Spatially and temporally resolved H and OH densities in a nanosecond pulsed plasma jet: an analysis of the radical generation, transport, recombination and memory effects
Not Available
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Not Available
Not Available
In this work, we report on the flow effects induced by a nanosecond pulsed helium cold atmospheric pressure plasma jet impinging on a glass substrate. Herein, gas temperature measurements have been performed using optical emission spectroscopy including rotational spectra of OH(A-X) (0,0) and N 2 (C-B) (0,0) and resonance broadening of a helium emission line at 667.8 nm. The measured increase in gas temperature was less than 15 K. We have measured the air concentration distribution in the jet effluent by means of Rayleigh scattering exploiting the large difference in Rayleigh cross-section of air and helium. The obtained results show that the plasma causes a broadening of the helium channel suggesting an enhanced gas velocity and mixing with the ambient air. The impact of the plasma on the jet effluent is polarity dependent and is larger in the case of positive applied voltage pulses. Using an estimation of the increased gas velocity required to obtain the observed air concentrations, we have shown that both gas heating and electrohydrodynamic (EHD) forces related to the propagation of an ionization front are not causing the observed phenomena. The surface charge which can exist for a much longer time than the duration of the applied voltage pulse is the primary cause of the EHD forces on the bulk charges which lead to significant different air concentration profiles in the jet effluent for plasma on and off.
The Small Angle Slot (SAS) was recently installed on DIII-D as an advanced divertor, promising easier plasma detachment and lower temperatures across the whole target. A twofold study of the SAS magnetic topology is presented in this paper. On one hand, a twodimensional uncertainty quantification analysis is carried out through a Monte Carlo approach in order to understand the level of accuracy of two-dimensional equilibrium computations in reconstructing the strike point and angle onto the divertor. Under typical experimental conditions, the uncertainties are found to be roughly 6.8 mm and 0.56 deg, respectively. On the other hand, a three-dimensional “vacuum” analysis is carried out to understand the effects of typical external perturbation fields on the scrape-off layer topology. When the threedimensional I-coils are switched on, poloidally-localized lobes are found to appear, grow, and hit the SAS target, although barely, even for 5 kA; at the same time, the strike point modulation is found to be roughly 1.8 mm and thus negligible for most purposes. Furthermore, such results complement previous two-dimensional analyses in characterizing typical SAS equilibria and provide useful background information for planning and interpreting SAS experiments.
Wind turbine loads predictions by blade-element momentum theory using the standard tip-loss correction have been shown to over-predict loading near the blade tip in comparison to experimental data. This over-prediction is theorized to be due to the assumption of light rotor loading, inherent in the standard tip-loss correction model of Glauert. A higher- order free-wake method, WindDVE , is used to compute the rollup process of the trailing vortex sheets downstream of wind turbine blades. Results obtained serve an exact correction function to the Glauert tip correction used in blade-element momentum methods. Lastly, it is found that accounting for the effects of tip vortex rollup within the Glauert tip correction indeed results in improved prediction of blade tip loads computed by blade-element momentum methods.
Inkjet printing is a more sustainable and scalable fabrication method than spin coating for producing perovskite solar cells (PSCs). Although spin-coated SnO 2 has been intensively studied as an effective electron transport layer (ETL) for PSCs, inkjet-printed SnO 2 ETLs have not been widely reported. Here, we fabricated inkjet-printed, solution-processed SnO x ETLs for planar PSCs. A champion efficiency of 17.55% was achieved for the cell using a low-temperature processed SnO x ETL. The low-temperature SnO x exhibited an amorphous structure and outperformed high-temperature crystalline SnO 2 . The improved performance was attributed to enhanced charge extraction and transport and suppressed charge recombination at ETL/perovskite interfaces, which originated from enhanced electrical and optical properties of SnO x , improved perovskite film quality, and well-matched energy level alignment between the SnO x ETL and the perovskite layer. Furthermore, SnO x was doped with Cu. Cu doping increased surface oxygen defects and upshifted energy levels of SnO x , leading to reduced device performance. A tunable hysteresis was observed for PSCs with Cu-doped SnO x ETLs, decreasing at first and turning into inverted hysteresis afterwards with increasing Cu doping level. This tunable hysteresis was related to the interplay between charge/ion accumulation and recombination at ETL/perovskite interfaces in the case of electron extraction barriers.
The phonon density of states (DOS) and phonon entropy of B2 FeAl were determined as functions of the Fe site vacancy concentration using several scattering techniques and were computed from first principles. Measurements at elevated temperature and pressure were performed to explore volume effects, test the usefulness of the quasiharmonic (QH) approximation, and provide comparison for the first-principles calculations. The average temperature and pressure dependencies of phonons were consistent with the QH model. The decrease in specific volume associated with the introduction of vacancies causes a stiffening of the DOS that was captured well with the experimentally determined Grueneisen parameter. Features associated with vacancies in the DOS are not well explained by this model, however, especially in the gap between the acoustic and optic branches. First-principles calculations indicated that these modes are primarily associated with vibrations of Al atoms in the first-nearest-neighbor shell of the vacancy, with some vibration amplitude also involving the second-nearest-neighbor Fe atoms. At the vacancy concentrations of study, the phonon entropy of vacancy formation was found to be approximately -1.7k{sub B}/atom, about half as large and of opposite sign as the configurational entropy of vacancy formation.
The two-dimensional model of itinerant electrons coupled to an antiferromagnetic order parameter is considered. In the mean-field solution the Fermi surface undergoes reconstruction and breaks into disconnected 'pockets'. We have studied the effect of the thermal fluctuations of the order parameter on the spectral density in such system. These fluctuations lead to a finite width of the spectral line scaling linearly with temperature. Due to the thermal fluctuations the quasiparticle spectral weight is transferred into a magnetic Brillouin zone. This can be interpreted as restoration of 'arcs' of the noninteracting Fermi surface.
Explore the source record for details and available documents.
Not Available
Not Available
Microscopic variations in composition or structure can lead to nanoscale inhomogeneity in superconducting properties such as the magnetic penetration depth, but measurements of these properties are usually made on longer length scales. We solve a generalized London equation with a non-uniform penetration depth {lambda}(r), obtaining an approximate solution for the disorder-averaged Meissner screening. We find that the effective penetration depth is different from the average penetration depth and is sensitive to the details of the disorder. These results indicate the need for caution when interpreting measurements of the penetration depth and its temperature dependence in systems which may be inhomogeneous.
Not Available
Not Available