Radiation heat transfer characteristics of turbine vane airfoils in a water-cooled cascade
Radiation heat transfer characteristics of turbine vane airfoils in water-cooled cascade
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Radiation heat transfer characteristics of turbine vane airfoils in water-cooled cascade
Procedures for predicting properties of transonic flows about thin airfoils and slender bodies
Wind tunnel measurements of pressure distributions on wing having NACA 4415 airfoil sections with trailing-edge flaps set at 0 deg and 40 deg
Unsteady airfoil stall characteristics using static data input for predicting stall flutter boundaries of space shuttle wing
Aerodynamic characteristics of thin, highly cambered airfoils in incompressible flow
Development of procedure for scaling of experimental turbine vane airfoil temperatures from low to high gas temperatures
Compressible transonic flow about two dimensional airfoils, developing inviscid nonlinear potential equations by relaxation procedures
An investigation of the longitudinal aerodynamic characteristics of an aspect ratio 4.735 airfoil having a 9.8 percent chord blowing flap has been made in an out of ground influence over the endless moving belt ground plane in the 5.18 meter test section of the former Langley 300 MPH 7 by 10 foot wind tunnel. For flap deflections of 30 deg or less, at a height of 0.25 span, ground effect was negligible; but at this ground height, at a flap deflection of 60 deg and a lift coefficient of 8.0, the lift loss was 27 percent. The lift loss for this same condition becomes negligible at a height of one span.
Wind tunnel tests to determine the flow characteristics of a stalled wing are described. The advantages of the plane wing over the ring wing for wind tunnel investigations are presented. The general flow pattern for stalled ring airfoils is developed. Photographs of the test equipment and installation are provided.
An exploratory wind tunnel test has been conducted at Mach numbers from 0.60 to 0.80 to investigate the effects of nozzle geometry and upper surface blowing on the aerodynamic characteristics of a 14-percent-thick airfoil. Measured data included lift, drag, pitching moments, surface pressures, and nozzle thrust.
Underwater towing experiments were carried out with a rectangular airfoil of aspect ratio 5.3 at 4 and 8 deg angles of attack and at chord-based Reynolds numbers between 2 x 100,000 and 7.5 x 100,000. Quantitative measurements by means of the hydrogen bubble technique indicated lower peak swirl velocities in the range of 100 to 1000 lenghts downstream than have been measured in wind tunnel of flight tests. The maximum circumferential velocity decayed whereas the turbulent eddy viscosity increased. This behavior and other known rates of vortex decay are explained in terms of an analytical solution for the vortex problem with time varying eddy viscosity. It is shown that this case corresponds to nonequilibrium turbulent vortex flow.
Verification of Curle's (1955) point dipole sound theory as a means for predicting the level and directivity of sound radiated from rigid surfaces in flow. A presented comparison between theory and experiment is shown to provide evidence that airfoils in flow, whose dimensions are small in relation to the wavelength of the radiated sound, radiate like point dipoles in apparent support of Curle's theory.
The local edge buckling phenomena that can occur along the heated thin edge of a wedge shape airfoil is calculated. Qualitative comparison (qualitative only because the experimental temperature distribution was not measured) is made to the experimentally observed phenomena. The consequences of the assumption of identical vibration and buckling modes is shown by a comparison of results with and without the assumption of mode identity. Computer plots of the elastic surface as local buckling develops with increasing temperature are shown. The calculated, fully developed local edge buckling is compared to a photograph of a fully developed buckling as observed in the laboratory.
Primed surface is covered with adhesive. Sheet of plastic film is stretched over adhesive and mechanical holder is used to apply tension to ends of sheet to make it conform to surface of airfoil. After adhesive cures, plastic can be trimmed with sharp cutting tool.
The water tunnel which was constructed at the NASA Ames Research Center is described along with the flow field adjacent to an oscillating airfoil. The design and operational procedures of the tunnel are described in detail. Hydrogen bubble and thymol blue techniques are used to visualize the flow field. Results of the flow visualizations are presented in a series of still pictures and a high speed movie. These results show that time stall is more complicated than simple shedding from the leading edge or the trailing edge, particularly at relatively low frequency oscillations comparable to those of a helicopter blade. Therefore, any successful theory for predicting the stall loads on the helicopter blades must treat an irregular separated region rather than a discrete vortex passing over each blade surface.
An analytical procedure based on the Navier-Stokes equations was developed for analyzing and representing properties of unsteady viscous flow around oscillating obstacles. A variational formulation of the vorticity transport equation was discretized in finite element form and integrated numerically. At each time step of the numerical integration, the velocity field around the obstacle was determined for the instantaneous vorticity distribution from the finite element solution of Poisson's equation. The time-dependent boundary conditions around the oscillating obstacle were introduced as external constraints, using the Lagrangian Multiplier Technique, at each time step of the numerical integration. The procedure was then applied for determining pressures around obstacles oscillating in unsteady flow. The obtained results for a cylinder and an airfoil were illustrated in the form of streamlines and vorticity and pressure distributions.
An investigation was conducted in a low-turbulence pressure tunnel to determine the two-dimensional lift and pitching-moment characteristics of an NACA 6716 and an NACA 4416 airfoil with 35-percent-chord single-slotted flaps. Both models were tested with flaps deflected from 0 deg to 45 deg, at angles of attack from minus 6 deg to several degrees past stall, at Reynolds numbers from 3.0 million to 13.8 million, and primarily at a Mach number of 0.23. Tests were also made to determine the effect of several slot entry shapes on performance.
An approximate solution is reported for the unsteady aerodynamic response of an infinite swept wing encountering a vertical oblique gust in a compressible stream. The approximate expressions are of closed form and do not require excessive computer storage or computation time, and further, they are in good agreement with the results of exact theory. This analysis is used to predict the unsteady aerodynamic response of a helicopter rotor blade encountering the trailing vortex from a previous blade. Significant effects of three dimensionality and compressibility are evident in the results obtained. In addition, an approximate solution for the unsteady aerodynamic forces associated with the pitching or plunging motion of a two dimensional airfoil in a subsonic stream is presented. The mathematical form of this solution approaches the incompressible solution as the Mach number vanishes, the linear transonic solution as the Mach number approaches one, and the solution predicted by piston theory as the reduced frequency becomes large.