our analysis of the Chandra and XMM-Newton observations of the high redshift, optically selected cluster ElS0954-2023/22, we have identified Chandra sources in the field and measured their count rate and fluxes. From the 15 ksec Chandra ACIS-S observation, we detected eleven X-ray sources. Their positions and count rates are listed below. Our analysis also shows faint diffuse emission associated with the optically identified cluster. This information was used in a joint analysis of the XMM-Newton observation of the cluster emission to determine the luminosity and temperature of the diffuse cluster gas.

Mushotzky, Richard F.↗
NASA NTRS2010

High-Resolution Subtropical Summer Precipitation Derived from Dynamical Downscaling of the NCEP-DOE Reanalysis: How Much Small-Scale Information Is Added by a Regional Model?

This study assesses the regional-scale summer precipitation produced by the dynamical downscaling of analyzed large-scale fields. The main goal of this study is to investigate how much the regional model adds smaller scale precipitation information that the large-scale fields do not resolve. The modeling region for this study covers the southeastern United States (Florida, Georgia, Alabama, South Carolina, and North Carolina) where the summer climate is subtropical in nature, with a heavy influence of regional-scale convection. The coarse resolution (2.5deg latitude/longitude) large-scale atmospheric variables from the National Center for Environmental Prediction (NCEP)/DOE reanalysis (R2) are downscaled using the NCEP Environmental Climate Prediction Center regional spectral model (RSM) to produce precipitation at 20 km resolution for 16 summer seasons (19902005). The RSM produces realistic details in the regional summer precipitation at 20 km resolution. Compared to R2, the RSM-produced monthly precipitation shows better agreement with observations. There is a reduced wet bias and a more realistic spatial pattern of the precipitation climatology compared with the interpolated R2 values. The root mean square errors of the monthly R2 precipitation are reduced over 93 (1,697) of all the grid points in the five states (1,821). The temporal correlation also improves over 92 (1,675) of all grid points such that the domain-averaged correlation increases from 0.38 (R2) to 0.55 (RSM). The RSM accurately reproduces the first two observed eigenmodes, compared with the R2 product for which the second mode is not properly reproduced. The spatial patterns for wet versus dry summer years are also successfully simulated in RSM. For shorter time scales, the RSM resolves heavy rainfall events and their frequency better than R2. Correlation and categorical classification (above/near/below average) for the monthly frequency of heavy precipitation days is also significantly improved by the RSM.

NARR↗
NASA NTRS2023

Coupled Fluid Dynamics and Material Response Simulations for Nitrogen High Enthalpy Flows

The study focuses on the interaction of nitrogen flows with thermal protection systems during atmospheric re-entry for NASA flight missions. The Ares multiphysics coupling tool is employed to investigate the coupling between the fluid (US3D) and material response (Icarus) solvers using various modeling approaches. These approaches include the equilibrium thin-film coefficients approach, a weakly coupled approach with temperature coupling, and an approach considering the full chemical composition of the surface and the transfer of pyrolysis gases. The objective is to understand and accurately represent the mechanisms of nitrogen interaction with the surface, such as nitridation and catalytic recombination. The study aims to assess the accuracy of the different approaches by comparing them to experimental results obtained from NASA arc-jet facilities. By addressing these challenges and improving the understanding of nitrogen-surface interactions, it is expected to enhance the design and performance analysis of thermal protection systems for future missions.

Ablation↗
DOE OSTI2020

The underappreciated lone pair in halide perovskites underpins their unusual properties

The presence of 6s 2 (5s 2 ) lone-pair electrons on the B-site Pb (Sn) in all-inorganic and hybrid halide ABX 3 perovskites distinguishes these materials from the familiar tetrahedral semiconductors traditionally employed in optoelectronics and is key to many of their appealing properties. These electrons are stereochemically active, albeit often in a hidden fashion, resulting in unusual and highly anharmonic lattice dynamics that are linked to many of the special optoelectronic properties displayed by this material class. This article describes the connections between this atypical electronic configuration and the electronic structure and lattice dynamics of these compounds. We illustrate how the lone pair leads to favorable bandwidths and band alignments, mobile holes, large ionic dielectric response, large positive thermal expansion, and even possibly defect-tolerant electronic transport. Taken together, the evidence suggests that other high-performing semiconductors may be found among compounds with lone-pair-bearing cations in high symmetry environments and a high degree of connectivity between atoms.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Thin, Highly Selective Polymer Membrane Separators for Advanced Liquid Alkaline Water Electrolysis

Our team will develop novel, dense, polymer electrolyte separators based on polybenzimidazole (PBI) derivatives that will enable tuning of water/KOH uptake in mechanically robust films for advanced liquid alkaline water electrolysis (LAWE). These material advances will enable thinner separators with increased selectivity (hydroxide conductivity/hydrogen permeability), thereby enabling higher operating currents, increased dynamic operating high-temperature stability, and catalyst-coated membranes (zero-gap design advantages) in direct alignment with stated lab call goals.

HYDROGEN↗