SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The status of the technologies for phased-array-fed dual reflector systems is reviewed. The different aspects of these technologies, including optical performances, phased array systems, problems encountered in phased array design, beamforming networks, MMIC design and its incorporation into waveguide systems, reflector antenna structures, and reflector deployment mechanisms are addressed.
This report documents work performed on the Solar Array Switching Power Management Study. Mission characteristics for three missions were defined to the depth necessary to determine their power management requirements. Solar array switching concepts were identified that could safisfy the mission requirements. These switching concepts were compared with a conventional buck regulator system on the basis of cost, weight and volume, reliability, efficiency and thermal control. For the missions reviewed, solar array switching provided significant advantages in all areas of comparison.
The charging behavior of a negatively biased solar cell array when subjected to a charged particle environment is studied in the ion density range from 200 to 12 000 ions/sq cm with the applied bias range of -500 to -1400 V. The profile of the surface potentials across the array is related to the presence of discharges. At the low end of the ion density range the solar cell cover slides charge to from 0 to +5 volts independent of the applied voltage. No discharges are seen at bias voltages as large as -1400 V. At the higher ion densities the cover slide potential begins to fluctuate, and becomes significantly negative. Under these conditions discharges can occur. The threshold bias voltage for discharges decreases with increasing ion density. A condition for discharges emerging from the experimental observations is that the average coverslide potential must be more negative than -4 V. The observations presented suggest that the plasma potential near the array becomes negative before a discharge occurs. This suggests that discharges are driven by an instability in the plasma.
Basic antenna theory which states that the field radiated from an antenna array is equal to the sum of the currents flowing in each element of the array is discussed. The feedline distribution system guarantees the proper amplitude and phase of the current for each element of an array. The difference in electrical lengths of the feedlines to the elements has to equal the desired phase angle. The current for voltage delay in a transmission line is equal to the transmission line electrical length in only a few special cases, when the transmission line is terminated in its characteristic impedance or when the transmission line's electrical length is a multiple of 90 degrees.
A miniaturized Cassegrainian concentrator (MCC) solar array system is examined to assess the practicality of assembling the basic MCC element into a total array system capable of producing multi-hundred kilowatts of power for Space Platform/Space Station or other low Earth orbit long lifetime missions. Preliminary mechanical and electrical subsystems are developed in order to determine first order performance characteristics. Results of the study support the feasibility of a 100-kilowatt MCC array system with beginning-of-life (BOL) performance of 160 watts per square meter and 28 W/kg. The performance numbers are based on 20 percent efficient (at operating temperature) solar cells and 0.25-millimeter thick electroformed nickel optics. These performance numbers can be improved upon significantly with the development of higher efficiency solar cells and/or lighter weight optics.
Structurally efficient ways to support the large solar arrays (3,716 square meters which are currently considered for space station use) are examined. An erectable truss concept is presented for the on orbit construction of winged solar arrays. The means for future growth, maintenance, and repair are integrally designed into this concept. Results from parametric studies, which highlight the physical and structural differences between various configuration options are presented. Consideration is given to both solar blanket and hard panel arrays.
Principles and design considerations of IR transparent solar arrays are discussed. Optimization of performance of flexible solar arrays was studied. Measured solar absorptance as low as alpha s = 0.59 was achieved which leads to a predicted BOL power density of 182.7 = W/square meters. Advanced array concepts, system level cascaded panels, and transparent rigid panels are proposed and expected benefits discussed.
Seven low cost multi-100 kW planar solar array modules were fabricated and tested. Two different designs were used, demonstrating advanced solar array construction practices. Both module types utilized second generation gridded back cells featuring high efficiency and IR transparency. A silicon dioxide AR coating optimized for transmission at gamma = 1.7 microns was applied to the back surface. Two interconnect types, a single sheet printed circuit and a roll type, with alternate approaches to increasing transparency and reducing cost were designed and fabricated. Hinge stress and electrical power optimization were also examined. Two point designs were studied. The first design used a coilage longeron mast and is autonomously deployable. The second design used a Stac Beam for high natural frequency response and required astronaut assistance and assembly on orbit. It was conclusively demonstrated that planar arrays are the most cost effective design for use on the space station or other high power applications.
Systolic arrays for determining the singular value decomposition of a mxn, m n, matrix A of bandwidth w are presented. After A has been reduced to bidiagonal form B by means of Givens plane rotations, the singular values of B are computed by the Golub-Reinsch iteration. The products of plane rotations form the matrices of left and right singular vectors. Assuming each processor can compute or supply a plane rotation, O(wn) processors accomplish the reduction to bidiagonal form in O(np) steps, where p is the number of superdiagonals. A constant number of processors then determines each singular value in about 6n steps. The singular vectors are computed by rerouting the rotations through the arrays used for the reduction to bidiagonal form, or else along the way by employing another rectangular array of O(wm) processors.
A decomposition of the adapted pattern generated by an adaptive array operating in an environment with one narrowband signal, K-1 narrowband jammers, and programmed to produce the maximum SNR is presented. The antenna voltage pattern is demonstrated to be a linear combination of K (or less) basis patterns, each from a sole source, and the kth basis pattern becomes the desired signal realized by the array. Isotropic array patterns result in retrodirective basis patterns, and the decomposition can be configured to obtain the retrodirective beams for all K.
This paper reports on the fabrication and ground testing of (a) a large area, light-weight, flexible substrate developmental solar array wing that has been built for NASA-MSFC and of (b) the supporting structure and data acquisition system (DAS) which, with the wing, will be flown in the Shuttle as an experiment in 1984. The experiment will verify the dynamics, thermodynamic, and electrical performance predictions of the array wing and will demonstrate the structural capability of the array wing for Orbiter launch and re-entry environments. The experiment hardware verification program was designed to minimize costs and risk of experiment performance degradation while maintaining Shuttle and crew safety. The previous full-scale wing hardware tests included an extension mast water table test and wing testing for random vibration, thermal vacuum, and acoustic environments. The results of these tests were used to define wing design modifications and to scope the test program for the experiment hardware.
There has been a continuing evolution toward larger arrays of infrared detectors, and the technology base derived from the Galileo Near Infrared Mapping Spectrometer (NIMS) has been expanded to linear arrays including from 128 to 512 elements. This advance is based on the commercial availability of high-quality InSb photodiodes and 128/256 element FET switch MUX's (multiplexing elements). The present investigation is concerned with an experimental 128-element linear imager using InSb detectors and silicon MUX for readout. Attention is given to detector array electrical characteristics, the detector readout architecture, noise, and special effects.
The development of the Electronically Steerable Spherical Array (ESSA) was started in 1975. ESSA provides the inertialess antenna needed by user satellites for communication over their large coverage angles towards the Tracking Data Relay Satellite System (TDRSS). The performance of ESSA over large coverage angles is better than the performance provided by phased arrays. The primary difference between the two antenna types is the method of beam forming. The ESSA steers a beam by illuminating a set of elements which point in the desired direction. This set of elements is illuminated by a simple multipole switch called a switching power divider (SPD). Attention is given to details regarding the difference in performance between ESSA and phased arrays, the ESSA block diagram, the performance improvement achieved by phase compensation, power requirements, the four operating modes, multibeam operation, and the data interface.
A new type of phase-locked injection laser array which utilises nonuniform spacing between the lasing stripes has been studied. The variation in spacing alters the stripe-to-stripe coupling which modifies the array mode selection. Arrays that operate with a single far-field lobe have been fabricated.
A series of experiments to study the optical and biological properties of terrestrial land cover are planned for late 1987 using a six-channel imaging spectroradiometer based on newly developed multispectral linear array (MLA) detector technology. Data from selected portions of the Sahel and rain forests of Africa and South America will be used to delineate biomass classes and estimate spherical albedos. A spatial resolution of 15 meters in the four visible-near IR channels and 30 meters in two shortwave IR channels, including a 'new' channel centered at 1.24 micrometers when combined with a spectral width of 20 nm for all channels, will be used to investigate possible improvements in land cover classification. Technology demonstrations include a test of data compression on data quality, the first spaceborne utilization of short wave infrared Schottky barrier Pd2Si detector arrays, and the use of close-butted, multi-array modules with attached spectral filters.
A single contact tailored gain-guided array is demonstrated in which the gain profile across the array is made strongly asymmetric by varying the width of the contact stripes. A proton isolated arary of six (GaAl)As lasers with 5-micron separations and widths varying linearly between 3 and 8 microns had a single lobed far field 2 deg wide, close to the diffraction limit for a single supermode. Fabrication of this device is simple, and suited to large-scale processing techniques. It is also shown that in such an asymmetric gain-guided array the fundamental mode is favored over higher order modes, and that higher order modes can have single lobed far-field patterns differing only slightly from that of the fundamental.
Line image observed simultaneously in two or more spectral bands. Incoming light focused through beam splitter onto two linear arrays of photodetectors to form line images. Array of band-pass filters above each detector array positioned to select spectral band of line image. These capabilities are valuable in such multispectral-imaging applications as spaceborne and airborne visible and infrared observation of Earth for geology, oil and mineral exploration, biomass distribution, forestry, agriculture, and urban and rural development.
EOPS empirically optimizes linear array of radiating elements. Program directly addresses problem of minimizing maximum side-lobe level of fixed length, linear arrays of radiating elements under realistic "on-the-vehicle" conditions. Used for both electromagnetic and acoustic arrays.