Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “level set”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,351 records · Page 75

An ab initio investigation of the structure, vibrational frequencies, and intensities of HO2 and HOCl

The infrared spectral intensities for HOCl and HO2 have been calculated using a new ab initio technique. Theoretical results for the geometries, vibrational frequencies, and the dipole moments of these species are also reported. All of the calculations were performed at the SCF level using near Hartree-Fock quality basis sets. The results for the molecular geometries and the vibrational frequencies are in good agreement with available experimental data. It is believed that the computed intensities are accurate to at least 50%. The results should be helpful in attempts to determine the stratospheric abundance of HOCl and HO2 by in situ infrared spectroscopic measurements.

Komornicki, A.↗

Status of linear boundary-layer stability and the e to the nth method, with emphasis on swept-wing applications

The-state-of-the-art for the application of linear stability theory and the e to the nth power method for transition prediction and laminar flow control design are summarized, with analyses of previously published low disturbance, swept wing data presented. For any set of transition data with similar stream distrubance levels and spectra, the e to the nth power method for estimating the beginning of transition works reasonably well; however, the value of n can vary significantly, depending upon variations in disturbance field or receptivity. Where disturbance levels are high, the values of n are appreciably below the usual average value of 9 to 10 obtained for relatively low disturbance levels. It is recommended that the design of laminar flow control systems be based on conservative estimates of n and that, in considering the values of n obtained from different analytical approaches or investigations, the designer explore the various assumptions which entered into the analyses.

Hefner, J. N.↗

Prediction of noise constrained optimum takeoff procedures

An optimization method is used to predict safe, maximum-performance takeoff procedures which satisfy noise constraints at multiple observer locations. The takeoff flight is represented by two-degree-of-freedom dynamical equations with aircraft angle-of-attack and engine power setting as control functions. The engine thrust, mass flow and noise source parameters are assumed to be given functions of the engine power setting and aircraft Mach number. Effective Perceived Noise Levels at the observers are treated as functionals of the control functions. The method is demonstrated by applying it to an Advanced Supersonic Transport aircraft design. The results indicate that automated takeoff procedures (continuously varying controls) can be used to significantly reduce community and certification noise without jeopardizing safety or degrading performance.

Padula, S. L.↗

Portable Radiometer Monitors Plant Growth

Three-band hand-held spectral radiometer measures electromagnetic energy reflected from plant canopies in the visible and infrared portions of the spectrum. It is mobile and easy to use for rapid, repeated measurements. Radiometer probe is held level over plant canopy, readout range switches are set and measurements are recorded. Chlorophyll content, leaf area index and leaf water content can be quickly and easily measured.

Tucker, C. J., III↗

C-MOS array design techniques

The entire complement of standard cells and components, except for the set-reset flip-flop, was completed. Two levels of checking were performed on each device. Logic cells and topological layout are described. All the related computer programs were coded and one level of debugging was completed. The logic for the test chip was modified and updated. This test chip served as the first test vehicle to exercise the standard cell complementary MOS(C-MOS) automatic artwork generation capability.

Feller, A.↗

Evaluation of the potential format and content of a cockpit display of traffic information

The types and formats of information most suitable to be displayed in a cockpit display of traffic information (CDTI) are investigated. Twenty three airline pilots and 13 instrumentated general aviation pilots were asked to select from sets of symbols of various complexities incorporating various levels of information that would contain all information necessary for monitoring the traffic situation, detecting errors, maintaining separation and merging. Display features selected by a significant number of pilots were then evaluated for their capabilities in helping pilots to assess the lateral or vertical separation between their own and another aircraft in a dynamic simulation. It is found that while some of the features initially chosen by the pilots, such as flightpath predictors, aided the pilots in perceiving the traffic situation correctly, others, such as ground speed and climb/descend arrows and relative altitude encoding of symbols for other aircraft, did not contribute to improved performance speed or accuracy.

Hart, S. G.↗

AgRISTARS: Foreign Commodity production forecasting. Project procedures designation and description document, volume 1

The crop estimation analysis procedures documentation of the AgRISTARS - Foreign Commodity Production Forecasting Project (FCPF) is presented. Specifically it includes the technical/management documentation of the remote sensing data analysis procedures prepared in accordance with the guidelines provided in the FCPF communication/documentation standards manual. Standard documentation sets are given arranged by procedural type and level then by crop types or other technically differentiating categories.

Waggoner, J. T.↗

X-ray observations of LMC X-3 with the monitor proportional counter aboard the HEAO 2 Einstein observatory - A comparison with Cygnus X-1

A comparison is presented of the black hole candidates LMC X-3 and Cygnus X-1 based on Einstein observations of LMC X-3 with the monitor proportional counter. A spectral analysis shows LMC X-3 to be more like the typical bright galactic X-ray source than Cygnus X-1. A search for periodic pulsations over a period range from 0.2 ms to over 1000 s set upper limits at the 90 percent confidence level of the order of 10 percent. An analysis of the aperiodic variability of LMC X-3 shows none of the shot noise behavior characteristic of Cygnus X-1. The absence of distinctive X-ray properties common to both sources suggests that the identification of black hole candidates on the basis of X-ray properties similar to Cygnus X-1 (or LMC X-3) is not reliable.

Weisskopf, M. C.↗

Evidence for equatorial Kelvin modes in Nimbus-7 LIMS

Equatorial Kelvin waves have emerged as an important source of westerly momentum for the tropical stratosphere. The present investigation is concerned with an analysis of remotely derived temperatures from Nimbus-7 LIMS (Limb Infrared Monitor of the Stratosphere). It is found that eastward propagating disturbances are present in two independent LIMS data sets. The disturbances manifest themselves consistently at several levels throughout the stratosphere and account for much of the tropical temperature variance out to latitudes where extratropical signals become large. Compelling evidence is found for several distinct phase velocities. Spectral analysis indicates isolated eastward variance at principally two frequencies for both wavenumbers.

Salby, M. L.↗

Improved Technique for Finding Vibration Parameters

Filtering and sample manipulation reduce noise effects. Analysis technique improves extraction of vibrational frequencies and damping rates from measurements of vibrations of complicated structure. Structural vibrations measured by accelerometers. Outputs digitized at frequency high enough to cover all modes of interest. Use of method on set of vibrational measurements from Space Shuttle, raised level of coherence from previous values below 50 percent to values between 90 and 99 percent

Andrew, L. V.↗

Optimally robust redundancy relations for failure detection in uncertain systems

All failure detection methods are based, either explicitly or implicitly, on the use of redundancy, i.e. on (possibly dynamic) relations among the measured variables. The robustness of the failure detection process consequently depends to a great degree on the reliability of the redundancy relations, which in turn is affected by the inevitable presence of model uncertainties. In this paper the problem of determining redundancy relations that are optimally robust is addressed in a sense that includes several major issues of importance in practical failure detection and that provides a significant amount of intuition concerning the geometry of robust failure detection. A procedure is given involving the construction of a single matrix and its singular value decomposition for the determination of a complete sequence of redundancy relations, ordered in terms of their level of robustness. This procedure also provides the basis for comparing levels of robustness in redundancy provided by different sets of sensors.

Lou, X.-C.↗

Feedback control for penetrating a downburst

Feedback logic is given that produces satisfactory penetration of an aircraft through a severe downburst. The logic has two parts: (1) A switch that calls for full throttle and tight climb-rate-hold feedback logic when the magnitude of headwind-rate exceeds a threshold level; this switch stays on until re-set by the pilot after penetration of the downburst. (2) A tight climb-rate-hold autopilot, using feedback of pitch-angle to angle-of-attack. After penetration, recovery to steady climbing flight is aided by using feedback of airspeed deviation to throttle. Insights on control strategy are gained from an analysis of energy changes during flight through a downburst. Closed-loop simulations are given for a 727 aircraft penetrating severe downbursts on take-off. Boeing's recommendation of constant pitch angle was confirmed as an excellent feedback control strategy.

Bryson, Arthur E., Jr.↗

Satellite/radiosonde comparison

Collocated measurements of radiosonde and TIROS Operational Vertical Sounder (TOVS) data are compared to determine whether significant latitudinal, seasonal, or instrumental biases exist. Long-wave structure determined by each system is being examined for correlation. Because U.S. radiosonde data are archived uncorrected, an effort to correct the measurements is being considered. These corrections will be applied to 7 years of measurements. New comparisons will then be made using corrected radiosonde and TOVS data. A regression method is used to retrieve temperatures, and radiosonde zonal means are used to update the regression coefficients. Preliminary results of auto-correlation analysis indicate that detection of long-wave structure in each set of data is slightly different with some levels and locations experiencing different wave periods or amplitudes. Scatter diagrams and linear regression for each layer show bias in the mean temperatures. Winter-time measurements show poorer correlations due to noisy measurements.

Schmidlin, F. J.↗

Deceit: A flexible distributed file system

Deceit, a distributed file system (DFS) being developed at Cornell, focuses on flexible file semantics in relation to efficiency, scalability, and reliability. Deceit servers are interchangeable and collectively provide the illusion of a single, large server machine to any clients of the Deceit service. Non-volatile replicas of each file are stored on a subset of the file servers. The user is able to set parameters on a file to achieve different levels of availability, performance, and one-copy serializability. Deceit also supports a file version control mechanism. In contrast with many recent DFS efforts, Deceit can behave like a plain Sun Network File System (NFS) server and can be used by any NFS client without modifying any client software. The current Deceit prototype uses the ISIS Distributed Programming Environment for all communication and process group management, an approach that reduces system complexity and increases system robustness.

Siegel, Alex↗

Multi-dimensional modulation codes for fading channel

Some new codes are presented which have good performance on Rician fading channel with small decoding complexities. A new M-way partition chain is proposed for the L x MPSK (L less than or equal to M) signal set which maximizes the intra-set distance of each subset at each partition level. Based on this partition chain, a class of asymptotical optimum codes was found. For M = 4, these codes have both large symbol distances and product distances. Multi-level coding scheme allows to construct a code by hand such that the code meets some desired parameters, e.g., symbol distance, product distance, etc. In design of a multi-level code, all factors were considered which affect the performance and complexity of the code, such as, the decoding scheme, decoding complexity, and performance under the decoding scheme, e.g., if the multi-stage decoding scheme is used, the performance degradation due to the suboptimum decoding is taken into consideration. The performance for most of the presented codes was simulated on Rayleigh fading channel, and the results show that these codes have good performance with small decoding complexities.

Lin, Shu↗

Vibration-dissociation coupling in nonequilibrium flows

The purpose of the study is to evaluate all important physical phenomena contributing to the vibration-dissociation problem by developing a numerical technique for the simulation of the vibrational relaxation and dissociation/recombination of N(2) in an isothermal box. A set of coupled master equations representing each vibrational level of N(2) is solved, and both V-V and V-T exchanges between molecules and atoms are included, along with the effects of dissociation and recombustion from/to each level. It is observed that the inverse range parameter has a strong impact on the vibrational exchange rates and relaxation. In a heating case, the lower vibrational levels relax through a series of equilibrium distributions, while in a cooling case, a population inversion is formed in the upper levels. Other cases of heating and cooling will be simulated, and together with this work, used to develop a matrix of nonequilibrium relaxation runs.

Landrum, D. Brian↗

Tectonic deformation on icy satellites: A model of compensating horsts

Voyager images demonstrate that the icy satellites have been shaped by a variety of magmatic and tectonic processes, of which ridge and trough terrain is a manifestation. This terrain is observed on Ganymede, Enceladus, Miranda, and Ariel, and many models have been proposed to explain its origin. A likely model is horst and graben style normal faulting, in which horizontal extension results in a series of downdropped grabens and relatively uplifted horsts. The apparent negative elevation of ridges and troughs relative to surrounding terrain has been used to argue such an extensional-tectonic origin for ridge and trough terrain on Ganymede and Enceladus. A ridge or ridge set which stands above a presumed original base level, thus, might be suspect of having a magmatic or compressional origin. It has been shown that rotation of domino-style normal faulting, which involves rotation of fault blocks about a fulcrum, can allow ridges to stand slightly above the original base level, and this relative uplift may be amplified by isostatic uplift. Compensation might also be accomplished through uplift of adjacent horsts. These theories are defended with dynamical equations.

Pappalardo, Robert↗