Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SLIPSTREAM”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7
All sourcesNASA NTRSDOE OSTI
NASA NTRS1965

Nasa research on the aerodynamics of jet vtol engine installations

This paper summarizes some of the more pertinent results of NASA investigations related to the aerodynamics of jet VTOL engine installations. It shows that there is a base loss in hovering due to suction forces creased on the underside of the fuselage by the entrainment of ambient air in the slipstream, and that the magnitude of this effect is related to the turbulence in the jet stream and its consequent rate of mixing with ambient air. It also shows that there are large lift losses and pitching moments due to jet-free-stream interference and that these characteristics can be significantly altered by proximity to the ground. And, finally, it shows that simple bellmouth inlets give good pressure recovery and low distortion for vertically mounted lift engines if the inlet lip radius is sufficiently large, but that such inlets are not suitable for windmill starting of the engines.

VTOL AIRCRAFT↗
NASA NTRS1966

Comparison of wind-tunnel and flight results on a four-propeller tilt-wing configuration

Over the years aerodynamicists have learned to rely heavily on wind­-tunnel-model results in predicting the aerodynamic characteristics of con­ventional aircraft configurations. With the development of V/STOL con­figurations which have high slipstream deflection angles. such as the four-propeller tilt-wing XC-142A V/STOL aircraft, the reliability of small-scale wind-tunnel-model results in predicting full-scale airplane characteristics needs to be reexamined. Extensive tests have been made by NASA on several sizes of wind-tunnel models of the XC-142A V/STOL configuration and by Ling-Temco-Vought, Inc., on the airplane. These results show that models predict the slow-speed level-flight characteristics very well but that small models underpredict the descent capability of the airplane. Larger scale wind-tunnel models of approximately half size show better agreement with the airplane descent characteristics. It was found from smoke flow studies that small models can also pre­dict the region in which self-generated disturbances will be encountered by tilt-wing configurations in ground proximity.

WIND TUNNEL MODEL↗
NASA NTRS1971

Fundamental limitations on V/STOL terminal guidance due to aircraft characteristics

A review is given of limitations on approach flight paths of V/STOL aircraft, including limits on descent angle due to maximum drag/lift ratio. A method of calculating maximum drag/lift ratio of tilt-wing and deflected slipstream aircraft is presented. Derivatives and transfer functions for the CL-84 tilt-wing and X-22A tilt-duct aircraft are presented. For the unaugmented CL-84 in steep descents the transfer function relating descent angle to thrust contains a right-half plane zero. Using optimal control theory, it is shown that this zero causes a serious degradation in the accuracy with which steep flight paths can be followed in the presence of gusts.

Wolkovitch, J.↗
NASA NTRS1972

Study of aircraft in intraurban transportation systems

A systems analysis was conducted to define the technical economic and operational characteristics of an aircraft transportation system for short-range intracity commutor operations. The analysis was for 1975 and 1985 in the seven county, Detroit, Michigan area. STOL and VTOL aircraft were studied in sizes from 40 to 120 passengers. The preferred vehicle for the Detroit area was the deflected slipstream STOL. Since the study was parametric in nature, it is applicable to generalization, and it was concluded that a feasible intraurban air transportation system could be developed in many viable situations.

Stout, E. G.↗
NASA NTRS1972

Study of short haul high-density V/STOL transportation systems, volume 1

The relative advantages of STOL aircraft concepts were examined by simulating the operations of a short haul high-density intercity STOL system set in two arenas, the California corridor and the Chicago-Detroit-Cleveland triangle, during the 1980 time period. The study was constrained to the use of three aircraft concepts designated as the deflected slipstream turboprop, externally blown flap, and augmentor wing turbofan configurations. The projected demographic, economic, travel demand, and travel characteristics of the representative arenas were identified. The STOL airline operating scenarios were then formulated and through the use of the aerospace modal split simulation program, the traveler modal choices involving alternative STOL concepts were estimated in the context of the total transportation environment for 1980. System combinations that presented the best potential for economic return and traveler acceptance were then identified for each STOL concept.

Solomon, H. L.↗
NASA NTRS1972

Program plan to develop airworthiness standards for STOL aircraft

A program plan to develop criteria for airworthiness standards for STOL transport aircraft is presented. Initially, three different STOL concepts are to be examined with a goal to arrive at a generalized set of standards. The Breguet 941 deflected-slipstream STOL has been initially evaluated on a piloted motion simulator and in flight. Confidence in establishing criteria for airworthiness standards for STOL transport aircraft has been obtained from these studies.

Cayot, J. E.↗
NASA NTRS1972

Optimum performance of static propellers and rotors.

A criterion for the optimum performance of static propellers and hovering helicopter rotors is developed. Numerical results are presented for the optimum radial distributions of circulation and inflow at the propeller disk and relating the optimum power coefficient and the figure of merit to the thrust coefficient. It is shown that the present theory, which fully accounts for the effect of slipstream rotation, predicts optimum distributions of circulation and inflow that differ significantly from those based on approximate methods.

Wu, J. C.↗
NASA NTRS1973

STOL aircraft flight and landing area considerations.

One proposed solution to the total short-haul transportation system problem is to use existing low-wing-loading turbopropeller STOL aircraft. Deflected slipstream turboprop aircraft have also been considered for early STOL service. Aspects of current aircraft research are discussed together with the NASA research aircraft, field length and aircraft performance considerations, crosswind landings, crosswind reducing fences, elevated STOL ports, a guaranteed friction STOL runway, and problems of runway containment.

Riebe, J. M.↗
NASA NTRS1974

The effect of wind tunnel wall interference on the performance of a fan-in-wing VTOL model

A fan-in-wing model with a 1.07-meter span was tested in seven different test sections with cross-sectional areas ranging from 2.2 sq meters to 265 sq meters. The data from the different test sections are compared both with and without correction for wall interference. The results demonstrate that extreme care must be used in interpreting uncorrected VTOL data since the wall interference may be so large as to invalidate even trends in the data. The wall interference is particularly large at the tail, a result which is in agreement with recently published comparisons of flight and large scale wind tunnel data for a propeller-driven deflected-slipstream configuration. The data verify the wall-interference theory even under conditions of extreme interference. A method yields reasonable estimates for the onset of Rae's minimum-speed limit. The rules for choosing model sizes to produce negligible wall effects are considerably in error and permit the use of excessively large models.

Heyson, H. H.↗
NASA NTRS1974

An Analytical Investigation of Wing-Jet Interaction

The aerodynamic interaction between the wing and an inviscid jet with Mach number nonuniformity is formulated by using a two-vortex-sheet model for the jet. One of the vortex sheets accounts for the induced jet flow and the other the induced outer flow. No additional source distribution is needed for the jet at an angle of attack. The above problem is solved by satisfying the jet and wing tangency and the jet pressure-continuity conditions and using a quasi vortex lattice method for computing the induced flow field. The latter method is derived through theoretical consideration by properly accounting for singularities present in the equations and possesses the same simplicity and generality as the conventional vortex lattice method but has a better rate of numerical convergence. The resulting system of algebraic equations is solved by Purcell's vector method. The numerical formulation is first applied to the wing-slipstream interaction problem. Results for one centered-jet configuration are compared with those predicted by some existing theories.

Lan, E. C.↗
NASA NTRS1975

Optimum performance and potential flow field of hovering rotors

Rotor and propeller performance and induced potential flowfields were studied on the basis of a rotating actuator disk concept, with special emphasis on rotors hovering out of ground effect. A new theory for the optimum performance of rotors hovering OGE is developed and presented. An extended theory for the optimum performance of rotors and propellers in axial motion is also presented. Numerical results are presented for the optimum distributions of blade-bound circulation together with axial inflow and ultimate wake velocities for the hovering rotor over the range of thrust coefficient of interest in rotorcraft applications. Shapes of the stream tubes and of the velocities in the slipstream are obtained, using available methods, for optimum and off-optimum circulation distributions for rotors hovering in and out of ground effect. A number of explicit formulae useful in computing rotor and propeller induced flows are presented for stream functions and velocities due to distributions of circular vortices over axi-symmetric surfaces.

Wu, J. C.↗
NASA NTRS1975

Time-dependent transonic flow solutions for axial turbomachinery

Three-dimensional unsteady transonic flow through an axial turbomachine stage is described in terms of a pair of two-dimensional formulations pertaining to orthogonal surfaces, namely, a blade-to-blade surface and a hub-to-casing surface. The resulting systems of nonlinear, inviscid, compressible equations of motion are solved by an explicit finite-difference technique. The blade-to-blade program includes the periodic interaction between rotor and stator blade rows. Treatment of the boundary conditions and of the blade slipstream motion by a characteristic type procedure is discussed in detail. Harmonic analysis of the acoustic far field produced by the blade row interaction, including an arbitrary initial transient, is outlined. Results from the blade-to-blade program are compared with experimental measurements of the rotating pressure field at the tip of a high-speed fan. The hub-to-casing program determines circumferentially averaged flow properties on a meridional plane. Blade row interactions are neglected in this formulation, but the force distributions over the entire blade surface for both the rotor and stator are obtained. Results from the hub-to-casing program are compared with a relaxation method solution for a subsonic rotor. Results are also presented for a quiet fan stage which includes transonic flow in both the rotor and stator and a normal shock in the stator.

Erdos, J.↗
NASA NTRS1976

Flight test evaluation of a method to determine the level flight performance propeller-driven aircraft

A procedure is developed for deriving the level flight drag and propulsive efficiency of propeller-driven aircraft. This is a method in which the overall drag of the aircraft is expressed in terms of the measured increment of power required to overcome a corresponding known increment of drag. The aircraft is flown in unaccelerated, straight and level flight, and thus includes the effects of the propeller drag and slipstream. Propeller efficiency and airplane drag are computed on the basis of data obtained during flight test and do not rely on the analytical calculations of inadequate theory.

Cross, E. J., Jr.↗
NASA NTRS1976

Energy consumption characteristics of transports using the prop-fan concept

The fuel saving and economic potentials of the prop-fan high-speed propeller concept were evaluated for twin-engine commercial transport airplanes designed for 3333.6 km range, 180 passengers, and Mach 0.8 cruise. A fuel saving of 9.7% at the design range was estimated for a prop-fan airplane having wing-mounted engines, while a 5.8% saving was estimated for a design having the engines mounted on the aft body. The fuel savings and cost were found to be sensitive to the propeller noise level and to aerodynamic drag effects due to wing-slipstream interaction. Uncertainties in these effects could change the fuel savings as much as + or - 50%. A modest improvement in direct operating cost (DOC) was estimated for the wing-mounted prop-fan at current fuel prices. This improvement could become substantial in the event of further relative increases in the price of oil. The improvement in DOC requires the achievement of the nominal fuel saving and reductions in propeller and gearbox maintenance costs relative to current experience.

Source record↗
NASA NTRS1977

A study of commuter airplane design optimization

Problems of commuter airplane configuration design were studied to affect a minimization of direct operating costs. Factors considered were the minimization of fuselage drag, methods of wing design, and the estimated drag of an airplane submerged in a propellor slipstream; all design criteria were studied under a set of fixed performance, mission, and stability constraints. Configuration design data were assembled for application by a computerized design methodology program similar to the NASA-Ames General Aviation Synthesis Program.

Roskam, J.↗