Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “AERODYNAMICS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,351 records · Page 75

Cascade flutter analysis with transient response aerodynamics

Two methods for calculating linear frequency domain aerodynamic coefficients from a time-marching Full-Potential cascade solver are developed and verified. In the first method, the Influence Coefficient method, solutions to elemental problems are superposed to obtain the solutions for a cascade in which all blades are vibrating with a constant interblade phase angle. The elemental problem consists of a single blade in the cascade oscillating while the other blades remain stationary. In the second method, the Pulse Response method, the response to the transient motion of a blade is used to calculate influence coefficients. This is done by calculating the Fourier transforms of the blade motion and the response. Both methods are validated by comparison with the Harmonic Oscillation method and give accurate results. The aerodynamic coefficients obtained from these methods are used for frequency domain flutter calculations involving a typical section blade structural model. An eigenvalue problem is solved for each interblade phase angle mode and the eigenvalues are used to determine aeroelastic stability. Flutter calculations are performed for two examples over a range of subsonic Mach numbers using both flat plates and actual airfoils.

Bakhle, Milind A.↗

Propulsion-induced aerodynamics of an ejector-configured STOVL fighter aircraft

Propulsion-induced aerodynamic effects are computed by using data obtained from tests of a full-scale model of the E-7A configuration that were run in the NASA Ames 40 x 80 and 80 x 120-foot tunnels. These effects are shown both in aerodynamic coefficients and nondimensionalized by thrust versus equivalent velocity. The test results show that the full-scale ventral nozzle-induced effects are smaller than scale model data, while the ejector-induced effects demonstrate fair agreement. The effect of tunnel test section size is primarily observed at low and static speed, high thrust conditions, as seen in comparisons of data from both tunnels. The 80 x 120-foot tunnel test gave better static thrust calibrations and permitted a greater range of test freestream velocities and angles-of-attack, extending the database provided by the full-scale model.

Poppen, William A.↗

Progress in laser-spectroscopic techniques for aerodynamic measurements - An overview

An overview is given of the capabilities and recent progress in laser-spectroscopic measurement techniques for use in aerodynamic test facilities and flight research vehicles. It includes a survey of the literature which is centered on this application of laser spectroscopy. The intended reader is the specialist in experimental fluid dynamics who is not intimately familiar with the physics or applications of laser spectroscopy. Thus, some discussion is also included of the nature of each laser-spectroscopic technique and the practical aspects of its use for aerodynamic measurements. The specific techniques reviewed include laser absorption, laser-induced fluorescence, laser Rayleigh scattering, and laser Raman scattering including spontaneous and coherent processes.

Mckenzie, Robert L.↗

Effect of a simulated ice accretion on the aerodynamics of a swept wing

The effect of a simulated glaze ice accretion on the aerodynamic performance of a three-dimensional swept wing is studied experimentally. A semispan wing of effective aspect ratio four was mounted from the sidewall of the UIUC subsonic wind tunnel. The model uses a NACA 0012 airfoil section on a rectangular planform with interchangeable tip and root sections to allow for 0- and 30-degree sweep. A sidewall suction system is used to minmize the tunnel boundary-layer interaction with the model. Surface pressure data from five spanwise stations are compared to earlier data from a similar tunnel. A three-component sidewall balance has been designed, built and used to measure lift, drag and pitching moment on the clean and iced model. The data compare well to the integrated pressure data and to theory on the clean model. In addition, helium-bubble flow visualization has been performed on the iced model and reveals extensive spanwise flow in the separation bubble aft of the upper surface horn. This compares well to the computational results of other researchers. Sidewall suction was found to have no effect on the aerodynamics of the swept wing.

Bragg, M. B.↗

Influence of aerodynamic forces in ice shedding

Stresses in accreted ice on a typical airfoil impact ice caused by aerodynamic forces have been studied using finite element analyses. The objective of this study is to determine the significance of these stresses relative to values needed to cause ice shedding. In the case studied, stresses are not significant (less than 10 percent) when compared to the fracture value for airspeeds below a Mach number of 0.45. Above this velocity, the influence of aerodynamic forces on impact ice stresses should be considered in analyses of ice shedding.

Scavuzzo, R. J.↗

Control of flow separation and mixing by aerodynamic excitation

The recent research progress in the control of shear flows using unsteady aerodynamic excitation conducted at the NASA Lewis Research Center is reviewed. The program is of fundamental nature concentrating on the physics of the unsteady aerodynamic processes. This field of research is a fairly new development with great promise in the areas of enhanced mixing and flow separation control. Enhanced mixing research reported in this paper include influence of core turbulence, forced pairing of coherent structures, and saturation of mixing enhancement. Separation flow control studies included are for a two-dimensional diffuser, conical diffusers, and single airfoils. Ultimate applications of this research include aircraft engine inlet flow control at high angle of attack, wide angle diffusers, highly loaded airfoils as in turbomachinery, and ejector/suppressor nozzles for the supersonic transport. An argument involving the Coanda Effect is made here that all of the above mentioned application areas really only involve forms of shear layer mixing enhancement. The program also includes the development of practical excitation devices which might be used in aircraft applications.

Rice, Edward J.↗

Development of unstructured grid methods for steady and unsteady aerodynamic analysis

The current status of the development of unstructured grid methods in the Unsteady Aerodynamic Branch at NASA-Langley is described. These methods are being developed for steady and unsteady aerodynamic applications. The flow solvers that were developed for the solution of the unsteady Euler and Navier-Stokes equations are highlighted and selected results are given which demonstrate various features of the capability. The results demonstrate 2-D and 3-D applications for both steady and unsteady flows. Comparisons are also made with solutions obtained using a structured grid code and with experimental data to determine the accuracy of the unstructured grid methodology. These comparisons show good agreement which thus verifies the accuracy.

Batina, John T.↗

Aeroassisted Flight Experiment aerodynamic characteristics at flight conditions

The success of NASA's Aeroassisted Flight Experiment project depends on the suitable placement of instrumentation on the vehicle surface and the ability of the vehicle to fly the maximum science payload. The initial aerodynamic data base was established using wind tunnel data and CFD analyses, where the influence of real-gas effects precluded the use of ground-facility data. More recently, a viscous thermochemical nonequilibrium flow analysis about the complete vehicle, including the wake, has updated the vehicle aerodynamic data base.

Weilmuenster, K. James↗

Incipient torsional stall flutter aerodynamic experiments on a swept three-dimensional wing

The aerodynamics of small amplitude pitching motions near stall have been studied experimentally in order to improve understanding of the torsional stall flutter problem for propeller blades. A model wing was oscillated in pitch at several small amplitudes over a wide and representative range of conditions. Unsteady surface pressures were measured and integrated to determine the aerodynamic damping at five spanwise stations. Strong negative damping was found for motions centered near static stall for all studied reduced frequencies, Mach numbers, and sweep angles. The 30-deg sweptback configuration was found to become negatively damped over the entire span nearly simultaneously, while the unswept model exhibited local regions of negative damping that moved toward the wing tip as the mean angle of attack was increased.

Lorber, Peter F.↗

Transonic adaptive flutter suppression using approximate unsteady time domain aerodynamics

A digital adaptive controller is applied to the active flutter suppression problem of a wing under time varying flight conditions in subsonic and transonic flow. Linear quadratic controller gain at each time step is obtained using an iterative Riccati solver. The digital adaptive optimal controller is robust with respect to the unknown external loads. Flutter and divergence instabilities are simultaneously suppressed using a trailing-edge control surface and displacement sensing. A new transonic unsteady aerodynamic approximation methodology is developed which enables one to carry out the rapid calculation required for transonic aeroservoelastic applications. This approximation is based on a combination of unsteady subsonic aerodynamics combined with a transonic correction procedure. Aeroservoelastic transient time response is obtained using Roger's approximation, state transition matrices and an iterative time marching algorithm. The aeroservoelastic system in the time domain is modeled using a deterministic ARMA model together with a parameter estimator. Transonic flutter boundaries of a wing structure are computed, in the time domain, using an estimated aeroelastic system matrix and are in good agreement with experimental data for the low transonic Mach number range.

Pak, Chan-Gi↗

A methodology for using nonlinear aerodynamics in aeroservoelastic analysis and design

A methodology is presented for using the Volterra-Wiener theory of nonlinear systems in aeroservoelastic (ASE) analyses and design. The theory is applied to the development of nonlinear aerodynamic response models that can be defined in state-space form and are, therefore, appropriate for use in modern control theory. The theory relies on the identification of nonlinear kernels that can be used to predict the response of a nonlinear system due to an arbitrary input. A numerical kernel identification technique, based on unit impulse responses, is presented and applied to a simple bilinear, single-input-single-output system. The linear kernel (unit impulse response) and the nonlinear second-order kernel of the system are numerically-identified and compared with the exact, analytically-defined linear and second-order kernels. This kernel identification technique is then applied to the CAP-TSD code for identification of the linear and second-order kernels of a NACA64A010 rectangular wing undergoing pitch at M = 0.5, M = 0.85 (transonic), and M = 0.93 (transonic). Results presented demonstrate the feasibility of this approach for use with nonlinear, unsteady aerodynamic responses.

Silva, Walter A.↗

Aerodynamic and structural studies of joined-wing aircraft

A method for rapidly evaluating the structural and aerodynamic characteristics of joined-wing aircraft was developed and used to study the fundamental advantages attributed to this concept. The technique involves a rapid turnaround aerodynamic analysis method for computing minimum trimmed drag combined with a simple structural optimization. A variety of joined-wing designs are compared on the basis of trimmed drag, structural weight, and, finally, trimmed drag with fixed structural weight. The range of joined-wing design parameters resulting in best cruise performance is identified. Structural weight savings and net drag reductions are predicted for certain joined-wing configurations compared with conventional cantilever-wing configurations.

Kroo, Ilan↗

Aerodynamic shape optimization using sensitivity analysis on third-order Euler equations

Two major advancements of an aerodynamic optimization method with two design variables are described. The first is represnted by an improved flow prediction method that uses the third-order accurate discretization of the Euler equations. This method makes it possible to predict the flowfield of a perturbed shape which generates shocks and other large gradients without intermediate CFD analysis. The second advancement is the use of every surface grid point as a design variable in the aerodynamic shape optimization problem. The improved algorithm is demonstrated by optimizing the ramp shape of a scramjet-afterbody configuration for maximum axial thrust. It is concluded that the improved flow-field prediction method eliminates most of the flow analysis and a priori guessing of all possible shapes from which the optimum is to be selected.

Baysal, Oktay↗

Probabilistic modeling for simulation of aerodynamic uncertainties in propulsion systems

The numerical simulation of the probabilistic aerothermodynamic response of propulsion system components to randomness in their environment was explored. The reusable rocket engine turbopumps were selected as an example because of the severe cryogenic environment in which they operate. The thermal and combustion instabilities, coupled with the engine thrust requirements from start up to shut down, lead to randomness in the flow variables and uncertainties in the aerosynamic loading. The probabilistic modeling of the turbopumps' aerodynamic response was accomplished using the panel method coupled with fast probability integration methods. The aerodynamic response in the form of probabilistic rotor blades and splitter loading were predicted and the results presented for specified flow coefficient and rotor preswirl variance. Possible future applications of the aerothermodynamic probabilistic modeling in engine transient simulation, condition monitoring, and engine life prediction are briefly discussed.

Hamed, A.↗

Supersonic aerodynamic characteristics of a maneuvering canard-controlled missile with fixed and free-rolling tail fins

Wind tunnel investigations were conducted on a generic cruciform canard-controlled missile configuration. The model featured fixed or free-rolling tail-fin afterbodies to provide an expanded aerodynamic data base with particular emphasis on alleviating large induced rolling moments and/or for providing canard roll control throughout the entire test angle-of-attack range. The tests were conducted in the NASA Langley Unitary Plan Wind Tunnel at Mach numbers from 2.50 to 3.50 at a constant Reynolds number per foot of 2.00 x 10 to the 6th. Selected test results are presented to show the effects of a fixed or free-rolling tail-fin afterbody on the static longitudinal and lateral-directional aerodynamic characteristics of a canard-controlled missile with pitch, yaw, and roll control at model roll angles of 0 deg and 45 deg.

Blair, A. B., Jr.↗

Plotting Program For Aerodynamical Computations

Panel Method Aerodynamic Plotting Program (PMAPP) written to plot results of aerodynamical analyses (flow data) from PMARC (ARC-12642), program for computation of three-dimensional flow by low-order panel method. PMAPP is interactive, color-capable graphics program designed to work with variety of computer terminals and printers. Also used to plot data from other programs, provided files containing those data defined according to PMARC conventions. Written in FORTRAN 77.

Wigren, L. J.↗

Aerodynamic Shutoff Valve

Aerodynamic flow achieved by adding fixed fairings to butterfly valve. When valve fully open, fairings align with butterfly and reduce wake. Butterfly free to turn, so valve can be closed, while fairings remain fixed. Design reduces turbulence in flow of air in internal suction system. Valve aids in development of improved porous-surface boundary-layer control system to reduce aerodynamic drag. Applications primarily aerospace. System adapted to boundary-layer control on high-speed land vehicles.

Horstman, Raymond H.↗

Recent progress in computational vortex-flow aerodynamics

Recent progress in computational vortex flow aerodynamics at the Langley Research Center is reviewed. Emphasis is placed on Navier-Stokes methodology, both for compressible and incompressible flows, and results are presented from central and upwind-biased schemes for fully laminar, transitional, and fully turbulent flows. In addition, results are presented from selected potential-based methods to address the hierarchy of formulations presently available for the computational analysis of aerodynamic vortex flows. Some comparisons among this hierarchy of methods are shown.

Luckring, James M.↗