Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “PISTONS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,315 records · Page 73

Nonlinear gas oscillations in pipes. II - Experiment

The problem of forced acoustic oscillations in a pipe was experimentally investigated, taking into account the response of both open and closed tubes to near-resonant excitation by large amplitude oscillations of a piston at one end of the tube. Attention was given to the effect of the orifice area on shock waves. By comparing the experimental results with nonlinear theory, wave reflection coefficients of the orifice plates were determined at both closed-tube and open-tube resonant frequencies. This approach can even be used when the terminating elements are subjected to intense periodic pressure pulses.

Sturtevant, B.↗

Attenuation characteristics of nonlinear pressure waves propagating in pipes

A series of experiments was conducted to investigate temporal and spatial velocity distributions of fluid flow in 3-in. open-end pipes of various lengths up to 210 ft, produced by the propagation of nonlinear pressure waves of various intensities. Velocity profiles across each of five sections along the pipes were measured as a function of time with the use of hot-film and hot-wire anemometers for two pressure waves produced by a piston. Peculiar configurations of the velocity profiles across the pipe section were noted, which are uncommon for steady pipe flow. Theoretical consideration was given to this phenomenon of higher velocity near the pipe wall for qualitative confirmation. Experimentally time-dependent velocity distributions along the pipe axis were compared with one-dimensional theoretical results obtained by the method of characteristics with or without diffusion term for the purpose of determining the attenuation characteristics of the nonlinear wave propagation in the pipes.

Shih, C. C.↗

Observations of coronal disturbances from 1 to 9 solar radii. II - Second event of 1973 January 11

Observations of a coronal disturbance on Jan. 11, 1973, commencing at 1801 hr UT are described. The event is homologous with an earlier disturbance from the same region of the corona. The observations suggest that a cloud of coronal gas containing about 4 x 10 to the 39th electrons propagated outward to more than 5 solar radii behind a piston-driven shock wave traveling at a velocity of 800 to 1200 km/sec.-

Stewart, R. T.↗

Interplanetary stream interfaces

At 1 AU there is a distinct boundary (the stream interface) in the interaction region of a stream in the solar wind, characterized by an abrupt drop in density, a similar increase in temperature, and a small increase in speed. In some cases, this is a tangential discontinuity, in others it is probably evolving into a tangential discontinuity. It is suggested that stream interfaces form in the interplanetary medium as a consequence of the nonlinear evolution of streams generated by an increase in temperature in the solar envelope. This evolution eventually leads to the formation of a reverse shock behind the interface and a forward shock ahead of it. Two instances in which both a stream interface and a reverse shock had developed at 1 AU are presented. Examples of flare-generated shocks that passed through a stream and were observed near a stream interface are also presented. It is shown that stream interfaces are definitely not the same structures that others have identified as piston boundaries.

Burlaga, L. F.↗

Bimetallic fluid displacement apparatus

Stirring and heating stored gases and liquids is accomplished by using the deformation of a bimetallic structure which deforms significantly when heated. The deformation is used to effect gradual or impulsive motion of a piston, vane, wire, or diaphram for displacement of the fluid. The heated bimetallic is also employed for heating the stored fluid.

Canning, T. N.↗

Automatic solar tracker

Mechanism uses differential pressure of condensable fluid against fixed piston to equalize radiant energy on pair of blackbody elements.

Conroy, B. L.↗

Effects of vibration and shock on the performance of gas-bearing space-power Brayton cycle turbomachinery. Part 4: Suppression of rotor-bearing system vibrations through flexible bearing support damping

A bearing damper, operating on the support flexure of a pivoted pad in a tilting-pad type gas-lubricated journal bearing, has been designed, built, and tested under externally-applied random vibrations. The NASA Brayton Rotating Unit (BRU), a 36,000 rpm, 10-Kwe turbogenerator had previously been subjected in the MTI Vibration Test Laboratory to external random vibrations, and vibration response data had been recorded and analyzed for amplitude distribution and frequency content at a number of locations in the machine. Based on data from that evaluation, a piston-type damper was designed and developed for each of the two flexibly-supported journal bearing pads (one in each of the two three-pad bearings). A modified BRU, with dampers installed, has been re-tested under random vibration conditions. Root-mean-square vibration amplitudes were determined from the test data, and displacement power spectral density analyses have been performed. Results of these data reduction efforts have been compared with vibration tolerance limits. Results of the tests indicate significant reductions in vibration levels in the bearing gas-lubricant films, particularly in the rigidly-mounted pads. The utility of the gas-lubricated damper for limiting rotor-bearing system vibrations in high-speed turbomachinery has thus been demonstrated.

Tessarzik, J. M.↗

Technology for reducing aircraft engine pollution

Programs have been initiated by NASA to develop and demonstrate advanced technology for reducing aircraft gas turbine and piston engine pollutant emissions. These programs encompass engines currently in use for a wide variety of aircraft from widebody-jets to general aviation. Emission goals for these programs are consistent with the established EPA standards. Full-scale engine demonstrations of the most promising pollutant reduction techniques are planned within the next three years. Preliminary tests of advanced technology gas turbine engine combustors indicate that significant reductions in all major pollutant emissions should be attainable in present generation aircraft engines without adverse effects on fuel consumption. Fundamental-type programs are yielding results which indicate that future generation gas turbine aircraft engines may be able to utilize extremely low pollutant emission combustion systems.

Rudey, R. A.↗

Supersonic flutter of panels loaded with inplane shear

A modal flutter analysis for biaxially loaded, orthotropic panels, using linear piston-theory aerodynamics, was extended in order to include the effects of inplane shear loading. Flutter boundaries for shear loads up to buckling are calculated for simply supported, isotropic panels of various length-width ratios and for a square, isotropic panel with elastic boundary conditions along the leading and trailing edges. These flutter boundaries are used to define conservative design curves. Sample calculations made using these design curves indicate that practical panels, which have otherwise been adequately designed, could become flutter critical if the inplane shear loads approach the buckling value.

Sawyer, J. W.↗

Evaluation by step response tests of prototype relief valves designed for YF-12 inlet stability bleed system

Two stability bleed system relief valves were tested in a special dynamic test facility. These poppet valves are prototypes for a stability bleed system designed for use in a YF-12 flight inlet. One valve is unshielded, while the other has a special shield to eliminate the flow effect pressures on the piston. The tests determined the size of a damping orifice to be used during wind tunnel tests of the bleed system and verified an analog simulation of the valves. The effects of initial pressure level, pressure step size, and spring rate were investigated.

Dustin, M. O.↗

Pneumatic load compensating or controlling system

A pneumatic load compensating or controlling system for restraining a load with a predetermined force or applying a predetermined force to the load is described; it includes a source of pressurized air, a one-way pneumatic actuator operatively connected to a load, and a fluid conduit fluidically connecting the actuator with the source of pressurized air. The actuator is of the piston and cylinder type, and the end of the fluid conduit is connected to the upper or lower portion of the cylinder whereby the actuator alternatively and selectively restrains the load with a predetermined force or apply a predetermined force to the load. Pressure regulators are included within the system for variably selectively adjusting the pressurized fluid to predetermined values as desired or required; a pressure amplifier is included within the system for multiplying the pressurized values so as to achieve greater load forces. An accumulator is incorporated within the system as a failsafe operating mechanism, and visual and aural alarm devices, operatively associated with pressure detecting apparatus, readily indicate the proper or improper functioning of the system.

Rogers, J. R.↗

Shock waves generated by the intense solar flare of 1972, August 7, 15:00 UT

The dynamic radio spectrum of the class 3B solar flare of 1972, August 7, 15:00 UT, over the band 10 to 2000 MHz is examined. Type II and type IV bursts in the spectrum are interpreted in terms of a piston-driven shock, which appeared to be traveling at a velocity of about 1500 km per sec and which generated pulsations in the band 100 to 200 MHz as it passed through the corona. The progress of the shock through the interplanetary plasma was subsequently monitored by Malitson et al. with radio equipment covering the band 0.03 to 2.6 MHz on the IMP-6 satellite.

Maxwell, A.↗

Propulsion dynamics of lunar hoppers

A feasibility study was recently completed on a hopping transporter concept for locomotion on the moon. Termed a Lunar Pogo because it would operate similarly to a conventional pogo stick, this vehicle would accelerate up an inclined leg, pick up the leg, and then enter ballistic flight over the moon's surface. Upon recontacting the lunar surface, the Lunar Pogo would decelerate down the leg. Propulsion would be provided by expansion of gas against a piston. Operation would be partially conservative because much of the energy expended by the gas during takeoff would be recovered by compressing the gas during landing. Two models of the ballistics and propulsion have been set up to estimate performance. The simplified first-order model illuminates the thermodynamics of ideal operation. The second-order model, which includes realistic effects such as sliding, provides a better approximation to actual performance. In a one-man Lunar Pogo, an astronaut would typically make 15-m (50-ft) leaps at an average speed of 5-8 km (3-5 miles) per hour.

Meetin, R. J.↗

Influence of grazing flow on duct wall normal impedances

A theory is developed for evaluating the normal impedance of an orifice connecting a cylindrical cavity to a flow duct. The impedance of a piston velocity source at the orifice is calculated in terms of the cavity modes which are modified by the presence of a vortex flow. The strength of the vortex is related to the mean flow in the duct. Results are presented showing the variation of the normal impedance spectrum with the cavity vortex. The trends of these variations are confirmed by comparison with measurements.

Mungur, P.↗

Sound propagation in curved ducts

An analysis of the sound field in a circularly curved duct of rectangular cross-section is carried out for both rigid and locally-reacting absorbing walls. The field is excited by a piston source at one end of the duct section, and comparisons of the acoustic field and the net power flow along the duct axis are made with corresponding results for a straight duct section for various frequencies. It is found that in general the curved duct yields a significant increase in sound attenuation along the duct axis as compared to the straight duct.

Myers, M. K.↗

The shape of the sodium D lines in a high-temperature helium atmosphere

An experiment was performed to measure the shape of the sodium resonance doublet (lambda 5890, lambda 5896) in a high-temperature helium atmosphere. A piston compressor was used to produce temperatures in the range 3000 K to 5500 K. Absorption-line widths and shifts are reported and the widths agree well with calculations.

Eckart, M. J.↗

Technology for reducing aircraft engine pollution

Programs have been initiated by NASA to develop and demonstrate advanced technology for reducing aircraft gas turbine and piston engine pollutant emissions. These programs encompass engines currently in use for a wide variety of aircraft from widebody-jets to general aviation. Emission goals for these programs are consistent with the established EPA standards. Full-scale engine demonstrations of the most promising pollutant reduction techniques are planned within the next three years. Preliminary tests of advanced technology gas turbine engine combustors indicate that significant reductions in all major pollutant emissions should be attainable in present generation aircraft engines without adverse effects on fuel consumption. Fundamental-type programs are yielding results which indicate that future generation gas turbine aircraft engines may be able to utilize extremely low pollutant emission combustion systems.

Rudey, R. A.↗

Pioneer 9 and OGO 5 observations of an interplanetary multiple shock ensemble on February 2, 1969

A multiple shock system was observed upstream (0.13 AU) of the earth by Pioneer 9 on February 2, 1969. The same system was observed at earth by Ogo 5 and was reported separately in the literature. This paper compares the two sets of observations in still further detail. Both magnetic-field and plasma data are used in a least-squares best-fit method to compute the characteristics of the fast forward shock wave (Pioneer 9 only) and two fast reverse shock waves. Nearly all major features (shock, piston, and tangential discontinuity) retained their characteristics during the transit of the shock ensemble from Pioneer 9 to Ogo 5. The genesis of the ensemble is believed to be due to a complex stream-stream interaction. A substantial density increase (including a large rise of alpha/proton abundance) at Ogo 5, but unobserved at Pioneer 9, is explained by a sudden meridional shift to a flow from below the ecliptic plane while the streams were en route to earth. This study demonstrates a spatial and temporal plasma inhomogeneity which is superimposed on the persistent major features.

Dryer, M.↗