Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “turbulence methods”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,549 records · Page 86
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Aerodynamic optimization, comparison, and trim design of canard and conventional high performance general aviation configurations

A design study has been conducted to optimize trim cruise flight of high performance general aviation canard aircraft which achieve minimum drag. In order to investigate the advantages and disadvantages of canard configured aircraft, corresponding conventional tail-aft 'baseline' aircraft were designed and used for comparison. Two-dimensional predictions were obtained by coupling inviscid results from a vortex panel multi-element program to a momentum integral boundary layer analysis. Using the results of the two-dimensional vortex panel analysis, a vortex lattice method was employed to predict the finite wing results. The analysis utilized a turbulent airfoil and a natural laminar airfoil which are two NASA state-of-the-art airfoil sections. The canard aircraft designs give quantitative results of wing and canard loadings, wing-to-canard moment arm ratios, and aspect ratio effects for trim cruise flight for a wide range of wing-to-canard area ratios. Both canard and baseline aircraft achieved a 25 to 30 percent improvement in performance over typical current technology aircraft, but high canard loading necessary for trim resulted in slightly poorer performance of the canard aircraft as compared to the baseline designs.

Keith, M. W.↗
NASA NTRS1983

Computation of transonic viscous-inviscid interacting flow

Transonic viscous-inviscid interaction is considered using the Euler and inverse compressible turbulent boundary-layer equations. Certain improvements in the inverse boundary-layer method are mentioned, along with experiences in using various Runge-Kutta schemes to solve the Euler equations. Numerical conditions imposed on the Euler equations at a surface for viscous-inviscid interaction using the method of equivalent sources are developed, and numerical solutions are presented and compared with experimental data to illustrate essential points. Previously announced in STAR N83-17829

Whitfield, D. L.↗
NASA NTRS1984

Development of a turbulence near-wall model and its application to separated and reattached flows

A numerical study is reported of flow and heat transfer in the separated and reattached flows created by an abrupt pipe expansion. In the study attention has been given primarily to the development of turbulence near-wall models based on the wall function. An efficient numerical method is also employed for the computation of high-velocity flows. The computed results are compared with experimental data obtained earlier. Generally, better results are obtained by employing the present near-wall models, and among them the three-layer model is superior to the two-layer one.

Amano, R. S.↗
NASA NTRS1985

Seeding techniques used in the Vortex Research Facility

For many years, the Vortex Research Facility used kerosene vapor as seeding particles. The kerosene vapor formed (approx. 1 micron) particles initially. After injection into the test section, the vapor would begin to condense and form larger particles. By switching to solid particles, this has been eliminated. The uniform-sized (approx. 1 micron) solid particle seeding is used both to seed the Laser Velocimeter system and for flow visualization. After injection, the solid particles reach a uniform suspension before the vehicle is launched. It is found that the kerosene vapor poses a problem because it is a heated gas which modified the test section temperature distribution. It also produces high turbulence and secondary air currents because it was continually injected from the time of vehicle launch until model passage. In cases where the effects of either turbulence or the vertical temperature distribution are of interest, this hot gas injection method is unsuitable. Both types of seeding particles provide adequate flow visualization but are sensitive to vertical temperature distributions.

Satran, D. R.↗
NASA NTRS1985

A zonal computational procedure adapted to the optimization of two-dimensional thrust augmentor inlets

A viscous-inviscid interaction methodology based on a zonal description of the flowfield is developed as a mean of predicting the performance of two-dimensional thrust augmenting ejectors. An inviscid zone comprising the irrotational flow about the device is patched together with a viscous zone containing the turbulent mixing flow. The inviscid region is computed by a higher order panel method, while an integral method is used for the description of the viscous part. A non-linear, constrained optimization study is undertaken for the design of the inlet region. In this study, the viscous-inviscid analysis is complemented with a boundary layer calculation to account for flow separation from the walls of the inlet region. The thrust-based Reynolds number as well as the free stream velocity are shown to be important parameters in the design of a thrust augmentor inlet.

Lund, T. S.↗
NASA NTRS1987

Toward the large-eddy simulations of compressible turbulent flows

New subgrid-scale models for the large-eddy simulation of compressible turbulent flows are developed based on the Favre-filtered equations of motion for an ideal gas. A compressible generalization of the linear combination of the Smagorinsky model and scale-similarity model (in terms of Favre-filtered fields) is obtained for the subgrid-scale stress tensor. An analogous thermal linear combination model is also developed for the subgrid-scale heat flux vector. The three dimensionless constants associated with these subgrid-scale models are obtained by correlating with the results of direct numerical simulations of compressible isotropic turbulence performed on a 96 to the third power grid using Fourier collocation methods. Extensive comparisons between the direct and modeled subgrid-scale fields are provided in order to validate the models. Future applications of these compressible subgrid-scale models to the large-eddy simulation of supersonic aerodynamic flows are discussed briefly.

Erlebacher, G.↗
NASA NTRS1987

Vortex simulation of three-dimensional mixing layers

Spanwise structures of 'nominally' two-dimensional (2D), spatially growing, turbulent mixing layers are simulated numerically by a three-dimensional (3D) vortex method. Small-amplitude 3D disturbances are introduced into an otherwise 2D flow field. Results show that a large-scale spanwise variation of the flow field is produced because of amplification of initial disturbances. Pairs of counterrotating streamwise vortices are formed as a result of stretching of primary spanwise vortices. The streamwise vortices are formed at a fixed spanwise location which depends on initial disturbances. The calculated magnitude of streamwise vorticity is close to that of the spanwise vorticity. The results also suggest that the presence of background disturbances may be essential for the formation of streamwise vortices. The results are in good qualitative agreement with experiments.

Inoue, Osamu↗
NASA NTRS1986

Numerical prediction of cold turbulent flow in combustor configurations with different centerbody flame holders

A numerical study of cold turbulent flow in a combustor containing a centerbody flame holder is presented. The axisymmetric Navier-Stokes equations incorporating a k-epsilon turbulence model were solved in a nonorthogonal curvilinear coordinate system. The finite volume method, applied to a staggered grid system, was used to discretize the differential equations. These finite differenced equations were then solved iteratively utilizing the SIMPLE algorithm described by Patankar (1980). Solutions were obtained for two combustor duct geometries with various centerbody flame holders which included a disk, a cone, and a sphere. The extent of mixing due to these bodies was evaluated. A comparison with previously obtained experimental data yielded moderately good agreement.

Yung, C. N.↗
NASA NTRS1988

Hot-wire accuracy in supersonic turbulence from comparisons with laser-induced fluorescence

A hot-wire anemometer and a new, nonintrusive, laser-induced fluorescence (LIF) technique are used to survey a turbulent boundary layer in a supersonic channel flow at Mach no. 2.06. The purpose is to test the accuracy of using the hot wire to measure the fluctuation amplitudes of static temperature and density in a compressible turbulent flow by comparing the results with independent and direct LIF measurements. Several methods of hot-wire calibration and analysis are applied. With each method, the hot-wire response can be related primarily to fluctuations of mass flux and total temperature, from which fluctuations of static temperature and density are calculated. However, these calculations are shown to be valid only if the fluctuations in static pressure are negligible. The acquisition and the analysis of the hot-wire data are often simplified further by neglecting the effects of fluctuations in total temperature. Comparisons of the fluctuation amplitudes of temperature and density obtained by hot-wire and LIF measurements demonstrate that such assumptions might not always be warranted, even in apparently simple flows.

Logan, Pamela↗
NASA NTRS1989

The solution of the Navier-Stokes equations using Gauss-Seidel line relaxation

The Navier-Stokes equations in an implicit flux-split difference formulation are solved numerically using a Gauss-Seidel line-relaxation procedure. Particular attention is given to the selection of flux-vector splitting method and flux splitting in boundary layers. Results for sample problems involving (1) turbulent supersonic flow over a cone and (2) the viscous hypersonic flow of a chemically reacting gas in thermal nonequilibrium past a blunted cone are presented in extensive graphs and briefly characterized. The present flux-split procedures are shown to provide accurate shear-layer calculations.

Maccormack, Robert W.↗
NASA NTRS1989

Numerical simulation of flow through a two-strut scramjet inlet

A three-dimensional, Reynolds-averaged Navier-Stokes code has been used to numerically analyze flow through a two-strut, supersonic combustion ramjet (scramjet) inlet configuration. It solves the governing equations in full conservation form using either a fully explicit or explicit-implicit method. An algebraic, two-layer eddy-viscosity model is used for turbulent flow calculations. The analysis allows inclusion of end effects that are caused by the aft placement of the cowl on the underside of the inlet. A special grid has been developed to accommodate the struts embedded in the inlet flowfield. Detailed numerical results are presented here for the two-strut configuration, and a comparison is made with the available experimental results.

Kumar, Ajay↗
NASA NTRS1991

Parabolized Navier-Stokes methods for hypersonic flows

A representative sampling of the techniques used in the integration of the Parabolized Navier-Stokes (PNS) equations is presented. Special atention is given to recent algorithms developed specifically for application to high speed flows, characterized by the presence of strong embedded shock waves and real gas effects. It is shown that PNS solvers are being used in the analysis of sonic boom signatures. Methods for modeling physical effects are discussed, including an overview of commonly used turbulence models and a more detailed discussion of techniques for including equilibrium and finite rate real gas effects.

Lawrence, Scott L.↗
NASA NTRS1990

Improvements to a nonequilibrium algebraic turbulence model

It has been noted that while the nonequilibrium turbulence model of Johnson and King (1985, 1987) performed significantly better than alternative methods, differences between predicted and observed shock locations for certain weak interactions are produced due to a defficiency in the model's inner eddy viscosity formulation. A novel formulation for the model is presented which removes this deficiency, while satisfying the law of the wall for adverse pressure-gradient conditions better than either the original formulation or mixing-length theory.

Johnson, D. A.↗
NASA NTRS1991

A planar Mie scattering technique for visualizing supersonic mixing flows

A planar Mie scattering technique is described which allows for the direct visualization of fluid mixing in supersonic flows. The mixed fluid is visualized by laser light sheet scattering from small alcohol droplets which condense as a result of the mixing of a vapor laden subsonic stream with a cold supersonic stream. Issues related to the formation, growth and size of the droplets are addressed. The technique reveals details of the turbulent structure which are masked by the spatial integration of schlieren and shadowgraph methods. Comparative visualizations using the vapor screen method to uniformly mark the high-speed fluid are also shown.

Clemens, N. T.↗
NASA NTRS1991

A numerical and experimental study of tangential jet blowing applied to bodies at high angles of attack

The effects of tangential jet blowing on the vortical structures developing about the fuselage of a missile or aircraft at high angle of attack are investigated numerically and experimentally. Computations are carried out for fully laminar and fully turbulent flows, and the results are compared with flow visualization data. It is shown that turbulent computations are more accurate in describing the flow behavior. The actuator plane method is shown to be sufficiently accurate in modeling the essential flow physics of a tangential jet.

Font, G. I.↗
NASA NTRS1991

Spectral methods for the Navier-Stokes equations with one infinite and two periodic directions

The time-dependent, 3D incompressible Navier-Stokes equations in (1) boundary layers, the semiinfinite domain, and (2) mixing layers or wakes, the fully infinite domain, are respectively solved by two numerical methods which employ rapidly decaying spectral basis functions to approximate the vertical dependence of the solutions. These functions are then combined with one, for method (1), and two, for method (2), slowly decaying 'extra functions' for each wave vector. Each extra function can exactly represent the solution's irrotational component at large distances. The two methods have been applied to extensive direct-numerical simulation of transition and turbulence.

Spalart, Philippe R.↗
NASA NTRS1992

A numerical study of two-dimensional vortex shedding from rectangular cylinders

An efficient time-marching, non-iterative calculation method is used to analyze time-dependent flows around rectangular cylinders. The turbulent flow in the wake region of a square section cylinder is analyzed using an anisotropic k-epsilon model. Initiation and subsequent development of the vortex shedding phenomenon is naturally captured once a perturbation is introduced in the flow. Transient calculations using standard eddy-viscosity and an anisotropic k-epsilon model averaged over an integral number of cycles to get the fluctuating energy (organized and turbulent) are compared with experimental data. It is shown that the anisotropic k-epsilon model resolves the anisotropy of the Reynolds stresses and gives mean energy distribution closer to the experiment than the standard k-epsilon model.

Hadid, A. H.↗
NASA NTRS1992

Shedding new light on gas dynamics

Modern laser-spectroscopic techniques usually incorporate one or more laser beams and depend on their radiative interaction with some spectroscopic feature of the gas. Attention is given to laser absorption, laser-induced fluorescence, Rayleigh scattering, and Raman scattering. Consideration is given to UV Rayleigh scattering applied to aerodynamic flows to obtain images of a supersonic boundary layer that show instantaneous turbulent structures at a level of detail not achieved by any other practical method.

Mckenzie, Robert L.↗