Investigation of Mass Transfer and Sorption in CO 2 /Brine/Rock Systems via In Situ FT-IR
CO 2 geological storage in deep saline formations is considered a promising method to mitigate anthropogenic CO 2 emissions and, thereby, minimize changes to the Earth’s atmosphere. A fundamental understanding of CO 2 mass transfer and sorption phenomena in brine-saturated reservoir formations is necessary to understand the long-term fate of injected CO 2 as it is subjected to different (physical, dissolution, and mineral) trapping mechanisms. In this work, we investigate CO 2 sorption in brine-saturated and dry Mt. Simon sandstone samples via in-situ Fourier Transform infrared spectroscopy (FT-IR) at elevated pressures, ranging from 0.3 MPa to 8.3 MPa, at a temperature of 50 ⁰C. The FT-IR spectra of bulk-phase CO 2 were simultaneously recorded under the same conditions. For bulk-phase CO 2 , we observed, in agreement with past studies, a doublet peak at 2361 cm -1 and 2336 cm -1 and another peak (ν 2 bending mode) at 667 cm -1 . With increasing pressure, the position of the peak at 667 cm -1 remains invariant, however, when crossing into the supercritical region the doublet peak degenerates onto a single peak at 2336 cm -1 with a barely visible shoulder at 2361 cm -1 . The bulk CO 2 data provide a perfect fit for Beer’s law for the whole range of pressure conditions. For the dry sample, the IR spectrum is experimentally indistinguishable from the bulk CO 2 spectrum, signifying that if physical adsorption occurs to any significant extent, the adsorbed CO 2 molecules are not substantially more rotationally constrained than the dense bulk CO 2 molecules. For the brine-saturated sample, we observe a strong band centered at 2342 cm -1 and a small companion peak at 2360-2361 cm -1 that degenerates into a barely visible shoulder peak at the higher pressures. The 2342 cm -1 band has been previously observed by other investigators for CO 2 dissolved in bulk water/brine as well during its adsorption on a variety of other wet natural porous media. We observe no peaks corresponding to bicarbonate or carbonate bulk species, which correlates well with the prior literature on similar low-pH aqueous solutions. The integrated peak area for the CO 2 sorbed in the brine-saturated sample correlates linearly with its solubility in the same bulk brine, as measured separately via a PVT-cell approach. Here, this validates the accuracy of both techniques, and the potential of the FT-IR method to be used in the study of mass transfer and adsorption in such systems. To that effect, a simple mathematical model is presented to analyze the FT-IR data to determine the CO 2 effective diffusivity in the brine-saturated sandstone sample.