Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Re”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS2017

Autogenic-Feedback Training Exercise (AFTE) Mitigates the Effects of Spatial Disorientation to Simulated Orion Spacecraft Re-Entry: Individual Differences

NASA has identified a potential risk of spatial disorientation to future astronauts during re-entry of the proposed Orion spacecraft. The purpose of this study was to determine if a 6-hour physiological training procedure, Autogenic-Feedback Training Exercise (AFTE), can mitigate these effects. Twenty subjects were assigned to two groups (AFTE and Control) matched for motion sickness susceptibility and gender. All subjects received a standard rotating chair test to determine motion sickness susceptibility; three training sessions on a manual performance task; and four exposures to a simulated Orion re-entry test in the rotating chair. Treatment subjects were given two hours of AFTE training before each Orion test. A diagnostic scale was used to evaluate motion sickness symptom severity. Results showed that 2 hours of AFTE significantly reduced motion sickness symptoms during the second Orion test. AFTE subjects were able to maintain lower heart rates and skin conductance levels and other responses than the control group subjects during subsequent tests. Trends show that performance was less degraded for AFTE subjects. The results of this study indicate that astronauts could benefit from receiving at least 2 hours of preflight AFTE. In addition, flight crews could benefit further by practicing physiologic self-regulation using mobile devices.

human performance↗
NASA NTRS2018

Characterization and Analysis of Aerosol Particle Retention and Re-aerosolization from Hook-and-Loop Fasteners on the International Space Station

The extensive use of hook and loop fasteners aboard the International Space Station warrants careful examination of its contribution to indoor air pollution, as its fine fibers catch aerosol particles then re-aerosolize them upon being pulled apart, often within the breathing zone of astronauts. This problem is expanded by the lack of gravity because airborne particles larger than 1 micrometer do not settle. Instead these aerosols remain in the air until removed by filtration. Aerosol inhalation can have negative health effects, ranging from acute symptoms to long-term consequences, depending on particle sizes, mass and material composition. This study characterizes the size distribution, number concentration, and mass concentration of re-aerosolized debris generated by hook and loop fasteners taken from the stray light cover of the Microgravity Science Glovebox in the U.S. Laboratory of the ISS to understand the extent of its impact on air quality. Transmission electron microscopy (TEM) and scanning transmission electron microscopy (STEM), in conjunction with energy dispersive spectroscopy (EDS) were also used to characterize the morphology and composition of the particles.

Boyajian, Barbara↗
NASA NTRS2020

New Insights into the Chemical Composition of Five Oort Cloud Comets After Re-analysis of their Infrared Spectra

We present revised results for the main molecular species in five Oort Cloud (OC) comets observed with NIRSPEC at the Keck Observatory between 1999 and 2012 (C/1999 S4 (LINEAR), C/2001 A2 (LINEAR), C/2007 W1 (Boattini), C/2012 F6 (Lemmon), and C/2012 S1 (ISON)). The re-evaluation of these data shows the improvement of results in some of the datasets, in particular for comets observed and analyzed before the advent of new and revised fluorescence models and terrestrial retrieval methods introduced since 2011. We observe significant improvements in the resulting rotational temperatures and production rates for all species, and in mixing ratios of minor species (relative to water). The re-analysis also allowed us to quantify species not analyzed previously, mostly due to the lack of molecular models (e.g., ammonia and formaldehyde). We note, however, that the improvement of these revised values is less substantial for comets observed (and/or analyzed) since 2010.

Manuela Lippi↗
NASA NTRS2022

Sub-Scale Adsorption and Compression CO2 Removal System Re-Design

This system is a re-design of NASA’s previously developed Thermally Coupled Temperature Swing Adsorption and Compression (TC-TSAC) systems, providing an air revitalization alternative to assist in the agency’s Moon to Mars exploration objectives. The system consists of two half-cycles whereby packed beds of regenerable bulk sorbents and heat cycles simultaneously adsorb and compress carbon dioxide. The team designed the adsorption and compression beds in a cylindrical shape to maximize airflow. A desiccant bed helps lower humidity and the sorbent Zeolite 13X is used to capture carbon dioxide. Both are monitored by sensors. There is a custom heater within the system that lies in the adsorption bed to regenerate the sorbent, and there is a cooler around the compression bed. The system produced for NASA modeling, experimental test results, and operational results to be able to be scaled up to 4kg CO2 removal per day. The system was found to be 1/16 scale for 1kg of CO2 removal per day. The adsorption and desorption processes were successful, however issues with making the compression bed airtight resulted in an inability to demonstrate full compression. The team provided design suggestions and alternative solutions given these results. This paper describes the final design, fabrication, assembly, and testing of the TC-TSAC re-design.

Joaquin Pesqueira↗
NASA NTRS2022

Terrestrial Exospheric Dayside H-density Profile at 3 - 15 RE from UVIS/HDAC and TWINS Lyman-alpha Data Combined

Terrestrial ecliptic dayside observations of the exospheric Lyman-α column intensity between 3–15 Earth radii (RE) by UVIS/HDAC (UVIS – ultraviolet imaging spectrograph; HDAC – hydrogen-deuterium absorption cell) Lyman-α photometer at CASSINI have been analyzed to derive the neutral exospheric H-density profile at the Earth’s ecliptic dayside in this radial range. The data were measured during CASSINI’s swing-by maneuver at the Earth on 18 August 1999 and are published by Werner et al. (2004). In this study the dayside HDAC Lyman-α observations published by Werner et al. (2004) are compared to calculated Lyman-α intensities based on the 3D H-density model derived from TWINS (Two Wide-angle Imaging Neutral-atom Spectrometers) Lyman-α observations between 2008–2010 (Zoennchen et al., 2015). It was found that both Lyman-α profiles show a very similar radial dependence in particular between 3–8RE. Between 3.0–5.5RE impact distance Lyman-α observations of both TWINS and UVIS/HDAC exist at the ecliptic dayside. In this overlapping region the cross-calibration of the HDAC profile against the calculated TWINS profile was done, assuming that the exosphere there was similar for both due to comparable space weather conditions. As a result of the cross-calibration the conversion factor between counts per second and rayleigh, fc = 3.285 counts s−1R−1, is determined for these HDAC observations. Using this factor, the radial H-density profile for the Earth’s ecliptic dayside was derived from the UVIS/HDAC observations, which constrained the neutral H density there at 10RE to a value of 35 cm-3. Furthermore, a faster radial H-density decrease was found at distances above 8RE (≈r−2.37) compared to the lower distances of 3–7RE (≈r−2.37). This increased loss of neutral H above 8RE might indicate a higher rate of H ionization in the vicinity of the magnetopause at 9–11RE (near subsolar point) and beyond, because of increasing charge exchange interactions of exospheric H atoms with solar wind ions outside the magnetosphere.

Jochen H Zoennchen↗
NASA NTRS2022

Re-Evaluation of Low Cloud Amount Relationships With Lower-Tropospheric Stability and Estimated Inversion Strength

Lower-tropospheric stability (LTS) and estimated inversion strength (EIS) have a widely accepted relationship with low cloud amount and are key observational foundations for understanding and modeling low-level stratiform clouds. Using the updated surface-based and satellite cloud data, we find that low cloud amount is not as strongly correlated with LTS, and not as sensitive to LTS, as established in the past. EIS does not provide a stronger correlation with low cloud amount than LTS over all eight regions (including the midlatitudes). Further analyzing the relationships between LTS and EIS with different types of low clouds, we find that there is a strong correlation of LTS and EIS with stratocumulus only. This explains the weaker correlation of low cloud fraction (including cumulus, stratocumulus, and stratus) to both LTS and EIS. These results also suggest the need to re-evaluate these relationships in Earth system models. Plain Language Summary: Low-level clouds play an important role in the global radiation budget. Low cloud amount has two established linear relationships with lower-tropospheric stability (LTS) and estimated inversion strength (ETS). These two relationships are re-evaluated here using three separate observational cloud and two reanalysis datasets for three distinct but overlapping time periods. The analysis shows that the strength of the LTS and ETS relationships with low cloud amount varies, depending on the cloud data used. They have a strong relationship with stratocumulus cloud amount only.

Lauren Cutler↗
NASA NTRS1994

Re-Engineering the Multimission Command System at the Jet Propulsion Laboratory

This paper will discuss the design and implementation of the command software, especially trade-offs and lessons learned from practical operational use in JPL's Advanced Multimission Operations System.The command system provides an advanced multimission environment for secure, concurrent commanding of multiple spacecraft. The lessons learned have resulted in a re-engineering of the command system, especially in its user interface and new automation capabilities. This paper will also discuss new development work including a multimission command database toolkit, a universal command translator for sequencing and real-time commands, and incorporation of telecommand capabilities for new missions.

re-engineering↗
NASA NTRS1961

ANALYSIS OF QUARTZ AND TEFLON SHIELDS FOR A PARTICULAR RE-ENTRY MISSION

The transient performance of ablation type heat protection shields is treated herein for the surface of a vehicle returning from outer space to the earth. The vehicle weighs 8640 kg, has a ballistic factor of 500 lb/ft2, re-enters with a speed of 11 km/sec at 120 km altitude, has a lift over drag ratio of -0.5, and is subjected to a maximum deceleration of 7.7 times the gravity constant. By use of well-known equations for the heat transfer and the mass transfer at a heated surface, a numerical calculation method is derived which, for the investigated ablation processes, yields exact transient solutions of the fundamental system of partial differential equations. The method is applied to various quartz shields and to one Teflon shield, which all evaporate so readily under the conditions of the problem at hand that practically no flow of molten shield material exists. The solutions also show comparatively small temperature changes parallel to the surface. The results show that the nose of the vehicle is cooled predominantly by the evaporation of the quartz or the Teflon; the rest of the vehicle's surface is cooled by radiation of the quartz or evaporation of the Teflon. The large mass transfer effects on the nose of the vehicle are detrimental since the resulting low surface temperatures prevent the radiative heat transfer out of the shield, which does not involve any mass loss, from being the desirable governing cooling factor.

ABLATING MATERIAL↗
NASA NTRS1968

Propulsive re-entry aerodynamics Interim report, 1 Jun. 1967 - 1 Jun. 1968

This report discusses the progress accomplished during the first year of a two-year contract to study Propulsive Re-Entry Aerodynamics. Analytical methods were developed during the first year to predict the flow field in the immediate vicinity of a planetary entry system composed of an aeroshell with a single retrorocket which exhausts into a subsonic or supersonic counterflowing planetary atmosphere. In the second year a digital computer program will be developed for the analytical solutions, and the analytical model will be tested by performing an experimental test program and comparing the experimental results with the analytical predictions. The analytical investigation considers the flow field due to a single supersonic retrorocket exhausting from an aeroshell into oncoming subsonic, transonic, or supersonic streams in the large thrusting coefficient regime, 0.5 < C(sub T) = T/q(sub ∞) A(sub m) < 15, which is the range of thrusting coefficients encountered during the terminal landing phase for planetary landing on Mars or Venus. Analyses are provided for all the geometrical features of the flow field such as the location of the terminal shock, jet boundary, and the profile for the interface between the jet and atmospheric gases. In addition, analyses are developed which describe the growth of the mixing layers along the interface and at the edge of the jet boundary and dead-air region and the reattachment of the shear layer to the aeroshell or the recompression of the shear layer in wake type flow. A comprehensive discussion of the experimental wind tunnel test program to be accomplished in Phase II is presented.

Philip O Jarvinen↗