Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “loop antenna”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

Ka-band monopulse antenna-pointing systems analysis and simulation

NASA 's Deep Space Network (DSN) has been using both 70-m and 34-m reflector antennas to communicate with spacecraft at S-band (2.3 GHz) and X-band (8.45 GHz). To improve the quality of telecommunication and to meet future mission requirements, JPL has been developing 34-m Ka-band (32-GHz) beam waveguide antennas. Presently, antenna pointing operates in either the open-loop mode with blind pointing using navigation predicts or the closed-loop mode with conical scan (conscan). Pointing accuracy under normal conscan operating conditions is in the neighborhood of 5 mdeg. This is acceptable at S- and X-bands, but not enough at Ka-band. Due to the narrow beamwidth at Ka-band, it is important to improve pointing accuracy significantly (approximately 2 mdeg). Monopulse antenna tracking is one scheme being developed to meet the stringent pointing-accuracy requirement at Ka-band. Other advantages of monopulse tracking include low sensitivity to signal amplitude fluctuations as well as single-pulse processing for acquisition and tracking. This article presents system modeling, signal processing, simulation, and implementation of Ka-band monopulse tracking feed for antennas in NASA/DSN ground stations.

Lo, V. Y.↗

Ka-Band Monopulse Antenna-Pointing Systems Analysis and Simulation

NASA's Deep Space Network (DSN) has been using both 70-m and 34-m reflector antennas to communicate with spacecraft at S-band (2.3 GHz) and X-band (8.45 GHz). To improve the quality of telecommunication and to meet future mission requirements, JPL has been developing 34-m Ka-band (32-GHz) beamwave guide antennas. Presently, antenna pointing operates in either the open-loop mode with blind pointing using navigation predicts or the closed-loop mode with conical scan (conscan). Pointing accuracy under normal conscan operating conditions is in the neighborhood of 5 mdeg. This is acceptable at S- and X-bands, but not enough at Ka-band. Due to the narrow beamwidth at Ka-band, it is important to improve pointing accuracy significantly (approx. 2 mdeg). Monopulse antenna tracking is one scheme being developed to meet the stringent pointing-accuracy requirement at Ka-band. Other advantages of monopulse tracking include low sensitivity to signal amplitude fluctuations as well as single-pulse processing for acquisition and tracking. This article presents system modeling, signal processing, simulation, and implementation of Ka-band monopulse tracking feed for antennas in NASA/DSN ground stations.

Lo, V. Y.↗

Analysis of GEOS-3 altimeter data and extraction of ocean wave height and dominant wavelength

When the amplitude and timing biases are removed from the GEOS-3 Sample and Hold (S&H) gates, the mean return waveforms can be excellently fitted with a theoretical template which represents the convolution of: (1) the radar point target response; (2) the range noise (jitter) in the altimeter tracking loop; (3) the sea surface height distribution; and (4) the antenna pattern as a function of the range to mean sea level. Several techniques of varying complexity to remove the effect of the tracking loop jitter in computing the wave height are considered. They include: (1) realigning the S&H gates to their actual positions with respect to mean sea level before averaging; (2) using the observed standard deviation on the altitude measurement to remove the integrated effect of the tracking loop jitter, and (3) using a look-up table to correct for the expected value of range noise. Analysis of skewness in the GEOS return waveform demonstrates the potential of a satellite radar altimeter to determine the dominant wavelength of ocean waves.

Walsh, E. J.↗

NASA future mission needs and benefits of controls-structures interaction technology

Two questions are addressed: (1) which future missions need Controls-Structures Interaction (CSI) technology for implementing large spacecraft in orbit; and (2) what specific benefits are to be derived if the technology is available? The answers to these questions were used to help formulate and direct the CSI technology development program. Many future NASA missions have common CSI technology needs which can best be developed in a broad-based, but focused, technology program to provide the greatest benefit to the largest number of users. Three CSI benefit studies were completed to date as part of ongoing assessment process: (1) missions requiring large antennas; (2) missions requiring large optical systems; and (3) missions requiring the use of closed-loop controlled, flexible, remote manipulator systems (RMS) for in-space assembly. The large antenna and flexible RMS mission benefits are discussed.

Grantham, William L.↗

Theory and Practical Design of Phase-locked Receivers, Volume I

This is Volume I of a two-volume work on the theory, of phase-locked receivers, with pertinent reference material on practical receiver design. Volume I is primarily devoted to the performance of carrier-tracking loops, including a rigorous treatment of narrow-band systems having IF limiters. The bulk of the work is based on a theoretical linear model, but a nonlinear method is also presented to predict behavior near the threshold. The emphasis throughout the work is toward completeness, simplicity, and internal consistency of the material assembled. Part I of this Volume is an exposition of the theory, the resulting equations, and the design philosophy that have enabled the phase-lock concept to evolve into the basic principle underlying the most sensitive receivers il, the world today. Part II is a condensed version of Part I, intended as a quick reference to formulas, definitions, and salient design considerations.

RECEIVER↗

Yaw Attitude Estimation for the Tracking and Data Relay Satellite System

The Tracking and Data Relay Satellite System (TDRSS) uses a groundbased attitude determination algorithm to open loop point the satellite's high data rate antennas. The spacecraft is able to measure its pitch and roll attitude, but its yaw attitude is periodically unobservable. The ground software uses a state-space estimator, an adaptation of a Luenberger observer, to predict the spacecraft yaw angle during these unobservable periods. It contains states associated with the roll/yaw dynamics and the on-board control law. The accuracy is limited by the modeling fidelity of the disturbance torques acting on the spacecraft. After initial operating problems were cleared up, the operation of the estimator has converged to predicted performance.

Staich, S.↗

Residual and suppressed-carrier arraying techniques for deep-space communications

Three techniques that use carrier information from multiple antennas to enhance carrier acquisition and tracking are presented. These techniques in combination with baseband combining are analyzed and simulated for residual and suppressed-carrier modulation. It is shown that the carrier arraying using a single carrier loop technique can acquire and track the carrier even when any single antenna in the array cannot do so by itself. The carrier aiding and carrier arraying using multiple carrier loop techniques, on the other hand, are shown to lock on the carrier only when one of the array elements has sufficient margin to acquire the carrier on its own.

Shihabi, M.↗

Apollo 14 and 15 missions: Intermittent steerable antenna operation

An attempt was made to determine the cause of antenna tracking interruptions during Apollo 14 and Apollo 15 missions prior to powered descent, and after ascent from the lunar surface but before rendezvous. Probable causes examined include: (1) amplitude modulation on the uplink radio frequency carrier, (2) noise capacitively or inductively coupled into the track error line, and (3) hardware problems resulting in tracking loop instabilities. It was determined that amplitude modulation caused the antenna oscillations. The corrective procedures taken are given.

Source record↗

Dichroic Design for the Orbiting VLBI Earth Station Antenna

In this paper the design and performance of a single screen frequency selective surface with gridded square loop patch elements are described for diplexing the X-and Ku-band signals in an Orbiting Very Long Baseline Interferometer (OVLBI) earth station reflector antenna system.

gridded square element resonant frequency drift Or↗

Voyager telecommunications - The broadcast from Jupiter

The means by which the data collected by the Voyager 1 mission to Jupiter were returned to earth are presented. Radio links between the earth and the spacecraft are used for the transmission of both imaging and nonimaging telemetry from the spacecraft and commands from the earth and for radiometric observations of the spacecraft and its environment. Features which have lead to vast improvements in the capability of the Voyager telecommunications system over that of previous space probes include the use of X-band rather than S-band telemetry, a dual power X-band traveling wave tube amplifier, a 3.7 m spacecraft antenna and a single channel telemetry system with concatenated coding. Communications equipment at the three ground complexes of the Deep Space Network for telemetry reception includes 64 m steerable antennas, cryogenic maser preamplifiers and a phase-lock loop receiver. Voyager 1 has met or exceeded all of its telecommunications requirements, providing a 98% data return and a total of 2 x 10 to the 11th data bits during the Jupiter encounter.

Edelson, R. E.↗

Modeling and simulations of the DSS 13 antenna control system

A model of the antenna control system for the azimuth and elevation axes of the Deep Space Station (DSS) 13 antenna is developed. This model is used for simulation of elevation and azimuth dynamics, cross-coupled dynamics, and radio-frequency pointing error due to both input commands and wind disturbances. This model also serves as a tool for the antenna controller design. A modal state-space model of the antenna structure was obtained from its finite-element model with a free-rotating tipping structure and alidade. Model reduction techniques applied separately for the antenna structure, elevation, and azimuth drives, and rate-loop model reduce the system order to one-third of that of the original, while preserving its significant dynamic properties. Extensive simulation results illustrate properties of the model.

Gawronski, W.↗

NASA Tech Briefs, July 2004

Topics: Optoelectronic Sensor System for Guidance in Docking; Hybrid Piezoelectric/Fiber-Optic Sensor Sheets; Multisensor Arrays for Greater Reliability and Accuracy; Integrated-Optic Oxygen Sensors; Ka-Band Autonomous Formation Flying Sensor; CMOS VLSI Active-Pixel Sensor for Tracking; Lightweight, Self-Deploying Foam Antenna Structures; Electrically Small Microstrip Quarter-Wave Monopole Antennas; A 2-to-28-MHz Phase-Locked Loop; Portable Electromyograph; Open-Source Software for Modeling of Nanoelectronic Devices; Software for Generating Strip Maps from SAR Data; Calibration Software for use with Jurassicprok; Software for Probabilistic Risk Reduction; Software Processes SAR Motion-Measurement Data; Improved Method of Purifying Carbon Nanotubes; Patterned Growth of Carbon Nanotubes or Nanofibers; Lightweight, Rack-Mountable Composite Cold Plate/Shelves; SiC-Based Miniature High-Temperature Cantilever Anemometer; Inlet Housing for a Partial-Admission Turbine; Lightweight Thermoformed Structural Components and Optics; Growing High-Quality InAs Quantum Dots for Infrared Lasers; Selected Papers on Protoplanetary Disks; Module for Oxygenating Water without Generating Bubbles; Coastal Research Imaging Spectrometer; Rapid Switching and Modulation by use of Coupled VCSELs; Laser-Induced-Fluorescence Photogrammetry and Videogrammetry; Laboratory Apparatus Generates Dual-Species Cold Atomic Beam; Laser Ablation of Materials for Propulsion of Spacecraft; Small Active Radiation Monitor; Hybrid Image-Plane/Stereo Manipulation; Partitioning a Gridded Rectangle into Smaller Rectangles; Digital Radar-Signal Processors Implemented in FPGAs; Part 1 of a Computational Study of a Drop-Laden Mixing Layer; and Some Improvements in Signal-Conditioning Circuits.

Source record↗

Optical Links and RF Distribution for Antenna Arrays

An array of three antennas has recently been developed at the NASA Jet Propulsion Laboratory capable of detecting signals at X and Ka band. The array requires a common frequency reference and high precision phase alignment to correlate received signals. Frequency and timing references are presently provided from a remotely located hydrogen maser and clock through a combination of commercially and custom developed optical links. The selected laser, photodetector, and fiber components have been tested under anticipated thermal and simulated antenna rotation conditions. The resulting stability limitations due to thermal perturbations or induced stress on the optical fiber have been characterized. Distribution of the X band local oscillator includes a loop back and precision phase monitor to enable correlation of signals received from each antenna.

antenna array↗

When Deployable Spacecraft Antennas Don’t

The objective of this paper is to explore possibilities for continued use of certain deployable spacecraft antennas when full deployment fails. Four (4) deployables are used as examples, including 1) a reflectarray, 2) a parabolic reflector, 3) a loop, and 4) a set of 4 monopoles. The measure of “continued usability” in each case is relative antenna gain as a function of partial deployment. Note, types (and levels) of partial deployment presented here are strictly hypothetical. Also, discussions of actual deployment mechanisms are considered outside the scope of this paper.

Cable, Vaughn↗