Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “responsivity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,567 records · Page 87
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Flight investigation of XB-70 structural response to oscillatory aerodynamic shaker excitation and correlation with analytical results

The low frequency symmetric structural response and damping characteristics of the XB-70 airplane were measured at four flight conditions: heavyweight at a Mach number of 0.87 at an altitude of 7620 meters (25,000 feet); lightweight at a Mach number of 0.86 at an altitude of 7620 meters (25,000 feet); a Mach number of 1.59 at an altitude of 11,918 meters (39.100 feet); and a Mach number of 2.38 and an altitude of 18,898 meters (62,000 feet). The flight data are compared with the response calculated by using early XB-70 design data and with the response calculated with mass, structural, and aerodynamic data updated to reflect as closely as possible the airplane characteristics at three of the flight conditions actually flown.

Mckay, J. M.↗
NASA NTRS1973

Dynamic response of Mach 2.5 axisymmetric inlet with 40 percent supersonic internal area contraction

Results of experimental tests conducted on a supersonic, mixed compression, axisymmetric inlet are presented. The inlet is designed for operation at Mach 2.5 with a turbofan engine (TF-30). The inlet was terminated with either a choked-orifice plate or a long pipe with variable area choked exit plug. Frequency responses were obtained for selected static pressures in the diffuser. These pressures were selected as potential control signals for terminal shock control. Frequency responses were obtained for the Mach 2 and 2.5 conditions for different terminations. Responses also were obtained with and without cowl bleed. Internal disturbances were produced by sinusoidally varying the inlet overboard bypass doors at frequencies out to 100 hertz.

Baumbick, R. J.↗
NASA NTRS1973

The midlatitude ionospheric response to fluctuations in solar activity under low geomagnetic activity conditions

The ionospheric response, which is the sensitivity and delay of the electron content to the 270 day fluctuations of solar radiation has been theoretically analyzed. In the context of the present work the sensitivity is defined as the magnitude of the electron content fluctuation for a given change in solar flux, and the delay is defined as the timeshift of the response of the electron content to fluctuations in solar flux. Both the model in which the action of neutral winds on the F-2 layer is disregarded and that in which the wind effect is included as part of a positive feedback mechanism, are studied. It is shown that the neutral winds play a dominant role in the mentioned ionospheric response. The computed delays decrease with increasing solar activity in both models.

Bendito, J. L.↗
NASA NTRS1973

Pressure-fluctuation inputs and response of panels underlying attached and separated supersonic turbulent boundary layers

Results of an investigation of surface pressure fluctuations and response of panels underlying attached and separated turbulent boundary layers and shock waves are summarized. Extensive tests of a large assortment of axisymmetric and two-dimensional models have been conducted at transonic and supersonic Mach numbers to 3.6 to study the pressure fields. Assorted fixed-edge flat panels have been tested at Mach numbers from 1.6 to 3.6 in attached and completely separated flow fields and also in mixed flow with a step induced shock wave oscillating on the panels. The surface pressure fluctuations are described in terms of broadband rms, spectral density, and spatial correlation information. The effectiveness of parameters for scaling the pressure fluctuations is also illustrated. Measurements of the amplitude and strain response of the panels are compared with response computations by the normal method of analysis.

Coe, C. F.↗
NASA NTRS1973

A study of the effect of a boundary layer profile on the dynamic response and acoustic radiation of flat panels

The response of a thin, elastic plate to a harmonic force which drives the plate from below and a compressible air stream with a viscous boundary layer flowing parallel to the upper surface along the length was investigated. Equations governing the forced response of the coupled plate-aerodynamic system are derived along with appropriate boundary conditions. Calculations of basic solution parameters for a linear velocity profile and for a Blasius profile showed that the same system response could be obtained from each profile if appropriate values of boundary layer thickness were chosen for each profile.

Mixson, J. S.↗
NASA NTRS1973

Night side electromagnetic response of the moon.

The inductive response of the moon to interplanetary magnetic field fluctuations has been measured by the Apollo 12 lunar surface magnetometer. The dependence of the night side lunar response on frequency in the band from about 0.001 to 0.01 Hz is reported. It is shown that the night side response of the moon is not that of a sphere in vacuum. Instead, hydromagnetic radiation scattered from the moon is strongly confined to the interior of the cavity formed downstream from the moon in the solar wind.

Schubert, G.↗
NASA NTRS1973

Transient response of rotor-bearing systems.

The equations of motion necessary to calculate the transient response of a multimass flexible rotor supported by nonlinear, damped bearings are derived from energy principles. Rotor excitation may be the result of imbalance, internal friction, rotor acceleration, nonlinear forces due to any number of bearing or seal stations, and gyroscopic couples developed from skewed disk effects. The method of solution for transient response simulation is discussed in detail and is based on extensive evaluation of numerical methods available for transient analysis. Examples of the application of transient response for the analysis of rotor bearing systems are presented and compared to actual machine performance. Recommendations for the use and extension of the present system simulation model are discussed.

Kirk, R. G.↗
NASA NTRS1973

Nonthermal metabolic response of rats to He-O2, N2-O2, and Ar-O2 at 1 atm.

Experiments were performed to describe qualitatively and quantitatively the nonthermal metabolic response of rats to normoxic mixtures of helium, nitrogen, or argon at 1 atm ambient pressure. Hypoxic mixtures were similarly tested to determine any differences in hypoxic response as a function of the diluent gas. Rats exposed to argon for 5 days had a reduced metabolic rate relative to nitrogen, as evidenced by oxygen and food consumption, CO2 production, and the catabolism of radiosubstrates. While some parameters indicated that helium increased metabolic rate, oxygen consumption did not significantly differ from that in nitrogen. The physiologic and metabolic response to an imposed hypoxia varied among the different environments. Certain indices suggested that the hypoxic effects were less severe in helium and more pronounced in argon than in nitrogen. The mechanisms by which the diluent gases produced the observed changes could not be identified, but some possibilities are discussed.

Schatte, C. L.↗
NASA NTRS1973

Response of panels to turbulence-induced, surface-pressure fluctuations and resulting acoustic radiation to the flow field.

The response of finite rectangular panels, excited by turbulent boundary layers and the resulting acoustical radiation into the flow field is studied. The method of normal modes and the technique of spectral analysis are used to compute the power spectra of the panel amplitude and strain response. Computed results are compared with the corresponding response measurements for panels exposed to attached and separated flows at supersonic speeds and attached flow at subsonic speeds. The thin plate and the convected wave equations are coupled through the boundary condition on the panel to give a formula for the radiation pressure power spectra. A formula for the acoustical damping ratio of the panel is obtained through the principle of virtual work.-

Chyu, W. J.↗
NASA NTRS1973

The effects of an autopilot on airplane responses to turbulence with emphasis on tail loads

An analytical study has been made to assess the loads developed on the horizontal tail of an autopilot-controlled rigid airplane flying in one-dimensional atmospheric turbulence. The root-mean-square values of rigid-airframe responses and tail-load responses were calculated at five flight conditions, and the behavior of these responses was observed in two autopilot modes: pitch-attitude-hold mode and altitude-control mode. It was found that pitch attitude and altitude can be controlled by the simple autopilot with acceptable or no increases in tail loads.

Perry, B., III↗
NASA NTRS1973

Application of the Collision-Imparted Velocity Method for Analyzing the Responses of Containment and Deflector Structures to Engine Rotor Fragment Impact

An approximate analysis, termed the Collision Imparted Velocity Method (CIVM), was employed for predicting the transient structural responses of containment rings or deflector rings which are subjected to impact from turbojet-engine rotor burst fragments. These 2-d structural rings may be initially circular or arbitrarily curved and may have either uniform or variable thickness; elastic, strain hardening, and strain rate material properties are accommodated. This approximate analysis utilizes kinetic energy and momentum conservation relations in order to predict the after-impact velocities of the fragment and the impacted ring segment. This information is then used in conjunction with a finite element structural response computation code to predict the transient, large deflection responses of the ring. Similarly, the equations of motion for each fragment are solved in small steps in time. Also, some comparisons of predictions with experimental data for fragment-impacted free containment rings are presented.

Collins, T. P.↗
NASA NTRS1973

Habituation of vestibular responses: An overview

An historical survey of vestibular habituation experiments has been undertaken. Methodological problems are presented briefly, and the influence of arousal on vestibular responses is detailed. Data obtained from animals and from man are treated separately. At least for man, the term habituation may be better defined by a dynamic change in the form of vestibular responses than by a simple response reduction.

Collins, W. E.↗
NASA NTRS1974

Transient Response of Shells of Revolution by Direct Integration and Modal Superposition Methods

The results of an analytical effort to obtain and evaluate transient response data for a cylindrical and a conical shell by use of two different approaches: direct integration and modal superposition are described. The inclusion of nonlinear terms is more important than the inclusion of secondary linear effects (transverse shear deformation and rotary inertia) although there are thin-shell structures where these secondary effects are important. The advantages of the direct integration approach are that geometric nonlinear and secondary effects are easy to include and high-frequency response may be calculated. In comparison to the modal superposition technique the computer storage requirements are smaller. The advantages of the modal superposition approach are that the solution is independent of the previous time history and that once the modal data are obtained, the response for repeated cases may be efficiently computed. Also, any admissible set of initial conditions can be applied.

Stephens, W. B.↗
NASA NTRS1974

Dynamic Docking Test System (DDTS) active table frequency response test results

Results are presented of the frequency response test performed on the dynamic docking test system (DDTS) active table. Sinusoidal displacement commands were applied to the table and the dynamic response determined from measured actuator responses and accelerometers mounted to the table and one actuator.

Gates, R. M.↗
NASA NTRS1974

DC responsivity of proximity effect bridges to high frequency radiation

The effect of microwave radiation on the dc current-voltage characteristic of proximity effect bridges has been studied at frequencies of 10, 35, and 90 GHz. The properties of bridges fabricated in layered films of Nb and Ta are reported. The fraction, epsilon, of the incident radiant power absorbed by the bridge is measured calorimetrically, permitting determination of the intrinsic responsivity (volts per watt of power absorbed when operated in a current-biased mode). In the test geometry employed, epsilon is typically about .0001 for a 0.1 ohm Nb-Ta bridge, and increases roughly linearly with dc junction resistance. Broad-band responsivity is generally independent of incident power, increases with increasing critical current (decreasing temperature), and decreases with increasing frequency. Peak responsivities achieved to date are about 100,000 V/W (absorbed) at 10 GHz and about 100 V/W (absorbed) at 90 GHz.

Hauser, M. G.↗
NASA NTRS1973

Models of subjective response to in-flight motion data

Mathematical relationships between subjective comfort and environmental variables in an air transportation system are investigated. As a first step in model building, only the motion variables are incorporated and sensitivities are obtained using stepwise multiple regression analysis. The data for these models have been collected from commercial passenger flights. Two models are considered. In the first, subjective comfort is assumed to depend on rms values of the six-degrees-of-freedom accelerations. The second assumes a Rustenburg type human response function in obtaining frequency weighted rms accelerations, which are used in a linear model. The form of the human response function is examined and the results yield a human response weighting function for different degrees of freedom.

Rudrapatna, A. N.↗
NASA NTRS1973

Handling properties of diverse automobiles and correlation with full scale response data

Driver/vehicle response and performance of a variety of vehicles in the presence of aerodynamic disturbances are discussed. Steering control is emphasized. The vehicles include full size station wagon, sedan, compact sedan, van, pickup truck/camper, and wagon towing trailer. Driver/vehicle analyses are used to estimate response and performance. These estimates are correlated with full scale data with test drivers and the results are used to refine the driver/vehicle models, control structure, and loop closure criteria. The analyses and data indicate that the driver adjusts his steering control properties (when he can) to achieve roughly the same level of performance despite vehicle variations. For the more disturbance susceptible vehicles, such as the van, the driver tightens up his control. Other vehicles have handling dynamics which cause him to loosen his control response, even though performance degrades.

Hoh, R. H.↗
NASA NTRS1973

Dynamic response and stability of a gas-lubricated Rayleigh-step pad

The quasi-static, pressure characteristics of a gas-lubricated thrust bearing with shrouded, Rayleigh-step pads are determined for a time-varying film thickness. The axial response of the thrust bearing to an axial forcing function or an axial rotor disturbance is investigated by treating the gas film as a spring having nonlinear restoring and damping forces. These forces are related to the film thickness by a power relation. The nonlinear equation of motion in the axial mode is solved by the Ritz-Galerkin method as well as the direct, numerical integration. Results of the nonlinear response by both methods are compared with the response based on the linearized equation. Further, the gas-film instability of an infinitely wide Rayleigh step thrust pad is determined by solving the transient Reynolds equation coupled with the equation of the motion of the pad. Results show that the Rayleigh-step geometry is very stable for bearing number A up to 50. The stability threshold is shown to exist only for ultrahigh values of Lambda equal to or greater than 100, where the stability can be achieved by making the mass heavier than the critical mass.

Cheng, C.↗