Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Sheet”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,369 records · Page 76

A thermal-capillary mechanism for a growth rate limit in edge-defined film-fed growth of silicon sheets

Capillarity, acting to set the shape of the melt/gas interfaces, and heat transfer can interact to cause limits to steady-state growth of thin silicon sheets by the Edge-Defined Film-Fed Growth (EFG) method. A finite-element/Newton solution method for a two-dimensional thermal-capillary model of EFG is used to show that limiting values of pull rate exist beyond which steady-state growth is impossible. The pull rate limit is also predicted by a one-dimensional heat transfer model valid when the die sides and menisci are almost parallel and when the thermal conductivities of melt, crystal, and die are all equal. Both the one- and two-dimensional heat transfer models show that heat loss from the melt is dominated by conduction into the crystal and slow heat release to the ambient along the length of the ribbon. The limiting pull rate results from the reduced efficiency of conduction through the melt caused by the curvature of the meniscus which increases height of the die top above the level of the melt. Thermal-capillary limits are predicted for both positive and negative pressure differences across the meniscus.

Thomas, P. D.↗

Structure of a slow mode shock observed in the plasma sheet boundary layer

A detailed study of the plasma parameters and magnetic field measured using instrumentation aboard ISEE 2 during the recovery phase of a substorm on Apr. 24, 1979, is presented. The purpose of this study was to determine the nature and structure of the lobe-plasma sheet boundary layer. The analysis shows that the lobeward edge of the boundary is consistent with a freestanding slow mode shock. This shock is followed by a slow compression wave containing a trailing ion cyclotron wave which also stands in the flow. Measurement of the cross-tail current in the shock and the current system within the wave gives a shock thickness and wavelength comparable to but larger than both the upstream ion inertial length and the downstream proton gyroradius. Equality of the shock thickness with the standing ion cyclotron wavelength suggests that the steepness of the front is limited by dispersion rather than current-driven anomalous resistivity.

Feldman, W. C.↗

A new model for the ion beams in the plasma sheet boundary layer

A new model is proposed for the ion beams frequently observed in the plasma sheet boundary layer. The model assumes injection of magnetosheath plasma onto closed tail field lines. The plasma then expands along the field lines and is convected towards the earth. Particle simulations of the expansion process are used to calculate properties of these beams. The expansion produces beams of ions at energies of up to a few tens of k(B)T(e), which are consistent with the observed energies of the beams.

Whelan, T.↗

The Giacobini-Zinner magnetotail - Tail configuration and current sheet

The configuration and properties of the draped Giacobini-Zinner magnetotail and its field-reversing current sheet are studied using the combined magnetic field and plasma electron data sets obtained from the International Cometary Explorer spacecraft when it traversed (in October 1985) the comet 7800 km downstream of the nucleus. The MHD equations are used to derive pressure balance and plasma acceleration conditions. The implications of the various properties derived are examined, particularly with regard to the upstream near-nucleus region where the tail formation process occurs.

Mccomas, D. J.↗

A sheet description of the emission from middle-aged supernova remnants

The hypothesis that sheetlike shock fronts propagating into large clouds immersed in a fairly uniform intercloud medium can provide a consistent picture accounting for essentially all the observational data for the Cygnus Loop SNR is considered. Filaments are interpreted as line-of-sight projections of portions of the sheet. Variations in the projection of the shock velocity along the line of sight lead naturally to 'turbulent' velocities consistent with observation. An analog model of a large, distorted, bumpy shock front is presented and shown to produce the observed morphology of the remnant's prominent optical filaments. Comparison with the observed morphology supports the idea that regions of optical emission lie on the local outer boundary of the shell and have not been engulfed by the blast wave. Bright X-ray emission arises when the blast wave encounters a preshock medium with an intermediate density higher than average for the adiabatic portion of the remnant, but still lower than that required for the shock to become radiative.

Hester, J. Jeff↗

In situ cosmogenic H-3, C-14, and Be-10 for determining the net accumulation and ablation rates of ice sheets

The usefulness of the in situ cosmogenic H-3, C-14, and Be-10 produced by spallation of oxygen nuclei in ice, as tracers to determine net accumulation/ablation rates of ice sheets is explored. The application of the in situ H-3 and Be-10 is severely constrained because at deposition, ice contains appreciable amounts of these isotopes from the atmosphere. The case is much more favorable for C-14, which is not carried with wet precipitations; atmospheric C-14 gets mechanically trapped in the ice during deposition. It is pointed out that cosmogenic C-14 would probably exist as (C-14)O in ice. This seems to be supported by the published results of Fireman and Norris (1981). Considering their inherent amounts in the ice and the expected in situ production rates, conditions under which these isotopes can be used to study net accumulation and ablation rates are discussed. Available data on C-14 and Be-10 on polar ice from accumulation and ablation zones is also discussed. It is concluded that H-3 and C-14 should find wide applications in studying ice dynamics and Be-10 in very special circumstances.

Lal, D.↗

Plasma sheet ion composition at various levels of geomagnetic and solar activity

The data obtained in the earth's plasma sheet by the Plasma Composition Experiment on the ISEE-1 spacecraft are briefly reexamined. The data are shown in the form of statistically averaged bulk parameters for the four major ions H(+), He(2+), He(+), and O(+) to illustrate the apparent mixture of solar and terrestrial ions, a mixture that varies with geomagnetic and other conditions. Some major differences in the statistical properties of different ions, which may have a bearing on the physics of the solar wind-magnetosphere interaction, are highlighted.

Lennartsson, W.↗

Dynamical features of the plasma-sheet ion composition, density, and energy

The effects of changes in solar and geomagnetic activity on the major plasma-sheet ions are investigated on the basis of a statistical analysis of 1500 h of data obtained at distances 10-23 earth radii and energy/charge ratios 0.1-16 keV/e by the ISEE-1 energetic-ion mass spectrometer. The results are presented in extensive graphs and discussed in detail. It is found that substorm activity is accompanied by a significant decrease in the density of solar-origin H(+) ions, a sharp increase in the energy per nucleon of both H(+) and He(+) ions, and an increase in the density of terrestrial O(+) ions. A factor-of-three increase in the overall O(+) density over the observation period is attributed to an increase in the solar EUV flux.

Lennartsson, W.↗

Energetic ion and electron beams at the plasma-sheet boundary in the distant tail

Several energetic particle bursts observed by ISEE 3 in the distant tail are analyzed. The energetic particle data are supplemented by the electron plasma and magnetic field measurements. These bursts are characterized by large velocity-dispersion effects, with energetic electrons observed first, followed by ions with continuously lower velocities. Both ions and electrons stream in the tailward direction. Protons and alpha particles of the same energy per nucleon are observed at the same time. The dispersion effects are observed in reverse order when the spacecraft leaves from the boundary layer into the lobe. No obvious signature indicating the passage of a plasmoid has been observed in the particle or magnetic field data during or immediately following these bursts. It is concluded that these beams at the plasma-sheet boundary originate at a steady source, presumably close to a neutral line, and not at a time varying source. The velocity filter effect in a dawn-dusk electric field arranges particles with progressively lower velocity further inside the wedge-shaped region of reconnected field lines. The plasma electron distribution exhibits a tailward directed heat flux within this layer.

Scholer, M.↗

Magnetic field and particle pressure in the plasma sheet of Jupiter

The results of an analysis of the energetic particle and magnetic field data acquired by the Voyager 2 spacecraft at distances of about 40-70 Jupiter radii on the nightside of the planet are reported. As in a previous study of similar data at distances of greater than about 80 Jupiter radii, the energy densities of ions (primarily protons) is found to be sufficient to provide the diamagnetic depressions measured in the magnetic field intensity as the spacecraft made successive encounters with the nightside plasma sheet. There is some evidence that the percent contribution of the protons to the energy balance decreases with increasing distance from the planet over this radial interval, although this conclusion is dependent upon the assumption that the proton and heavier ion (oxygen) energy spectra are similar.

Lanzerotti, L. J.↗

Generalized adiabatic theory applied to the magnetotail current sheet

The generalized first adiabatic invariant, an extension of the magnetic moment for regions of large field gradients, has been applied to the study of particles in the magnetotail current sheet. Boundaries in phase space are obtained which form a generalized loss cone and separate particles drifting into and out of the layer from particles trapped within the layer, and the boundaries can be employed in the moment integrals for densities and currents when the drifting particles differ in temperature. It is shown that the parallel pressure of the drifting particles must exceed the transverse pressure for self-consistent solutions to exist. Fully self-consistent solutions are obtained using bi-Maxwellian ion and Maxwellian electron distributions.

Rogers, Shelley H.↗

The Milankovitch theory and climate sensitivity. I - Equilibrium climate model solutions for the present surface conditions. II - Interaction between the Northern Hemisphere ice sheets and the climate system

A seasonal climate model was developed to test the climate sensitivity and, in particular, the Milankovitch (1941) theory. Four climate model versions were implemented to investigate the range of uncertainty in the parameterizations of three basic feedback mechanisms: the ice albedo-temperature, the outgoing long-wave radiation-temperature, and the eddy transport-meridional temperature gradient. It was found that the differences between the simulation of the present climate by the four versions were generally small, especially for annually averaged results. The climate model was also used to study the effect of growing/shrinking of a continental ice sheet, bedrock sinking/uplifting, and sea level changes on the climate system, taking also into account the feedback effects on the climate of the building of the ice caps.

Neeman, Binyamin U.↗

Inviscid spatial stability of a compressible mixing layer. Part 2: The flame sheet model

The results of an inviscid spatial calculation for a compressible reacting mixing layer are reported. The limit of infinitive activation energy is taken and the diffusion flame is approximated by a flame sheet. Results are reported for the phase speeds of the neutral waves and maximum growth rates of the unstable waves as a function of the parameters of the problem: the ratio of the temperature of the stationary stream to that of the moving stream, the Mach number of the moving streams, the heat release per unit mass fraction of the reactant, the equivalence ratio of the reaction, and the frequency of the disturbance. These results are compared to the phase speeds and growth rates of the corresponding nonreacting mixing layer. We show that the addition of combustion has important, and complex effects on the flow stability.

Jackson, T. L.↗

Polar wind ion bands after neutral sheet acceleration

The transport of polar wind protons from their ionospheric source through the magnetosphere is examined, using three-dimensional particle codes. The trajectory simulations demonstrate the escape of the high-latitude polar wind in the boundary layers during the quiescent magnetosphere, and, in contrast, its trapping in the nightside plasma sheet at times of high Kp. It is shown that the equatorial curvature of the magnetic field lines plays the role of an acceleration filter which yields, during active conditions, an 'ion band'-like precipitation of the polar wind protons characterized by a decrease of the downflowing ion energy with latitude, from several hundred down to a few electron volts. A further comparison between data and computations tends to indicate that, during disturbed times, the dayside originating polar wind provides an important contribution to the hundreds of electron volt downflowing protons in the nightside sector.

Delcourt, D. C.↗

Linear, collisionless, bi-Maxwellian neutral-sheet tearing instability

The problem of linear bi-Maxwellian neutral-sheet tearing instability has been solved, using neither an approximation of the orbits nor the constant-psi approximation. The present method has a larger range of validity than the best previous approximation, the three-region approximation. It is found that as the temperature anisotropy is increased, the growth rate increases and the wavelength associated with the peak growth decreases. It is suggested that if small-island formation is experimentally observed, then temperature anisotropy may be present.

Burkhart, G. R.↗

Collisionless tearing instability of a bi-Maxwellian neutral sheet - An integrodifferential treatment with exact particle orbits

The integrodifferential equation describing the linear tearing instability in the bi-Maxwellian neutral sheet is solved without approximating the particle orbits or the eigenfunction psi. Results of this calculation are presented. Comparison between the exact solution and the three-region approximation motivates the piecewise-straight-line approximation, a simplification that allows faster solution of the integrodifferential equation, yet retains the important features of the exact solution.

Burkhart, G. R.↗

A new calculation of the cosmic-ray antiproton spectrum in the Galaxy and heliospheric modulation effects on this spectrum using a drift plus wavy current sheet model

The expected interstellar antiproton spectrum arising from cosmic-ray interactions in the Galaxy is recalculated, and the modulation of both antiprotons and protons is calculated using a two-dimensional modulation model incorporating gradient and curvature drifts and a wavy current sheet as well as the usual diffusion, convection, and energy-loss effects. Significant differences in the antiproton/proton ratio for different solar magnetic field polarities are predicted as well as a 'low-energy' component for antiprotons below about 1 GeV.

Webber, W. R.↗

MATE (Materials for Advanced Turbine Engines) Program, Project 3. Volume 2: Design, fabrication and evaluation of an oxide dispersion strengthened sheet alloy combustor liner

The suitability of wrought oxide dispersion strengthened (ODS) superalloy sheet for gas turbine engine combustor applications was evaluated. Two yttria (Y2O3) dispersion strengthened alloys were evaluated; Incoloy MA956 and Haynes Development Alloy (HDA) 8077 (NiCrAl base). Preliminary tests showed both alloys to be potentially viable combustor materials, with neither alloy exhibiting a significant advantage over the other. MA956 was selected as the final alloy based on manufacturing reproducibility for evaluation as a burner liner. A hybrid PW2037 inner burner liner containing MA956 and Hastelloy X components and using a louvered configuration was designed and constructed. The louvered configuration was chosen because of field experience and compatibility with the bill of material PW2037 design. The simulated flight cycle for the ground based engine tests consisted of 4.5 min idle, 1.5 min takeoff and intermediate conditions in a PW2037 engine with average uncorrected combustor exit temperature of 1527 C. Post test evaluation consisting of visual observations and fluorescent penetrant inspections was conducted after 500 cycles of testing. No loss of integrity in the burner liner was shown.

Bose, S.↗