Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “STREAMS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,369 records · Page 76

Free-flight Performance of 16-inch-diameter Supersonic Ram-jet Units III : Four Units Designed for Combustion-chamber-inlet Mach Number of 0.245 at Free-stream Mach Number of 1.8 (units D-1, D-2, D-3, and D-4)

Performance of four 16-inch-diameter ram-jet units was determined at free-stream Mach numbers of 0.49 to 1.78 over range of gas total-temperature ratios of 1.0 to 6.1. Time histories of each flight and data on thrust, drag, diffuser efficiency, and combustion are presented. A maximum thrust coefficient of 0.88 and a maximum net acceleration of 5.13 g's were observed for the four units.

COMBUSTION - RAM-JET ENGINES↗

Nomogram for correcting drag and angle of attack of an airfoil model in an air stream of finite diameter

In experimenting with airfoil models in a wind tunnel, the magnitude of the forces acting on the model is affected by the fact that the air stream in which the model is suspended, has a restricted cross-section. In order to utilize the results for an airplane in an unlimited quantity of air, a correction must be made. The magnitude of this correction was determined by Prandtl by the application of his wing theory.

MATHEMATICS↗

Pressure distribution and aerodynamic coefficients associated with heat addition to supersonic air stream adjacent to two-dimensional supersonic wing

The modifications in the pressure distributions and the aerodynamic coefficients associated with additions of heat to the two-dimensional supersonic in viscid flow field adjacetnt to the lower surface of of a 5-percent-thickness symmetrical circular-arc wing are presented in this report. The pressure distributions are obtained by the use of graphical method which gives the two-dimensional supersonic inviscid flow field obtained with moderate heat addition. The variation is given of the lift-drag ratio and of the aerodynamic coefficients of lift, drag, and moment with free stream Mach number, angle of attack, and parameters defining extent and amount of heat addition. The six graphical solutions used in this study included Mach numbers of 3.0 and 5.0 and angles of attack of 0 degrees and 2 degrees.

Pinkel, I Irving↗

Boundary-layer Transition at High Reynolds Numbers as Obtained in Flight of a 20 Degree Cone-cylinder with Wall to Local Stream Temperature Ratios near 1.0

Boundary-layer transition data at low ratios of wall to local stream temperature have been obtained during the free flight of a highly polished cone-cylinder to a maximum Mach number of 5.02 A maximum transition Reynolds number of 32 x 10(exp 6) occurred at a distance of 25.84 inches from the cone apex. The temperature ratio at transition for a local Mach number of 4.0 was approximately 1.30 as compared with theoretical infinite stability solutions of 1.47 and 1.65 by Dunn and Lin (three-dimensional) and Van Driest (two-dimensional), respectively.

Rabb, Leaonard↗

Investigation of the Jet Effects on a Flat Surface Downstream of the Exit of a Simulated Turbojet Nacelle at a Free-Stream Mach Number of 2.02

An investigation at a free-stream Mach number of 2.02 was made to determine the effects of a propulsive jet on a wing surface located in the vicinity of a choked convergent nozzle. Static-pressure surveys were made on a flat surface that was located in the vicinity of the propulsive jet. The nozzle was operated over a range of exit pressure ratios at different fixed vertical distances from the flat surface. Within the scope of this investigation, it was found that shock waves, formed in the external flow because of the presence of the propulsive jet, impinged on the flat surface and greatly altered the pressure distribution. An integration of this pressure distribution, with the location of the propulsive jet exit varied from 1.450 propulsive-jet exit diameters to 3.392 propulsive-jet exit diameters below the wing, resulted in an incremental lift for all jet locations that was equal to the gross thrust at an exit pressure ratio of 2.86. This incremental lift increased with increase in exit pressure ratio, but not so rapidly as the thrust increased, and was approximately constant at any given exit pressure ratio.

Bressette, Walter E.↗

Effects of external stream flow and afterbody variations on the performance of a plug nozzle

The off-design operation of an isentropic plug nozzle designed for a jet pressure ratio of 15 was investigated experimentally at subsonic Mach numbers up to 0.9 and jet pressure ratios up to 5. When installed in a cylindrical nacelle with a sharp turn at the nozzle lip, the interaction of the jet and the external stream produced low pressures on the base formed by the high lip angle. These low pressures increased the nacelle drag and caused an overexpansion of the jet, which resulted in lower pressures on the plug and, hence, reduced thrust. With a boattail ahead of the plug nozzle, the base pressures were increased and the jet overexpansion significantly reduced.

Salmi, R J↗

Experimental investigation of water injection in subsonic diffuser of a conical inlet operation at free-stream Mach number of 2.5

A spike-type nose inlet with sharp-lip cowl was investigated at a free-stream Mach number of 2.5 with water injection in its 16-inch diameter, 11-foot-long subsonic diffuser section. Inlet total temperature of exit with liquid-air ratios of about 0.04 with no apparent change in the critical pressure recovery. The observed temperature drops were less than the theoretically predicted values, and the amount of water evaporated was 35 to 50 percent less than that theoretically possible.

Beke, Andrew↗

Observation of Laminar Flow on a Blunted 15 Degree Cone-cylinder in Free Flight at High Reynolds Numbers and Free-stream Mach Numbers to 8.17

A highly polished 15 degree included-angle cone-cylinder with hemispherical tip has been flown to obtain boundary-layer transition and heat-transfer data. The model was launched from a carrier plane at an altitude of 47,500 feet. Laminar flow existed at a Reynolds number greater than 38.5 x 10(exp) 6 on the cylinder when the model was at the peak free-stream Mach number of 8.17. The results indicate an appreciable and favorable effect of tip bluntness in raising the allowable skin temperature for a given boundary-layer transition Reynolds number.

Disher, John H↗

Slip-stream corrections performance computation

This report is an analysis of experiments performed by Eiffel on the air velocity in slip stream of a propeller, and also includes a theoretical discussion of the magnitude of the velocity in different propellers.

Warner, Edward P↗

Heat Transfer from Finned Metal Cylinders in an Air Stream

This report presents the results of tests made to supply design information for the construction of metal fins for the cooling of heated cylindrical surfaces by an air stream. A method is given for determining fin dimensions for a maximum heat transfer with the expenditure of a given amount of material for a variety of conditions of air flow and metals.

Biermann, Arnold, E↗

On stability of free laminar boundary layer between parallel streams

An analysis and calculations on the stability of the free laminar boundary layer between parallel streams were made for an incompressible fluid using the Tollmien-Schlichting theory of small disturbances. Because the boundary conditions are at infinity, two solutions of the Orr-Sommerfeld stability equations need not be considered, and the remaining two solutions are exponential in character at the infinite boundaries. The calculations show that the flow is unstable except for very low Reynolds numbers.

Lessen, Martin↗

Free-Stream Boundaries of Turbulent Flows

Report presents the results of an experimental and theoretical study made of the instantaneously sharp and irregular front which is always found to separate turbulent fluid from contiguous "nonturbulent" fluid at a free-stream boundary. This distinct demarcation is known to give an intermittent character to hot-wire signals in the boundary zone. The overall behavior of the front is described statistically in terms of its wrinkle-amplitude growth and its lateral propagation relative to the fluid as functions of downstream coordinate.

Corrsin, Stanley↗

Experimental Investigation of Effects of Primary Jet Flow and Secondary Flow Through a Zero-length Ejector on Base and Boattail Pressures of a Body of Revolution at Free-stream Mach Numbers of 1.62, 1.93, and 2.41

An investigation was made at free-stream Mach numbers of 1.62, 1.93, and 2.41 to determine the effects of a primary jet and secondary air flow on the base pressure and pressures acting over the boattailsurface of a body of revolution for two secondary discharge areas. The Mach numbers of the primary nozzles were 1 and 3.23 with the secondary mass flow being varied from 0 to 10 percent of the primary mass flow. The ratio of jet stagnation temperature to tunnel stagnation temperature was about 0.96. The Reynolds number range of the investigation was from 2.1 x 10(6) to 2.9 x 10(6)based on body length. All testing was conducted with a turbulent boundary layer along the model. This report presents results obtained with zero-length ejector and covers jet static-pressure ratios from the jet-off condition to a maximum of about 128 for the sonic nozzle and to a maximum of about 9 for the supersonic nozzle.

O'Donnell, Robert M↗

Attaining a steady air stream in wind tunnels

Many experimental arrangements of varying kind involve the problems of assuring a large, steady air stream both as to volume and to time. For this reason a separate discussion of the methods by which this is achieved should prove of particular interest. Motors and blades receive special attention and a review of existent wind tunnels is also provided.

Prandtl, L↗

A CM chondrite cluster and CM streams

An elongate year-day concentration of CM meteoroid falls between 1921 and 1969 is inconsistent with a random flux of CM meteoroids and suggests that most or all such meteorites, and perhaps the Kaidun C-E chondrite breccia, resulted from streams of meteoroids in nearly circular, Earth-like orbits. To establish whether the post-1920 cluster might have arisen from random sampling, we determined the year-day distribution of 14 falls between 1879 and 1969 by treating each as the corner of a cell of specified dimensions (e.g. 30 years x 30 days) and calculated how many falls occurred in that cell. We then compared the CM cell distribution with random distributions over the same range of years. The results show that for 30 x 30 and 45 x 45 cells, fewer than 5 percent of random sets match the CM distribution with respect to maximum cell content and number of one-fall cells.

Dodd, R. T.↗

Investigation of AIRSAR signatures of the Gulf Stream

Extensive Airborne Synthetic Aperture Radar (AIRSAR) measurements were made on 20 July 1990 during the NRL Gulf Stream (GS) experiment which addressed a number of scientific questions relating to SAR imaging of the ocean surface in the presence of variable currents and the background thermohaline circulation. The nature of the electromagnetic (e.m.) backscatter from the North edge of the GS using polarimetric signatures and amplitude imagery from the AIRSAR data is addressed.

Valenzuela, G. R.↗

Multivariate statistical analysis: Principles and applications to coorbital streams of meteorite falls

Multivariate statistical analysis techniques (linear discriminant analysis and logistic regression) can provide powerful discrimination tools which are generally unfamiliar to the planetary science community. Fall parameters were used to identify a group of 17 H chondrites (Cluster 1) that were part of a coorbital stream which intersected Earth's orbit in May, from 1855 - 1895, and can be distinguished from all other H chondrite falls. Using multivariate statistical techniques, it was demonstrated that a totally different criterion, labile trace element contents - hence thermal histories - or 13 Cluster 1 meteorites are distinguishable from those of 45 non-Cluster 1 H chondrites. Here, we focus upon the principles of multivariate statistical techniques and illustrate their application using non-meteoritic and meteoritic examples.

Wolf, S. F.↗

The 5-6 December 1991 FIRE IFO 2 jet stream cirrus case study: The influence of volcanic aerosols

In presenting an overview of the cirrus clouds comprehensively studied by ground-based and airborne sensors from Coffeyville, KS, during the 5-6 Dec. 1992 Project FIRE (First International Satellite Cloud Climatology Project Regional Experiment) IFO II case study period, evidence is provided that volcanic aerosols from the June 1991 Pinatubo eruptions significantly influenced the formation and maintenance of the cirrus. Following the local appearance of a spur of stratospheric volcanic debris from the subtropics, a series of jet streaks subsequently conditioned the troposphere through tropopause foldings with sulfur-based particles that became effective cirrus cloud-forming nuclei. Aerosol and ozone measurements suggest a complicated history of stratospheric-tropospheric exchanges embedded within the upper level flow, and cirrus cloud formation was noted to occur locally at the boundaries of stratospheric aerosol-enriched layers that became humidified through diffusion, precipitation, or advective processes. Apparent cirrus cloud alterations include abnormally high ice crystal concentrations (up to approximately 600 l(sup -1), small but complex radial ice crystal types, and relatively large haze particles in cirrus uncinus cell heads at temperatures between -40 to -50 C. Implications for volcanic-cirrus cloud climate effects, and usual (non-volcanic aerosol) jet stream cirrus cloud formation are discussed.

Sassen, Kenneth↗