Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “wind data”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,333 records · Page 74
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Use of steepest descent and various approximations for efficient computation of minimum noise aircraft landing trajectories

The following areas related to landing trajectory optimization research were discussed: (1) programming and modifying the steepest descent optimization procedure, (2) successfully iterating toward the optimum for a four-mile trajectory, (3) beginning optimization runs for a twenty-mile trajectory, and (4) adapt wind tunnel data for computer usage. Other related areas were discussed in detail in the two previous annual reports.

Cook, G.↗
NASA NTRS1975

X-24B flight test program

The X-24B is an air launched, rocket powered research aircraft. A number of its design features constitute a tradeoff between aerodynamics and heating considerations. A vehicle description is given and test program objectives are discussed along with operational procedures and aspects of energy management. Attention is also given to X-24B handling qualities, approach and landing, wind tunnel data and simulation, and proposed X-24C vehicle requirements.

Manke, J. A.↗
NASA NTRS1976

Preliminary flight-test results of an advanced technology light twin-engine airplane /ATLIT/

The present status and flight-test results are presented for the ATLIT airplane. The ATLIT is a Piper PA-34 Seneca I modified by the installation of new wings incorporating the GA(W)-1 (Whitcomb) airfoil, reduced wing area, roll-control spoilers, and full-span Fowler flaps. Flight-test results on stall and spoiler roll characteristics show good agreement with wind-tunnel data. Maximum power-off lift coefficients are greater than 3.0 with flaps deflected 37 deg. With flaps down, spoiler deflections can produce roll helix angles in excess of 0.11 rad. Flight testing is planned to document climb and cruise performance, and supercritical propeller performance and noise characteristics. The airplane is scheduled for testing in the NASA-Langley Research Center Full-Scale Tunnel.

Holmes, B. J.↗
NASA NTRS1977

Transonic wind-tunnel wall interference

A method for analyzing wall interference is described which avoids the assumption of linear superposition of perturbations in extracting the wall induced velocity field. Measurements of pressure distribution on or near the tunnel walls during the actual wind tunnel test, are imposed as boundary values to be matched. Instead of applying wall interference corrections to the wind tunnel data, some property of the wall is adjusted until a calculated interference free criterion is satisfied for each tunnel data point. The mode of operation for the National Transonic Facility, envisioned as a correctable interference transonic tunnel, combines the capability for accurate assessment of wall interference with a limited capability for wall control.

Kemp, W. B., Jr.↗
NASA NTRS1977

The panel on propulsion aerodynamics

Sources of discrepancies noted between propulsion aerodynamic characteristics as predicted from wind tunnel tests and as measured in flight are discussed. The variable Reynolds capability of the National Transonic Facility will provide a tool for understanding and quantifying uncertainties involved in extrapolating the corrected wind tunnel data from tunnel conditions to full scale flight conditions.

Bowditch, D.↗
NASA NTRS1976

Some theoretical considerations of longitudinal stability in power-on flight with special reference to wind-tunnel testing, November 1942

Some problems relating to longitudinal stability in power-on flight are considered. A derivation is included which shows that, under certain conditions, the rate of change of the pitching moment coefficient with lift coefficient as obtained in wind tunnel tests simulating constant power operation is directly proportional to one of the indices of stability commonly associated with flight analysis, (the slope of the curve relating the elevator angle for trim and lift coefficient). The necessity of analyzing power-on wind tunnel data for trim conditions is emphasized, and a method is provided for converting data obtained from constant thrust tests to simulated constant throttle flight conditions.

Donlan, C. J.↗
NASA NTRS1976

Computation of wave drag for transonic flow

The paper develops a method for calculating wave drag for two-dimensional transonic flow, with particular application to the prediction of the drag rise Mach number of a supercritical wing section. The method is based on a transonic similarity model which is defined by a normalized small perturbation equation and represents shock waves by the addition of an artificial viscosity term in the region of supersonic flow to the partial differential equation. The drag formula obtained allows the computer simulation of transonic wind tunnel data taking account of boundary layer and wall effects.

Garabedian, P. R.↗
NASA NTRS1977

In-flight measurements of the GA/W/-2 aerodynamic characteristics

Flight tests of a new 13% General Aviation Airfoil - the GA(W)-2 - gloved full span onto the existing wing of a Beech Sundowner have generated chordwise pressure distributions and wake surveys. Section lift, drag and moment coefficients derived from these measurements verify wind tunnel data and theory predicting the performance of this airfoil. The effect of steps, rivets and surface coatings upon the drag of the GA(W)-2 was also evaluated.

Gregorek, G. M.↗
NASA NTRS1978

Flight evaluation of the transonic stability and control characteristics of an airplane incorporating a supercritical wing

A TF-8A airplane was equipped with a transport type supercritical wing and fuselage fairings to evaluate predicted performance improvements for cruise at transonic speeds. A comparison of aerodynamic derivatives extracted from flight and wind tunnel data showed that static longitudinal stability, effective dihedral, and aileron effectiveness, were higher than predicted. The static directional stability derivative was slower than predicted. The airplane's handling qualities were acceptable with the stability augmentation system on. The unaugmented airplane exhibited some adverse lateral directional characteristics that involved low Dutch roll damping and low roll control power at high angles of attack and roll control power that was greater than satisfactory for transport aircraft at cruise conditions. Longitudinally, the aircraft exhibited a mild pitchup tendency. Leading edge vortex generators delayed the onset of flow separation, moving the pitchup point to a higher lift coefficient and reducing its severity.

Matheny, N. W.↗
NASA NTRS1978

A method of calibrating wind velocity sensors with a modified gas flow calibrator

A procedure was described for calibrating air velocity sensors in the exhaust flow of a gas flow calibrator. The average velocity in the test section located at the calibrator exhaust was verified from the mass flow rate accurately measured by the calibrator's precision sonic nozzles. Air at elevated pressures flowed through a series of screens, diameter changes, and flow straighteners, resulting in a smooth flow through the open test section. The modified system generated air velocities of 2 to 90 meters per second with an uncertainty of about two percent for speeds below 15 meters per second and four percent for the higher speeds. Wind tunnel data correlated well with that taken in the flow calibrator.

Stump, H. P.↗
NASA NTRS1978

Prediction of unsteady separated flows on oscillating airfoils

Techniques for calculating high Reynolds number flow around an airfoil undergoing dynamic stall are reviewed. Emphasis is placed on predicting the values of lift, drag, and pitching moments. Methods discussed include: the discrete potential vortex method; thin boundary layer method; strong interaction between inviscid and viscous flows; and solutions to the Navier-Stokes equations. Empirical methods for estimating unsteady airloads on oscillating airfoils are also described. These methods correlate force and moment data from wind tunnel tests to indicate the effects of various parameters, such as airfoil shape, Mach number, amplitude and frequency of sinosoidal oscillations, mean angle, and type of motion.

Mccroskey, W. J.↗
NASA NTRS1978

Computational studies of turbulent merger of corotational vortices

A computational study has been conducted to gain a better understanding of the criteria governing the merger of corotating vortices. The zero-equation and one-equation turbulent-flow models are used to model the interaction of two rolled-up, corotational vortices. A model appropriate for the swirling flow under consideration has been proposed to prescribe the algebraic variation of mixing-length in the flow field. The unsteady, two-dimensional equations in a cross-plane are solved for primitive variables using an implicit finite-difference code. The computed downstream merging distances are in good agreement with available wind tunnel data.

Raj, P.↗
NASA NTRS1978

Wall region of a relaxing three-dimensional incompressible turbulent boundary layer

A three-dimensional turbulent boundary layer relaxing behind a transverse hump (shaped as a 30-deg swept 5-ft chord wing-type model) was studied in a low-speed wind tunnel. Data obtained with hot-wire probes showed that the apparent dimensionless velocity profiles in the viscous sublayer prevail universally; evidence for wall similarity in the relaxing flow field was confirmed in the form of a log law. An unusual region of slightly decreasing cross-flow angle was found in collateral regions, and a near-wall noncollateral flow was posited. Streamwise relaxation of the mean flow field was also investigated.

Hebbar, K. S.↗
NASA NTRS1977

Computer simulation of hypersonic flow over the Space Shuttle Orbiter

Computer simulations of the flow field around the Space Shuttle Orbiter are described. Results of inviscid calculations are presented for the shock wave pattern and bottom centerline pressure distribution at 30 deg angle of attack. Results of viscous calculations are presented for wall pressure and heat transfer distributions for simple configurations representative of regions where shock wave-boundary layer interactions occur. The computer codes are verified by comparisons with wind-tunnel data and can be applied to flight conditions.

Inouye, M.↗
NASA NTRS1978

A method for predicting full scale buffet response with rigid wind tunnel model fluctuating pressure data. Volume 1: Prediction method development and assessment

The method requires unsteady aerodynamic forces, natural airplane modes, and the measured pressure data as input. A gust response computer program is used to calculate buffet response due to the forcing function posed by the measured pressure data. By calculating both symmetric and antisymmetric solutions, upper and lower bounds on full-scale buffet response are formed. Comparisons of predictions with flight test results are made and the effects of horizontal tail loads and static aeroelasticity are shown. Discussions are also presented on the effects of primary wing torsion modes, chordwise and spanwise phase angles, and altitude.

Cunningham, A. M., Jr.↗