Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “PENETRATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,423 records · Page 79
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

An aerodynamic study of scramjet fuel injectors

The aerodynamic drag and fuel distribution patterns of injectors designed for a supersonic combustion ramjet were measured at Mach numbers of 2, 2.5, and 3. The most significant parameter effecting the drag was found to be the injector thickness ratio. A twofold reduction in the thickness ratio caused a 65% decrease in drag. Changing the injector sweep angle by a factor of 2 resulted in only a small change in drag. A reversal of injector sweep, from sweepback to sweepforward, did not change the measured drag. Helium gas was injected through the struts to simulate the penetration and spreading patterns of hydrogen. Sampling measurements were made at approximately two duct heights downstream of the combustor. The spacing required between fuel injectors was found to be about 10 jet diameters. The effect of gas injection on the measured drag was found to be minor.

Povinelli, L. A.↗
NASA NTRS1974

Bremsstrahlung in the atmosphere at satellite altitudes

Transport calculations have been made to determine the emission of bremsstrahlung by electrons in the atmosphere and the penetration of this radiation to high altitudes where it can be detected by satellite-borne instruments. The calculations were done assuming uniform wide-area precipitation into the atmosphere of an electron flux isotropic over the downward hemisphere. The intensity and energy spectrum of the bremsstrahlung have been obtained for the case of incident monoenergetic electron beams at energies between 20 keV and 2 MeV, for incident electron beams with exponential spectra with e-folding energies between 5 and 200 keV.

Seltzer, S. M.↗
NASA NTRS1974

Magnetospheric particle composition experiment

Thin foils of aluminum and platinum were mounted on the exterior of the Skylab spacecraft where they were bombarded by particles that penetrate to the 400-km spacecraft altitude, including auroral particles precipitating from the earth magnetosphere. These foils have a high trapping efficiency for both charged and neutral particles above 1 keV and a decreasing but appreciable efficiency below that energy. Some sections of the foils were double layered to obtain an estimate of the energy of the entrapped particles. The foils were retrieved and returned for analysis in an ultrahigh-vacuum mass spectrometer. So far, the noble gas components of the entrapped particles have been analyzed in selected sections of two foils. Helium-4, helium-3, neon-20, and neon-22 have been detected.

Geiss, J.↗
NASA NTRS1974

Characterization of charge states of energetic ions in solids from associated K X-ray production

The strong projectile-charge-state dependence of K X-ray production in gases establishes a charge-state scale for ions penetrating solids. Si K X-ray cross sections in gaseous SiH4 were compared to those in solid Si for 40-MeV O (6+ to 8+) and 86-MeV Ar (6+ to 16+) projectiles. For Ar an effective charge of 11 plus or minus one is found compared to an emergent charge of 14.8 plus or minus 0.5. The result is discussed in terms of alternate models for steady-state excitation in solids.

Datz, S.↗
NASA NTRS1974

Results of full-scale vortex attenuation flight experiments

Flight tests have been conducted to evaluate the effectiveness of a wing-tip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wing-tip splines attached, and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 n mi to less than 1 n mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex-induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n mi to less than 1 n mi. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program.

Hastings, E. C., Jr.↗
NASA NTRS1974

Optical measurement of interplanetary particulates from Pioneer 10

The spatial concentration and size distribution for particulates measured in situ by the asteroid/meteoroid detector on Pioneer 10 between 1.0 and 3.5 AU are presented. The size distribution includes particles of radii from about 35 microns to 10 cm. Extrapolation from the smallest particle sizes measured shows good agreement with the results of the particle penetration detector carried on the same spacecraft. Within the uncertainties of this experiment, a single size distribution seems appropriate for all but the smallest particles measured. There is evidence for the existence of a planetary sweeping effect in the vicinity of the Mars orbit. As calculated from the particle spatial distribution, the zodiacal light brightness is found to vary approximately as the inverse square of solar distance out to about 2.25 AU and then decrease more rapidly. The absolute value of the zodiacal light brightness as calculated from the particle spatial concentration is found to be too high by a factor of 10.

Soberman, R. K.↗
NASA NTRS1975

Improved ion exchange membrane

Membrane, made from commercially-available hollow fibers, is used in reverse osmosis, or dialysis. Fiber has skin layers which pass only small molecules. Macromolecules cannot penetrate skin. Fibers can also be used to remove other undesirable anions, such as phosphate, sulfate, carbonate, and uranium in form of uranium-sulfate complex.

Rembaum, A.↗
NASA NTRS1975

Investigations of multiple jets in a crossflow

Study was conducted to determine penetration and mixing characteristics of multiple jets of ambient temperature air injected perpendicularly into ducted mainstream of hot combustion gases.

Walker, R. E.↗
NASA NTRS1975

Determination of bone mineral mass in vivo

Radiographic equipment incorporates two radiation sources, generating high-energy and low-energy beams. Recording equipment measures amount of radiation that has penetrated limb. Data are fed into computer that determines mass of the examined bone.

Cameron, J. R.↗
NASA NTRS1974

Radiation damage and structure recorded at high resolution in grains from fine fractions of Luna 16 surface material

Samples returned to earth by Luna 16, were studied with a high voltage electron microscope for ultramicroscopic features. The following amazing features were noted in particles of surface material returned in all the lunar trips: A very high density of tracks of nuclear particles, ultrathin amorphous shells, highly rounded forms, and amazingly good ordering of crystal lattice. These features were used along with calibration experiments in solving the following problems: (1) determining the energy spectrum and chemical abundances of the very heavy nuclei in the solar wind and in the solar cosmic rays; (2) studying the past activity of the sun; (3) obtaining data on lunar dynamic processes affecting dust particles; (4) analyzing composite effects caused by penetration of solar wind into the lunar surface material; and (5) establishing the existence of the ancient lunar atmosphere and magnetic field.

Durrieu, L.↗
NASA NTRS1974

Structural heat pipe

A combined structural reinforcing element and heat transfer member is disclosed for placement between a structural wall and an outer insulation blanket. The element comprises a heat pipe, one side of which supports the outer insulation blanket, the opposite side of which is connected to the structural wall. Heat penetrating through the outer insulation blanket directly reaches the heat pipe and is drawn off, thereby reducing thermal gradients in the structural wall. The element, due to its attachment to the structural wall, further functions as a reinforcing member.

Ollendorf, S.↗
NASA NTRS1974

Cryogenic thermal control technology summaries

A summarization and categorization is presented of the pertinent literature associated with cryogenic thermal control technology having potential application to in-orbit fluid transfer systems and/or associated space storage. Initially, a literature search was conducted to obtain pertinent documents for review. Reports determined to be of primary significance were summarized in detail. Each summary, where applicable, consists of; (1) report identification, (2) objective(s) of the work, (3) description of pertinent work performed, (4)major results, and (5) comments of the reviewer (GD/C). Specific areas covered are; (1) multilayer insulation of storage tanks with and without vacuum jacketing, (2) other insulation such as foams, shadow shields, microspheres, honeycomb, vent cooling and composites, (3) vacuum jacketed and composite fluid lines, and (4) low conductive tank supports and insulation penetrations. Reports which were reviewed and not summarized, along with reasons for not summarizing, are also listed.

Stark, J. A.↗
NASA NTRS1974

Lunar highlands breccias generated by major impacts

Lunar missions are reported which have returned a variety of different types of breccias. These rocks differ greatly in their mechanisms of formation, source materials, and histories after formation; but all are related in that all were generated by impact processes. The impact processes involved in the formation of several major types of breccias are discussed. Some types that may have originated in large impacts are identified. Such breccias are extremely important. The impacts that formed them penetrated deeply into, and perhaps through the lunar crust and brought up materials that had previously experienced little or no impact modification. Detailed studies of such breccias can permit partial reconstruction of their preimpact source terranes and yield information on the nature of the early lunar crust (and possibly the upper mantle as well).

James, O. B.↗
NASA NTRS1974

The challenges of technology transfer

Observations of challenges of technology transfer are presented with emphasis placed on the position of industry seeking technology through the media of technology searches. Factors considered are: (1) not-invented-here syndrome; (2) penetration of technological literature; (3) gap between origin and industry use; (4) large aerospace manufacturer vs. the small manufacturer; (5) link between the technology disseminator and the potential user; (6) feasibility of substitutions in terms of production costs; and (7) role of patents. It is shown that industry, government agencies, and others having technology to disseminate or use, must mutually understand the technology tools and translate to one another's capabilities, in order to profit from this national resource.

Hazelwood, J. N.↗
NASA NTRS1974

Data book for 12.5-inch diameter SRB thermal model water flotation test; 1.29 psia, series P022

Data acquired from tests conducted to determine how thermal conditions affect SRB (Space Shuttle Solid Rocket Booster) flotation at a scaled pressure of 1.29 psia are presented. Included are acceleration, pressure, and temperature data recorded from initial water impact to final flotation position using a 12.5-inch diameter thermal model of the SRB. Nineteen valid tests were conducted. These thermal tests indicated the following basic differences relative to the ambient temperature and pressure model tests: (1) more water was taken on board during penetration and (2) model flotation/sinking was temperature sensitive.

Allums, S. L.↗
NASA NTRS1975

Multiplate focusing collimator

An appartus is described for scanning relatively small near sources of penetrating radiation to obtain the energy distribution thereof, wherein a collimator assembly is interposed between a radiation source and a radiation detector. The collimator assembly has a plurality of plates aligned in parallel planes with respect to a common axis normal to their centers. All the plates have similar random distribution of apertures. All apertures on each plate are the same size. The size of respective plates, the size of the apertures of said respective plates, and the spacing between said respective plates vary precisely according to a predetermined ratio to produce radiation channels which converge to a focal point. The radiation incident to the radiation detector is maximized when the focal point and the radiation source are co-incident.

Hoover, R. B.↗