Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “lateral”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

The Effects of Slots and Flaps on Lateral Control of a Low-wing Monoplane as Determined in Flight

This paper presents the results of flight tests made to determine the effect of slots and flaps on the lateral control of a low-wing monoplane. Maximum angular accelerations in roll and yaw produced by sudden application of the ailerons and maximum accelerations in yaw produced by sudden application of the rudder during gliding flight were recorded for the following wing arrangements: (a) no auxiliary device; (b) full-span slots; (c) plain flaps; (d) flaps and full-span slots; (e) wing-tip slots. Rolling- and yawing-moment coefficients were derived from the accelerations. The full span slots and the flaps each had about the same influence on the aileron rolling moments. At values of the lift coefficient obtainable with the plain wing, the effect of these devices was negligible. At the higher lift coefficients obtainable with these devices, the rolling-moment coefficients increased slightly but, despite this increase, the aileron effectiveness progressively decreased with increasing lift coefficient, owing to the corresponding reduction in air speed. In the range covered by the tests, the effectiveness of the controls was appreciably reduced by the wing-tip slots. The adverse yawing moment of the ailerons experienced at the large lift coefficients obtained with the flaps was appreciably less than at similar lift coefficients obtained with either full-span or wing-tip slots. The yawing moments produced by the rudder were only slightly affected by the use of the auxiliary devices. The airplane was found to be laterally unstable with all combinations tested. Because of the angular velocities acquired in the time taken to deflect the ailerons the rolling moments recorded in flight were only about two thirds the values that would have been obtained with the wing restrained as in wind-tunnel tests.

WING SLOTS↗

Calculation of the lateral-dynamic stability of aircraft

Graphs and formulas are given with the aid of which all the aerodynamic coefficients required for computing the lateral dynamic stability can be determined. A number of numerical examples are given for obtaining the stability derivatives and solving the characteristic-stability equation. Approximate formulas are derived with the aid of which rapid preliminary computations may be made and the stability coefficients corrected for certain modifications of the airplane. A derivation of the lateral-dynamic-stability equations is included.

STABILITY, LATERAL - DYNAMIC↗

Investigation of a Spoiler-Type Lateral Control System on a Wing with Full-Span Flaps in the Langley 19-Foot Pressure Tunnel

Tests of a partial-span model of a large bomber-type air1ane were conducted to determine the. aerodynamic characteristics of the wing equipped with full-span flaps and a retractable spoiler end aileron lateral control system. The arrangement consisted of (1) a double slotted flap extending over aproximate1y 86 percent of the wing semispan, (2) a 20-percent constant-percentage-chord aileron extending from the outboard end of the flap to the wing tip, and (3) a retractable spoiler, located at the 65-percent wing-chord station and extending from approximately 63 percent of the wing semispan to the wing tip. In addition, tests were made of a wing vent (of 1 and 2 percent of the wing chord located directly behind the spoiler), perforations in the spoiler, a blot or cut-out along the lower edge of the spoiler and spoilers of various spans. With full-span flaps deflected and with the 2-percent vent open or closed the initial stalling of the wing occurred at the tips, but with the vents closed there probably would be no appreciable loss in lateral control until maximum lift was reached. The l-percent vent increased the rolling effectiveness of the spoiler at small spoi1er deflections, particularly at high angles of attack with flaps deflected. With flaps deflected the 2-percent vent caused a large reduction in both the wing lift and rolling effectiveness of the spoiler at large angles of attack. However, at small angle of attack the 2-percent vent increased the rolling effectiveness of the spoiler at small spoiler deflections. The simultaneous operation of the spoiler and vent (in contrast to a vent fixed in the wing) would result in a large increase in the effectiveness of the spoiler and would avoid any loss in wing lift as in a fixed vent arrangement. The tests of the spoiler modifications revealed that (1) the spoiler perforations reduced the rolling-moment and yawing-moment coefficients but caused the spoiler hinge-moment coefficients to become more positive; (2) the spoiler slot had no notable effect on the rolling-moment and yawing-moment characteristics but produced a positive increase in the spoiler hinge-moment coefficients at large spoiler deflections; (3) the effects produced by the individual modifications were additive when the various modifications were combined. In general, progressively decreasing the spoiler span by removing the segments from the inboard end of the spoiler caused a decrease in rolling effectiveness approximately proportional to the span of the segment.

WING FLAPS, SLOTTED & AILERONS↗

Static Longitudinal and Lateral Stability Characteristics at Low Speed of 45 Degree Sweptback-midwing Models Having Wings with an Aspect Ratio of 2, 4, or 6

Results are presented of tests conducted in the Langley stability tunnel to determine the effects of various components and combinations of components on the static longitudinal and lateral stability characteristics at low speed of a series of 45 degree sweptback-midwing-airplane configurations having wings with an aspect ratio of 2, 4, or 6. The tests were made at a dynamic pressure of 24.9 pounds per square foot which corresponds to a Mach number of 0.13 and Reynolds numbers of 1.00 x 10(exp 6), 0.71 x 10 (exp 6), and 0.58 x 10 (exp 6) based on the respective wing mean aerodynamic chords. The angle-of-attack range covered was from -4 degrees to 32 degrees and the sideslip angles used for the lateral-derivative tests were 5 degrees and -5 degrees. An increasing loss in tail contribution to directional stability both with increasing wing aspect ratio and increasing angle of attack was found to be a principal cause of all the complete models becoming directionally unstable in the high angle-of-attack range.

STABILITY, LONGITUDINAL - STATIC↗

A Flight Study of the Effects on Tracking Performance of Changes in the Lateral-oscillatory Characteristics of a Fighter Airplane

A study of the effects of variations in lateral-oscillatory characteristics on air-to-air tracking performance has been made, using a conventional, propeller-driven fighter airplane equipped with servo devices for varying these characteristics in flight. Tracking runs were made both in smooth air and in simulated rough air. The lateral-oscillation period, damping, and roll coupling were varied over wide ranges during the investigation.

GUSTS, TURBULENCE↗

Lateral ring metal elastic wheel absorbs shock loading

Lateral ring metal elastic wheel absorbs practically all shock loading when operated over extremely rough terrain and delivers only a negligible shock residue to associated suspension components. The wheel consists of a rigid aluminum assembly to which lateral titanium ring flexible elements with treads are attached.

Galan, L.↗

Initial operating experience with an aircraft simulator having extensive lateral motion

The flight simulation facility features an extensive cockpit motion system, emphasizing lateral motion for the simulation of lateral-directional control tasks. The motion capabilities of the simulator are briefly described, and the logic with which the motion drives are controlled to provide the most effective approximations of the motions of flight is discussed. Preliminary assessments of the effectiveness of these motions, in the simulation of large transport aircraft, are discussed.

Bray, R. S.↗

Effects of eccentricities and lateral pressure on the design of stiffened compression panels

An analysis for determining the effects of eccentricities and lateral pressure on the design of stiffened compression panels is presented. The four types of panel stiffeners considered are integral, zee, integral zee, and integral tee. Mass-strength curves, which give the mass of the panel necessary to carry a specified load, are given along with related design equations needed to calculate the cross-sectional dimensions of the minimum-mass-stiffened panel. The results of the study indicate that the proportions of the panels are geometrically similar to the proportions of panels designed for no eccentricity or lateral pressure, but no cross-sectional dimensions are greater, resulting in significantly increased mass. The analytical minimum-mass designs of zee-stiffened panels are compared with designs from experimentally derived charts. An assumed eccentricity of 0.001 times the length of the panel is used to correlate the analytical and experimental data. Good correlation between the experimentally derived and the analytical curves is obtained for the range of loading where materials yield governs the design. At lower loads the mass given by the analytical curve using this assumed eccentricity is greater than that given by the experimental results.

Giles, G. L.↗

Buckling of nearly cylindrical shells under lateral pressure.

The effect of slight meridional curvature on the buckling of shells subjected to an external constant directional lateral pressure is examined. A class of nearly cylindrical shells with constant meridional curvature, a central radius-to-thickness ratio of 500, and central rise-to-shell-length ratios varying from plus 5% to minus 5% is considered. A brief study is presented of the dependence of the critical lateral pressure on the meridional curvature and on the length and meridional edge restraint.

Cooper, P. A.↗

Applicability of a diffusion model to lateral transport in the terrestrial and lunar exospheres.

Kinetic theory is used to determine a series expansion of the vertical flux of particles in an exosphere in terms of time and space derivatives of particle concentration, exobase velocity, and temperature. For sufficiently large scale variations of these parameters in time and space, the series can be truncated to a form that is similar to a diffusion equation. Owing to this analogy, it is possible to unite the mathematical description of molecular diffusion, which governs thermospheric flow, and the corresponding exospheric equation by using effective transport coefficients which change smoothly with altitude through the transition from thermosphere to exosphere. A new definition of the exobase for lateral flow emerges from the analogy of exospheric and thermospheric diffusion, as the altitude where the horizontal mean free path length equals the mean horizontal extent of ballistic trajectories of the transported gas, as opposed to the scale height of the dominant gas which determines the exobase for escape. It is shown that the approximation of exospheric lateral flow as a diffusion process is applicable to global scale problems concerning terrestrial helium and heavier gases, and lunar gases heavier than helium.

Hodges, R. R., Jr.↗

Nonlinear response of plates subjected to inplane and lateral pressure pulses.

The nonlinear response of a rectangular plate exposed to a far-field sonic boom disturbance is studied. The plate is subjected to both lateral and in-plane disturbances. The lateral disturbance is in the form of an N-shaped pressure pulse, and the in-plane disturbance is represented by a sinusoidal pulse. The equations of motion are reduced to a set of nonlinear coupled ordinary differential equations using Galerkin's method. These equations are solved numerically using Hamming's (1959) modified predictor-corrector integration method. The effects of in-plane boundary conditions and in-plane inertia are investigated. The nonlinear results, when compared to the linear theory, serve to delineate the realm of validity of the linear theory.

Knapp, L. J.↗

Computed lateral power spectral density response of conventional and STOL airplanes to random atmospheric turbulence

A method of computing the power spectral densities of the lateral response of airplanes to random atmospheric turbulence was adapted to an electronic digital computer. By use of this program, the power spectral densities of the lateral roll, yaw, and sideslip angular displacement of several conventional and STOL airplanes were computed. The results show that for the conventional airplanes, the roll response is more prominent than that for yaw or sideslip response. For the STOL airplanes, on the other hand, the yaw and sideslip responses were larger than the roll response. The response frequency of the STOL airplanes generally is higher than that for the conventional airplanes. This combination of greater sensitivity of the STOL airplanes in yaw and sideslip and the frequency at which they occur could be a factor causing the poor riding qualities of this class of airplanes.

Lichtenstein, J. H.↗

Lateral conduction effects on heat-transfer data obtained with the phase-change paint technique

A computerized tool, CAPE, (Conduction Analysis Program using Eigenvalues) has been developed to account for lateral heat conduction in wind tunnel models in the data reduction of the phase-change paint technique. The tool also accounts for the effects of finite thickness (thin wings) and surface curvature. A special reduction procedure using just one time of melt is also possible on leading edges. A novel iterative numerical scheme was used, with discretized spatial coordinates but analytic integration in time, to solve the inverse conduction problem involved in the data reduction. A yes-no chart is provided which tells the test engineer when various corrections are large enough so that CAPE should be used. The accuracy of the phase-change paint technique in the presence of finite thickness and lateral conduction is also investigated.

Maise, G.↗

Differential equation of exospheric lateral transport and its application to terrestrial hydrogen

The differential equation description of exospheric lateral transport of Hodges and Johnson is reformulated to extend its utility to light gases. Accuracy of the revised equation is established by applying it to terrestrial hydrogen. The resulting global distributions for several static exobase models are shown to be essentially the same as those that have been computed by Quessette using an integral equation approach. The present theory is subsequently used to elucidate the effects of nonzero lateral flow, exobase rotation, and diurnal tidal winds on the hydrogen distribution. Finally it is shown that the differential equation of exospheric transport is analogous to a diffusion equation. Hence it is practical to consider exospheric transport as a continuation of thermospheric diffusion, a concept that alleviates the need for an artificial exobase dividing thermosphere and exosphere.

Hodges, R. R., Jr.↗

Wind Tunnel Generation of Sinusoidal Lateral and Longitudinal Gusts by Circulation of Twin Parallel Airfoils

A gust generator capable of producing sinusoidal lateral and longitudinal gusts was developed for the purpose of studying the gust response of a model rotor-propeller in a wind tunnel. The gust generator utilized harmonic circulation control of twin parallel airfoils to achieve the harmonic lift variation required for gust generation. The gust generator design, construction, and testing is described. Typical test results are presented in the form of lateral and longitudinal gust perturbation velocities as a function of generator reduced frequency.

Ham, N. D.↗

The effect of lateral controls in producing motion of an airplane as computed from wind-tunnel data

An analytical study of the lateral controllability of an airplane has been made in which both the static rolling and yawing moments supplied by the controls and the reactions due to the inherent stability of the airplane have been taken into account. A hypothetical average airplane, embodying the essential characteristics of both the wind tunnel models and the full size test airplanes, was assumed for the study. Computations made of forced rolling and yawing motions of an F-22 airplane caused by a sudden deflection of the ailerons were found to agree well with actual measurements of these motions. The conditions following instantaneous full deflections of the lateral control have been studied, and some attention has been devoted to the controlling of complete turn maneuvers.

Weick, F. E.↗

The influence of lateral stability on disturbed motions of an airplane with special reference to the motions produced by gusts

Disturbed lateral motions have been calculated for a hypothetical small airplane with various modifications of fin area and dihedral setting. The modifications of the airplane include changes of dihedral and changes of weathercock stability. Fin area and wing dihedral were found to be of primary importance in side gusts. It was found that the rolling action of the wing with as much as 5 deg dihedral was distinctly unfavorable, especially when the weathercock stability was small. It is pointed out that the greatest susceptibility to lateral disturbances lies in the inherent damping and coupling moments developed by the wing.

Jones, R. T.↗