Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “sublimation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

The ablation of graphitic materials in the sublimation regime.

A large variety of graphitic materials have been tested in an arc heated air stream at a surface pressure of 4.3 atm and a nominal surface temperature of 3925 K. Included were commercial and developmental grades of artificial graphites, both two and three dimensional carbon-carbon composites, composites seeded with refractory compounds, and several special materials such as pyrolytic graphite, mesophase graphite, glassy carbon, and natural graphite. ATJ graphite was used as a control material. Except for the seeded materials which had poor performance, the mass loss rate for all the man-made graphitic materials fell within the range of 17 per cent less to 30 per cent more than the rate for ATJ. Thus it is concluded that wide variations in constituents, processing, fabrication and structure have relatively little effect on the ablation performance of graphitic materials, at least under the conditions of the present tests. Particulate mass loss was observed for all the materials tested and is the dominant mechanism for mass removal at the present test conditions. It is suggested that this mechanism results from physical failure, primarily by compressive thermal stress.

Lundell, J. H.↗
NASA NTRS1978

Sublimate morphology on 74001 and 74002 orange and black glassy droplets

SEM-EDX analysis of the surface morphology of the 74001 and 74002 orange and black glassy droplets has revealed the presence of ubiquitous micromound coatings. Assuming that the diameter of an individual micromound is an indication of total coating thickness, then the thickness of this volatile and metal-rich layer ranges from less than 20 A to over 300 A in thickness. On rare droplets the micromound coating is partially covered by a sparse population of crystals and masses that are essentially NaCl in composition. Additionally, an irregular mass on the surface of one black droplet may contain free sulfur. Amoeboid masses of iron, some with incipient crystal faces, are also present on a few droplet surfaces. The above features, i.e., halite crystals, sulfur-rich masses and amoeboid iron, are rare; the more common occurrence of metals and volatiles is in the micromound coating. Based on our observations of several hundred spheres from both Apollo and Luna missions, the classic micromound coating is unique to the Apollo 15 green and Apollo 17 orange and black droplets. Although some investigators have proposed various impact sequences to produce these unique droplets, the volcanic fire fountain origin is favored.

Clanton, U. S.↗
NASA NTRS1985

Supersonic meteorology of Io - Sublimation-driven flow of SO2

The horizontal flow of SO2 gas from the day side to the night side of IO is calculated on the basis of a hydrodynamic model. The flow speed is found to be supersonic for all realistic values of the parameters. The surface pressure follows the frost vapor pressure within a factor of 2 in spite of day-night pressure ratios of 10,000 or more. Atmospheric temperature is generally below the surface temperature due to decompression in the expanding flow. The greatest sensitivity of the solution is connected with the frost temperature at the subsolar point. The quantities that involve the mass of the atmosphere (density, pressure, mass transport, and condensation rate) all vary as the vapor pressure of the frost, which is a sensitive function of frost temperature.

Ingersoll, A. P.↗
NASA NTRS1989

Subliming Layers Would Reveal Aerodynamic Effects

In proposed technique, flow of fluid across surface studied in detail by use of multilayered, multicolored coating. Particularly useful in study of flow of air over small area of aerodynamic surface. By use of this method, incremental determinations made as to friction, transfer of heat, positions of shock waves, and position and extent of turbulence on given surface. Technique applied to surface of model in wind tunnel or to aerodynamics surface on aircraft.

Jensen, Ronald N.↗
NASA NTRS1988

Climatological observations and predicted sublimation rates at Lake Hoare, Antarctica

In December 1985, an automated meteorological station was established at Lake Hoare in the dry valley region of Antarctica. Here, the first year-round observations available for any site in Taylor Valley are reported. The mean annual solar flux at Lake Hoare was 92 W/sq m during 1986, the mean air temperature -17.3 C, and the mean 3-m wind speed 3.3 m/s. The local climate is controlled by the wind regime during the 4-month sunless winter and by seasonal and diurnal variations in the incident solar flux during the remainder of the year.

Clow, Gary D.↗
NASA NTRS1990

Sublimation and transport of water from the north residual polar cap on Mars

The possible role of the north residual cap in the current Martian water cycle was examined using models to assess the ability of the cap to supply water to the atmosphere and the ability of the atmospheric circulation to transport it out of the polar regions to low northern latitudes. Results indicate that rather extreme circumstances would be required for the cap to provide all of the observed increase in atmospheric water, such as a combination of high surface winds, low cap emissivities, or substantial evaporation from dark material. But even if these conditions could be met, the high-latitude circulation is too localized in scale to move much water vapor out of the polar environment. Both the present calculations and the data from the Viking's Mars Atmospheric Water Detection Experiment show that about two thirds of the water appearing in the Martian northern hemisphere during summer must be supplied by other sources. It is suggested that the additional source is water desorbing from the nonpolar regolith.

Haberle, Robert M.↗
NASA NTRS1990

Semiconductor surface sublimation energies and atom-atom interactions

The energy required to remove an atom from semiconductor surfaces is calculated using a Green's-function approach. Contrary to intuition, it is found that, in some cases, less energy is needed to remove an atom from the nearly full surface than from a nearly empty surface. The results are explained in terms of the relative energies of anion and cation dangling bonds, and the charge transfers between them. The deducted effective pair-interaction energies and their effects on surface morphology and growth perfection are discussed.

Krishnamurthy, Srinivasan↗
NASA NTRS1989

Sublimating comets as the source of nucleation seeds for grain condensation in the gas outflow from AGB stars

A growing amount of observational and theoretical evidence suggests that most main sequence stars are surrounded by disks of cometary material. The dust production by comets in such disks is investigated when the central stars evolve up the red giant and asymptotic giant branch (AGB). Once released, the dust is ablated and accelerated by the gas outflow and the fragments become the seeds necessary for condensation of the gas. The origin of the requisite seeds has presented a well known problem for classical nucleation theory. This model is consistent with the dust production observed in M giants and supergiants (which have increasing luminosities) and the fact that earlier supergiants and most WR stars (whose luminosities are unchanging) do not have significant dust clouds even though they have significant stellar winds. Another consequence of the model is that the spatial distribution of the dust does not, in general, coincide with that of the gas outflow, in contrast to the conventional condensation model. A further prediction is that the condensation radius is greater that that predicted by conventional theory which is in agreement with IR interferometry measurements of alpha-Ori.

Whitmire, D. P.↗
NASA NTRS1992

Crystallization, sublimation, and gas release in the interior of a porous comet nucleus

A numerical code is developed for evolutionary calculations of the thermal structure and composition of a porous comet nucleus made of water ice, in amorphous or crystalline form, other volatiles, dust, and gases trapped in amorphous ice. Bulk evaporation, crystallization, gas release, and free (Knudsen) flow of gases through the pores are taken into account. The numerical scheme yields exact conservation laws for mass and energy. The code is used to study the effect of bulk evaporation of ice in the interior of a comet nucleus during crystallization. It is found that evaporation controls the temperature distribution; the vapor prevents cooling of the crystallized layer of ice, by recondensation and release of latent heat. Thus high temperatures are maintained below the surface of the nucleus and down to depths of tens or hundreds of meters, even at large heliocentric distances, as long as crystallization goes on. Gas trapped in the ice and released during the phase transition flows both toward the interior and toward the surface and out of the nucleus. The progress of crystallization is largely determined by the contribution of gas fluxes to heat transfer.

Prialnik, Dina↗