Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “model testing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,513 records · Page 84
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Reduction of intensity variations on a photovoltaic array with compound parabolic concentrators

The reduction of nonuniformities in the intensity distribution of light focused on a photovoltaic array by a compound parabolic concentrator is investigated. The introduction of small distortions into the surfaces of the reflector in order to diffuse the incident collimated light to fill the angular acceptance of the concentrator is calculated by means of ray tracing to decrease the irradiance nonuniformity at the cost of a lowered effective concentration of the concentrator. Measurements of the intensity distribution on a scale test model in terrestrial sunlight with corrugated aluminized mylar reflectors are shown to be in good agreement with the ray tracing results. A two-stage concentrator consisting of a focusing primary and a nonimaging secondary is also shown to result in a fairly uniform intensity distribution except in the case of a 4-deg incidence angle, which may be corrected by the introduction of distortions into one or both concentration stages.

Greenman, P.↗
NASA NTRS1980

Active damping of modal vibrations by force apportioning

The theory and numerical simulation of active structural damping is described which requires few discrete control thrusters positioned on the structure. A particular apportioning of coherently phased control forces is applied for each vibration mode which is to be damped; this strongly affects the damped vibration mode, while minimally exciting all other modes. The force apportioning used is that which would tune a target mode if the structure was being shaken in a model vibration test. In contrast to model testing, the forces are varied temporally so as to dampen, rather than excite, the target mode(s).

Hallauer, W. L., Jr.↗
NASA NTRS1980

Experimental evaluation of exhaust mixers for an Energy Efficient Engine

Static scale model tests were conducted to evaluate exhaust system mixers for a high bypass ratio engine as part of the NASA sponsored Energy Efficient program. Gross thrust coefficients were measured for a series of mixer configurations which included variations in the number of mixer lobes, tailpipe length, mixer penetration, and length. All of these parameters have a significant impact on exhaust system performance. In addition, flow visualization pictures and pressure/temperature traverses were obtained for selected configurations. Parametric performance trends are discussed and the results considered relative to the Energy Efficient Engine program goals.

Kozlowski, H.↗
NASA NTRS1980

Energy efficient engine diffuser/combustor model technology

A full scale, full annular diffuser/combustor model test rig was tested to investigate how configurational changes affect pressure loss and flow separation characteristics. The rig was characterized by five major modules: inlet; prediffuser; strut; simulated combustor; and full combustor. The prediffuser featured a short, curved wall dump design. Performance goals included: (1) a separation-free prediffuser flow field; (2) total pressure loss limited to 3.0 percent in the prediffuser and shrouds; and (3) an overall section pressure loss of 5.5 percent P sub T3 at the design airflow distribution. The results indicated that the prediffuser configurations operate well within the program goals for pressure loss and demonstrate separation free operation over a wide range of inlet conditions.

Gardner, W.↗
NASA NTRS1969

Effect of wing-transition location and slotted and unslotted flaps on aerodynamic characteristics of a fighter model at high subsonic speeds

An investigation was conducted in the Langley 8 foot transonic pressure tunnel to determine the effects of wing transition location and of slotted and unslotted full span flaps on the longitudinal aerodynamic characteristics of a 1/15 scale model of a variable wing sweep tactical fighter model. Tests were at Mach numbers from 0.70 to 0.85 for a wing leading edge sweep of 26 deg.

Ayers, T. G.↗
NASA NTRS1981

High frequency drive mechanism for an active controls systems aircraft control surface

The mechanism was successfully utilized on a wind tunnel model tested in the transonic blow down tunnel. The mechanism is also applicable to a flying aircraft. Several interrelated mechanical subsystems were utilized, including a low inertia antibacklash drive mechanism for high frequency oscillation and a compact antibacklash drive mechanism for conversion of rotary motion to linear motion.

Smith, H. E.↗
NASA NTRS1981

Proton-induced noise in digicons

The Space Telescope, which carries four Digicons, will pass several times per day through a low-altitude portion of the radiation belt called the South Atlantic Anomaly. This is expected to create interference in what is otherwise anticipated to be a noise-free device. Two essential components of the Digicon, the semiconductor diode array and the UV transmitting window, generate noise when subjected to medium-energy proton radiation, a primary component of the belt. These trapped protons, having energies ranging from 2 to 400 Mev and fluences at the Digicon up to 4,000 P+/sec-sq cm, pass through both the window and the diode array, depositing energy in each. In order to evaluate the effect of these protons, engineering test models of Digicon tubes to be flown on the High Resolution Spectrograph were irradiated with low-flux monoenergetic proton beams at the University of Maryland cyclotron. Electron-hole pairs produced by the protons passing through the diodes or the surrounding bulk caused a background count rate. This is the result of holes diffusing over a distance of many diode spacings, causing counts to be triggered simultaneously in the output circuits of several adjacent diodes. Pulse-height spectra of these proton-induced counts indicate that most of the bulk-related counts overlap the single photoelectron peak. A geometrical model will be presented of the charge collection characteristics of the diode array that accounts for most of the observed effects.

Smith, L. C.↗
NASA NTRS1981

An analytical approach to airfoil icing

An analytical procedure has been developed to predict rime ice growth on unprotected airfoil sections and to evaluate the aerodynamic performance. A time stepping method is used in which: (1) water droplet trajectories are calculated, (2) a rime ice shape determined, (3) the flowfield around the iced airfoil is recalculated, and (4) the build-up process iterated upon until the desired icing time is reached. The performance of the iced airfoil shapes are then determined from existing analytic methods. Rime ice shapes determined in the NASA Lewis Icing Research Tunnel on a modified NACA 64 series airfoil agree well with the shapes predicted by the analytical method. Measured and predicted increases in drag due to the rime ice also agree favorably. A simplified scaling analysis is also presented and verified which provides the duplication of full scale results of rime ice accretions in small scale model tests.

Bragg, M. B.↗
NASA NTRS1981

Anomalous C-12H4:C-13H4 strengths in 3 ny sub 3

The C-12:C-13 ratios in the atmospheres of the outer planets are important parameters with which to test models for isotope formation and fractionation during the early history of the solar system, yielding insight into processes occurring in the primitive solar nebula. The 3 ny sub 3 spectra of methane were obtained using the Kitt Peak Solar Fourier Transform Spectrometer and a 6 m White cell. The experimental results are summarized in a table. The strength ratios for the R-branch of 3 ny sub 3 exhibit strong anomalies, with C-13H4 lines consistently weaker than their C-12H4 counterparts. The C-12:C-13 abundance ratios for the atmospheres of Jupiter and Saturn have been redetermined using the 3 ny sub 3 line-strength ratios measured.

Brault, J. W.↗
NASA NTRS1983

Rod-Wall Sound Shield for Wind Tunnels

Test model is shielded from turbulence radiated from wind tunnel walls. Shield overcomes problems caused by leading-edge configuration and leading edge angle of inclination of previous designs. Has successfully maintained a laminar rather than turbulent boundary layer.

Creel, T. R. J.↗
NASA NTRS1981

Wind tunnel supplementary Mach number minimum section insert

A device is described which changes the Mach number capability of a wind tunnel without permanently altering the existing nozzle of the tunnel. An insert is removably attached to the wall of the existing nozzle expansion area thereby creating a second minimum section upstream of the model test section. The added insert may be removed without complicated and expensive changes to the basic wind tunnel. In one embodiment, a removable insert is disposed within wind tunnel nozzle walls with a portion of the flow boundary layer being bled off from the tunnel via passageway and tunnel exit to reduce the extent of separated flow normally occuring upstream of the insert contraction section.

Couch, L. M.↗
NASA NTRS1982

Transit Thermal Control Design for Galileo Entry Probe for Planet Jupiter

A totally passive design was completed for the thermal control of the Galileo entry probe during its transit to the planet Jupiter. The design utilizes radio isotope heater units, multilayer insulation blankets and a thermal radiator in conjunction with a design conductance support structure to achieve both the required storage and critical initial planet atmosphere entry temperatures. The probe transit thermal design was completed and verified based on thermal vacuum testing of a prototype probe thermal test model.

Haverly, George C.↗
NASA NTRS1982

Experimental study of turbulence in blade end wall corner region

Corner flows and wall pressure fluctuations, design and fabrication of the test model, preliminary resuls on boundary layer, flow visualization, turbulence intensity and spectra measurements are presented. The design consideration and fabrication report on the newly built wind tunnel to be used for subsequent continuation of the research effort is also presented.

Raj, R.↗
NASA NTRS1982

Experimental investigation of two nonaxisymmetric wedge nozzles at free stream Mach numbers up to 1.20

Forces and pressures on two nonaxisymmetric wedge nozzles were measured in a 16 foot transonic tunnel. Tests were conducted at static conditions and at free stream Mach numbers of 0.60, 0.80, 0.90, 0.94, and 1.20. The range of nozzle pressure ratios varied with configuration and Mach number. The internal and external geometry of the nozzles and the test model are defined in detail. Nozzle performance data are presented as discharge coefficients, internal thrust ratios, thrust minus nozzle drag ratios, and ideal thrust coefficients. Extensive internal and external pressure measurements are presented.

Mason, M. L.↗
NASA NTRS1982

Measurement of Three-dimensional Density Distributions by Holographic Interferometry and Computer Tomography

The use of holographic interferometry to measure two and threedimensional flows and the interpretation of multiple-view interferograms with computer tomography are discussed. Computational techniques developed for tomography are reviewed. Current research topics are outlined including the development of an automated fringe readout system, optimum reconstruction procedures for when an opaque test model is present in the field, and interferometry and tomography with strongly refracting fields and shocks.

Vest, C. M.↗
NASA NTRS1982

Propeller tip vortex - A possible contributor to aircraft cabin noise

Wind tunnel model tests support the hypothesis that a propeller tip vortex may subject a downstream wing surface to greater excitation than would be experienced by the aircraft fuselage side wall exposed to propeller-generated noise, ultimately transmitting this structural response to incident dynamic pressure to the cabin interior. Even if structure-borne excitations are less efficient than airborne excitations in the creation of cabin noise, the higher level of the former could still govern cabin noise levels.

Miller, B. A.↗
NASA NTRS1982

Higher-order flow angle corrections for three-dimensional wind tunnel wall interference

A second-order theory including camber effects in wind tunnel wall interference corrections is described. Changes in the geometrical configuration of the model tested are avoided by introducing the camber correction as an equivalent angle-of-attack correction. Tabular and graphic data are presented which indicate improved accuracy for second-order over first-order theory.

Rizk, M. H.↗
NASA NTRS1982

Conceptual design, evaluation and research identification for Remote Augmented Propulsive Lift Systems (RALS) with ejectors for VTOL aircraft

Ejector concepts for use with a remote augmented lift system (RALS) exhaust nozzle were studied. A number of concepts were considered and three were selected as having the greatest promise of providing the desired aircraft and exhaust gas cooling and lift enhancement. A scale model test program is recommended to explore the effects of the more important parameters on ejector performance.

Willis, W. S.↗