Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “entry”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,477 records · Page 82
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Pioneer Venus Multiprobe entry telemetry recovery

The Entry Phase of the Pioneer Venus Multiprobe Mission involved data transmission over only a two-hour span. The criticality of recovery of those two hours of data, coupled with the fact that there were no radio signals from the Probes until their arrival at Venus, dictated unique telemetry recovery approaches on the ground. The result was double redundancy, use of spectrum analyzers to aid in rapid acquisition of the signals, and development of a technique for recovery of telemetry data without the use of real-time coherent detection which is normally employed by all other NASA planetary missions.

Miller, R. B.↗
NASA NTRS1980

Flowfield calculations past an entry probe with ablated nose shape

The effects of ablated nose shapes on the flowfield solutions are studied, using a time-dependent finite-difference method developed by Kumar, et al. (1979). Solutions are obtained for the laminar flow of a radiating mixture of H-He in chemical equilibrium past a blunt axisymmetric body at zero angle of attack. The freestream conditions correspond to a point on a typical Jovian entry trajectory, and the initial probe shape is a 45-deg half-angle spherically blunted cone. It is found that as nose bluntness increases, the following occur: in the nose region, shock standoff distances and radiative heating rates increase substantially; surface pressure level increases, but convective heating rates decrease.

Kumar, A.↗
NASA NTRS1980

Galileo probe forebody entry thermal protection - Aerothermal environments and heat shielding requirements

Solutions are presented for the aerothermal heating environments and the material thermal response for the forebody heatshield on the candidate 242 kg Galileo probe entering the modeled nominal and cold-dense Jovian atmospheres. In the flowfield analysis, a finite difference procedure was employed to obtain benchmark predictions of pressure, radiation and convective heating rates (both laminar and turbulent) and the corresponding wall blowing obtained under the steady state approximation. The fluxes over the probe flank were found to be in a range where spallation is an important mass loss mechanism. The predicted heating rates were also used as boundary conditions for a charring materials ablation which was used to predict thermochemical based surface recession, mass loss and bondline temperatures. The contingency factor of 30% currently employed by NASA was found to be insufficient for entry into the cold-dense atmosphere.

Nicolet, W. E.↗
NASA NTRS1980

Equivalent-cone calculation of nitric oxide production rate during Space Shuttle re-entry

The amount of nitric oxide likely to be produced in the shock layer around a Space Shuttle orbiter vehicle during its reentry is calculated at one point on the trajectory. An equivalent-cone is defined as one that produces the same amount of nitric oxide as the orbiter. The amounts of nitric oxide produced by the cone are calculated at points along the trajectory to determine their total and altitudinal distribution. The results show that about 14 tonne nitric oxide is produced at each entry, the peak occurring at 68 km altitude.

Park, C.↗
NASA NTRS1981

Qualification testing of secondary sterilizable silver-zinc cells for use in the Jupiter atmospheric entry probe

A series of qualification tests were run on the secondary, sterilizable silver oxide - zinc cell developed at the NASA Lewis Research Center to determine if the cell was capable of providing mission power requirements for the Jupiter atmospheric entry probe. The cells were tested for their ability to survive radiation at the levels predicted for the Jovian atmosphere with no loss of performance. Cell performance was evaluated under various temperature and loading conditions, and the cells were tested under various environmental conditions related to launch and to deceleration into the Jovian atmosphere. The cell performed acceptably except under the required loading at low temperatures. The cell was redesigned to improve low-temperature performance and energy density. The modified cells improved performance at all temperatures. Results of testing cells of both the original and modified designs are discussed.

Manzo, M. A.↗
NASA NTRS1981

Transport properties associated with entry into the atmosphere of Titan

In this paper the transport properties in the atmosphere of Titan and at the shock front and the probe surface for non-ablative entry into Titan's atmosphere are calculated, using the kinetic theory of gases. The species N2, H2, CH4, HCN, N, and H contribute to the transport properties under these conditions. The transport properties were calculated by using accurate potential energy curves for each of the thirteen two-body interactions which occur between these species. Results are given for the binary diffusion coefficients, the non-reactive and reactive thermal conductivity, and the viscosity from 1000 K to 8000 K. This information is needed for calculating flowfield properties and surface heating rates. The most important conclusions are that the non-reactive thermal conductivity is much larger behind the shock layer than it is in the ambient atmosphere and that the nonreactive thermal conductivity appears to be nearly constant in the shock layer.

Flori, B.↗
NASA NTRS1981

Fixed-trim re-entry guidance analysis

The terminal guidance problem for a fixed-trim re-entry body is formulated with the objective of synthesizing a closed-loop steering law. A transformation of variables and subsequent linearization of the motion, with the sight-line to the target as a reference, reduces the order of the state system for the guidance problem. The reduced order system, although nonlinear and time-varying, is simple enough to lend itself to synthesis of a class of guidance laws. A generalization of the feedforward device of classical control theory is successfully employed for compensation of roll autopilot lags. The proposed steering law exhibits superior miss-distance performance in a computational comparison with existing fixed-trim guidance laws.

Gracey, C.↗
NASA NTRS1981

An experimental study of massive blowing from a nosetip during Jovian entry

The fluid dynamic structure and stability of the boundary layer and shock layer ahead of a highly blowing heat shield in an environment simulating entry into the Jovian atmosphere were investigated. The experimental studies were conducted in the Calspan 96 in shock tunnel with a freestream of a H2/He mixture at Mach numbers above 10. Measurements of heat transfer and pressure were made on the porous model surface, and high-speed schlieren photography was used to examine the structure and stability of the shock layer. Results are presented which show how the heat transfer and shock layer stability vary for gases of different molecular weights for a range of Reynolds numbers and mass-addition rates.

Holden, M. S.↗
NASA NTRS1979

Influence of precursor heating on viscous flow around a Jovian entry body

The influence of changes in precursor region flow properties (resulting from the absorption of radiation from the shock layer) on the entire shock layer flow phenomena was investigated. The axially symmetric case is considered for both the preheating zone (precursor region) and shock layer. The flow in the shock layer is assumed to be viscous with chemical equilibrium but radiative nonequilibrium. Realistic thermophysical and spectral models are employed, and results are obtained by implicit finite difference and iterative procedures. The results indicate that precursor heating increases the radiative heating of the body by a maximum of 7.5 percent for 116 km entry conditions.

Tiwari, S. N.↗
NASA NTRS1981

Horizontal wind estimates deterministically derived from the STS-1 entry flight date--a comparison with available meteorology data

Two wind profiles were determined from STS-1 entry flight data based on preliminary best estimate trajectory (BET). The deterministic process used in deriving the atmospheric winds requires inertial estimates of the spacecraft angle-of-attack (alpha) and side-slip angle (beta) from the BET in conjunction with some air data system measurements of the actual angles. The current orbiter air data system (OADS) provides the necessary alpha information. Two beta profiles were adopted. The first profile assumed that the spacecraft would weathervane into any prevailing wind. The second assumed a conservative side-slip history computed from measured accelerations in the spacecraft body axes. It is shown that there are no major differences between the deterministic winds computed using both methods. Further, comparisons of these winds with raw measurements from Tehachapi, California, and preliminary winds obtained from the LaRC LAIRS file and the JSC/TRW descent BET are presented.

Kelly, G. M.↗
NASA NTRS1982

Preliminary analysis of STS-2 entry flight data

A preliminary analysis of the data obtained during the entry of the STS-2 flight was completed. The stability and control derivatives from STS-2 were examined. Questions still remain throughout the flight envelope and the area below Mach 3 needs more study. With three controls operating in a high gain feedback system, it is difficult to separate the individual effects of each of the controls. Analysis of the aerothermal data shows that wing structural-temperature measurements are generally repeatable and consistent with the trajectories. The measured wing upper surface temperatures are in reasonable agreement with Dryden predictions but wing lower surface temperatures are higher than Dryden predictions. Heating and heat transfer models will be adjusted to improve the temperature prediction capability for future trajectories.

Source record↗
NASA NTRS1982

Health and safety evaluation of a modified tunnel borer design for application to single entry coal mine development

A health and safety analysis of a single entry coal tunnel borer system is given. The results of the health analysis indicated that while the tunnel borer design offered improvements in dust control through the use of water sprays, a higher face ventilation rule, and the application of spalling rather than the conventional grinding process, it interjected an additional mutagen and toxic compound into the environment through the use of shotcrete. The tunnel borer system easily conformed with the prescribed fatality limit, but exceeded the required limits for disabling and overall injuries. It also exhibited projected disabling and overall injury rates considerably higher than existing continuous mining injury rates. Consequently, the tunnel borer system was not considered an advanced system.

Zimmerman, W. F.↗
NASA NTRS1982

Space Shuttle orbiter entry heating and TPS response: STS-1 predictions and flight data

Aerothermodynamic development flight test data from the first orbital flight test of the Space Transportation System (STS) transmitted after entry blackout is given. Engineering predictions of boundary layer transition and numerical simulations of the orbiter flow field were confirmed. The data tended to substantiate preflight predictions of surface catalysis phenomena. The thermal response of the thermal protection system was as expected. The only exception is that internal free convection was found to be significant in limiting the peak temperature of the structure in areas which do not have internal insulation.

Ried, R. C.↗
NASA NTRS1982

Preliminary Analysis of STS-3 Entry Heat-Transfer Data for the Orbiter Windward Centerline

A preliminary analysis of heat transfer data on the space shuttle orbiter windward centerline for the STS-3 mission entry is presented. Temperature-time history plots for each measurement location and tabulated wall temperature and convective heating rate data at 21 selected trajectory points are included. The STS-3 flight data are also compared with predictions by two approximation methods for computing convective heat transfer rates in equilibrium air.

Throckmorton, D. A.↗
NASA NTRS1980

User's guide for the computer code COLTS for calculating the coupled laminar and turbulent flow over a Jovian entry probe

A user's guide for a computer code 'COLTS' (Coupled Laminar and Turbulent Solutions) is provided which calculates the laminar and turbulent hypersonic flows with radiation and coupled ablation injection past a Jovian entry probe. Time-dependent viscous-shock-layer equations are used to describe the flow field. These equations are solved by an explicit, two-step, time-asymptotic finite-difference method. Eddy viscosity in the turbulent flow is approximated by a two-layer model. In all, 19 chemical species are used to describe the injection of carbon-phenolic ablator in the hydrogen-helium gas mixture. The equilibrium composition of the mixture is determined by a free-energy minimization technique. A detailed frequency dependence of the absorption coefficient for various species is considered to obtain the radiative flux. The code is written for a CDC-CYBER-203 computer and is capable of providing solutions for ablated probe shapes also.

Kumar, A.↗
NASA NTRS1981

Research analysis of Space Shuttle Orbiter entry aerothermodynamic flight data at the NASA Langley Research Center

The methods used to analyze the aerothermodynamic data gathered from the Shuttle protoflights are reviewed. Trajectory and atmospheric reconstruction allow an accurate definition of the freestream environment through which the Shuttle has flown. The reconstructions, combined with aerodynamic coefficient and convective heating rate determinations, provide predictive capability for comparison with future flights. Data are acquired by operational instrumentation (12,000 parameters), development flight instrumentation (4500 measurements), and Orbiter experiments instrumentation; tracking and meteorological data are also included in the analyses. The aerothermodynamic and aerodynamic technology base for large, winged, lifting body entry vehicles is being expanded by the analysis efforts. Sensor locations on the Shuttle and data management techniques are described.

Throckmorton, D. A.↗
NASA NTRS1981

Anatomy of an entry vehicle experiment

The anatomy and evolution of a simple small-scale unmanned entry vehicle is described that is delivered to orbit by the shuttle and entered into the atmosphere from orbit to acquire flight data to improve our knowledge of boundary-layer behavior and evaluate advanced thermal protection systems. The anatomy of the experiment includes the justification for the experiments, instrumentation, configuration, material, and operational needs, and the translation of these needs into a configuration, weight statement, aerodynamics, program cost, and trajectory. Candidates for new instrumentation development are also identified for nonintrusive measurements of the boundary-layer properties.

Eide, D. G.↗
NASA NTRS1982

Influence of radiant energy exchange on the determination of convective heat transfer rates to Orbiter leeside surfaces during entry

Temperatures measured at the aerodynamic surface of the Orbiter's thermal protection system (TPS), and calorimeter measurements, are used to determine heating rates to the TPS surface during atmospheric entry. On the Orbiter leeside, where convective heating rates are low, it is possible that a significant portion of the total energy input may result from solar radiation, and for the wing, cross radiation from the hot (relatively) Orbiter fuselage. In order to account for the potential impact of these sources, values of solar- and cross-radiation heat transfer are computed, based upon vehicle trajectory and attitude information and measured surface temperatures. Leeside heat-transfer data from the STS-2 mission are presented, and the significance of solar radiation and fuselage-to-wing cross-radiation contributions to total energy input to Orbiter leeside surfaces is assessed.

Throckmorton, D. A.↗