Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Ore”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Creep-fatigue of low cobalt superalloys

Testing for the low cycle fatigue and creep fatigue resistance of superalloys containing reduced amounts of cobalt is described. The test matrix employed involves a single high temperature appropriate for each alloy. A single total strain range, again appropriate to each alloy, is used in conducting strain controlled, low cycle, creep fatigue tests. The total strain range is based upon the level of straining that results in about 10,000 cycles to failure in a high frequency (0.5 Hz) continuous strain-cycling fatigue test. No creep is expected to occur in such a test. To bracket the influence of creep on the cyclic strain resistance, strain hold time tests with ore minute hold periods are introduced. One test per composition is conducted with the hold period in tension only, one in compression only, and one in both tension and compression. The test temperatures, alloys, and their cobalt compositions that are under study are given.

Halford, G. R.↗
NASA NTRS1982

Measurement of interstage fluid-annulus dynamical properties

The work described in this paper is part of an Electric Power Research Institute sponsored effort to improve rotor vibrational performance on power plant feed water pumps. A major objective of this effort is to reduce vibration levels by devising inter-stage sealing configurations with optimized damping capacity, realizing that the typical multi-stage centrifugal pump has several ore inter-stage fluid annuli than it has journal bearings. Also, the fluid annuli are distributed between the journal bearings where vibration levels are highest and can therefore be 'exercised' more as dampers than can the bearings. Described in this paper is a test apparatus which has been built to experimentally determine fluid-annulus dynamical coefficients for various configurations of inter-stage sealing geometry.

Adams, M. L.↗
NASA NTRS1981

Remote sensing and uranium exploration at Lisbon Valley, Utah

As part of the joint NASA-Geosat uranium test case program, aircraft-acquired multispectral scanner data are used to investigate the distribution of bleaching in Windgate sandstone exposed in Lisbon Valley anticline, Utah. It is noted that all of the large ore bodies contained in lower Chinle Triassic age or Cutler Permian age strata in this area lie beneath or closely adjacent to such bleached outcrops. The geographic coincidences reported here are seen as inviting renewed interest in speculation of a causal relation between occurrences of Mississippian-Pennsylvanian oil and gas in this area and of Triassic uranium accumulation and rock bleaching.

Conel, J. E.↗
NASA NTRS1982

Materials processing in space

Processing-refining of raw materials from extraterrestrial sources is detailed for a space materials handling facility. The discussion is constrained to those steps necessary to separate desired components from raw or altered input ores, semi-purified feedstocks, or process scrap and convert the material into elements, alloys, and consumables. The materials are regarded as originating from dead satellites and boosters, lunar materials, and asteroids. Strong attention will be given to recycling reagent substances to avoid the necessity of transporting replacements. It is assumed that since no aqueous processes exist on the moon, the distribution of minerals will be homogeneous. The processing-refining scenario will include hydrochemical, pyrochemical, electrochemical, and physical techniques selected for the output mass rate/unit plant mass ratio. Flow charts of the various materials processing operations which could be performed with lunar materials are provided, noting the necessity of delivering several alloying elements from the earth due to scarcities on the moon.

Waldron, R. D.↗
NASA NTRS1983

Structure of the Saint Francois Mountains and surrounding lead belt, south east Missouri: Inferences from thermal IR and other data sets

Several digital data sets were registered to a common base map for southern Missouri. These registered data sets were examined in an attempt to improve our understanding of the crustal structure and the relationships between structure and Pb-Zn-Cu, Fe, Mn, and Ba ores in the area. Data included land station reading of gravity, geologic data, and Heat Capacity Mapping Mission (HCMM) images. The HCMM day infrared (IR) images of Missouri displayed linear features, which parallel a newly discovered NW-SE trending Bouguer gravity low. The structural pattern over the gravity low suggests vertical uplift of the low density crust via isostatic readjustment and consequent fracturing of the Paleozoic sedimentary cover. The presence of a gravity low is interesting because rifts are often sites of extensive mineralization. The HCMM thermal data were also examined in conjunction with digital topography, land use, and LANDSAT MSS data to understand the phenomena that produce linears on the HCMM day IR images. Finally, the kinds of information that can be extracted from day-night IR pairs are discussed.

Arvidson, R. E.↗
NASA NTRS1983

Application of thematic mapper-type data over a porphyry-molybdenum deposit in Colorado

The objective of the study was to evaluate the utility of thematic mapper data as a source of geologically useful information for mountainous areas of varying vegetation density. Much of the processing was done in an a priori manner without prior ground-based information. This approach resulted in a successfull mapping of the alteration associated with the Mt. Emmons molybdenum ore body as well as several other hydrothermal systems. Supervised classification produced a vegetation map at least as accurate as the mapping done for the environmental impact statement. Principal components were used to map zones of general, subtle alteration and to separate hematitically stained rock from staining associated with hydrothermal activity. Decorrelation color composites were found to be useful field mapping aids, easily delineating many lithologies and vegetation classes of interest. The factors restricting the interpretability and computer manipulation of the data are examined.

Rickman, D. L.↗
NASA NTRS1985

Purifying Aluminum by Vacuum Distillation

Proposed method for purifying aluminum employs one-step vacuum distillation. Raw material for process impure aluminum produced in electrolysis of aluminum ore. Impure metal melted in vacuum. Since aluminum has much higher vapor pressure than other constituents, boils off and condenses on nearby cold surfaces in proportions much greater than those of other constituents.

Du Fresne, E. R.↗
NASA NTRS1986

The stratigraphy of the Steep Rock Group, N.W. Ontario, with evidence of a major unconformity

The Steep Rock Group is exposed 6 km north of Atikokan, 200 km west of Thunder Bay. It is situated on the southern margin of the Wabigoon Belt of the Archaean Superior Province, N. W. Ontario. Reinvestigation of the geology of the Group has shown that the Group lies unconformably on the Tonalite Complex to the east. This unconformity has been previously suspected, from regional and ine mapping but no conclusive outcrop evidence for its existence has as yet been published. The strike of the group, comprised of Basal Conglomerate, Carbonate Member, Ore Zone and Ashrock is generally north-northwest dipping steeply to the southwest. Of the 7 contacts between the Steep Rock Group and the Tonalite Complex, 3 expose the unconformity (The Headland, S. Roberts Pit, Trueman Point), and 4 are faulted. These three outcrops demonstrate unequivocally that the Steep Rock group was laid down unconformably on the underlying Tonalite Complex, which is circa 3 Ga old.

Wilks, M. E.↗
NASA NTRS1985

Toward a spartan scenario for use of lunar materials

The present discussion has the objective to identify those raw materials for use in manufacture which can most readily be obtained from lunar materials as they are currently known. The state of lunar exploration is incomplete, and concentrated ores may exist for elements now regarded as rare or dispersed. This paper provides a description of minimum possibilities, based on the notion of making do with the least feasible amounts of separation and processing. The discussion is limited to the most abundant materials observed at lunar sites visited by the Apollo missions. The ground rules for use of lunar products are considered along with the tools required to carry out any significant production of raw materials for manufacture, and lunar surface conditions. Readily available materials include unprocessed regolith and minimally processed regolith. A few examples of processing methods are provided, giving attention to thermal release of gases, hydrogen reduction of ilmenite, carbonyl processing, electrolysis of molten silicate, and destructive distillation.

Haskin, L. A.↗
NASA NTRS1987

FORTRAN Algorithm for Image Processing

FORTRAN computer algorithm containing various image-processing analysis and enhancement functions developed. Algorithm developed specifically to process images of developmental heat-engine materials obtained with sophisticated nondestructive evaluation instruments. Applications of program include scientific, industrial, and biomedical imaging for studies of flaws in materials, analyses of steel and ores, and pathology.

Roth, Don J.↗
NASA NTRS1986

Automation of preparation of nonmetallic samples for analysis by atomic absorption and inductively coupled plasma spectrometry

For a rapid preparation of solutions intended for analysis by inductively coupled plasma emission spectrometry or atomic absorption spectrometry, an automatic device called Plasmasol was developed. This apparatus used the property of nonwettability of glassy C to fuse the sample in an appropriate flux. The sample-flux mixture is placed in a composite crucible, then heated at high temperature, swirled until full dissolution is achieved, and then poured into a water-filled beaker. After acid addition, dissolution of the melt, and filling to the mark, the solution is ready for analysis. The analytical results obtained, either for oxide samples or for prereduced iron ores show that the solutions prepared with this device are undistinguished from those obtained by manual dissolutions done by acid digestion or by high temperature fusion. Preparation reproducibility and analytical tests illustrate the performance of Plasmasol.

Wittmann, A.↗
NASA NTRS1987

Potential benefits of magnetic suspension and balance systems

The potential of Magnetic Suspension and Balance Systems (MSBS) to improve conventional wind tunnel testing techniques is discussed. Topics include: elimination of model geometry distortion and support interference to improve the measurement accuracy of aerodynamic coefficients; removal of testing restrictions due to supports; improved dynamic stability data; and stores separation testing. Substantial increases in wind tunnel productivity are anticipated due to the coalescence of these improvements. Specific improvements in testing methods for missiles, helicopters, fighter aircraft, twin fuselage transports and bombers, state separation, water tunnels, and automobiles are also forecast. In a more speculative vein, new wind tunnel test techniques are envisioned as a result of applying MSBS, including free-flight computer trajectories in the test section, pilot-in-the-loop and designer-in-the-loop testing, shipboard missile launch simulation, and optimization of hybrid hypersonic configurations. Also addressed are potential applications of MSBS to such diverse technologies as medical research and practice, industrial robotics, space weaponry, and ore processing in space.

Lawing, Pierce L.↗
NASA NTRS1987

Gossans on Mars: Spectral features attributed to jarosite

Jarosites, which are present in terrestrial gossans capping oxidized sulfides associated with mafic igneous rocks, may also be present in Martian regolith. Spectral characteristics of jarosites are displayed in remote sensed reflectance spectra of bright regions of Mars surface. The occurrence of jarosite in the regolith would imply that acidic permafrost and sulfide ores exist beneath the surface of Mars.

Burns, Roger G.↗
NASA NTRS1987

Electrochemical generation of useful chemical species from lunar materials

A high temperature electrolytic cell which simultaneously generates oxygen at the anode and liquid alkali metals at the cathode is electrochemically characterized. The electrolytic technology being investigated utilizes the oxygen vacancy conducting solid electrolyte, yttria stabilized zirconia, which effectively separates the oxygen evolving (at La0.89Sr0.10MnO3) and alkali metal (Li, Na) reducing (from a molten salt at either Pt or FeSi2) half cell reactions. In the finally engineered cell liquid alkali metal would be continuously removed from the cathode compartment and used as an effective reductant for the direct thermochemical refining of lunar ores to their metallic state with simultaneous oxidation of the alkali metal to its oxide. The alkali metal oxide would then be reintroduced into the electrolytic cell to complete the overall system cycle.

Sammells, Anthony F.↗
NASA NTRS1988

The theory of flotation

A brief summary of the fundamentals of the Linear theory of flotation is given. The theory by no means contradicts the previous Laminar theory or even the thermodynamics (Wark-Siedler), rather it is a refinement of the known Hardy-Langmuir-Harkin conceptions for the case when there are not two phases and phase boundaries, but rather three phases and corresponding phase boundary edges. The appearance of such three-phase boundaries (ore, water, air) is characteristic for modern flotation methods.

Ostwald, Wolfgang↗
NASA NTRS1988

Assessment of lunar sources of He-3 for use on earth

As a gross measure of the economics of mining lunar sources of He-3, the energy densities (GJ/ton) of lunar soils were compared with the energy densities of various existing and future terrestrial sources of energy. On this basis, only the very richest lunar ores appear competitive with coal. Future lunar exploration might emphasize identification of lunar soils having higher concentrations of He-3.

English, Robert E.↗
NASA NTRS1988

Geochemistry of amphibolites from the Kolar Schist Belt

How the Nd isotope data suggest that the amphibolites from the schist belt were derived from long-term depleted mantle sources at about 2.7 Ga is described. Trace element and Pb isotope data from the amphibolites also suggest that the sources for the amphibolites on the western and eastern sides of the narrow schist belt were derived from different sources. The Pb data from one outcrop of the central tholeiitic amphibolites lies on a 2.7 Ga isochron with a low model. The other amphibolites (W komatiitic, E komatiitic, and E tholeiitic) do not define isochrons, but suggest that they were derived from sources with distinct histories of U/Pb. There is some suggestion that the E komatiitic amphibolites may have been contaminated by fluids carrying Pb from a long-term, high U/Pb source, such as the old granitic crust on the west side of the schist belt. This is consistent with published galena Pb isotope data from the ore lodes within the belt, which also show a history of long-term U/Pb enrichment.

Balakrishnan, S.↗