Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “TUNNEL EFFECT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Effect of slot width on transition and noise attenuation of a sound shield panel for supersonic wind tunnels

The effect of slot width on transition and noise attenuation of a planar rod wall sound shield has been investigated at Mach 6. Boundary layer laminarization was obtained by induced suction through adjustable slots or gaps between the rods. Transition Reynolds numbers increased significantly with increasing gap width. The local mean flow field above the suction panel rod array was uniform. Important factors for design and performance of a supersonic wind-tunnel sound shield are rod diameter, gap-to-rod diameter ratio, surface finish of the rods, and leading-edge configuration.

Harvey, W. D.↗
NASA NTRS1982

Wind-tunnel investigation of effects of wing-leading-edge modifications on the high angle-of-attack characteristics of a T-tail low-wing general-aviation aircraft

Exploratory tests have been conducted in the NASA-Langley Research Center's 12-Foot Low-Speed wind Tunnel to evaluate the application of wing-leading-edge devices on the stall-departure and spin resistance characteristics of a 1/6-scale model of a T-tail general-aviation aircraft. The model was force tested with an internal strain-gauge balance to obtain aerodynamic data on the complete configuration and with a separate wing balance to obtain aerodynamic data on the outer portion of the wing. The addition of the outboard leading-edge droop eliminated the abrupt stall of the windtip and maintained or increased the resultant-force coefficient up to about alpha = 32 degrees. This change in slope of the resultant-force coefficient curve with angle of attack has been shown to be important for eliminating autorotation and for providing spin resistance.

White, E. R.↗
NASA NTRS1959

Wind-Tunnel Measurements of Effect of Dive-Recovery Flaps at Transonic Speeds on Models of a Seaplane and a Transport

The effects of wing-lower-surface dive-recovery flaps on the aero- dynamic characteristics of a transonic seaplane model and a transonic transport model having 40 deg swept wings have been investigated in the Langley 16-foot transonic tunnel. The seaplane model had a wing with an aspect ratio of 5.26, a taper ratio of 0.333, and NACA 63A series airfoil sections streamwise. The transport model had a wing with an aspect ratio of 8, a taper ratio of 0.3, and NACA 65A series airfoil sections perpendicular to the quarter-chord line. The effects of flap deflection, flap longitudinal location, and flap sweep were generally investigated for both horizontal-tail-on and horizontal-tail-off configurations. Model force and moment measurements were made for model angles of attack from -5 deg to 14 deg in the Mach number range from 0.70 to 1.075 at Reynolds numbers of 2.95 x 10(exp 6) to 4.35 x 10(exp 6). With proper longitudinal location, wing-lower-surface dive-recovery flaps produced lift and pitching-moment increments that increased with flap deflection. For the transport model a flap located aft on the wing proved to be more effective than one located more forward., both flaps having the same span and approximately the same deflection. For the seaplane model a high horizontal tail provided added effectiveness for the deflected-flap configuration.

Heath, Atwood R., Jr.↗
NASA NTRS1975

A wind-tunnel study of sea breeze effects

A wind-tunnel simulation of the diffusion patterns in a sea breeze has been attempted. No attempt was made to reproduce the recirculation that characterizes a sea breeze, but the results indicate that the low-level onshore flow was well simulated for neutral, stable, unstable, and elevated inversion conditions. Velocity, turbulence, shear stress, and temperature data were taken, and the spread of emissions from ground-level sources was investigated. Comparison is made with theoretical predictions by Inoue (1960) and with the open, countryside results of Pasquill. Agreement with the predictions by Inoue is good. The comparison with Pasquill's results shows that the wind-tunnel flows are shifted two categories towards more stable. The discrepancy may be explained as a lack of mesoscale turbulence in the wind tunnel.

Ogawa, Y.↗
NASA NTRS1987

Low-frequency rotational noise in closed-test-section wind tunnels

The effects of closed-section wind-tunnel walls on the sound field radiated from a helicopter rotor are investigated by means of numerical simulations, summarizing the findings reported by Mosher (1986). The techniques used to model the rotor and the test section (including geometry, wall absorption, and measurement location) are outlined, and the results are presented in extensive tables and graphs. It is found that first-harmonic acoustic measurements obtained in a hard-walled wind tunnel twice as wide as the rotor diameter do not accurately represent the free-field rotational noise, that the relationship between the sound-pressure levels in the wind tunnel and in the free field is complex, that multiple near-field measurements are needed to characterize the direct acoustic field of the rotor, and that absorptive linings are of little value in enlarging the accurate-measurement zone.

Mosher, Marianne↗
NASA NTRS1989

Tunnel and field effect carrier ballistics

Methods and apparatus for interacting carriers with a structure of matter employ an electrode for emitting said carriers at a distance from a surface of that structure, and cause such carriers to travel along ballistic trajectories inside that structure by providing along the mentioned distance a gap for performance of a process selected from the group of carrier tunneling and field emission and injecting carriers emitted by the mentioned electrode and that process ballistically into the structure through the gap and the mentioned surface. The carriers are collected or analyzed after their travel along ballistic trajectories in the structure of matter. Pertinent information on the inside of the structure is obtained by conducting inside that structure what conventionally would have been considered external ballistics, while performing the carrier-propelling internal ballistics conversely outside that structure.

Kaiser, William J.↗
NASA NTRS1974

The effect of wind tunnel wall interference on the performance of a fan-in-wing VTOL model

A fan-in-wing model with a 1.07-meter span was tested in seven different test sections with cross-sectional areas ranging from 2.2 sq meters to 265 sq meters. The data from the different test sections are compared both with and without correction for wall interference. The results demonstrate that extreme care must be used in interpreting uncorrected VTOL data since the wall interference may be so large as to invalidate even trends in the data. The wall interference is particularly large at the tail, a result which is in agreement with recently published comparisons of flight and large scale wind tunnel data for a propeller-driven deflected-slipstream configuration. The data verify the wall-interference theory even under conditions of extreme interference. A method yields reasonable estimates for the onset of Rae's minimum-speed limit. The rules for choosing model sizes to produce negligible wall effects are considerably in error and permit the use of excessively large models.

Heyson, H. H.↗
NASA NTRS2003

A Wind Tunnel Study of Icing Effects on a Business Jet Airfoil

Aerodynamic wind tunnel tests were conducted to study the effects of various ice accretions on the aerodynamic performance of a 36-inch chord, two-dimensional business jet airfoil. Eight different ice shape configurations were tested. Four were castings made from molds of ice shapes accreted in an icing wind tunnel. Two were made using computationally smoothed tracings of two of the ice shapes accreted in the icing tunnel. These smoothed profiles were then extended in the spanwise direction to form a two-dimensional ice shape. The final two configurations were formed by applying grit to the smoothed ice shapes. The ice shapes resulted in as much as 48% reduction in maximum lift coefficient from that of the clean airfoil. Large increases in drag and changes in pitching moment were also observed. The castings and their corresponding smoothed counterparts yielded similar results. Little change in performance was observed with the addition of grit to the smoothed ice shapes. Changes in the Reynolds number (from 3 x 10(exp 6) to 10.5 x 10(exp 6) and Mach number (from 0.12 to 0.28) did not significantly affect the iced-airfoil performance coefficients.

Addy, Harold E., Jr.↗
NASA NTRS2020

Effect of Atmospheric Wind and Upstream Buildings on the Flow Quality in the Test Section of the 80-by 120-Foot Wind Tunnel

The effect of upwind buildings on flow quality in the test section of the 80- by-120-Foot Wind Tunnel housed at the National Full-Scale Aerodynamics Complex at NASA Ames Research Center was modeled at reduced scale. A 1/50th-scale model of the 80x120 leg was placed on the turntable in the test section of the full-scale NFAC 80x120 wind tunnel. Ambient wind was simulated by means of a fixed linear array of 6 blowers mounted upstream of the NFAC turntable. NFAC turntable rotation was used to change ambient (atmospheric) wind direction. Models of existing upwind buildings and the planned Google Campus buildings (Googleplex) were constructed at 1/50th-scale. In addition, a variety of upwind blockage conditions were studied, using rectangular bodies, to simulate either a 2D or 3D blockage directly ahead of the inlet. Computer-controlled surveys of test section flow quality were measured using a Cobra probe to provide all three orthogonal velocity components. Surprisingly, measurements indicate that test section flow quality will be unaffected or slightly improved by the upwind presence of the Google Campus. A possible explanation is discussed.

open-circuit wind tunnel↗
NASA NTRS1982

Jet V/STOL wind-tunnel simulation and groundplane effects

The pretest preparation necessary to define the objectives of an appropriate investigation into the jet V/STOL wind tunnel simulation and ground plane effects were examined. Low speed wind tunnel testing of V/STOL aircraft concepts to determine the aerodynamic propulsion interaction effects during the transition between hover and wingborne flight is a necessary step in the development cycle of this type of aircraft. Powered models are normally used to determine the aerodynamic performance characteristics. Several factors which influence the selection of the model concept and the engine simulator are discussed. Some of the test techniques important for this class of aircraft model are examined. Wind tunnel wall effects important to this aircraft testing with special emphasis on groundplane effects are reviewed.

Margason, R. J.↗
DOE OSTI2021

Heavy-ion-induced displacement damage effects in magnetic tunnel junctions with perpendicular anisotropy

Here, we evaluate the resilience of CoFeB/MgO/CoFeB magnetic tunnel junctions (MTJs) with perpendicular magnetic anisotropy to displacement damage induced by heavy ion irradiation. MTJs were exposed to 3 MeV Ta 2+ ions at different levels of ion beam fluence spanning five orders of magnitude. The devices remained insensitive to beam fluences up to 10 11 ions/cm 2 , beyond which a gradual degradation in the device magnetoresistance, coercive magnetic field, and spin-transfer-torque switching voltage were observed, ending with a complete loss of magnetoresistance at very high levels of displacement damage (>0.035 displacements per atom). The loss of magnetoresistance is attributed to structural damage at the MgO interfaces, which allows electrons to scatter among the propagating modes within the tunnel barrier and reduces the net spin polarization. Ion-induced damage to the interface also reduces the perpendicular magnetic anisotropy. This study clarifies the displacement damage thresholds that lead to significant irreversible changes in the characteristics of spin-transfer-torque magnetic random access memory (STT-MRAM) and elucidates the physical mechanisms underlying the deterioration in device properties.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗