Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Absorption”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,567 records · Page 87

Spectrophotometry of six broad absorption line QSOs

Spectrophotometric observations of six broad absorption-line QSOs (BALQSOs) are presented. The continua and emission lines are compared with those in the spectra of QSOs without BALs. A statistically significant difference is found in the emission-line intensity ratio for (N V 1240-A)/(C IV 1549-A). The median value of (N V)/(C IV) for the BALQSOs is two to three times the median for QSOs without BALs. The absorption features of the BALQSOs are described, and the column densities and limits on the ionization structure of the BAL region are discussed. If the dominant ionization mechanism is photoionization, then it is likely that either the ionizing spectrum is steep or the abundances are considerably different from solar. Collisional ionization may be a significant factor, but it cannot totally dominate the ionization rate.

Junkkarinen, Vesa T.↗

Acoustic absorption by sunspots

The paper presents the initial results of a series of observations designed to probe the nature of sunspots by detecting their influence on high-degree p-mode oscillations in the surrounding photosphere. The analysis decomposes the observed oscillations into radially propagating waves described by Hankel functions in a cylindrical coordinate system centered on the sunspot. From measurements of the differences in power between waves traveling outward and inward, it is demonstrated that sunspots appear to absorb as much as 50 percent of the incoming acoustic waves. It is found that for all three sunspots observed, the amount of absorption increases linearly with horizontal wavenumber. The effect is present in p-mode oscillations with wavelengths both significantly larger and smaller than the diameter of the sunspot umbrae. Actual absorption of acoustic energy of the magnitude observed may produce measurable decreases in the power and lifetimes of high-degree p-mode oscillations during periods of high solar activity.

Braun, D. C.↗

Laboratory evaluation and application of microwave absorption properties under simulated conditions for planetary atmospheres

Radio absorptivity data for planetary atmospheres obtained from spacecraft radio occultation experiments and Earth-based radio astronomical observations can be used to infer abundances of microwave absorbing atmospheric constituents in those atmospheres, as long as reliable information regarding the microwave absorping properties of potential constituents is available. The use of theoretically derived microwave absorption properties for such atmospheric constituents, or laboratory measurements of such properties under environmental conditions which are significantly different than those of the planetary atmosphere being studied, often leads to significant misinterpretation of available opacity data. Laboratory measurement of the microwave properties of atmospheric gases under simulated conditions for the outer planets were conducted. Results of these measurements are discussed.

Steffes, Paul G.↗

High resolution infrared absorption spectra of various trace gases present in the upper atmosphere of the Earth

The objective of NASA Grant NsG 7473 was to obtain and analyze high resolution infrared absorption spectra of various trace gases present in the Earth's upper atmosphere. The goal of the spectral analysis was to obtain values of absorption line strengths, widths and frequencies of sufficient accuracy for use in upper atmosphere trace gas monitoring. During the early phase of the grant, high resolution spectra were obtained from two instruments. One was the 0.02/cm resolution vacuum grating spectrometer at the Florida State University and the other was the 0.01/cm resolution Fourier transform spectrometer at the McMath solar telescope at the Kitt Peak Observatory. Using these instruments, a considerable amount of spectra of methane and hydrogen peroxide were obtained and analyzed. During the latter years of the project, data taking was halted while efforts were devoted to building a new 0.0025/cm resolution vacuum Fourier transform spectrometer. Progress during this phase of the grant then became greatly slowed due to a lack of suitable graduate students in the program. However, the instrument was completed and brought to the point of producing interferograms.

Hunt, Robert H.↗

Absorption of isotropic radiation

Estimates of the absorption of isotropic radiation are given for an absorbing medium whose geometrical shape is either a plane-parallel sided slab or a cylinder. By including the directional variation of absorption path length, the results show appreciable differences to the 'unidirectional radiation' formulas.

Harries, Wynford L.↗

Nonlinear intersubband optical absorption in a semiconductor quantum well

The third-order nonlinear intersubband absorption in a semiconductor quantum well is studied theoretically using the density matrix formalism including intrasubband relaxation. It is shown that the peak absorption is reduced by half for an optical intensity 1 MW/sq cm for the well size L = 126.5 A with 3.0 x 10 to the 16th/cu cm electrons.

Ahn, D.↗

Observations of absorption lines from highly ionized atoms

In the ultraviolet spectra of hot stars, absorption lines can be seen from highly ionized species in the interstellar medium. Observations of these features which have been very influential in revising the perception of the medium's various physical states, are discussed. The pervasiveness of O 6 absorption lines, coupled with complementary observations of a diffuse background in soft X-rays and EUV radiation, shows that there is an extensive network of low density gas (n approx. few x 0.001/cu cm) existing at coronal temperatures log T = 5.3 or 6.3. Shocks created by supernova explosions or mass loss from early-type stars can propagate freely through space and eventually transfer a large amount of energy to the medium. To create the coronal temperatures, the shocks must have velocities in excess of 150 km/sec; shocks at somewhat lower velocity (v = 100 km/sec) can be directly observed in the lines of Si3. Observations of other lines in the ultraviolet, such as Si 4V and C 5, may highlight the widespread presence of energetic UV radiation from very hot, dwarf stars. More advanced techniques in visible and X-ray astronomical spectroscopy may open up for inspection selected lines from atoms in much higher stages of ionization.

Jenkins, Edward B.↗

Energy absorption of composite material and structure

Results are presented from a joint research program on helicopter crashworthiness conducted by the U.S. Army Aerostructures Directorate and NASA Langley. Through the ongoing research program an in-depth understanding has been developed on the cause/effect relationships between material and architectural variables and the energy-absorption capability of composite material and structure. Composite materials were found to be efficient energy absorbers. Graphite/epoxy subfloor structures were more efficient energy absorbers than comparable structures fabricated from Kevlar or aluminum. An accurate method of predicting the energy-absorption capability of beams was developed.

Farley, Gary L.↗

Temperature-dependent absorption cross sections for hydrogen peroxide vapor

Relative absorption cross sections for hydrogen peroxide vapor were measured over the temperature ranges 285-381 K for lambda = 230 nm-295 nm and 300-381 K for lambda = 193 nm-350 nm. The well established 298 K cross sections at 202.6 and 228.8 nm were used as an absolute calibration. A significant temperature dependence was observed at the important tropospheric photolysis wavelengths lambda over 300 nm. Measured cross sections were extrapolated to lower temperatures, using a simple model which attributes the observed temperature dependence to enhanced absorption by molecules possessing one quantum of O-O stretch vibrational excitation. Upper tropospheric photodissociation rates calculated using the extrapolated cross sections are about 25 percent lower than those calculated using currently recommended 298 K cross sections.

Nicovich, J. M.↗

H I emission-absorption studies with high-velocity resolution

The properties of interstellar H I are investigated using high-velocity resolution, Arecibo emission-absorption spectra in the direction of 40 radio continuum sources, including 21 at low Galactic latitude. Comparison of the data with the results of previous studies confirms the earlier suggestion that the H I density in the nearest 100 pc is lower than the disk average by about a factor of two and the separation of H I emission into material associated with absorbing 'clouds' and physically independent, not strongly absorbing material. A comparison of lines of sight with different geometries supports the suggestion that spin temperatures are higher far above the Galactic disk. There is little correlation between the properties of the H I emission fluctuations on 3.8 arcmin separations and the properties of either the emission or absorption profiles.

Colgan, Sean W. J.↗

Scalar and vector collisional interference in the vibration-rotation absorption spectra of H2 and HD

The only atomic or molecular spectra known to exhibit 'collisional interference' effects are those of H2 and its isotopes. Attention is presently given to the sharp absorption spectra of HD, which demonstrate collisional interference effects is a fashion that while surprising has been experimentally verified and theoretically characterized in detail. Collisional interference can dramatically alter the line shapes usually encountered in dipole absorption spectra, while nevertheless remaining narrow.

Herman, R. M.↗

Differential absorption lidar signal averaging

This paper presents experimental results using an atmospheric backscatter dual CO2 laser DIAL. It is shown that DIAL signals can be averaged to obtain an N exp -1/2 dependence decrease in the standard deviation of the ratio of backscattered returns from two lasers, where N is the number of DIAL signals averaged, and that such a lidar system can make measurements of gas concentrations with a precision of 0.7 percent in absorptance over 75 m in a short measurement time when the signal strength is high. Factors that eventually limit the rate of improvement in the SNR, such as changes in the ratio of the absorption and/or backscatter at the two laser frequencies and background noise, are discussed. In addition, it is noted that DIAL measurements made using hard-target backscatter often show departures from N exp -1/2 dependence improvement in the standard deviation because they are further limited by the combined effects of atmospheric turbulence and speckle (since the relative reproducibility of the speckle pattern on the receiver gives rise to correlations of the lidar signals).

Grant, William B.↗

Pressure-induced absorption coefficients for radiative transfer calculations in Titan's atmosphere

The semiempirical theory of Birnbaum and Cohen (1976) is used to calculate the FIR pressure-induced absorption (PIA) spectra of N2, CH4, N2 + Ar, N2 + CH4, and N2 + H2 under conditions like those in the Titan troposphere. The results are presented graphically and compared with published data from laboratory measurements of PIA in the same gases and mixtures (Dagg et al., 1986; Dore et al., 1986). Good agreement is obtained, with only a slight underestimation of PIA at 300-400/cm in the case of CH4. The absorption coefficients are presented in tables, and it is suggested that the present findings are of value for evaluating the effects of tropospheric clouds on the Titan FIR spectrum and studying the greenhouse effect near the Titan surface.

Courtin, Regis↗

Resonance absorption of Alfven waves at comet-solar wind interaction regions

The interaction of the low-frequency (0.01 Hz) MHD waves, observed upstream of comets, with the structured plasma near the cometary bow wave is examined. It is suggested that the waves undergo resonant absorption due to either ambient density gradients or localized shear in the background magnetic field. The absorption process can give rise to rapid heating of the solar wind protons, in agreement with observations from Comet Halley. Since the free energy for the generation of MHD waves came from deceleration (without accompanying heating) of the solar wind protons during the pick-up of cometary ions, the subsequent reabsorption of the energy is equivalent to a nonlocal transformation of ordered to random energy and can be described as nonlocal viscosity.

Sharma, A. S.↗

Laboratory evaluation and application of microwave absorption properties under simulated conditions for planetary atmospheres

Radio absorptivity data for planetary atmospheres obtained from spacecraft radio occultation experiments and earth-based radio astronomical observations can be used to infer abundances of microwave absorbing atmospheric constituents in those atmospheres, as long as reliable information regarding the microwave absorbing properties of potential constituents is available. The key activity for this grant year has continued to be laboratory measurements of the microwave and millimeter-wave properties of the simulated atmospheres of the outer planets and their satellites. A Fabry-Perot spectrometer system capable of operation from 32 to 41 GHz was developed. Initially this spectrometer was used to complete laboratory measurements of the 7.5 to 9.3 mm absorption spectrum of ammonia. Laboratory measurements were begun at wavelengths near 3.2 mm, where a large number of observations of the emission from the outer planets were made. A description of this system is presented.

Steffes, Paul G.↗

Non-destructive plant health sensing using absorption spectroscopy

The sensor group of the 1988 EGM 4001 class, working on NASA's Controlled Ecological Life Support Systems (CELSS) project, investigated many different plant health indicators and the technologies used to test them. The project selected by the group was to measure chlorophyll levels using absorption spectroscopy. The spectrometer measures the amount of chlorophyll in a leaf by measuring the intensity of light of a specific wavelength that is passed through a leaf. The three wavelengths of light being used corresponded to the near-IR absorption peaks of chlorophyll a, chlorophyll b, and chlorophyll-free structures. Experimentation showed that the sensor is indeed measuring levels of chlorophyll a and b and their changes before the human eye can see any changes. The detector clamp causes little damage to the leaf and will give fairly accurate readings on similar locations on a leaf, freeing the clamp from having to remain on the same spot of a leaf for all measurements. External light affects the readings only slightly so that measurements may be taken in light or dark environments. Future designs and experimentation will concentrate on reducing the size of the sensor and adapting it to a wider range of plants.

Bledsoe, Jim↗

Nonlinear absorption properties of AlGaAs/GaAs multiple quantum wells grown by metalorganic chemical vapor deposition

The nonlinear absorption properties of the excitonic resonances associated with multiple quantum wells (MQWs) in AlGaAs/GaAs grown by metalorganic chemical vapor deposition are reported. The dependence of the saturation properties on growth parameters, especially growth temperature, and the well width are described. The minimum measured saturation intensity for these materials is 250 W/sq cm, the lowest reported value to date. The low saturation intensities are the result of excellent minority carrier properties. A systematic study of minority carrier lifetimes in quantum wells are reported. Lifetimes range from 50-350 ns depending on growth temperature and well width. When corrected for lateral diffusion effects and the measured minority carrier lifetime, the saturation data suggest that saturation intensities as low as 2.3 W/sq cm can be achieved in this system. The first measurements of the dependence of the exciton area and the magnitude of the excitonic absorption on well width are prsented. The growth of MQW structures on transparent GaP substrates is demonstrated and the electroabsorption properties of these structures are reviewed.

Lee, Hsing-Chung↗

Mg I absorption features in the solar spectrum near 9 and 12 microns

High-resolution FTS observations from the Kitt Peak National Solar Observatory and the Spacelab 3 ATMOS experiment have revealed additional infrared transitions due to Mg I in the spectra of both quiet sun and sunspot penumbra. In contrast to previous observations, these transitions are seen in absorption, not emission. Absorption intensities range from 1 to 7 percent of the continuum in the quiet sun. In the penumbra, the same features appear to show Zeeman splitting. Modeling of the line profiles in the photospheric spectrum shows evidence for a factor of three overabundance in the n = 5 or more levels of Mg I in the upper photosphere, but with no deviations from a Planck source function. It is concluded that whatever the process that produces the emission (including the Lemke and Holweger mechanism), it must occur well above the tau(5000) = 0.01 level.

Glenar, David A.↗