SEARCH · Engineering Papers

Results for “Commanding”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,315 records · Page 73

All sources NASA NTRS DOE OSTI

NASA NTRS1979

Modern digital flight control system design for VTOL aircraft

Methods for and results from the design and evaluation of a digital flight control system (DFCS) for a CH-47B helicopter are presented. The DFCS employed proportional-integral control logic to provide rapid, precise response to automatic or manual guidance commands while following conventional or spiral-descent approach paths. It contained altitude- and velocity-command modes, and it adapted to varying flight conditions through gain scheduling. Extensive use was made of linear systems analysis techniques. The DFCS was designed, using linear-optimal estimation and control theory, and the effects of gain scheduling are assessed by examination of closed-loop eigenvalues and time responses.

Broussard, J. R.↗

NASA NTRS1979

A piloted simulator study on augmentation systems to improve helicopter flying qualities in terrain flight

Four basic single-rotor helicopters, one teetering, on articulated, and two hingeless, which were found to have a variety of major deficiencies in a previous fixed-based simulator study, were selected as baseline configurations. The stability and control augmentation systems (SCAS) include simple control augmentation systems to decouple pitch and yaw responses due to collective input and to quicken the pitch and roll control responses; SCAS of rate-command type designed to optimize the sensitivity and damping and to decouple the pitch-roll due to aircraft angular tate; and attitude-command type SCAS. Pilot ratings and commentary are presented as well as performance data related to the task. SCAS control usages and their gain levels associated with specific rotor types are also discussed.

Chen, R. T. N.↗

NASA NTRS1978

A conceptual design for an integrated data base management system for remote sensing data

The requirements of potential users were considered in the design of an integrated data base management system, developed to be independent of any specific computer or operating system, and to be used to support investigations in weather and climate. Ultimately, the system would expand to include data from the agriculture, hydrology, and related Earth resources disciplines. An overview of the system and its capabilities is presented. Aspects discussed cover the proposed interactive command language; the application program command language; storage and tabular data maintained by the regional data base management system; the handling of data files and the use of system standard formats; various control structures required to support the internal architecture of the system; and the actual system architecture with the various modules needed to implement the system. The concepts on which the relational data model is based; data integrity, consistency, and quality; and provisions for supporting concurrent access to data within the system are covered in the appendices.

Maresca, P. A.↗

NASA NTRS1977

NASA standard communications and data handling subsystem

The paper gives a functional description and discusses hardware implementation for the Communication and Data Handling (C&DH) subsystem of the Multimission Modular Spacecraft. The C&DH subsystem: (1) provides the command and telemetry link between the spacecraft and the terrestrial system, (2) distributes commands to and collects telemetry from all spacecraft systems via a duplex serial multiplex data bus and remote interface units, and (3) contains onboard computation capability. The C&DH is a single 4 x 4 x 1-1/2 foot module; the stuffed module weighs 270 lbs including 60 lbs of mission unique weight. The hardware is versatile and cost effective, and its modular structure permits repair, refurbishment, and even modification/updating in space

Robinson, D. L.↗

NASA NTRS1977

Adaptive supervisory control of remote manipulation

The command language by which an operator exerts supervisory control over a general purpose remote manipulator should be designed to accommodate certain characteristics of human performance if there is to be effective communication between the operator and the machine. Some of the ways in which people formulate tasks, use language, learn and make errors are discussed and design implications are drawn. A general approach to command language design is suggested, based on the notion matching the operator's current task schema or context by appropriate program structures or 'frames' in the machine.

Ferrell, W. R.↗

NASA NTRS1978

A piloted simulator investigation of augmentation systems to improve helicopter nap-of-the-earth handling qualities

A piloted simulation study assessed various levels of stability and control augmentation designed to improve the handling qualities of several helicopters in nap-of-the-earth (NOE) flight. Five basic single rotor helicopters - one teetering, two articulated, and two hingeless - which were found to have a variety of major deficiencies in a previous fixed-based simulator study were selected as baseline configurations. The stability and control augmentation systems (SCAS) include simple control augmentation systems (CAS) to decouple pitch and yaw responses due to collective input and to quicken the pitch and roll control responses; SCAS of rate command type designed to optimize the sensitivity and damping and to decouple the pitch-roll due to aircraft angular rate; and attitude command type SCAS. Pilot ratings and commentary are presented as well as performance data related to the task. SCAS control usage and their gain levels associated with specific rotor type are also discussed.

Chen, R. T. N.↗

NASA NTRS1978

Shuttle entry guidance

This paper describes the design of the entry guidance for the Space Shuttle Orbiter. This guidance provides the steering commands for trajectory control from initial penetration of the earth's atmosphere until the terminal area guidance is activated at an earth-relative speed of 2500 fps. At this point, the Orbiter is at a distance of about 50 nmi from the runway threshold, and at an altitude of about 80,000 ft. The entry guidance design is based on an analytic solution of the equations of motion defining the drag acceleration profile that meets the terminal criteria of the entry flight while maintaining the flight within systems and operational constraints. Guidance commands, which are based on a control law that ensures damping of oscillatory type trajectory motion, are computed to steer the Orbiter to this drag acceleration profile.

Harpold, J. C.↗

NASA NTRS1979

A detached experiment carrier aids adaptation of experiments from sounding rockets to Space Shuttle

The detached experiment carrier (DEC) system aids the adaptation of small, low-weight experiments to Space Shuttle missions. The carrier system consists of the detached experiment carrier (free-flyer), a command station at the Orbiter aft station, and a flight support station in the Orbiter payload bay. The carrier is a compact vehicle that is radio controlled by the Shuttle crew. It uses control television, command, and cold gas propulsion systems to deploy experiments from and later rendezvous with the Orbiter. The carrier propulsion system also maintains the attitude control required during experiment execution. Results of engineering investigation, analysis, component design and development, and testing indicate that the DEC system concept is practical. Results of preliminary engineering investigations, including maneuvering system handling qualities and television/telemetry display formats, indicate that the concept of flying the DEC 'out of' and 'into' the Orbiter payload bay is both safe and practical for small, compact free-flyer deployment and retrieval. This paper describes the carrier system, its operations, and potential applications.

Ritz, W. F.↗

NASA NTRS1979

Trends in the automation of planetary spacecraft

The automation of planetary spacecraft at the Jet Propulsion Laboratory (JPL) is discussed. Factors affecting the development of spacecraft automation, such as predictable and repetitive functions and narrow time-window, are analyzed. The volume of command data transmitted to the spacecraft is considered, together with an examination of 'autonomy' (executing functions without outside control) in relation to the ground command activity needed during the mission. The role of the spacecraft's growing computational power in increasing vehicle autonomy is noted.

Bird, T. H.↗

NASA NTRS1979

Preliminary study of pilot lateral control of two light airplanes near the stall

For two representative light, single-engine airplanes the single-axis piloting task of controlling bank angle with combined aileron and rudder, and a two-axis task of controlling bank angle with aileron and sideslip with rudder have been studied. For these tasks existing divergence criteria have been applied to determine conditions for closed-loop stability for selected flight conditions near the stall; in addition closed-loop stability characteristics and airplane response to bank angle command were calculated. Results obtained from applying the divergence criterion and from calculations of airplane responses to bank angle command indicate that aileron-alone bank angle control is marginally acceptable at high angle of attack. Of the two rudder control techniques considered, rudder used with the aileron in controlling bank angle increasd stability and produced satisfactory responses; the combined bank angle and sideslip control task does not warrant further consideration because of the task difficulty and the small improvement indicated in airplane closed-loop response with this technique.

Moul, M. T.↗

NASA NTRS1979

Optimal control of the Shuttle-Tethered-Subsatellite system

Alternate control laws based on an application of the linear regulator problem are developed for possible use in the operation of the Shuttle-Tethered-Subsatellite system. Control is assumed to be provided only by modulating the tension level in the tether as a function of the difference between actual and commanded tether line length, length rate, in (orbital) plane swing angle and swing angle rate. Necessary and sufficient conditions for stability of the (linear) system motion in the vicinity of its nominal local vertical orientation are developed. By proper selection of the state and control penalty matrices it is possible to obtain faster responses with no increase in maximum power levels for use in station keeping when compared with alternate control strategies. The weighting matrices are adjusted in a piecewise adaptive manner to provide control law gains in order to achieve a smooth deployment history. Successful retrieval is dependent mainly on the initial conditions and the rate at which the commanded length is reduced.

Bainum, P. M.↗

NASA NTRS1963

Apollo 2 Second Generation Lunar Exploration System Studies CFY 1963

The Apollo II Second Generation Lunar Exploration System includes the direct landing spacecraft which consists of cargo command module, service module, and landing module. The landing module is also capable of being used as the Lunar Landing Vehicle (LLV) for landing unmanned cargos consisting of shelter modules such as the Lunar Occupancy Payload and other cargo in support of lunar surface operations. High energy cryogenic propellants are utilized to permit direct landing, manned, or logistic missions with use of a single Saturn V class booster. In last year's studies, the LLV was configured for maximum payload and with consideration for the direct three-man landing and return mission. Light weight and low vehicle height above the lunar surface at touchdown were major objectives. Logistic cargos of more than 27,000 pounds landed on the Moon were achieved within the single Saturn V boost capability. For the manned mission, the lunar take-off weight was determined to be 28,000 pounds ready for the return-to-Earth portion of the mission. The command module utilized was an advanced light-weight design weighing 10,000 pounds including supporting subsystems. Cryogenic oxygen/hydrogen propulsion was again used for maximum propulsion efficiency. Study of the Lunar Occupancy Payload was also accomplished last year. This module was configured to serve as an early lunar shelter or outpost station or as a basic module of an integrated base module complex. Single and dual compartment versions, as well as special mission versions, were studied.

Matzenaur, J. O.↗

NASA NTRS1980

Computer-controlled warmup circuit

Filament of high-power radio transmitter is brought to operating temperature automatically. Pushbotton reduces operator's role to one-step command and is compatible with various forms of computer control. Filiament shutdown is initiated by "down" command from operator, failure of cooling systems, or power failure for more than few seconds.

Daeges, J. J.↗

NASA NTRS1981

Toggled signal for prevention of control errors

Redundant command lines use two different "true" signals to avoid common failure modes. When function is required to operate, computer generates command and transmits it to demultiplexer, where it is split along two paths, producing outputs from separate electronic cards. Outputs combine to drive AND gate high and begin function.

Wyllie, C. E.↗

NASA NTRS1980

Flight evaluation of configuration management system concepts during transition to the landing approach for a powered-lift STOL aircraft

Flight experiments were conducted to evaluate two control concepts for configuration management during the transition to landing approach for a powered-lift STOL aircraft. NASA Ames' augmentor wing research aircraft was used in the program. Transitions from nominal level-flight configurations at terminal area pattern speeds were conducted along straight and curved descending flightpaths. Stabilization and command augmentation for attitude and airspeed control were used in conjunction with a three-cue flight director that presented commands for pitch, roll, and throttle controls. A prototype microwave system provided landing guidance. Results of these flight experiments indicate that these configuration management concepts permit the successful performance of transitions and approaches along curved paths by powered-lift STOL aircraft. Flight director guidance was essential to accomplish the task.

Franklin, J. A.↗

NASA NTRS1980

Design of a nonlinear adaptive filter for suppression of shuttle pilot-induced oscillation tendencies

Analysis of a longitudinal pilot-induced oscillation (PIO) experienced just prior to touchdown on the final flight of the space shuttle's approach landing tests indicated that the source of the problem was a combination of poor basic handling qualities aggravated by time delays through the digital flight control computer and rate limiting of the elevator actuators due to high pilot gain. A nonlinear PIO suppression (PIOS) filter was designed and developed to alleviate the vehicle's PIO tendencies by reducing the gain in the command path. From analytical and simulator studies it was shown that the PIOS filter, in an adaptive fashion, can attenuate the command path gain without adding phase lag to the system. With the pitch attitude loop of a simulated shuttle model closed, the PIOS filter increased the gain margin by a factor of about two.

Smith, J. W.↗

NASA NTRS1980

A pilot's assessment of helicopter handling-quality factors common to both agility and instrument flying tasks

A series of simulation and flight investigations were undertaken to evaluate helicopter flying qualities and the effects of control system augmentation for nap-of-the-Earth (NOE) agility and instrument flying tasks. Handling quality factors common to both tasks were identified. Precise attitude control was determined to be a key requirement for successful accomplishment of both tasks. Factors that degraded attitude controllability were improper levels of control sensitivity and damping, and rotor system cross coupling due to helicopter angular rate and collective pitch input. Application of rate command, attitude command, and control input decouple augmentation schemes enhanced attitude control and significantly improved handling qualities for both tasks. The NOE agility and instrument flying handling quality considerations, pilot rating philosophy, and supplemental flight evaluations are also discussed.

Gerdes, R. M.↗

NASA NTRS1980

MCC level C formulation requirements. Shuttle TAEM guidance and flight control, STS-1 baseline

The TAEM guidance and body rotational dynamics models required for the MCC simulation of the TAEM mission phase are defined. This simulation begins at the end of the entry phase and terminates at TAEM autoland interface. The logic presented is the required configuration for the first shuttle orbital flight (STS-1). The TAEM guidance is simulated in detail. The rotational dynamics simulation is a simplified model that assumes that the commanded rotational rates can be achieved in the integration interval. Thus, the rotational dynamics simulation is essentially a simulation of the autopilot commanded rates and integration of these rates to determine orbiter attitude. The rotational dynamics simulation also includes a simulation of the speedbrake deflection. The body flap and elevon deflections are computed in the orbiter aerodynamic simulation.

Carman, G. L.↗