Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “BANDWIDTH”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,531 records · Page 85

Broad-band half-wave dipole

A fan-dipole or bowtie element operating over a ground plane has been empirically designed to maximize the impedance bandwidth near the half-wavelength resonance. It is shown that a bandwidth of 37 percent can be achieved with a simple bowtie element less than a half-wavelength at the center frequency. This design could be useful as a radiating element in a wide-band phased array application or as a wide-band reflector feed or cavity-backed dipole.

Bailey, M. C.↗

Applications of excimer lasers for atmospheric species measurements

Excimer lasers are proven sources of high pulse energy and high average power coherent radiation at several wavelength regions throughout the ultraviolet spectrum. If designed properly, excimer lasers can be operated with both low divergence and narrow spectral bandwidth, and using an oscillator - injection-locked amplifier configuration they can be tuned over a 10 to 20 A bandwidth without appreciable loss in energy. Additional wavelength coverage from excimer lasers can be obtained by stimulated Raman scattering. With the development of magnetic switching for the high voltage, high power switches, the electric discharge excimer laser can also be operated reliably for extended periods of time at high pulse rates. All these features make excimer lasers ideal sources of ultraviolet radiation for a variety of remote and in-situ atmospheric species measurements.

Laudenslager, J. B.↗

Single longitudinal mode operation of an XeCl laser

Single longitudinal mode output from a directly tuned, long pulse, magnetically switched XeCl laser is reported for the first time. Mode control was achieved using spatial apertures and intracavity etalons. The narrow bandwidth laser output was diffraction limited with an optical pulse width of 30 ns, which would yield a transform limited bandwidth of 30 MHz.

Pacala, T. J.↗

Effects of ISI and satellite channel nonlinearity on Viterbi demodulation/decoding

It is shown that, for convolutionally coded transmission over bandwidth-constrained channels, a mere reversal of the switching direction at the encoder output produces a change in the system bit error probability performance. This change is significant when the Viterbi demodulator/decoder is matched to the total channel memory and is more significant for linear channels than for nonlinear ones. The reversal of switching direction is a simple demonstration of the fact that the well-known optimum codes for the linear AGWN channel are no longer necessarily optimum for a bandwidth-constrained channel with or without the addition of channel nonlinearity. It is concluded that potentially significant performance improvement can be obtained by matching the encoder (through the appropriate choice of tap weights and modulo-2 summers) to the channel in addition to matching the demodulator/decoder to the channel for a given encoder.

Divsalar, D.↗

Design and Performance of Sampled Data Loops for Subcarrier and Carrier Tracking

Design parameters and resulting performance are presented for the sampled data analogies of continuous time phase locked loops of second and third order containing perfect integrators. Expressions for noise equivalent bandwidth and steady state errors are given. Stability and gain margin are investigated using z plane root loci. Finally, an application is presented for Voyager subcarrier and carrier tracking under the dynamics of the encounters with Uranus and Neptune. For carrier tracking, loop bandwidth narrow enough for satisfactory loop signal to noise ratios can be achieved using third order loops without rate aiding, whereas second order loops would require aiding. For subcarrier tracking, third order loops can be used when the sampling rate is limited to approximately once per second, as in the Baseband Assembly, whereas second order loops sufficiently wide to track the dynamics have stability problems at that sampling rate.

Aguirre, S.↗

Subjective Workload Assessment and Voluntary Control of Effort in a Tracking Task

A manual control tracking task was manipulated along two dimensions: (1) control order and (2) forcing function bandwidth. In the first phase of the experiment subjective workload assessments were collected. It was found that subjective assessments of workload were closely associated with performance in the case of increasing control order, but not in the case of increasing bandwidth. This was interpreted as indicating that subjective workload assessments are most appropriate for the study of increasing difficulty centered in response selection processes as opposed to response execution processes. In the second phase of the experiment the subjects were asked to voluntarily limit the effort they applied in the performance of the tracking task. The results indicate that the subjects were quite facile in doing this. However, comparison of these data to the findings of other studies that manipulated effort via dual-task biasing indicate that effort manipulation is much more potent in a single-task configuration. This finding is discussed in terms of multiple resource theories of attentional capacity. The utility of an analysis of covariance procedure in studying the relationships between subjective ratings and performance is highlighted.

Vidulich, M. A.↗

Precise control of flexible manipulators

The design and experimental testing of end point position controllers for a very flexible one link lightweight manipulator are summarized. The latest upgraded version of the experimental set up, and the basic differences between conventional joint angle feedback and end point position feedback are described. A general procedure for application of modern control methods to the problem is outlined. The relationship between weighting parameters and the bandwidth and control stiffness of the resulting end point position closed loop system is shown. It is found that joint rate angle feedback in addition to the primary end point position sensor is essential for adequate disturbance rejection capability of the closed loop system. The use of a low order multivariable compensator design computer code; called Sandy is documented. A solution to the problem of control mode switching between position sensor sets is outlined. The proof of concept for endpoint position feedback for a one link flexible manipulator was demonstrated. The bandwidth obtained with the experimental end point position controller is about twice as fast as the beam's first natural cantilevered frequency, and comes within a factor of four of the absolute physical speed limit imposed by the wave propagation time of the beam.

Cannon, R. H., Jr.↗

Performance of the Dsa's Subcarrier Demodulation Digital Loop

The subcarrier demodulation digital loop is part of the baseband assembly. The subcarrier demodulator is a fourth-order Costas-type loop corresponding to a type 2 analog loop in terms of steady state response. The expected value and the variance of the error signal are determined as functions of the input SNR. A Nyquist sampling rate of the input signal is assumed. From the integro-difference equations a mixed s/z domain block diagram is obtained. From the loop's transfer function a set of gains for the loop filter is obtained. Also, a set of state equations is presented for future reference. Finally, the noise-equivalent bandwidths are calculated for normalized computation times of 0, 0.25 and 0.5. The subcarrier demodulator analyzed tracks a parabolic phase input with finite steady state error. Since at each update instant the loop gains are adjusted to compensate for the variations in SNR of the input signal, the noise-equivalent bandwidth is maintained constant.

Simon, M. K.↗

Impact of magnetic isolation on pointing system performance in the presence of structural flexibility

The inertial pointing stability of a gimbal pointing system (AGS) was compared with a magnetic pointing/gimbal followup system (ASPS), under certain conditions of system structural flexibility and disturbance inputs from the gimbal support structure. Separate 3 degree-of-freedom (3DOF) linear models based on NASTRAN modal flexibility data for the gimbal and support structures were generated for the ASPS configurations. Using the models inertial pointing control loops providing 6dB of gain margin and 45 deg of phase margin were defined for each configuration. The pointing loop bandwidth obtained for the ASPS is more than twice the level achieved for the AGS configuration. The AGS limit is attributed to the gimbal and support structure flexibility. As a result of the higher ASPS pointing loop bandwidth and the disturbance rejection provided by the magnetic isolation ASPS pointing performane is significantly better than that of the AGS system. The low frequency peak of the ASPS transfer function from base disturbance to payload angular motion is almost 60dB lower than AGS low frequency peak.

Seller, J.↗

Phase locked loop synchronization for direct detection optical PPM communication systems

Receiver timing synchronization of an optical pulse position modulation (PPM) communication system can be achieved using a phase locked loop (PLL) if the photodetector output is properly processed. The synchronization performance is shown to improve with increasing signal power and decreasing loop bandwidth. Bit error rate (BER) of the PLL synchronized PPM system is analyzed and compared to that for the perfectly synchronized system. It is shown that the increase in signal power needed to compensate for the imperfect synchronization is small (less than 0.1 dB) for loop bandwidths less than 0.1% of the slot frequency.

Chen, C. C.↗

Combined trellis coding with asymmetric MPSK modulation: An MSAT-X report

Traditionally symmetric, multiple phase-shift-keyed (MPSK) signal constellations, i.e., those with uniformly spaced signal points around the circle, have been used for both uncoded and coded systems. Although symmetric MPSK signal constellations are optimum for systems with no coding, the same is not necessarily true for coded systems. This appears to show that by designing the signal constellations to be asymmetric, one can, in many instances, obtain a significant performance improvement over the traditional symmetric MPSK constellations combined with trellis coding. The joint design of n/(n + 1) trellis codes and asymmetric 2 sup n + 1 - point MPSK is considered, which has a unity bandwidth expansion relative to uncoded 2 sup n-point symmetric MPSK. The asymptotic performance gains due to coding and asymmetry are evaluated in terms of the minimum free Euclidean distance free of the trellis. A comparison of the maximum value of this performance measure with the minimum distance d sub min of the uncoded system is an indication of the maximum reduction in required E sub b/N sub O that can be achieved for arbitrarily small system bit-error rates. It is to be emphasized that the introduction of asymmetry into the signal set does not effect the bandwidth of power requirements of the system; hence, the above-mentioned improvements in performance come at little or no cost. MPSK signal sets in coded systems appear in the work of Divsalar.

Simon, M. K.↗

Advanced 30/20 GHz multiple beam antenna for future communications satellites

The technologies which will be implemented in advanced satellite communications systems being studied by NASA and the intended coverage scenarios are described. The systems will function at 30/20 GHz with 2.5 GHz bandwidth for the uplink and downlink. Subfrequencies will have 500 MHz bandwidth and operations will include TDMA modes. Sample scan patterns are presented for the centerminous U.S. The signals will be broadcast from a multibeam offset Cassegrain reflector antenna to obtain a low sidelobe, wide angle scan. Three contiguous low sidelobe beams will be generated with a diplex feed cluster and a 19 element scanning beam-forming network. The same technology will be used to double the capacity of current 14/12 GHz satellites.

Chen, C. C.↗

Convolutional coding combined with continuous phase modulation

Background theory and specific coding designs for combined coding/modulation schemes utilizing convolutional codes and continuous-phase modulation (CPM) are presented. In this paper the case of r = 1/2 coding onto a 4-ary CPM is emphasized, with short-constraint length codes presented for continuous-phase FSK, double-raised-cosine, and triple-raised-cosine modulation. Coding buys several decibels of coding gain over the Gaussian channel, with an attendant increase of bandwidth. Performance comparisons in the power-bandwidth tradeoff with other approaches are made.

Pizzi, S. V.↗

Spectral broadening of VLF transmitter signals observed on DE 1 - A quasi-electrostatic phenomenon?

Spectrally broadened VLF transmitter signals are observed on the DE 1 satellite using alternatively both electric and magnetic field sensors. It is found that at times when the electric field component undergoes significant bandwidth expansion (up to about 110 Hz) the magnetic field component has a bandwidth of less than 10 Hz. The results support the theory that the off-carrier components are quasi-electrostatic in nature. Measurement of the absolute E and B field magnitudes of the broadened signals are used to determine the wave Poynting vector. It is found that the observed power levels can be understood without invoking any strong amplification process that operates in conjunction with the spectral broadening. The implications of this finding in distinguishing among the various possible mechanisms for spectral broadening are discussed.

Inan, U. S.↗

Direct-detection optical communication with color coded pulse position modulation signaling

The performance characteristics of a direct-detection optical communication system which is based on a laser transmitter which produces single light pulses at selected nonoverlapping optical center frequencies are discussed. The signal format, called color coded pulse position modulation (CCPPM), uses more of the total available response bandwidth characteristics of the photodetector than does ordinary PPM signaling. The advantages of CCPPM signaling are obtained at the expense of an increased optical bandwidth of the transmitted signal and a more complicated transmitter and receiver structure. When the signal format is used in conjunction with block length Reed-Solomon codes, high data rates and reliable high-speed optical communications under conditions of optimal energy efficiency are obtained.

Davidson, F.↗

The N/rev phenomenon in simulating a blade-element rotor system

When a simulation model produces frequencies that are beyond the bandwidth of a discrete implementation, anomalous frequencies appear within the bandwidth. Such is the case with blade element models of rotor systems, which are used in the real time, man in the loop simulation environment. Steady state, high frequency harmonics generated by these models, whether aliased or not, obscure piloted helicopter simulation responses. Since these harmonics are attenuated in actual rotorcraft (e.g., because of structural damping), a faithful environment representation for handling qualities purposes may be created from the original model by using certain filtering techniques, as outlined here. These include harmonic consideration, conventional filtering, and decontamination. The process of decontamination is of special interest because frequencies of importance to simulation operation are not attenuated, whereas superimposed aliased harmonics are.

Mcfarland, R. E.↗

The downshift of electron plasma oscillations in the electron foreshock region

Electron plasma oscillations in the earth's electron foreshock region are observed to shift above and below the local electron plasma frequency. As plasma oscillations shift downward from the plasma frequency, their bandwidth increases and their wavelength decreases. Observations of plasma oscillations well below the plasma frequency are correlated with times when ISEE 1 is far downstream of the electron foreshock boundary. Although wavelengths of plasma oscillations below the plasma frequency satisfy k x lambda-De approximately 1 the Doppler shift due to the motion of the solar wind is not sufficient to produce the observed frequency shifts. A beam-plasma interaction with beam velocities on the order of the electron thermal velocity is suggested as an explanation for plasma oscillations above and below the plasma frequency. Frequency, bandwidth, and wavelength changes predicted from the beam-plasma interaction are in good agreement with the observed characteristics of plasma oscillations in the foreshock region.

Fuselier, S. A.↗

Four-dimensional modulation and coding - An alternate to frequency-reuse

Four dimensional modulation as a means of improving communication efficiency on the band-limited Gaussian channel, with the four dimensions of signal space constituted by phase orthogonal carriers (cos omega sub c t and sin omega sub c t) simultaneously on space orthogonal electromagnetic waves are discussed. 'Frequency reuse' techniques use such polarization orthogonality to reuse the same frequency slot, but the modulation is not treated as four dimensional, rather a product of two-D modulations, e.g., QPSK. It is well known that, higher dimensionality signalling affords possible improvements in the power bandwidth sense. Four-D modulations based upon subsets of lattice-packings in four-D, which afford simplification of encoding and decoding are described. Sets of up to 1024 signals are constructed in four-D, providing a (Nyquist) spectral efficiency of up to 10 bps/Hz. Energy gains over the reuse technique are in the one to three dB range t equal bandwidth.

Wilson, S. G.↗