Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “TURBIDITY”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7

A new device for acquiring ground truth on the absorption of light by turbid waters

The author has identified the following significant results. A new device, called a Spectral Attenuation Board, has been designed and tested, which enables ERTS-1 sea truth collection teams to monitor the attenuation depths of three colors continuously, as the board is being towed behind a boat. The device consists of a 1.2 x 1.2 meter flat board held below the surface of the water at a fixed angle to the surface of the water. A camera mounted above the water takes photographs of the board. The resulting film image is analyzed by a micro-densitometer trace along the descending portion of the board. This yields information on the rate of attenuation of light penetrating the water column and the Secchi depth. Red and green stripes were painted on the white board to approximate band 4 and band 5 of the ERTS MSS so that information on the rate of light absorption by the water column of light in these regions of the visible spectrum could be concurrently measured. It was found that information from a red, green, and white stripe may serve to fingerprint the composition of the water mass. A number of these devices, when automated, could also be distributed over a large region to provide a cheap method of obtaining valuable satellite ground truth data at present time intervals.

Klemas, V.↗

Correlation of coastal water turbidity and current circulation with ERTS-1 and Skylab imagery

The article reviews investigations of current circulation patterns, suspended sediment concentration, coastal frontal systems, and waste disposal plumes based on visual interpretation and digital analysis of ERTS-1 and Skylab/EREP imagery. Data on conditions in the Delaware Bay area were obtained from 10 ERTS-1 passes and one Skylab pass, with simultaneous surface and airborne sensing. The current patterns and sediments observed by ERTS-1 correlated well with ground-based observations. Methods are suggested which would make it possible to identify certain pollutants and sediment types from multispectral scanner data.

Klemas, V.↗

Mobile Bay turbidity plume study

Laboratory and field transmissometer studies on the effect of suspended particulate material upon the appearance of water are reported. Quantitative correlations were developed between remotely sensed image density, optical sea truth data, and actual sediment load. Evaluation of satellite image sea truth data for an offshore plume projects contours of transmissivity for two different tidal phases. Data clearly demonstrate the speed of change and movement of the optical plume for water patterns associated with the mouth of Mobile bay in which relatively clear Gulf of Mexico water enters the bay on the eastern side. Data show that wind stress in excess of 15 knots has a marked impact in producing suspended sediment loads.

Crozier, G. F.↗

Laser application to measure vertical sea temperature and turbidity, design phase

An experiment to test a new method was designed, using backscattered radiation from a laser beam to measure oceanographic parameters in a fraction of a second. Tyndall, Rayleigh, Brillouin, and Raman scattering all are utilized to evaluate the parameters. A beam from a continuous argon ion laser is used together with an interferometer and interference filters to gather the information. The results are checked by direct measurements. Future shipboard and airborne experiments are described.

Hirschberg, J. G.↗

Mobile Bay turbidity study

The termination of studies carried on for almost three years in the Mobile Bay area and adjacent continental shelf are reported. The initial results concentrating on the shelf and lower bay were presented in the interim report. The continued scope of work was designed to attempt a refinement of the mathematical model, assess the effectiveness of optical measurement of suspended particulate material and disseminate the acquired information. The optical characteristics of particulate solutions are affected by density gradients within the medium, density of the suspended particles, particle size, particle shape, particle quality, albedo, and the angle of refracted light. Several of these are discussed in detail.

Crozier, G. F.↗

Penetration depth at green wavelengths in turbid waters

A laboratory and field measurement program was conducted to determine apparent remote sensing penetration depths at a wavelength of 520 nm. Tests were made for various types of sediments under controlled conditions in a laboratory. Field tests were conducted in several different water bodies over a wide range of solar elevation angles. Laboratory results indicate that apparent penetration depth is significantly influenced by mineral content and/or size of suspended sediments. Field measurements show wide variation in apparent penetration depth, even when suspended solids concentration is nearly constant. Apparent penetration depth does not appear to be a strong function of solar elevation angle so long as the water mixture remains constant.

Whitlock, C. H.↗

Turbid water measurements of remote sensing penetration depth at visible and near-infrared wavelength

Remote sensing of water quality is dicussed. Remote sensing penetration depth is a function both of water type and wavelength. Results of three tests to help demonstrate the magnitude of this dependence are presented. The water depth to which the remote-sensor data was valid was always less than that of the Secchi disk depth, although not always the same fraction of that depth. The penetration depths were wavelength dependent and showed the greatest variation for the water type with largest Secchi depth. The presence of a reflective plate, simulating a reflective subsurface, increased the apparent depth of light penetration from that calculated for water of infinite depth.

Morris, W. D.↗

Computed laser backscattering from turbid liquids - Comparison with laboratory results

A recently developed semianalytic Monte Carlo radiative transfer model applicable to oceanographic lidar systems (SALMON) has been used to simulate a series of laboratory experiments studying the backscatter of laser light from dispersions of Teflon spheres. Results obtained with SALMON, using best estimates of pertinent optical parameters, compared quite well with experimental data in both a qualitative and quantitative sense, with the largest relative discrepancies being approximately 30%. The results firmly establish the validity of SALMON in studying the performance of real oceanographic lidar systems.

Poole, L. R.↗

A radiative transfer model for remote sensing of laser induced fluorescence of phytoplankton in non-homogeneous turbid water

A semi-analytic Monte Carlo simulation methodology (SALMON) was discussed. This simulation technique is particularly well suited for addressing fundamental radiative transfer problems in oceanographic LIDAR (optical radar), and also provides a framework for investigating the effects of environmental factors on LIDAR system performance. The simulation model was extended for airborne laser fluorosensors to allow for inhomogeneities in the vertical distribution of constituents in clear sea water. Results of the simulations for linearly varying step concentrations of chlorophyll are presented. The SALMON technique was also employed to determine how the LIDAR signals from an inhomogeneous media differ from those from homogeneous media.

Venable, D. D.↗

Airborne detection of oceanic turbidity cell structure using depth-resolved laser-induced water Raman backscatter

Airborne laser-induced, depth-resolved water Raman backscatter is useful in the detection and mapping of water optical transmission variations. This test, together with other field experiments, has identified the need for additional field experiments to resolve the degree of the contribution to the depth-resolved, Raman-backscattered signal waveform that is due to (1) sea surface height or elevation probability density; (2) off-nadir laser beam angle relative to the mean sea surface; and (3) the Gelbstoff fluorescence background, and the analytical techniques required to remove it. When converted to along-track profiles, the waveforms obtained reveal cells of a decreased Raman backscatter superimposed on an overall trend of monotonically decreasing water column optical transmission.

Hoge, F. E.↗

The Transport and Fate of Particulate Material in a Shallow, Turbid Estuary: Seasonal and Decadal Characteristics from 7-Be and 210-Pb Techniques

Seasonal and long-term sediment transport characteristics were examined using surficial sediment 7-Be inventories and the down core distribution of excess 210-Pb. Data were collected in the Barataria Basin, LA over the fifteen month period from September 1995 to January 1997. Seasonal sediment transport rates based on 7-Be inventories ranged from -1.6E3 to 1.42E4 g/m2/yr, whereas decadal sediment burial rates based on excess 210-Pb ranged from 3.83E2 to 2.00E3 g/m2/yr, respectively. Seasonal transport characteristics vary with location in the basin and appear to be largely controlled by seasonal weather patterns and the associated winds. It appears that, at less sheltered locations, long term rates of sediment burial are controlled by frontal passages and the associated strong northerly and southerly component winds; whereas at fetch limited locations burial rates are likely controlled by stronger weather events such as tropical storms and hurricanes.

Booth, J. G.↗

Estimating Coastal Turbidity using MODIS 250 m Band Observations

Terra MODIS 250 m observations are being applied to a Suspended Sediment Concentration (SSC) algorithm that is under development for coastal case 2 waters where reflectance is dominated by sediment entrained in major fluvial outflows. An atmospheric correction based on MODIS observations in the 500 m resolution 1.6 and 2.1 micron bands is used to isolate the remote sensing reflectance in the MODIS 25Om resolution 650 and 865 nanometer bands. SSC estimates from remote sensing reflectance are based on accepted inherent optical properties of sediment types known to be prevalent in the U.S. Gulf of Mexico coastal zone. We present our findings for the Atchafalaya Bay region of the Louisiana Coast, in the form of processed imagery over the annual cycle. We also apply our algorithm to selected sites worldwide with a goal of extending the utility of our approach to the global direct broadcast community.

Davies, James E.↗

Hybrid-dual-fourier tomographic algorithm for a fast three-dimensionial optical image reconstruction in turbid media

A reconstruction technique for reducing computation burden in the 3D image processes, wherein the reconstruction procedure comprises an inverse and a forward model. The inverse model uses a hybrid dual Fourier algorithm that combines a 2D Fourier inversion with a 1D matrix inversion to thereby provide high-speed inverse computations. The inverse algorithm uses a hybrid transfer to provide fast Fourier inversion for data of multiple sources and multiple detectors. The forward model is based on an analytical cumulant solution of a radiative transfer equation. The accurate analytical form of the solution to the radiative transfer equation provides an efficient formalism for fast computation of the forward model.

Alfano, Robert R.↗