Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “averaging”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,549 records · Page 86

Diagnostic analysis of two-dimensional monthly average ozone balance with Chapman chemistry

Chapman chemistry has been used in a two-dimensional model to simulate ozone balance phenomenology. The similarity between regions of ozone production and loss calculated using Chapman chemistry and those computed using LIMS and SAMS data with a photochemical equilibrium model indicate that such simplified chemistry is useful in studying gross features in stratospheric ozone balance. Net ozone production or loss rates are brought about by departures from the photochemical equilibrium (PCE) condition. If transport drives ozone above its PCE condition, then photochemical loss dominates production. If transport drives ozone below its PCE condition, then photochemical production dominates loss. Gross features of ozone loss/production (L/P) inferred for the real atmosphere from data are also simulated using only eddy diffusion. This indicates that one must be careful in assigning a transport scheme for a two-dimensional model that mimics only behavior of the observed ozone L/P.

Stolarski, Richard S.↗

The effect of gravity level on the average primary dendritic spacing of a directionally solidified superalloy

The effect of alternating low (0.01 g) and high (1.8 g) gravity force on the primary spacings in the dendrite structure in a directionally solidified Ni-based superalloy (PWA 1480, containing 5 pct Co, 10 pct Cr, 4 pct W, 12 pct Ta, 5 pct Al, 1.5 pct Ti, and the balance Ni) was investigated using samples solidified in a directional solidification furnace aboard the NASA KC-135 aircraft that made a series of low-g parabolas. The cross-section slices for each growth rate were polished and etched with Kallings II, and the primary dendritic arm spacings were measured using the method of Jacobi and Schwerdtfeger (1976). The arm spacings were found to fluctuate with gravity force, increasing as the gravity level decreased, and growing finer as gravity increased.

Mccay, M. H.↗

Average spatial distributions of energetic O(+), O(2+), O(6+), and C(6+) ions in the magnetosphere observed by AMPTE CCE

Measurements with the charge energy mass spectrometer of the AMPTE CCE spacecraft are used to determine the relative fluxes of these ions near the equatorial plane as a function of the drift shell parameter L, the magnetic activity index Kp, and the local time LT. The O(+) and O(2+) ions have radial profiles with maxima at about L = 5 and diurnal variations with a broad maximum on the dayside. The O(6+) and C(6+) ion fluxes increase with L between L = 5 and L = 7 and level off farther out. The diurnal variations of the relative O(6+) and C(6+) fluxes exhibit a pronounced minimum on the dayside. The observations can be interpreted in terms of ion convection from the tail onto quasi-trapped drift orbits and further radial diffusion onto closed drift shells. The maximum of the O(+) and O(2+) fluxes as well as the minimum of the O(6+) and C(6+) fluxes on the dayside can be explained by drift shell splitting. The inward transport is associated with ion losses, mainly by charge exchange. O(6+) and C(6+) ions are removed already at larger distances than O(+) and O(2+). As a result, the ionosphere contributes most of the oxygen ions in the magnetosphere. Important contributions from the solar wind are encountered in the outer magnetosphere.

Kremser, G.↗

Estimation of the average surface heat flux over an inhomogeneous terrain from the vertical velocity variance

An indirect method of estimating the surface heat flux from observations of vertical velocity variance at the lower mid-levels of the convective atmospheric boundary layer is described. Comparison of surface heat flux estimates with those from boundary-layer heating rates is good, and this method seems to be especially suitable for inhomogeneous terrain for which the surface-layer profile method cannot be used.

Eilts, M. D.↗

High-speed flow calculations past 3-D configurations based on the Reynolds averaged Navier-Stokes equations

A computational fluid dynamics tool has been developed capable of analyzing the viscous supersonic/hypersonic flow about realistic configurations. This techniques can predict the flow in regions of canopies, wings, and canards in addition to the usual simple symmetric configurations. It also allows for interactions between aerodynamic surfaces such as the vortex interaction between canards and wings.

Chaussee, Denny S.↗

Investigation of the validity of Reynolds averaged turbulence models at the frequencies that occur in turbomachinery

Turbulent flows subjected to various kinds of unsteady disturbances were simulated using a large-eddy-simulation computer code for flow in a channel. The disturbances were: a normal velocity expressed as a traveling wave on one wall of the channel; staggered blowing and suction distributions on the opposite walls of the channel; and oscillations of the mean flow through the channel. The wall boundary conditions were designed to simulate the effects of wakes of a stator stage passing through a rotor channel in a turbine. The oscillating flow simulated the effects of a pressure pulse moving over the rotor blade boundary layer. The objective of the simulations was to provide better understanding of the effects of time-dependent disturbances on the turbulence of a boundary layer and of the underlying physical phenomena regarding the basic interaction between the turbulence and external disturbances of the type found in turbomachinery. Results showed that turbulence is sensitive to certain ranges of frequencies of disturbances. However, no direct connection was found between the frequency of imposed disturbances and characteristic burst frequency of turbulence. New insight into the nature of turbulence at high frequencies was found. The viscous phenomena near solid walls was found to be the dominant influence for high frequency perturbations. At high frequencies, the turbulence was found to be undisturbed, remaining the same as for the steady mean flow. A transition range exists between the high frequency range and the low, or quasi-steady, range in which the turbulence is not predictable by either quasi-steady models or the steady flow model. The limiting lowest frequency for use of the steady flow turbulence model is that for which the viscous Stokes layer based on the blade passing frequency is thicker than the laminar sublayer.

Kuhn, Gary D.↗

Effect of orbital and rotational angular momentum averaging on branching ratios of dynamical resonances in the reaction H + p-H2 yields o-H2 + H

The paper reports extensive quantum mechanical calculations of the product vibrational branching ratios in the reaction H + p-H2 yields o-H2 + H. The calculations involve total angular momentum up to 2 and excited as well as ground initial rotational states, and they are completely converged with up to 513 channels in individual total angular momentum/parity blocks. Comparisons are made with recent experiments by Nieh and Valentini.

Mladenovic, Mirjana↗

A simple parcel method for prediction of cumulus onset and area-averaged cloud amount over heterogeneous land surfaces

A set of PBL data selected from the Wangara experiment is used to examine the relationship between cumulus amount and the calculated relative humidity of rising parcels. The Wilde et al. (1985) method is compared to two explicit parcel methods. It is shown that predictions using parcel methods, in which surface air is lifted to its equilibrium level while being diluted by a defined amount of mixed layer air, are superior for cloud amount, especially during periods of rapid cloud onset when the mean boundary layer top is swiftly rising through a near-neutral layer. Pending independent verification, it appears that an rms error in instantaneous cloud amount of + or - 10 percent may be achievable.

Wetzel, Peter J.↗

Performance of two texture-based classifiers of cloud fields using spatially averaged Landsat data

Using the gray-level difference vector approach, classification accuracies with 1/8-km spatial-resolution data are similar to those obtained using the full spatial-resolution features. Hence no advantage is to be gained in cloud classification accuracies by using even higher spatial resolutions obtained from Landsat TM or SPOT imagery. The optimum spatial resolution is 1/4 km. However, significant improvement in cloud-classification accuracy compared to that available from the 1-km resolution of AVHRR and GOES imagery is obtained using 1/2-km-resolution data. Cirrus-classification accuracy is especially compromised as spatial resolution is degraded. However, texture measures defined at the combination of pixel separations d = 1,4 improve classification accuracies by several percent, even for 1-km spatial-resolution data. Cirrus-classification accuracy is significantly improved by the use of multiple distance features.

Sengupta, S. K.↗

Viscosity and inertia in cosmic-ray transport - Effects of an average magnetic field

A generalized transport equation is introduced which describes the transport and propagation of cosmic rays in a magnetized, collisionless medium. The equation is valid if the cosmic-ray distribution function is nearly isotropic in momentum, if the ratio of fluid speed to fluid-flow particle speed is small, and if the ratio of collision time to time for change in the macroscopic flow is small. Five independent cosmic-ray viscosity coefficients are found, and the ralationship of this viscosity to particle orbits in a magnetic field is presented.

Williams, L. L.↗

Linking correlations and structure - Stochastic estimation and conditional averaging

The principles and applications of stochastic estimation are reviewed and the results of various investigations as they pertain to the structure of shear flow turbulence are presented. These results support a picture in which hairpin vortices and/or vortex rings dominate in the outer layer, whereas structures elongated in the streamwise direction and possessing vorticity in the streamwise direction dominate the wall layer. They may result from vortices moving along the wall, or the vortices may result from the interaction of the streamwise streaks with the wall and with themselves.

Adrian, Ronald J.↗

An efficient nonlinear relaxation technique for the three-dimensional, Reynolds-averaged Navier-Stokes equations

An efficient implicit method for the computation of steady, three-dimensional, compressible Navier-Stokes flowfields is presented. A nonlinear iteration strategy based on planar Gauss-Seidel sweeps is used to drive the solution toward a steady state, with approximate factorization errors within a crossflow plane reduced by the application of a quasi-Newton technique. A hybrid discretization approach is employed, with flux-vector splitting utilized in the streamwise direction and central differences with artificial dissipation used for the transverse fluxes. Convergence histories and comparisons with experimental data are presented for several 3-D shock-boundary layer interactions. Both laminar and turbulent cases are considered, with turbulent closure provided by a modification of the Baldwin-Barth one-equation model. For the problems considered (175,000-325,000 mesh points), the algorithm provides steady-state convergence in 900-2000 CPU seconds on a single processor of a Cray Y-MP.

Edwards, Jack R.↗

Average effects of large-scale convection on helioseismic line widths and frequencies

The formalism of Lavely and Ritzwoller (1992) is here applied to the model of stationary large-scale solar convection developed by Glatzmaier (1984) in order to determine a characteristic giant-cell convection signature in helioseismic data. Frequency and line-width measurements are presented on spatially filtered spectra, so that references to azimuthal orders apply to the m-value of the spatial filter's spherical harmonic. Attention is given to the 'Q-bowl' pattern of large-scale convection, a systematic, apparent line-broadening.

Lavely, Eugene M.↗

Energy transports by ocean and atmosphere based on an entropy extremum principle. I - Zonal averaged transports

The maximum entropy production principle suggested by Paltridge (1975) is applied to separating the satellite-determined required total transports into atmospheric and oceanic components. Instead of using the excessively restrictive equal energy dissipation hypothesis as a deterministic tool for separating transports between the atmosphere and ocean fluids, the satellite-inferred required 2D energy transports are imposed on Paltridge's energy balance model, which is then solved as a variational problem using the equal energy dissipation hypothesis only to provide an initial guess field. It is suggested that Southern Ocean transports are weaker than previously reported. It is argued that a maximum entropy production principle can serve as a governing rule on macroscale global climate, and, in conjunction with conventional satellite measurements of the net radiation balance, provides a means to decompose atmosphere and ocean transports from the total transport field.

Sohn, Byung-Ju↗