Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Launch”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,387 records · Page 77

Unfolding the air vanes on a supersonic air-launched missile

ASALM (Advanced Strategic Air-Launched Missile) is a supersonic air vehicle designed to be air-launched from a carrier aircraft. The four aft aerodynamic control vanes are folded to maximize the number of missiles carried on-board. The unfolding (erection) system must be small, energetic, fast, and strong. The materials selected and problems that arose during development of the unfolding system are described.

Wohltmann, M.↗

Fuel/hydraulic transfer valve improves reliability of Atlas space launch vehicle

The Atlas fuel hydraulic transfer valve design is described. The design satisfies primary goals such as fuel and oil isolation before launch in order to use existing ground support and airborne hardware and procedures. The valve operates only after the vehicle has been committed to launch. Hydraulic system function is maintained if the valve fails to function. Valve operation is mechanical and interfaces only with the propulsion system.

Ogman, M.↗

Aerodynamics of a turbojet-boosted launch vehicle concept

Results from analytical and experimental studies of the aerodynamic characteristics of a turbojet-boosted launch vehicle are presented. The success of this launch vehicle concept depends upon several novel applications of aerodynamic technology, particularly in the area of takeoff lift and minimum transonic drag requirements. The take-off mode stresses leading edge vortex lift generated in parallel by a complex arrangement of low aspect ratio booster and orbiter wings. Wind-tunnel tests on a representative model showed that this low-speed lift is sensitive to geometric arrangements of the booster-orbiter combination and is not predictable by standard analytic techniques. Transonic drag was also experimentally observed to be very sensitive to booster location; however, these drag levels were accurately predicted by standard farfield wave drag theory.

Small, W. J.↗

Launch mission summary: INTELSAT 5(F1) ATLAS/CENTAUR-56

The technology and capability of the INTELSAT 5 series satellites and the Atlas-Centaur launch vehicle are described. Data relative to launch windows, flight plans, radar, and telemetry are included along with selected trajectory information and a sequence of flight events.

Source record↗

Dynamics Explorer dual spacecraft to be launched on July 31

Plans for the launch of the Dynamics Explorers A and B are announced. The mission of the spacecraft is described. Specific knowledge about the coupling of energy, electric currents, electric fields, and plasmas between the magnetosphere, the ionosphere, and the atmosphere is sought. The instrumentation of the spacecraft is described and the spacecraft and Delta 3918 launch vehicle characterized. Detailed background information amplifying the mission is included.

Source record↗

Dynamics Explorer launch

Simultaneously launched from the WSMC, two satellites are to be placed into polar, copolar orbit in order to acquire data on the coupling phenomena between Earth's lower thermosphere and the magnetosphere, as part of the Solar-Terrestrial Program. The mission sequence, instruments, and science data processing system are described as well as the characteristics of the Delta 3913 launch vehicle, and payload separation staging.

Source record↗

Space shuttle launch era spacecraft injection errors and DSN initial acquisition

The initial acquisition of a spacecraft by the Deep Space Network (DSN) is a critical mission event. This results from the importance of rapidly evaluating the health and trajectory of a spacecraft in the event that immediate corrective action might be required. Further, the DSN initial acquisition is always complicated by the most extreme tracking rates of the mission. The DSN initial acquisition characteristics will change considerably in the upcoming space shuttle launch era. How given injection errors at spacecraft separation from the upper stage launch vehicle (carried into orbit by the space shuttle) impact the DSN initial acquisition, and how this information can be factored into injection accuracy requirements to be levied on the Space Transportation System (STS) is addressed. The approach developed begins with the DSN initial acquisition parameters, generates a covariance matrix, and maps this covariance matrix backward to the spacecraft injection, thereby greatly simplifying the task of levying accuracy requirements on the STS, by providing such requirements in a format both familiar and convenient to STS.

Khatib, A. R.↗

Ablation and deceleration of mass-driver launched projectiles for space disposal of nuclear wastes

The energy cost of launching a projectile containing nuclear waste is two orders of magnitude lower with a mass driver than with a typical rocket system. A mass driver scheme will be feasible, however, only if ablation and deceleration are within certain tolerable limits. It is shown that if a hemisphere-cylinder-shaped projectile protected thermally with a graphite nose is launched vertically to attain a velocity of 17 km/sec at an altitude of 40 km, the mass loss from ablation during atmospheric flight will be less than 0.1 ton, provided the radius of the projectile is under 20 cm and the projectile's mass is of the order of 1 ton. The velocity loss from drag will vary from 0.4 to 30 km/sec, depending on the mass and radius of the projectile, the smaller velocity loss corresponding to large mass and small radius. Ablation is always within a tolerable range for schemes using a mass driver launcher to dispose of nuclear wastes outside the solar system. Deceleration can also be held in the tolerable range if the mass and diameter of the projectile are properly chosen.

Park, C.↗

Saturn launch vehicles

The paper discusses the technical challenge confronting the developers of the Saturn series of launch vehicles to meet the commitment to land a man on the moon. The challenge ranged from the development and clustering of high-thrust, high-specific-impulse cryogenic rocket engines and associated in-flight conditioning and ignition, to the problems inherent in the application of a variety of materials at cryogenic temperatures. This paper presents the more significant of these specific design accomplishments, along with the system design approach essential to the development of the rocket engines, propellant tanks and feed systems, and avionic systems. Emphasis is placed on the integration of the major components into a multiple-stage launch vehicle capable of injecting the Apollo CSM and LEM into a cislunar trajectory and, with minor modification, placing the Skylab space station into low earth orbit.

Lucas, W. R.↗

Third Intelsat 5 satellite scheduled for launch

The launch sequence of the Intelsat 5-C satellite is announced. A brief description of the satellite and the Atlas Centaur launch vehicle is given. Prelaunch operations are included.

Source record↗

Launch mission summary: Intelsat 5 (F3) Atlas/Centaur-55

Intelsat 5 (F3) spacecraft, launch vehicle, and mission are described. Information relative to launch windows, flight plan, radar and telemetry coverage, selected trajectory information, and a brief sequence of flight events is provided.

Source record↗

INTELSAT V-D (F-4) Launch

Plans for the Intelsat 5D (F4) satellite launch are presented. The spacecraft and its subsystems are described and the mission is summarized. The Atlas Centaur launch vehicle is also described.

Source record↗

INSAT-1A launch on Delta

The INSAT-1A, the first in a series of 12 transponder communications satellites developed for India, is described as well as the launch plans. The launch vehicle will be the Delta 3910 configuration which incorporates an extended long tank Thor booster, nine Castor IV strap-on motors, a TR-201 second stage, and an 8 foot fairing. The satellite will be placed in a suborbital trajectory. A DAM-D stage will then thrust it into a synchronous transfer orbit. An apogee kick motor will be fired to circularize its orbit at a geosynchronous altitude of 19,300 nautical miles.

Source record↗

INTELSAT satellite scheduled for launch

The launch schedule for INTELSAT V-D, the fourth of a series of nine international telecommunications satellites, is presented. Satellite and launch vehicle specifications are presented.

Source record↗

Offshore Space Center (offshore launch site)

Any activity requiring the development of the HLLV can benefit by operations from an offshore space center (OSC) since operating near the equator provides a twenty percent increase in payload in an ecliptic plan orbit. Some OSC concepts considered include a moored floating (semisubmersible) design, a stationary design supported by fixed piles, and a combination of these two. The facility supports: a 15,000 foot long, 300 foot wide runway, designed to accommodate a two staged winged launch vehicle, with a one million pound payload capacity to low earth orbit; an industrial area for HLLV maintenance; an airport terminal, control and operation center, and observation tower; liquid hydrogen and liquid oxygen production and storage, and fuel storage platforms; a power generation station, docks with an unloading area; two separate launch sites; and living accommodations for 10,000 people. Potential sites include the Paramount Seamount in the Pacific Ocean off the north coast of South America. Cost estimates are considered.

Harvey, D. G.↗