Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “LAND”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,369 records · Page 76

A Summery of an In-flight Evaluation of Control System Pure Time Delays During Landing Using the F-8 DFBW Airplane

An in-flight investigation of the effect of pure time delays on low L/D space shuttle type landing tasks was undertaken. The results indicate that the sensitivity of the pilot ratings to changes in pure time delay in pitch is strongly affected by the task and only slightly affected by changes in control system augmentation mode. Low L/D spot landings from a lateral offset were twice as sensitive to pure time delay as normal low L/D landings. For comparison purposes, formation flying was also investigated, and was found to be less sensitive to time delay than the landing tasks.

Berry, D. T.↗

Landing flying qualities evaluation criteria for augmented aircraft

The criteria evaluated were: Calspan Neal-Smith; Onstott (Northrop Time Domain); McDonnell-Douglas Equivalent System Approach; R. H. Smith Criterion. Each criterion was applied to the same set of longitudinal approach and landing flying qualities data. A revised version of the Neal-Smith criterion which is applicable to the landing task was developed and tested against other landing flying qualities data. Results indicated that both the revised Neal-Smith criterion and the Equivalent System Approach are good discriminators of pitch landing flying qualities; Neal-Smith has particular merit as a design guide, while the Equivalent System Approach is well suited for development of appropriate military specification requirements applicable to highly augmented aircraft.

Radford, R. C.↗

Development of SCR Aircraft takeoff and landing procedures for community noise abatement and their impact on flight safety

Piloted simulator studies to determine takeoff and landing procedures for a supersonic cruise transport concept that result in predicted community noise levels which meet current Federal Aviation Administration (FAA) standards are discussed. The results indicate that with the use of advanced procedures, the subject simulated aircraft meets the FAA traded noise levels during takeoff and landing utilizing average flight crew skills. The advanced takeoff procedures developed involved violating three of the current Federal Aviation Regulations (FAR) noise test conditions. These were: (1) thrust cutbacks at altitudes below 214 meters (700 ft); (2) thrust cutback level below those presently allowed; and (3) configuration change, other than raising the landing gear. It was not necessary to violate any FAR noise test conditions during landing approach. It was determined that the advanced procedures developed do not compromise flight safety. Automation of some of the aircraft functions reduced pilot workload, and the development of a simple head-up display to assist in the takeoff flight mode proved to be adequate.

Grantham, W. D.↗

Studies of some unconventional systems for solving various landing problems

Solutions to various landing problems were obtained through unconventional systems. The first, of these is the air cushion landing system, where efforts were concentrated on development of adequate braking and steering systems and an improved understanding of scaling laws and behavior. The second was concentrated on use of a wire brush skid as a drag producing device, which was shown to have good friction coefficients and reasonable wear rates at ground bearing pressures up to 689 kPa and forward speeds up to 80 km/hr. The third showed great promise in an active control landing gear where significant load reductions were possible during landing impact and subsequent rollout.

Leland, T. J.↗

Simulator evaluation of the effects of reduced spoiler and thrust authority on a decoupled longitudinal control system during landings in wind shear

The effect of reduced control authority, both in symmetric spoiler travel and thrust level, on the effectiveness of a decoupled longitudinal control system was examined during the approach and landing of the NASA terminal configured vehicle (TCV) aft flight deck simulator in the presence of wind shear. The evaluation was conducted in a fixed-base simulator that represented the TCV aft cockpit. There were no statistically significant effects of reduced spoiler and thrust authority on pilot performance during approach and landing. Increased wind severity degraded approach and landing performance by an amount that was often significant. However, every attempted landing was completed safely regardless of the wind severity. There were statistically significant differences in performance between subjects, but the differences were generally restricted to the control wheel and control-column activity during the approach.

Miller, G. K., Jr.↗

VTOL control for shipboard landing in high sea states

A control algorithm is developed for a VTOL type aircraft landing on a small ship in rough seas. The work covers modelling the dynamics of the two vehicles, the design of an aircraft-tracking-ship-motion controller, and the specification of an actual landing control algorithm. The landing controller design is more practical and found to perform better than the hover controller. In addition to outlining a design technique, the results provide design guidelines and performance bounds for practical landing control systems.

Mcmuldroch, C. G.↗

Application of remote sensing for California irrigated lands assessment

Recognizing the need for land use data as an input to State water planning, the California Department of Water Resources (DWR) and its predecessor agencies have conducted land use surveys since the late 1940's. In 1957 the California Water Plan was established. A statewide assessment is compiled every four to five years to review overall water resource conditions. Satellite remote sensing imagery, such as available from Landsat, has been recognized by DWR as a potential source of land use data. Analysis of Landsat imagery in connection with 'calibrating' data from low altitude photography and/or field checks can provide an economical means for providing a large scale, single year base inventory of general land use. The purpose of the Applications Pilot Test is to develop and document the use of Landsat for such an inventory. Towards the overall goal of developing an operational methodology that DWR could cost effectively implement four tasks have been specified.

Tinney, L.↗

Flexible Aircraft Takeoff and Landing Analysis

Flexible Aircraft Takeoff and Landing Analysis Program, FATOLA, simulates aircraft takeoff and landing dynamics. Program includes maneuver logic and autopilots for glide slope, flare, landing, and takeoff and is modular so performance of aircraft in flight and during landing and ground maneuvers can be studied separately or in combination.

Carden, H. D.↗

Development and evaluation of automatic landing control laws for light wing loading STOL aircraft

Automatic flare and decrab control laws were developed for NASA's experimental Twin Otter. This light wing loading STOL aircraft was equipped with direct lift control (DLC) wing spoilers to enhance flight path control. Automatic landing control laws that made use of the spoilers were developed, evaluated in a simulation and the results compared with these obtained for configurations that did not use DLC. The spoilers produced a significant improvement in performance. A simulation that could be operated faster than real time in order to provide statistical landing data for a large number of landings over a wide spectrum of disturbances in a short time was constructed and used in the evaluation and refinement of control law configurations. A longitudinal control law that had been previously developed and evaluated in flight was also simulated and its performance compared with that of the control laws developed. Runway alignment control laws were also defined, evaluated, and refined to result in a final recommended configuration. Good landing performance, compatible with Category 3 operation into STOL runways, was obtained.

Feinreich, B.↗

MLS vertical guidance and navigation for a STOL airplane landing on an elevated STOLport

In contrast to CTOL landing operations, STOL airplanes landing on short STOLport runways typically begin the flare maneuver before reaching the runway surface. Vertical guidance procedures were developed to allow an autoland flight control system for a STOL airplane to use Microwave Landing System (MLS) signals as altitude and sink rate references for flare initiation, with a transition to radar altimeter after the airplane is over the runway. The implementation has minimum impact on the control system and landing performance. Data are presented which show validation of the concepts in a simulator.

Warner, D. N., Jr.↗

Land use in the Paraiba Valley through remotely sensed data

A methodology for land use survey was developed and land use modification rates were determined using LANDSAT imagery of the Paraiba Valley (state of Sao Paulo). Both visual and automatic interpretation methods were employed to analyze seven land use classes: urban area, industrial area, bare soil, cultivated area, pastureland, reforestation and natural vegetation. By means of visual interpretation, little spectral differences are observed among those classes. The automatic classification of LANDSAT MSS data using maximum likelihood algorithm shows a 39% average error of omission and a 3.4% error of inclusion for the seven classes. The complexity of land uses in the study area, the large spectral variations of analyzed classes, and the low resolution of LANDSAT data influenced the classification results.

Dejesusparada, N.↗

Aerodynamic penalties of heavy rain on a landing aircraft

The aerodynamic penalties of very heavy rain on landing aircraft were investigated. Based on severity and frequency of occurrence, the rainfall rates of 100 mm/hr, 500 mm/hr, and 2000 mm/hr were designated, respectively, as heavy, severe, and incredible. The overall and local collection efficiencies of an aircraft encountering these rains were calculated. The analysis was based on raindrop trajectories in potential flow about an aircraft. All raindrops impinging on the aircraft are assumed to take on its speed. The momentum loss from the rain impact was later used in a landing simulation program. The local collection efficiency was used in estimating the aerodynamic roughness of an aircraft in heavy rain. The drag increase from this roughness was calculated. A number of landing simulations under a fixed stick assumption were done. Serious landing shortfalls were found for either momentum or drag penalties and especially large shortfalls for the combination of both. The latter shortfalls are comparable to those found for severe wind shear conditions.

Haines, P. A.↗

Experimental investigation of active loads control for aircraft landing gear

Aircraft dynamic loads and vibrations resulting from landing impact and from runway and taxiway unevenness are recognized as significant in causing fatigue damage, dynamic stress on the airframe, crew and passenger discomfort, and reduction of the pilot's ability to control the aircraft during ground operations. One potential method for improving operational characteistics of aircraft on the ground is the application of active control technology to the landing gears to reduce ground loads applied to the airframe. An experimental investigation was conducted which simulated the landing dynamics of a light airplane to determine the feasibility and potential of a series hydraulic active control main landing gear. The experiments involved a passive gear and an active control gear. Results of this investigation show that a series hydraulically controlled gear is feasible and that such a gear is very effective in reducing the loads transmitted by the gear to the airframe during ground operations.

Mcgehee, J. R.↗

Gravity, lignification, and land plant evolution

Vascular plants began their occupation of the wetlands interfacing both terrestrial and marine environments at some point in early Paleozoic time. Chemical differences between green algae and vascular land plants are mainly related to an abundance of lignins in the land plants. Answers to questions relating to the phylogeny and adaptive significance of the lignins must depend on experiments and observations using contemporary plant material. A summary is provided of a series of such observations. It is found that the differences between modern Chlorophyta and vascular land plants cannot be explained in full on the basis of lignification alone. Nevertheless, the data point to the emergence of the primitive land populations into an oxygen-rich terrestrial world where the need for mechanical support and water conservation could be met by a single aerobic biochemical process connected to essential aromatic amino acids likely to be found in every cell

Siegel, S. M.↗

Use of aerial photography in determining land use and streamflow relationships on small developing watersheds

Using aerial photographs dating back to 1937, the historical trends of five land use classes (crop, forest, open field, urban and suburban) are determined. The relationships between these and various flow regime parameters are investigated. Annual runoff is found to be 7.5 inches greater now than in the year 1932. It is also found that growing season runoff increased by 3.5 inches during the same period. This increase is approximately equivalent to 160 area inches of excess runoff during the 45-year period of observation. The increase in runoff is found to be positively correlated with the percent basin area in the urban, suburban and open field land use classes. A negative correlation is established with forest and crop land. Although poor correlations are found with high flow, low flow, flow interval and flow date data, it is thought that a more precise quantification of land use or a smaller basin area may possibly have yielded more positive results for streamflow timing data.

Owe, M.↗

Improved land use classification from Landsat and Seasat satellite imagery registered to a common map base

In the case of Landsat Multispectral Scanner System (MSS) data, ambiguities in spectral signature can arise in urban areas. A study was initiated in the belief that Seasat digital SAR could help provide the spectral separability needed for a more accurate urban land use classification. A description is presented of the results of land use classifications performed on Landsat and preprocessed Seasat imagery that were registered to a common map base. The process of registering imagery and training site boundary coordinates to a common map has been reported by Clark (1980). It is found that preprocessed Seasat imagery provides signatures for urban land uses which are spectrally separable from Landsat signatures. This development appears to significantly improve land use classifications in an urban setting for class 12 (Commercial and Services), class 13 (Industrial), and class 14 (Transportation, Communications, and Utilities).

Clark, J.↗

LANDSAT applications by the Adirondack Park Agency for land cover analyses and forest cover change

The New York State Adirondack Park Agency is using LANDSAT imagery to provide current, consistent parkwide data on forest cover, forest change and other land cover characteristics for the Adirondack Park, an area of 9,375 sq. miles (24,280 sq km). Boundaries of the study area were digitized and the data were enhanced and geographically rectified. A classification scheme was devised which emphasized the basic land cover types of the Park: hardwoods, spruce-fir, pine, wet conifer, brushland, grassland, agricultural areas, exposed earth, urban areas, and water bodies. Cover type classifications for disturbed forest land were also chosen: cut hardwoods, regenerating hardwoods, and cut spruce fir. Field verification of 1978 classification revealed an accurate differentiation of forest types within types and between nonforested/forested areas. The classification accurately detects forest land disturbances; however, it is not always descriptive of the level of disturbance.

Banta, J. S.↗

Application of tire dynamics to aircraft landing gear design analysis

The tire plays a key part in many analyses used for design of aircraft landing gear. Examples include structural design of wheels, landing gear shimmy, brake whirl, chatter and squeal, complex combination of chatter and shimmy on main landing gear (MLG) systems, anti-skid performance, gear walk, and rough terrain loads and performance. Tire parameters needed in the various analyses are discussed. Two tire models are discussed for shimmy analysis, the modified Moreland approach and the von Schlippe-Dietrich approach. It is shown that the Moreland model can be derived from the Von Schlippe-Dietrich model by certain approximations. The remaining analysis areas are discussed in general terms and the tire parameters needed for each are identified. Accurate tire data allows more accurate design analysis and the correct prediction of dynamic performance of aircraft landing gear.

Black, R. J.↗