Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “LENGTH”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,369 records · Page 76

Truncation length for Viterbi decoding

A bound is derived and analyzed for the bit error rate (BER) of a Viterbi decoder with survivor truncation. Estimates of the SNR (signal-to-noise ratio) loss on the AWGN (additive white Gaussian noise) channel due to truncation are obtained for convolutional codes. Larger truncation lengths are required than the smallest value that does not effectively decrease the code's free distance, especially at low Eb/N0.

Onyszchuk, Ivan M.↗

Influence of aerodynamic roughness length on aeolian processes: Earth, Mars, Venus

The aerodynamic roughness length (z sub 0) is the height at which a wind profile assumes a zero velocity. The lower part of the atmospheric boundary layer will be impeded by friction with the surface. An increase in surface roughness will also increase the shear stress required to initiate particle entrainment by the wind. Bagnold (1941) estimated z sub 0 as being 1/30 of the mean particle size. In Nature, surface roughness is composed of nonerodible elements as well as sand-size erodible particles. To assess z sub 0 values as a function of terrain, field experiments were conducted to obtain wind profiles monitored over natural surfaces at 15 sites in the Mojave Desert, Death Valley, and Nye County, Nevada. These sites span a variety of arid-land terrains, including smooth playas, alluvial fans, and lava flows; z sub 0 values ranged from 0.0001 cm to 1 cm. These values were incorporated in a threshold model and a flux model to assess transport efficiency over such terrains in three planetary environments (Venus, Earth, and Mars), and for particle sizes ranging from 60-500 micron. Threshold and flux are a function of planetary environment, particle density and size (Dp), and z sub 0, and the shear velocity of 1.2 x U sub *t (for Dp = 250 micron and z sub 0 = 0.84). Results show that flux on Mars is approximately 14 g/(cm x s), on Earth it is approximately 3 g/(cm x s), and on Venus 0.5 g/(cm x s). Under all planetary environments, the results also show a dramatic decrease in the flux for particles greater than 200 microns when z sub 0 increases above 0.0085 cm (corresponding to sites consisting of alluvium). When z sub 0 approaches 0.03 cm (corresponding to a mantled pahoehoe lava), the flux diminishes.

Blumberg, Dan G.↗

Length scales and dissipation of fine eddies in a mixing layer

It has been shown that small scale turbulence is produced by the interactions of the merging spanwise structures (rollers) and the streamwise vortices (ribs). In this study, we examine the dissipation rate of the three dimensional kinetic energy and length scales associated with the dissipation rate in a temporally evolving mixing layer.

Zohar, Y.↗

Extratropical aspects of the 40-50 day oscillation in length-of-day and atmospheric angular momentum

The 40-50-d oscillation in length-of-day (LOD) and AAM is investigated using the 12-yr overlap between two records: AAM data, compiled from the NMC, and LOD variation from the JPL Kalman-filtered earth rotation series. The NMC records are analyzed by latitude belts, in the light of the UCLA GCM results, in order to identify possibly distinct sources of the AAM oscillation in the midlatitudes and the tropics. Results suggest that two intraseasonal oscillations exist in the earth-atmosphere system: a tropical 50-d oscillation associated with the convectively driven waves of the type first described by Madden and Julian (1971) and a midlatitude 40-d oscillation associated with the interaction of nonzonal flow with topography.

Dickey, J. O.↗

Forecasting atmospheric angular momentum and length-of-day using operational meteorological models

Forecasts of zonal wind fields produced by the medium-range forecast model of the U.S. National Meteorological Center are used to create predictions of the atmosphere's angular momentum at lead times of 1-10 days. The skill of these forecasts, which are of interest to those concerned with monitoring changes in the length-of-day for navigational purposes, is assessed, and the regions in the atmosphere that contribute most importantly to forecast errors are identified.

Rosen, R. D.↗

Evaluation of the minority carrier diffusion length and surface-recombination velocity in GaAs p/n solar cells

The minority carrier diffusion length (Lp) and the surface recombination velocity (Vs) were measured as a function of distance (x) from the p-n junction in GaAs p/n concentrator solar cells. The measured Vs values were used in a theoretical expression for the normalized electron-beam-induced current. A fitting procedure was then used to fit this expression with experimental values to obtain Lp. The results show that both Vs and Lp vary with x. Lp measured in irradiated cells showed a marked reduction. These values were compared to those measured previously which did not account for Vs.

Hakimzadeh, Roshanak↗

The cosmic-ray path length (age) distribution in the Galaxy - Experimental limits on the deviation from an exponential

A systematic examination is presented of the observational effects that can provide information on the departure of the cosmic-ray path length distribution (PLD) for propagation in the Galaxy from a simple exponential distribution. The possible physical causes for this departure are examined in order to set realistic limits on how well a simple exponential PLD actually describes the distribution of sources and propagation of cosmic rays in the galaxy. From the findings, it is argued that the cosmic ray source distribution must be quite uniform, probably on a scale of about 50 pc or less near the sun. Extending this uniformity to the Galaxy as a whole would imply more than 100,000 active sources. The cosmic-ray propagation can be described quite well by a leaky box model which is equivalent to observing the particles through a dense fog.

Webber, W. R.↗

Improved solar models constructed with a formulation of convection for stellar structure and evolution calculations without the mixing-length theory approximations

We have updated a previous attempt to incorporate within a solar model a treatment of convection based upon numerical simulations of convection rather than mixing-length theory (MLT). We have modified our formulation of convection for a better treatment of the kinetic energy flux. Our solar model has been updated to include a complete range of OPAL opacities, the Debye-Hueckel correction to the equation of state, helium diffusion due to gravitational settling, and atmospheres by Kurucz. We construct a series of models using both MLT and our revised formulation of convection and the compared results to measurements of the solar radius, the solar luminosity, and the depth of the solar convection zone as inferred from helioseismology. We find X(solar) = 0.702 +/- 0.005, Y(solar) = 0.278 +/- 0.005, and Z(solar) = 0.0193 +/- 0.0005.

Lydon, Thomas J.↗

Atmospheric attenuation length for relativistic solar protons

We compute the mean attenuation length lambda(f) in earth's atmosphere for the protons produced in the solar flare of 29 September, 1989. We use data obtained with three pairs of neutron monitors. The detectors in the pair have very similar values of the geomagnetic vertical cutoff rigidity R(0) and overlapping asymptotic cones of acceptance but they differ in terms of the altitudes of the observing sites. We apply the Wilson et al. (1967) method to compute the values of lambda(f) for the three representative pairs which cover a range of solar proton rigidities. The computed mean values of lambda(f) are significantly larger than the consensus value of (100 +/- 5) g/sq cm reported in the literature. Also, they exhibit a linear correlation with R(0).

Ahluwalia, H. S.↗

Minority carrier diffusion length and edge surface-recombination velocity in InP

A scanning electron microscope was used to obtain the electron-beam-induced current (EBIC) profiles in InP specimens containing a Schottky barrier perpendicular to the scanned (edge) surface. An independent technique was used to measure the edge surface-recombination velocity. These values were used in a fit of the experimental EBIC data with a theoretical expression for normalized EBIC (Donolato, 1982) to obtain the electron (minority carrier) diffusion length.

Hakimzadeh, Roshanak↗

A physical basis formulation for the electromagnetic backscattering by a finite-length rectangular trough in a ground plane

The electromagnetic backscattering from a finite-length rectangular trough in an infinite ground plane is examined. A physical basis formulation, as introduced by Richmond (1985), is used to express the unknown currents in the trough aperture in terms of a forced wave resulting from the incident plane wave, and one or more pairs of oppositely directed traveling waves propagating along the trough. A Galerkin solution is employed to solve a very small system of equations to determine the weights of the postulated aperture currents, and then radiated to compute the radar cross section (RCS). These results are then compared with a measurement of a trough in a finite ground.

Shamansky, Harry T.↗

A formulation of convection for stellar structure and evolution calculations without the mixing-length theory approximations. II - Application to Alpha Centauri A and B

We have constructed a series of models of Alpha Centauri A and Alpha Centauri B for the purposes of testing the effects of convection modeling both by means of the mixing-length theory (MLT), and by means of parameterization of energy fluxes based upon numerical simulations of turbulent compressible convection. We demonstrate that while MLT, through its adjustable parameter alpha, can be used to match any given values of luminosities and radii, our treatment of convection, which lacks any adjustable parameters, makes specific predictions of stellar radii. Since the predicted radii of the Alpha Centauri system fall within the errors of the observed radii, our treatment of convection is applicable to other stars in the H-R diagram in addition to the sun. A second set of models is constructed using MLT, adjusting alpha to yield not the 'measured' radii but, instead, the radii predictions of our revised treatment of convection. We conclude by assessing the appropriateness of using a single value of alpha to model a wide variety of stars.

Lydon, Thomas J.↗

Characterization of length and velocity scales of free stream turbulence and investigation of their effects on surface heat transfer

The main objective of this research is to address two important but unresolved problems: (1) the measurement of vertical and transverse length scales via space correlations for all Reynolds stress components and velocity-temperature correlations, both in the free stream and within the boundary layer using the existing triple and quad-wire probes; and (2) to relate the character of the free stream turbulence to the character of the turbulence within the boundary layer in order to determine the effect on surface heat transfer.

Yavuzkurt, Savash↗

Effect of orifice length-diameter ratio on the coefficient of discharge of fuel-injection nozzles

The variation of the coefficient of discharge with the length-diameter ratio of the orifice was determined for nozzles having single orifice 0.008 and 0.020 inch in diameter. Ratios from 0.5 to 10 were investigated at injection pressures from 500 to 5,000 pounds per square inch. The tests showed that, within the error of the observation, the coefficients were the same whether the nozzles were assembled at the end of a constant tube or in an automatic injection valve having a plain stem.

Gelalles, A G↗

Linear theory of boundary effects in open wind tunnels with finite jet lengths

In the first part, the boundary conditions for an open wind tunnel (incompressible flow) are examined with special reference to the effects of the closed entrance and exit sections. Basic conditions are that the velocity must be continuous at the entrance lip and that the velocities in the upstream and downstream closed portions must be equal. In the second part, solutions are derived for four types of two-dimensional open tunnels, including one in which the pressures on the two free surfaces are not equal. Numerical results are given for every case. In general, if the lifting element is more than half the tunnel height from the inlet, the boundary effect at the lifting element is the same as for an infinitely long open tunnel. In the third part, a general method is given for calculating the boundary effect in an open circular wind tunnel of finite jet length. Numerical results are given for a lifting element concentrate at a point on the axis.

Katzoff, S↗

Concerning the flow about ring-shaped cowlings Part II : annular bodies of infinite length with circulation for smooth entrance

The investigations carried out in a previous report (NACA TM 1325) concerning the flow about ring-shaped cowlings were extended by taking a circulation about the cowling into consideration. The present second report treats bodies of infinite length with approximately smooth entrance. The circulation was caused by distributing vortex rings of constant density over a stream surface extending to infinity. Furthermore, the influence of a hub body on such cowlings was dealt with. The examples treated are meant to give the designer a basis for his design.

FLOW, INCOMPRESSIBLE↗

Optimality Of Variable-Length Codes

Report presents analysis of performances of conceptual Rice universal noiseless coders designed to provide efficient compression of data over wide range of source-data entropies. Includes predictive preprocessor that maps source data into sequence of nonnegative integers and variable-length-coding processor, which adapts to varying entropy of source data by selecting whichever one of number of optional codes yields shortest codeword.

Yeh, Pen-Shu↗