Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SEAS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,423 records · Page 79

Short pulse radar used to measure sea surface wind speed and SWH

A joint airborne measurement program is being pursued by NRL and NASA Wallops Flight Center to determine the extent to which wind speed and sea surface significant wave height (SWH) can be measured quantitatively and remotely with a short pulse (2 ns), wide-beam (60 deg), nadir-looking 3-cm radar. The concept involves relative power measurements only and does not need a scanning antenna, Doppler filters, or absolute power calibration. The slopes of the leading and trailing edges of the averaged received power for the pulse limited altimeter are used to infer SWH and surface wind speed. The interpretation is based on theoretical models of the effects of SWH on the leading edge shape and rms sea-surface slope on the trailing-edge shape. The models include the radar system parameters of antenna beam width and pulsewidth.

Hammond, D. L.↗

An improved model for the dielectric constant of sea water at microwave frequencies

The advent of precision microwave radiometry has placed a stringent requirement on the accuracy with which the dielectric constant of sea water must be known. To this end, measurements of the dielectric constant have been conducted at S-band and L-band with a quoted uncertainty of tenths of a percent. These and earlier results are critically examined, and expressions are developed which will yield computations of brightness temperature having an error of no more than 0.3 K for an undisturbed sea at frequencies lower than X-band. At the higher microwave and millimeter wave frequencies, the accuracy is in question because of uncertainties in the relaxation time and the dielectric constant at infinite frequency.

Klein, L. A.↗

Albedo of the ocean-atmosphere system - Influence of sea foam

The influence of the ocean's optical properties and wind induced sea surface foam (white caps) on the short-wave albedo of the ocean-atmosphere system is studied by solving the radiative transfer equation using a Monte Carlo method. It is found that for a foam free ocean, the planetary albedo of a very clear ocean is at most 10 percent greater than that for a totally absorbing ocean. However, the introduction of a relatively small amount of sea foam on the surface can produce a considerable increase in the albedo, especially if the foam is highly reflecting. For example, it is shown that for foam which is totally reflecting (the foam albedo is 1), an increase in the wind speed from 6 to 14 m/sec would double the planetary albedo for small solar zenith angles.

Gordon, H. R.↗

The stereoisomeric composition of phytanyl chains in lipids of Dead Sea sediments

Lipid extracts from five recent Dead Sea sediments were analyzed for isoprenoid compounds and the following were isolated: free and phospholipid-bound di-O-phytanylglycerol, free phytanol and free and esterified phytanic acid. The phytanyl groups of the diether and the free phytanol were oxidized to the corresponding phytanic acid; the stereoisomeric composition of the derived phytanic acids as well as of the ester-bound phytanic acid was determined by open-tubular gas-liquid chromatography of the corresponding methyl esters on butanediolsuccinate polyester. Only the 3R, 7R, 11R-isomer of phytanic acid was detected in each of the phytanate samples, indicating that these phytanyl chains in the Dead Sea sediments are most likely derived from extremely halophilic bacteria rather than from phytol of chlorophyll origin. These findings also provide further evidence that the mixtures of RRR and SRR-phytanic acids previously isolated from organic-rich shales were most likely derived from the phytyl chain in chlorophyll.

Anderson, R.↗

The analysis of GEOS-3 altimeter data in the Tasman and Coral seas

A technique was developed for preprocessing GEOS-3 altimetry data to establish a model of the regional sea surface. The algorithms developed models for a 35,000,000 sq km area with an internal precision of + or - 1 m. There were discrepancies between the sea surface model so obtained and GEM6 based geoid profiles with wavelengths of approximately 2500 km and amplitudes of up to 5 m in this region. The amplitudes were smaller when compared with GEM10-based geoid determinations. However, the comparison of 14 pairs of overlapping passes in the region indicated altimeter resolution of the + or - 25 cm level if the wavelength corresponding to the Nyquist frequency were 30 km. The spectral analysis of such comparisons indicated the existence of significant signal strength in the discrepancies after least squares fitting, with wavelengths in excess of 200 km.

Mather, R. S.↗

Deep sea tides determination from GEOS-3

GEOS 3 altimeter data in a 5 degree X 5 degree square centered at 30 deg N, 70 deg W were analyzed to evaluate deep sea tide determination from a spacecraft. The signal to noise ratio of known tidal variability to altimeter measurement of sea level above the ellipsoid was 0.1. A sample was obtained in a 5 deg x 5 deg area approximately once every four days. The randomly spaced time series was analyzed using two independent least squares techniques.

Maul, G. A.↗

Estimation of the sea surface's two-scale backscatter parameters

The relationship between the sea-surface normalized radar cross section and the friction velocity vector is determined using a parametric two-scale scattering model. The model parameters are found from a nonlinear maximum likelihood estimation. The estimation is based on aircraft scatterometer measurements and the sea-surface anemometer measurements collected during the JONSWAP '75 experiment. The estimates of the ten model parameters converge to realistic values that are in good agreement with the available oceanographic data. The rms discrepancy between the model and the cross section measurements is 0.7 db, which is the rms sum of a 0.3 db average measurement error and a 0.6 db modeling error.

Wentz, F. J.↗

Fisheries imaging radar surveillance test /FIRST/ - Bering Sea test

A joint NOAA, U.S. Coast Guard and NASA program is being conducted to determine if a synthetic aperture radar (SAR) system, such as planned for NASA's SEASAT, can be useful in monitoring fishing vessels within the newly established 200-mile fishing limit. As part of this program, data gathering field operations were conducted over concentrations of foreign fishing vessels in the Bering Sea off Alaska in April 1976. The Jet Propulsion Laboratory developed synthetic aperture L-band radar which was flown aboard the NASA Convair 990 aircraft, with a Coast Guard cutter and C-130 aircraft simultaneously gathering data to provide both radar imagery and sea truth information on the vessels being imaged. Results indicate that synthetic aperture radar systems have potential for all weather detection, enumeration and classification of fishing vessels.

Woods, E. G.↗

Microwave remote sensing of sea ice in the AIDJEX Main Experiment

A microwave remote sensing program of sea ice in the Beaufort Sea was conducted during the Arctic Ice Dynamics Joint Experiment (AIDJEX). Several types of both passive and active sensors were used to perform surface and aircraft measurements during all seasons of the year. In situ observations were made of physical properties (salinity, temperature, density, surface roughness), dielectric properties, and passive microwave measurements were made of first-year, multiyear, and first-year/multiyear mixtures. Airborne passive microwave measurements were performed with the electronically scanning microwave radiometer while airborne active microwave measurements were performed by synthetic aperture radar, X- and L-band radar, and a scatterometer.

Campbell, W. J.↗

Theory of spectral radiance of pollutants at sea

Remote measurement of soluble pollutants that change the color of the water in the sea is reported. The sensor is a spectral radiometer that flies over the polluted area and compares its spectral radiance to that of surrounding clean seawater. A quantitative analysis of the concentration of pollutants using the measured radiance of the sea compared to laboratory measurements of reflection and transmission spectra of the pollutants is presented. The quantities involved are defined and means for measuring them are described. The equations for remote sensing with a low-flying aircraft, in which case the absorption and radiance of intervening air is negligible are derived. High-flying aircraft and satellites, in which case the radiance of intervening air is the major problem are applied.

Source record↗

Theory of spectral radiance of pollutants at sea, volume 1

Remote measurement of pollutants dumped in the sea, not oil slicks, but soluble pollutants that change the color of the water, is addressed. The sensor is a spectral radiometer that flies over the polluted area and compares its spectral radiance (color) to that of surrounding clean seawater. The goal is to infer the concentration of pollutants using the measured radiance of the sea compared to laboratory measurements of reflection and transmission spectra of the pollutants. The subject is treated in three steps: (1) the quantities involved are defined and means for measuring them are described; (2) the equations for remote sensing with a low-flying aircraft are derived, in which wase the absorption and radiance of intervening air is negligible; and (3) high-flying aircraft and satellites are applied, in which case the radiance of intervening air is the major problem.

Source record↗

Tropical sea surface temperature - An interactive one-dimensional atmosphere-ocean model

It is shown that the (cumulus) convective processes in the tropics may be described by a one-dimensional cloud model, while the near-surface ocean may similarly be described by a one-dimensional mixed-layer model. The coupling is achieved through a sea surface flux budget combined with the flux parameterizations implied by Monin-Obukhov similarity theory. The coupled one-dimensional atmosphere-ocean model is applied to the equilibrium situation in which all temperatures reach a steady state. For the ocean, the fluxes must vanish in equilibrium, but the atmosphere maintains a stable lapse rate by balancing cumulonimbus heating against net radiative cooling. All water precipitating from cumulonimbus clouds must have evaporated from the sea. It is shown that this equilibrium system is closed and determinable solely in terms of the solar constant.

Sarachik, E. S.↗

Mapping of sea ice and measurement of its drift using aircraft synthetic aperture radar images

Side-looking radar images of Arctic sea ice were obtained as part of the Arctic Ice Dynamics Joint Experiment. Repetitive coverages of a test site in the Arctic were used to measure sea ice drift, employing single images and blocks of overlapping radar image strips; the images were used in conjunction with data from the aircraft inertial navigation and altimeter. Also, independently measured, accurate positions of a number of ground control points were available. Initial tests of the method were carried out with repeated coverages of a land area on the Alaska coast (Prudhoe). Absolute accuracies achieved were essentially limited by the accuracy of the inertial navigation data. Errors of drift measurements were found to be about + or - 2.5 km. Relative accuracy is higher; its limits are set by the radar image geometry and the definition of identical features in sequential images. The drift of adjacent ice features with respect to one another could be determined with errors of less than + or - 0.2 km.

Leberl, F.↗

The reflection of impulses from a nonlinear random sea

A model of the reflection of radar impulses from the sea at near-vertical incidence is used to account for non-Gaussian ocean waves statistics. The joint probability density function (pdf), of wave height and slope, is calculated according to the theory of Longuet-Higgins (1963) on the distribution of variables in a 'weakly nonlinear' random era. The long-crested approximation is made, a Phillips wave spectrum is assumed, and the Gram-Charlier series is truncated after skewness terms. It is found that the height and height-slope skewness coefficients bear the ratio 1:2 and that the derived impulse response and conditional cross section versus wave height are in excellent agreement with previous observations. Finally, it is suggested that the empirically determined and theoretically predicted sea state bias be corrected for in the routine processing of satellite radar altimeter data.

Jackson, F. C.↗

A study of possible sea state information in the sample and hold gate statistics for the GEOS-3 satellite altimeter

The statistical variations in the sample gate outputs of the GEOS-3 satellite altimeter were studied for possible sea state information. After examination of a large number of statistical characteristics of the altimeter waveforms, it was found that the best sea predictor for H-1/3 in the range of 0 to 3 meters was the 75th percentile of sample and hold gate number 11.

Wells, W. T.↗

Satellite monitoring of sea surface pollution

The author has identified the following significant results. Image processing techniques developed are well adapted to the exploration and isolation of local areas which exhibit small temperature differences between themselves and their surroundings. In the worst case of imagery of small areal extent of sea surface having no coastal boundary in the area, there is yet no method of distinguishing unambiguously an oil spill from fog, cloud, the effect produced by shallow sediments, or the effects of naturally occuring thermal fronts. In the case of uniform slicks of liquid North Sea oil in still air, laboratory simulation experiments show that, for oil thicknesses in excess of 1 or 2 mm, there is, under equilibrium conditions, little dependence of oil surface temperature on the thickness of the oil layer. The surface temperature of oil is consistently higher than that of water, the difference being about 1 K at low values of relative humidity, but tending to increase as the relative humidity increases.

Fielder, G.↗

Temporal variations in regional models of the Sargasso Sea from GEOS-3 altimetry

The paper considers temporal variations in regional models of the Sargasso sea from GEOS-3 telemetry. The methods of regional models and the analysis of overlapping passes are utilized, and short-wave maxima and minima in the regional surface models are examined for correlations with surface and remote sensed infrared temperature data supplemented with subsurface expendable bathythermograph data (XBT). The analysis of overlapping passes provide a better picture of instanteneous sea surface height (SSH) variability through wavelengths greater than 30 km. Correlation studies with cyclonic and anticyclonic ocean eddies from infrared imagery and XBT data indicate satisfactory agreement with equivalent SSH features 98% of the time if the time varying factors are allowed for.

Mather, R. S.↗

Dynamic sea surface topography from GEOS-3 altimetry - Determination of some dominant parameters

The second, third and fourth degree zonal harmonics of the quasi-stationary dynamic sea surface topography can be recovered from the GEOS-3 altimetry despite the adverse levels of noise indicated by the crossover discrepancies generated from the best orbits available at the end of 1977 and the GEOS-3 altimetry. Techniques for modelling the global sea surface topography are discussed along with methods for signal recovery in the presence of significant levels of noise. The analysis also provides a means of defining the geocentricity of the system of reference used in preparing the GEOS-3 ephemeris.

Mather, R. S.↗