Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “EROSION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,585 records · Page 88

12054 and 76215 - New measurements of interplanetary dust and solar flare fluxes

The mass distribution and flux of micrometeoroids, variations in solar activity, solar-wind erosion and solar-flare track production are discussed on the basis of lunar sample analyses. A bimodal size frequency distribution of micrometeorites is found; the ratio of the density of craters larger than 0.1 micron to the density of those larger than 500 microns is 50 to 100 million. Solar cosmic-ray track ages determined for the lunar samples through use of the model of Blanford et al. (1975) indicate no variation in solar activity over a period of 2 million years. Solar wind erosion is set at no more than 0.03 A per year.

Morrison, D. A.↗

Direct measurement of surface carbon concentrations

Measurements of surface concentrations of carbon in lunar soils and soil breccias provide information on the origin of carbon in the regolith. The reaction C-12 (d, p sub zero) is used to measure 'surface' and 'volume' concentrations in lunar samples. This method has a depth resolution of 1 micron, which permits only a 'surface' and a 'volume' component to be measured. Three of four Apollo 16 double drive tube samples show a surface carbon concentration of about 8 by 10 to the 14th power/sq cm, whereas the fourth sample gave 4 by 10 to the 14th power/sq cm. It can be convincingly shown that the measured concentration does not originate from fluorocarbon or hydrocarbon contaminants. Surface adsorbed layers of CO or CO2 are removed by a sputter cleaning procedure using a 2-MeV F beam. It is shown that the residual C concentration of 8 by 10 to the 14th power/sq cm cannot be further reduced by increased F fluence, and it is therefore concluded that it is truly lunar. If one assumes that the measured surface C concentration is a steady-state concentration determined only by a balance between solar-wind implantation and sputtering, a sputter erosion rate of 0.1 A/yr is obtained. However, it would be more profitable to use an independently derived sputter erosion rate to test the hypothesis of a solar-wind origin of the surface carbon.

Filleux, C.↗

Preliminary results of the mission profile life test of a 30 cm Hg bombardment thruster

Long term tests were performed on a 30 cm Hg bombardment thruster and a power processing unit to determine lifetime characteristics. The thruster performance data and other operational characteristics taken at various times during the test segment are presented and evaluated with the life limiting mechanisms: discharge chamber erosion, deposition and spalling, external erosion, cathode degradation, and propellant isolator leakage. The control algorithms for thruster start up, steady state operation, throttle, detection and correction of off normal conditions, and shutdown are discussed.

Bechtel, R. T.↗

Differential aeolian redistribution rates on Mars

Data from the Viking Orbiters and Landers, which have been monitoring the Martian aeolian environment since 1976, are employed to study erosion rates and the redistribution of rocks and soil deposits on the planet. Examination of the Martian cratering history yields a computed erosion rate of about one meter per billion yr. The extent of deflation between ejecta deposits and the surrounding terrain, and the origin and age of Martian windblown drifts are also discussed. The study indicates that approximately the present aeolian environment has prevailed on the planet for a significant fraction of geological time.

Arvidson, R.↗

Cropping management using color and color infrared aerial photographs

The Universal Soil Loss Equation (USLE) is a widely accepted tool for erosion prediction and conservation planning. Solving this equation yields the long-term average annual soil loss that can be expected from rill and inter-rill erosion. In this study, manual interpretation of color and color infrared 70 mm photography at the scale of 1:60,000 is used to determine the cropping management factor in the USLE. Accurate information was collected about plowing practices and crop residue cover (unharvested vegetation) for the winter season on agricultural land in Pheasant Branch Creek watershed in Dane County, Wisconsin.

Morgan, K. M.↗

Cap protects aircraft nose cone

Inexpensive, easily fabricated cap protects aircraft nose cone from erosion. Made of molded polycarbonate, cap has been flight tested at both subsonic and supesonic speeds. Its strength and erosion characteristics are superior to those of fiberglass cones.

Bryan, C. F., Jr.↗

Feasibility of SiC composite structures for 1644 deg gas turbine seal applications

The feasibility of silicon carbide composite structures was evaluated for 1644 K gas turbine seal applications. The silicon carbide composites evaluated consisted of Si/SiC Silcomp (Trademark) - and sintered silicon carbide as substrates, both with attached surface layers containing BN as an additive. A total of twenty-eight candidates with variations in substrate type and density, and layer chemistry, density, microstructure, and thickness were evaluated for abradability, cold particle erosion resistance, static oxidation resistance, ballistic impact resistance, and fabricability. The BN-free layers with variations in density and pore size were later added for evaluation. The most promising candidates were evaluated for Mach 1.0 gas oxidation/erosion resistance from 1477 K to 1644 K. The as-fabricated rub layers did not perform satisfactorily in the gas oxidation/erosion tests. However, preoxidation was found to be beneficial in improving the hot gas erosion resistance. Overall, the laboratory and rig test evaluations show that material properties are suitable for 1477 K gas turbine seal applications.

Darolia, R.↗

Some considerations of the performance of two honeycomb gas path seal material systems

A standard Hastelloy-X honeycomb material and a pack aluminide coated honeycomb material were evaluated as to their performance as labyrinth seal materials for aircraft gas turbine engines. Consideration from published literature was given to the fluid sealing characteristics of two honeycomb materials in labyrinth seal applications, and their rub characteristics, erosion resistance, and oxidation resistance were evaluated. The increased temperature potential of the coated honeycomb material compared to the uncoated standard could be achieved without compromising the honeycomb material's rub tolerance, although there was some penalty in terms of reduced erosion resistance.

Bill, R. C.↗

Improved PFB operations: 400-hour turbine test results

A pressurized fluidized bed (PFB) coal-burning reactor was used to provide hot effluent gases for operation of a small gas turbine. Preliminary tests determined the optimum operating conditions that would result in minimum bed particle carryover in the combustion gases. Solids were removed from the gases before they could be transported into the test turbine by use of a modified two stage cyclone separator. Design changes and refined operation procedures resulted in a significant decrease in particle carryover, from 2800 to 93 ppm (1.5 to 0.05 grains/std cu ft), with minimal drop in gas temperature and pressure. The achievement of stable burn conditions and low solids loadings made possible a 400 hr test of small superalloy rotor, 15 cm (6 in.) in diameter, operating in the effluent. Blades removed and examined metallographically after 200 hr exhibited accelerated oxidation over most of the blade surface, with subsurface alumina penetration to 20 micron m. After 400 hours, average erosion loss was about 25 micron m (1 mil). Sulfide particles, indicating hot corrosion, were present in depletion zones, and their presence corresponded in general to the areas of adherent solids deposit. Sulfidation appears to be a materials problem equal in importance to erosion.

Rollbuhler, R. J.↗

Wind tunnel simulation of Martian sand storms

The physics and geological relationships of particles driven by the wind under near Martian conditions were examined in the Martian Surface Wind Tunnel. Emphasis was placed on aeolian activity as a planetary process. Threshold speeds, rates of erosion, trajectories of windblown particles, and flow fields over various landforms were among the factors considered. Results of experiments on particles thresholds, rates of erosion, and the effects of electrostatics on particles in the aeolian environment are presented.

Greeley, R.↗

A model for nitrogen chemisorption in ion thrusters

A theoretical model describing the formation of nitrogen species subject to chemisorption on ion thruster discharge chamber surfaces is presented. Molecules, atoms, atomic ions and molecular ions are identified as the important species in the analysis. Current densities of the atomic and molecular ions predicted by the model are compared to current densities measured in the beam of a SERT II thruster. The predicted and measured values of these two current densities are shown to agree within about + or - 100%. The mechanisms involved in the erosion of a surface subjected to simultaneous nitrogen chemisorption and sputter erosion by high energy ions are also discussed.

Wilbur, P. J.↗

Pitted and fluted rocks in the Western Desert of Egypt - Viking comparisons

The Western Desert of Egypt is one of the most arid regions on earth and is probably the closest terrestrial analog to the surface of Mars. An expedition to the area in 1978 revealed an abundance of quartzite and basalt rocks that have been pitted and fluted by wind erosion and deflation of the desert surface. These pitted rocks are internally homogeneous, show no internal holes or vesicles, and are considered an important but neglected type of ventifact. They bear a striking resemblance to the pitted and fluted rocks seen by the Viking Landers, rocks that have generally been interpreted as vesicular basalts only slightly modified by wind erosion. Wind tunnel studies of the air flow over and around nonstreamlined hand specimens from the Western Desert show that windward abrasion coupled with negative flow, secondary flow, and vorticity in a unidirectional wind can explain the complex arrays of pits and flutes. These field and laboratory observations suggest that the pitted rocks at the Viking Lander sites are also ventifacts, and thus the Martian surface may be far more wind eroded than previously thought.

Mccauley, J. F.↗

New methods to detect particle velocity and mass flux in arc-heated ablation/erosion facilities

Arc-heated flow facilities with injected particles are used to simulate the erosive and ablative/erosive environments encountered by spacecraft re-entry through fog, clouds, thermo-nuclear explosions, etc. Two newly developed particle diagnostic techniques used to calibrate these facilities are discussed. One technique measures particle velocity and is based on the detection of thermal radiation and/or chemiluminescence from the hot seed particles in a model ablation/erosion facility. The second technique measures a local particle rate, which is proportional to local particle mass flux, in a dust erosion facility by photodetecting and counting the interruptions of a focused laser beam by individual particles.

Brayton, D. B.↗

Effects of solid particles suspended in fluid flow through an axial flow compressor stage

An approximate method for calculating the flow properties of gas-particle mixture flowing over blades in a cascade is studied. Using an analytical method, the solid particle trajectory and location of collisions between the solid particles and the blade surfaces are determined. In addition an experimental investigation of the trajectories and velocities of solid particles suspended in a fluid passing through an axial flow compressor cascade was performed. The cascade blades were made of 2024 aluminum alloy and the solid particles used were quartz sand with average diameter of 165 microns. The following parameters were investigated: blade pressure distribution, and total pressure loss coefficient, both depending on the degree of erosion. In addition, a theoretical estimation of the blade erosion is compared with the experimental data.

Tabakoff, W.↗

Mn-53 and Al-26 evidence for solar cosmic ray constancy - An improved model for interpretation

A general, numerical method for calculating activities of solar cosmic ray produced radionuclides at any point within an irregularly shaped lunar rock of known surface contour and lunar surface orientation is described. This method is then used to predict the activities of Mn-53 andAl-26 as a function of postion within lunar rock 68815 for various assumed values of solar cosmic ray flux (J), rigidity (R sub 0), and rock erosion rate (ER). The predicted activities agree with the measured activities of Kohl et al. (1978) when values of R sub 0 = 100 MV, J = 70 p/sq cm-sec (4 pi, E greater than 10 MeV), ER not greater than 1 mm/m.y. and a total exposure time of 2 m.y. are assumed. These values are in agreement with those found for rocks exposed for not less than 10 m.y. and provide no evidence for variation of the average solar cosmic ray parameters between the last 2 and 10 m.y. intervals. When interpreted with the improved model the activity vs. depth profiles for three faces of 68815 show no evidence of SCR anisotropy or differential erosion.

Russ, G. P., III↗

On the electrostatic charging of the cometary nucleus

The paper demonstrates that a water-dominated cometary nucleus is not shielded from solar UV radiation or solar wind by protective atmospheres beyond a heliocentric distance of 5 AU. It is also shown that submicron dust particles can be electrostatically levitated and blown off the cometary surface. An upper limit on the total mass that can be lost from the sunlit hemisphere is derived using two solar wind models, and the dust mantle erosion is estimated at 5-12 cm. It is noted that the erosion is comparable to the mass of dust blown off a typical medium bright comet by the viscous drag of the sublimating gases during perihelium passage between 3.0 and 0.5 AU, and it is therefore proposed, that the surface dust blow-off be included in the current balance equation.

Mendis, D. A.↗

Solar wind sputtering effects in the atmospheres of Mars and Venus

It is found through an investigation, combining Monte Carlo simulations and analytical techniques, of the direct collisional interaction of an energetic particle flux with the neutral components of a planetary atmosphere, that solar wind sputtering could provide an important exospheric mass sink on both Mars and Venus under appropriate conditions. The computed rates of helium loss in the Venusian atmosphere and of carbon, nitrogen and oxygen in the Martian atmosphere imply that sputtering would have a significant effect on the noble gas budget of Venus and dominate the chemical and photochemical loss processes of Mars. Because of diffusive separation of lighter elements and isotopes, and because the gravitational binding energy is proportional to the mass, the erosion process preferentially removes the lighter components of the atmosphere. Solar wind sputtering could therefore compete with other erosion mechanisms in generating substantial fractionation effects.

Watson, C. C.↗

Fragmentation of ice by low velocity impact

Low-velocity impact experiments (0.14 to 1 km/s) carried out in polycrystalline water ice targets at 257 and 81 K reveal interactions which are assigned to four fragmentation classes: cratering, erosion, disruption, and total fragmentation. The specific kinetic energies for the transitions between these classes are found to be about one to two orders of magnitude below those for silicate rocks. The mass vs. cumulative number distribution of fragments in the experiments is described by a simple power law, similar to that observed in fragmented rocks both in the laboratory and in nature. The logarithmic slopes of cumulative number vs. fragment weight range from -0.9 to -1.8; they decrease with increasing projectile energy and are approximately independent of target temperature. The shapes of fragments resulting from erosion and disruption of ice targets are found to be significantly less spherical for 257 K targets than for 81 K targets. Fragment sphericity increases with increasing projectile energy at 257 K; however, no similar trend is observed for 81 K ice.

Lange, M. A.↗