SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Converter is used to energize group of proportional-counter event-detection tubes. Supply is programmed by using output signal of low voltage digital-to-analog converter. Programming voltage ranges from 1.53 to 2.91 V in 127 0.0108 mV steps, and it is used to control converter high voltage output which ranges from 700 to 1,335 V in like number of increments.
A seven channel physiological telemetry system was designed, constructed, and tested for a space environment to transfer physiological and voice information to and from an astronaut. Three ECG leads were monitored simultaneously, and two-way voice communication was achieved. The portable unit operated properly under ground based station (GBS) control. The major design problem was associated with the constraints of a wide bandwidth FM transmitter with crystal control combined with the tri-state logic format used. However, by using an ''indirect FM'' scheme and incorporating additional waveshaping circuits at the GBS, proper operation of the system was obtained. In the present form, the telemetry system has capability for seven channels of low level (2.5 mv peak maximum) physiological signals with bandwidths between 0.03 Hz and 100 Hz. Additional signal conditioning and modification of the instrumentation amplifier gains are required for other signals.
An on-line minimum variance parameter identifier was developed which embodies both accuracy and computational efficiency. The new formulation resulted in a linear estimation problem with both additive and multiplicative noise. The resulting filter is shown to utilize both the covariance of the parameter vector itself and the covariance of the error in identification. It is proven that the identification filter is mean square covergent and mean square consistent. The MV parameter identification scheme is then used to construct a stable state and parameter estimation algorithm.
An on-line minimum variance parameter identifier is developed which embodies both accuracy and computational efficiency. The formulation results in a linear estimation problem with both additive and multiplicative noise. The resulting filter which utilizes both the covariance of the parameter vector itself and the covariance of the error in identification is proven to be mean square convergent and mean square consistent. The MV parameter identification scheme is then used to construct a stable state and parameter estimation algorithm.
Recent advances in solar cell technology have led to the development of laboratory cells with efficiencies above 15% and production cells with efficiencies in the area of 13%. The increased output is largely the result of increases in the short-circuit current. The most significant gain in the amount of light entering the cell has been obtained through surface texturing by chemical etching techniques. Sheet resistances resulting from phosphorus diffusion in the 800 C temperature range yield junction depths on the order of 0.1 micrometer, leading to significant increases in the blue region of the cell spectral response. The inclusion of a back surface field in 10 ohm-cm cells has produced an increase in open-circuit voltage of about 50 mV and an increase in the minority carrier lifetime. It appears that a low emitter efficiency of the diffused region is the cause of poor voltages. Future research will be primarily directed toward correcting this deficiency and toward the development of low cost production methods.
An on-line minimum variance parameter identifier is developed which embodies both accuracy and computational efficiency. The formulation results in a linear estimation problem with both additive and multiplicative noise. The resulting filter which utilizes both the covariance of the parameter vector itself and the covariance of the error in identification is proven to be mean square convergent and mean square consistent. The MV parameter identification scheme is then used to construct a stable state and parameter estimation algorithm.
The use of sounding rockets for calibrating solar cells offers two principal advantages: (1) there is no effect due to the terrestrial atmosphere, and (2) the cells are recoverable immediately after the calibration. On March 30, 1976, 29 n/p silicon and four p/n gallium arsenide solar cells were calibrated in space and successfully recovered from a NASA-Astrobee F rocket that reached a peak altitude of 230 km. Approximately 75 IV characteristic curves were generated for 32 of the cells to an accuracy of plus or minus 0.2 ma and plus or minus 0.2 mV.
The growth of an oxide interfacial layer was recently found to increase the open-circuit voltage (OCV) and efficiency by up to 60 per cent in GaAs metal-semiconductor solar cells. Details of oxidation techniques to provide the necessary oxide thickness and chemical structure and using ozone, water-vapor-saturated oxygen, or oxygen gas discharges are described, as well as apparent crystallographic orientation effects. Preliminary results of the oxide chemistry obtained from X-ray, photoelectron spectroscopy are given. Ratios of arsenic oxide to gallium oxide of unity or less seem to be preferable. Samples with the highest OVC predominantly have As(+3) in the arsenic oxide rather than As(+5). A major difficulty at this time is a reduction in OCV by 100-200 mV when the antireflection coating is vacuum deposited.
Vesicles can be prepared from Halobacterium halobium cell envelopes, which contain properly oriented bacteriorhodopsin and which extrude H(+) during illumination. The pH difference that is generated across the membranes is accompanied by an electrical potential of 90 to 100 mV (interior negative) and the movements of other cations. Among these is the efflux of Na(+), which proceeds against its electrochemical potential. The relationship between the size and direction of the light-induced pH gradient and the rate of depletion of Na(+) from the vesicles, as well as other evidence, suggest that the active Na(+) extrusion is facilitated by a membrane component that exchanges H(+) for Na(+) with a stoichiometry greater than 1. The gradients of H(+) and Na(+) are thus coupled to one another. The Na(+) gradient (efflux much larger than influx), which arises during illumination, plays a major role in energizing the active transport of amino acids.
Five environmental models were constructed to represent the solar wind and the upper, middle, and lower ionosphere of Venus. The spacecraft structure was modeled with over 140 passive electrical elements representing structural elements of the spacecraft. Electron, ion, secondary electron, and photocurrents to the spacecraft from the plasma were calculated, ignoring sheath effects. In all but one case, potentials of interest were less than 1 volt. Potential differences between widely separated points on the equipment shelf were less than 1 mV. The one area of concern is the solar panel potential when the orbiter is passing through the bowshock region.
A microparticle accelerator has been devised for micrometeoroid impact and cratering simulation; the device produces high-velocity (0.5-15 km/sec), micrometer-sized projectiles of any cohesive material. In the source, an electrodynamic levitator, single particles are charged by ion bombardment in high vacuum. The vertical accelerator has four drift tubes, each initially at a high negative voltage. After injection of the projectile, each tube is grounded in turn at a time determined by the voltage and charge/mass ratio to give four acceleration stages with a total voltage equivalent to about 1.7 MV.
Dichlorosilane (SiH2Cl2) was used as the silicon source material in all of the epitaxial growths. Both n/p/p(+) and p/n/n(+) structures were studied. Correlations were made between the measured profiles and the solar cell parameters, especially cell open-circuit voltage. It was found that in order to obtain consistently high open-circuit voltage, the epitaxial techniques used to grow the surface layer must be altered to obtain very abrupt doping profiles in the vicinity of the junction. With these techniques, it was possible to grow reproducibly both p/n/n(+) and n/p/p(+) solar cell structures having open-circuit voltages in the 610- to 630-mV range, with fill-factors in excess of 0.80 and AM-1 efficiencies of about 13%. Combinations and comparisons of epitaxial and diffused surface layers were also made. Using such surface layers, we found that the blue response of epitaxial cells could be improved, resulting in AM-1 short-circuit current densities of about 30 mA/cm sq. The best cells fabricated in this manner had AM-1 efficiency of 14.1%.
The design and performance characteristics of an electrochemical NO2 sensor selected by NASA for the space shuttle program is described. The instrument consists of a sample pump, an electrochemical cell, and control and display electronics. The pump pushes the sample through the electrochemical cell where the vapors are analyzed and an output proportional to the NO2 concentration is produced. The output is displayed on a panel meter, and is also available at a recorder jack. The electrochemical cell is made up of a polypropylene chamber covered with teflon membrane faceplates. Plantinum electrodes are bonded to the faceplates, and the sensing and counter electrodes are potentiostatically controlled at -200 mV with respect to the reference electrode. The cell is filled with electrolyte, consisting of 13.5 cc of 23% solution of KOH.
Mn-53 and Al-26 activities have been measured in fourteen samples carefully ground from the upper 1.5 cm of rock 68815 to discern whether the magnitude and shape of the solar cosmic ray (SCR) flux in the last 2 m.y. has differed from the recent SCR flux and that averaged over the last 10 m.y. Results yield no evidence that the SCR flux has varied among these time intervals. Assuming the appropriate erosion rates, the measured profiles of rock 68815 (with a 2 m.y. surface exposure) and of rocks 12002 and 14321 (saturated with respect to Mn-53 and Al-26) can all be fit with the SCR parameters of R sub zero = 100 MV and J = 70 protons/sq cm/sec (4 pi, energy greater than 10 MeV). The measured profiles of 68815 and 14310 are incompatible with the short surface exposure age (less than 3 m.y.) proposed for 14310 on the basis of track studies. Activity vs. depth profiles for three different faces of 68815, show surface activities nearly independent of sample inclination.
The high-low (H-L) junction in the emitter region that defines the high-low-junction emitter (HLE) solar cell suppresses the dark emitter recombination current J sub E so that the base recombination current dominates in determining the open-circuit voltage. For silicon cells this enables the achievement of considerably larger values of open-circuit voltage than those achievable in conventional structures. This paper describes experiments that demonstrate the achievement of J sub E suppression (to less than 5 x 10 to the -14th A/sq cm) and large open-circuit voltage (640 mV) in HLE test cells of two distinct types. In the first type (the diffused HLE structure) impurity diffusion forms the H-L junction in the emitter; in the second type (the oxide-charge-induced HLE structure) the H-L junction is formed in emitter material of relatively low doping concentration by an oxide-charge-induced electron accumulation layer.
Lithium counterdoped n+/p silicon solar cells were irradiated with 1 MV electrons and their post irradiation performance and low temperature annealing properties were compared to that of the 0.35 ohm cm control cells. Cells fabricated from float zone and Czochralski grown silicon were investigated. It was found that the float zone cells exhibited superior radiation resistance compared to the control cells, while no improvement was noted for the Czochralski grown cells. Room temperature and 60 C annealing studies were conducted. The annealing was found to be a combination of first and second order kinetics for short times. It was suggested that the principal annealing mechanism was migration of lithium to a radiation induced defect with subsequent neutralization of the defect by combination with lithium. The effects of base lithium gradient were investigated. It was found that cells with negative base lithium gradients exhibited poor radiation resistance and performance compared to those with positive or no lithium gradients; the latter being preferred for overall performance and radiation resistance.
The results of a 14 month program to improve the open circuit voltage of low resistivity silicon solar cells are described. The approach was based on ion implantation in 0.1- to 10.0-ohm-cm float-zone silicon. As a result of the contract effort, open circuit voltages as high as 645 mV (AMO 25 C) were attained by high dose phosphorus implantation followed by furnace annealing and simultaneous SiO2 growth. One key element was to investigate the effects of bandgap narrowing caused by high doping concentrations in the junction layer. Considerable effort was applied to optimization of implant parameters, selection of furnace annealing techniques, and utilization of pulsed electron beam annealing to minimize thermal process-induced defects in the completed solar cells.
Silicon solar cells were fabricated to verify the predictions that: (1) thin n(+)pp(+) cells can provide high values of open circuit voltage even when high resistivity base material ( 1000 omega-cm) is used; (2) cells with good p(+) back contacts will display an increase in open circuit voltage with decreasing cell thickness; and (3) high quality, thin, high resistivity, solar cells can be made using processing compatible with conventional practice. Analysis of I-V and spectral response measurements of these cells confirmed theoretical predictions and thereby pointed to voltages beyond the near 600 mV obtained in this study.