Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “HoPS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

Dielectric properties of 'diamondlike' carbon prepared by RF plasma deposition

Metal-carbon-metal structures were fabricated using either gold or aluminum evaporated electrodes and RF plasma (methane) deposited 'diamondlike' carbon films. Alternating-current conductance and capacitance versus voltage and frequency (10 Hz to 13 MHz) data were taken to determine the dielectric properties of these films. Conductance versus frequency data fit a generalized power law, consistent with both dc and hopping conduction components. The capacitance versus frequency data are well matched to the conductance versus frequency data, as predicted by a Kramers-Kronig analysis. The dielectric loss tangent is nearly constant at 0.5 to 1.0 percent over the frequency range from 1 to 100 kHz. The dc resistivity is above 10 to the 13th ohm cm, and the dc breakdown strength is above 8 x 10 to the 6th V/cm is properly prepared samples.

Lamb, J. D.↗

Performance of a normalized energy metric without jammer state information for an FH/MFSK system in worst case partial band jamming

For a frequency-hopped noncoherent MFSK communication system without jammer state information (JSI) in a worst case partial band jamming environment, it is well known that the use of a conventional unquantized metric results in very poor performance. In this paper, a 'normalized' unquantized energy metric is suggested for such a system. It is shown that with this metric, one can save 2-3 dB in required signal energy over the system with hard decision metric without JSI for the same desired performance. When this very robust metric is compared to the conventional unquantized energy metric with JSI, the loss in required signal energy is shown to be small. Thus, the use of this normalized metric provides performance comparable to systems for which JSI is known. Cutoff rate and bit error rate with dual-k coding are used for the performance measures.

Lee, P. J.↗

Electrical measurements in the atmosphere and the ionosphere over an active thunderstorm. I - Campaign overview and initial ionospheric results

The first simultaneous electric field observations performed in the ionosphere and atmosphere over an active nighttime thunderstorm are reported here. In the stratosphere, typical storm-related dc electric fields were detected from a horizontal distance of about 100 km, and transient electric fields due to lightning were measured at several different altitudes. In the ionosphere and mesosphere, lightning-induced transient electric fields in the range of tens of millivolts per meter were detected with rise times at least as fast as 0.2 ms and typical duration of 10-20 ms. The transients had significant components parallel to the magnetic field at 150 km altitude. This implies that either considerable Joule heating occurs or a collective instability is present because of the high drift velocities induced by the transient electric fields. Copious numbers of whistlers were generated by the storm and were detected above but not below the base of the ionosphere. The outline of a new model for direct whistler wave generation over an active thunderstorm is presented based on these observations. The intensity of the observed two-hop whistlers implies that they were amplified along their propagation path and suggests that particles were precipitated in both hemispheres.

Kelley, M. C.↗

Strategies for FH/MFSK signaling with diversity in worst-case partial-band noise

Optimum diversity and worst-case partial-band noise jamming conditions have been derived for noncoherent energy detection of frequency-hopped (FH) M-ary frequency-shift keyed (MFSK) signals using a soft-chip decision suboptimum linear combining metric with perfect jamming-state side information. However, the assumption implicit in previous publications is that the error is first maximized over the jammer's partial-band duty factor for arbitrary diversity, and the result is then minimized over the amount of diversity. This paper shows that if the order of optimization is reversed, different conditions and performance are produced; that is, the previous solution is not a saddlepoint. This introduces some game-theoretic considerations for the communicator and the jammer, the risks and advantages of which are explored.

Levitt, B. K.↗

FH/MFSK performance in multitone jamming

The performance of frequency-hopped (FH) M-ary frequency-shift keyed (MFSK) signals in partial-band noise as analyzed in the open literature. The previous research is extended to the usually more effective class of multitone jamming. Some objectives researched are: (1) To categorize several different multitone jamming strategies; (2) To analyze the performance of FH/MSFK signaling, both uncoded with diversity, assuming a noncoherent energy detection metric with linear combining and perfect jamming state side information, in the presence of worst case interference for each of these multitone categories; and (3) To compare the effectiveness of the various multitone jamming techniques, and contrast the results with the partial band noise jamming case.

Levitt, B. K.↗

High-temperature thermoelectric energy conversion. II - Materials survey

The current status of materials research for high-temperature thermoelectric energy conversion is reviewed. Two general classes of materials show promise for high temperature figure of merit (Z) values, viz, the rare-earth chalcogenides and the boron-rich borides. The electronic transport properties of the rare-earth chalcogenides are explicable on the basis of degenerate or partially degenerate n-type semiconductors. Boron and boron-rich borides exhibit p-type hopping conductivity, with detailed explanations proposed for the transport differing from compound to compound. Some discussion is presented on the reasons for the low thermal conductivities in these materials. Also, ZTs greater than one appear to have been realized at high temperature in many of these compounds.

Wood, C.↗

Morphological evidence of mechanoreceptive gravity perception in a water flea - Daphnia magna

Hair-like structures or setae located in the basal membrane of the swimming antennae of the water flea, D. magna, were observed by scanning electron microscopy and compared to mechanoreceptors in the Higher Order Crustacea. Similarities in anatomy, size, attachment, number, length, and orientation support the hypothesis that the setae are rheoceptive mechanoreceptors which mediate gravity perception through deflection by water currents during the sink phase of hop-and-sink swimming behavior.

Meyers, D. G.↗

The polar caps

According to the most common definition, the 'polar cap' is the region bounded by the average or statistical auroral oval. Studies of the effects of the interplanetary magnetic field (IMF) on various upper atmospheric phenomena are reviewed. The Antarctic region and the Arctic region represent an area for such investigations. Particular attention is given in this paper to those observations in the highest latitude region which provide some information concerning corresponding changes of the internal structure of the magnetosphere. A definition and working definition of the polar cap are considered along with the IMF and magnetospheric models, the entry of solar energetic electrons, statistical studies regarding the aurora, individual events, polar cap arcs, the cusp aurora, auroral electron precipitation, convection, ionospheric currents and field-aligned currents, the ionosphere, the thermosphere, polar rain, polar wind, and hopping motions of heavy ions.

Akasofu, S.-I.↗

Status of NTD Ge bolometer material and devices

The first IR Detector Technology Workshop took place at NASA Ames Research Center on July 12 and 13, 1983. The conclusions presented at that meeting are still valid. More was learned about the physics of hopping conduction at very low temperatures which will be important for bolometer design and operation at ever decreasing temperatures. Resistivity measurements were extended down to 50 mK. At such low temperatures, precise knowledge of the neutron capture cross sections sigma (sub n) of the various Ge isotopes is critical if one is to make an accurate prediction of the dopant concentrations and compensation, and therefore resistivity, that will result from a given irradiation. An empirical approach for obtaining the desired resistivity material is described and the process of conducting a set of experiments which will improve the knowledge of the effective sigma (sub n) values for a given location in a particular reactor is discussed. A wider range of NTD Ge samples is now available. Noise measurements on bolometers with ion implanted contacts show the no 1/f noise component appears down to 1 Hz and probably lower.

Haller, E. E.↗

Advanced space communications architecture study. Volume 2: Technical report

The technical feasibility and economic viability of satellite system architectures that are suitable for customer premise service (CPS) communications are investigated. System evaluation is performed at 30/20 GHz (Ka-band); however, the system architectures examined are equally applicable to 14/11 GHz (Ku-band). Emphasis is placed on systems that permit low-cost user terminals. Frequency division multiple access (FDMA) is used on the uplink, with typically 10,000 simultaneous accesses per satellite, each of 64 kbps. Bulk demodulators onboard the satellite, in combination with a baseband multiplexer, convert the many narrowband uplink signals into a small number of wideband data streams for downlink transmission. Single-hop network interconnectivity is accomplished via downlink scanning beams. Each satellite is estimated to weigh 5600 lb and consume 6850W of power; the corresponding payload totals are 1000 lb and 5000 W. Nonrecurring satellite cost is estimated at $110 million, with the first-unit cost at $113 million. In large quantities, the user terminal cost estimate is $25,000. For an assumed traffic profile, the required system revenue has been computed as a function of the internal rate of return (IRR) on invested capital. The equivalent user charge per-minute of 64-kbps channel service has also been determined.

Horstein, Michael↗

Advanced space communications architecture study. Volume 1: Executive summary

The technical feasibility and economic viability of satellite system architectures that are suitable for Customer Premise Service (CPS) communications is investigated. System evaluation is performed at 30/20 GHz (Ka-band); however, the system architectures examined are equally applicable to 14/11 GHz (Ku-band). Emphasis is placed on system that permit low cost user terminals. Frequency Division Multiple Access (FDMA) is used on the uplink, with typically 10,000 simultaneous accesses per satellite, each of 64 kbps. Bulk demodulators onboard the satellite, in combination with a baseband multiplexer, convert the many narrowband uplink signals into a small number of wideband data streams for downlink transmission. Single hop network interconnectivity is accomplished through use of downlink scanning beams. Each satellite is estimated to weigh 5600 lb and consume 6850W of power; the corresponding payload totals are 1000 lb and 5000W. Nonrecurring satellite cost is estimated at $110 million, with the first unit cost at $113 million. In large quantities, the user terminal cost estimate is $25,000.

Horstein, Michael↗

Concurrent communication among multi-transceiver stations over shared media

In order to increase a local-area network's throughput beyond a single bus data rate without using dedicated switching nodes, multiple buses and multitransceiver stations are required. The design space of single-hop interconnections is explored among such stations. Interconnections are presented whose throughput can grow quadratically with the number of transmitters and receivers per station. These are referred to as selective broadcast interconnections (SBIs). The performance of various SBIs are studied. A spread-spectrum channel can accommodate several current successful transmission, and a single-transceiver node can thus utilize only a small fraction of the channel capacity. In order to allocate the appropriate fraction of capacity to a busy node, it is proposed to equip it with several transmitters and receivers, thereby turning it into a supernode. Several architectures and operation policies for supernodes are suggested and compared. It is shown that a supernode can significantly outperform a collection of independent conventional nodes with the same total numbers of transmitters and receivers. Packet-radio networks with half-duplex nodes, as well as networks with full-duplex nodes, are considered.

Birk, Yitzhak↗

A study of pulse surface flashover in a vacuum

The prebreakdown phenomenon of pulsed surface flashover across solid insulators has been observed in a vacuum using image converter photography. A very good time and space resolution has been obtained. In summary, it was found that visible light (low luminosity) is initially emitted from the cathode and the light front propagates at a constant speed of approximately 1 X 10 to the 7th power ms. This low luminous light has a banded structure corresponding to the electron hopping distance as proposed in theoretical flashover models, and the light intensity gradually increases as it travels towards the anode. The bright light starts from the anode and expands towards the cathode, bridging the gap within 0.5 ns.

Lakdawala, Vishnukumar K.↗

Communications satellites in the fiber optics era

Three new satellite technologies, i.e., electronically hopped antenna beams, on-board switching, and laser intersatellite links, will soon be tested on experimental satellites. These technologies will enable future satellites to capture significant amounts of data and voice traffic. Fiber cables on the continents will dominate trunking routes, but satellites functioning as switches will be more flexible and reliable, and will cost less than terrestrial-based switches. When satellite switches and laser intersatellite links are combined, the resulting satellite networks will provide cost-effective, independent voice/data networks in the coming global village. They will augment existing terrestrial networks for thin route and low data rate links.

Lovell, R. R.↗

High temperature thermoelectric energy conversion

The theory and current status of materials research for high-temperature thermoelectric energy conversion are reviewed. Semiconductors are shown to be the preferred class of materials for this application. Optimization of the figure of merit of both broadband and narrow-band semiconductors is discussed as a function of temperature. Phonon scattering mechanisms are discussed, and basic material guidelines are given for reduction of thermal conductivity. Two general classes of materials show promise for high temperature figure of merit (Z) values, namely the rare earth chalcogenides and the boron-rich borides. The electronic transport properties of the rare earth chalcogenides are explicable on the basis of degenerate or partially degenerate n-type semiconductors. Boron and boron-rich borides exhibit p-type hopping conductivity, with detailed explanations proposed for the transport differing from compound to compound. Some discussion is presented on the reasons for the low thermal conductivities in these materials. Also, ZTs greater than one appear to have been realized at high temperature in many of these compounds.

Wood, Charles↗

ACTS - The first step toward a switchboard in the sky

The Advanced Communications Technology Satellite (ACTS), now under development and scheduled for launch in May 1992, is presently the main focus of NASA's communications program. Key technologies for ACTS include electronically hopping spot beam antennas, on-board processing and circuit switching, and Ka-band transmission.

Naderi, F. Michael↗

Electronic transport properties of hot-pressed B6Si

Measurements of the electrical conductivity, Seebeck coefficient and Hall mobility from -300 K to -1300 K have been carried out on multiphase hotpressed samples of the nominal composition B6Si. In all samples the conductivity and the p-type Seebeck coefficient both increase smoothly with increasing temperature. By themselves, these facts suggest small-polaronic hopping between inequivalent sites. The measured Hall mobilities are always low, but vary in sign. A possible explanation is offered for this anomalous behavior.

Wood, C.↗