The effect of free-stream turbulence on heat transfer to a strongly accelerated turbulent boundary layer
Strongly accelerated turbulent boundary layer, investigating free stream turbulence effect on heat transfer
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Strongly accelerated turbulent boundary layer, investigating free stream turbulence effect on heat transfer
The paper describes an investigation of the velocity fluctuations in the free stream above an incompressible turbulent boundary layer developing at constant pressure. Measurements were performed in a wind tunnel with an rms level of axial velocity fluctuations of about 0.2 percent. The possibility of assessing the contributions to the rms level of the velocity fluctuations without using the high-pass filtering technique is demonstrated.
Skin friction and heat transfer on flat plate in high velocity laminar motion with mass transfer for any free stream and injected gas combination
Nozzle wall hypersonic turbulent boundary layers at free stream Mach number using pitot, hot wire, and wall fluctuation and static pressure measurements
Flow field from forward facing nozzles exhausting near large cylindrical body at free-stream Mach numbers of 3.0 and 6.0
Experimental and theoretical studies of low speed leading edge boundary layer receptivity to free-stream vorticity produced by upstream wires normal to the leading edge are discussed. Data include parametric variations in leading edge configuration and details of the incident disturbance field including single and multiple wakes. The induced disturbance amplitude increases with increases in the leading edge diameter and wake interactions. Measurements agree with the theory of M. E. Goldstein.
Influence of interaction of flow field with boundary layer on heat transfer in vicinity of interior corner aligned with free stream velocity
A spike-type nose inlet with sharp-lip cowl was investigated at a free-stream Mach number of 2.5 with water injection in its 16-inch diameter, 11-foot-long subsonic diffuser section. Inlet total temperature of exit with liquid-air ratios of about 0.04 with no apparent change in the critical pressure recovery. The observed temperature drops were less than the theoretically predicted values, and the amount of water evaporated was 35 to 50 percent less than that theoretically possible.
Laminar boundary-layer heat transfer and shear stress predictions from similarity solutions, emphasizing large free-stream velocity gradients and highly cooled walls
Laminar boundary-layer heat transfer and shear stress predictions from similarity solutions, emphasizing large free-stream velocity gradients and highly cooled walls
Spectroscopic measurements of non-equilibrium emission were made in the free stream of the 60 megawatts Interaction Heating Facility at NASA Ames Research Center. In the visible near infrared wavelength region, the most prominent emission was from molecular N2, and in the ultra violet region, the spectra were dominated by emission from molecular NO. The only atomic lines observed were those of copper (an erosion product of the electrodes). The bands of the 1st Positive system of N2 (if B is true then A is true) differed significantly from spectra computed spectra assuming only thermal excitation, suggesting overpopulation of the high vibrational states of the B state of N2. Populations of these high vibrational levels (peaking at v (sub upper) equals 13) of the N2 B state were determined by scaling simulated spectra; calculations were performed for each upper vibrational state separately. The experimental-theoretical procedure was repeated for several radial positions away from the nozzle axis to obtain spatial distributions of the upper state populations; rotational symmetry of the flow was assumed in simulations. The overpopulation of the high vibrational levels has been interpreted as the effect of inverse pre-dissociation of neutral atoms in the N2 A state, which populates the N2 B state through a level crossing process at v (sub upper) is greater than 10.
Results are presented for two experimental programs related to augmentation of heat transfer by complex flow characteristics. In one program, high free stream turbulence (up to 63 percent) was shown to increase the Stanton number by more than a factor of 5, compared with the normally expected value based on x-Reynolds number. These experiments are being conducted in a free-jet facility, near the margins of the jet. To a limited extent, the mean velocity, turbulence intensity, and integral length scale can be separately varied. The results show that scale is a very important factor in determining the augmentation. Detailed studies of the turbulence structure are being carried out using an orthogonal triple hot-wire anemometer equipped with a fourth wire for measuring temperature. The v' component of turbulence appears to be distributed differently from u' or w'. In the second program, the velocity distributions and boundary layer thicknesses associated with a pair of counter-rotating, streamwise vortices were measured. There is a region of considerably thinned boundary layer between the two vortices when they are of approximately the same strength. If one vortex is much stronger than the other, the weaker vortex may be lifted off the surface and absorbed into the stronger.
The method of matched asymptotic expansions is used to study the generation of Tollmien-Schlichting waves by free stream disturbances incident on a flat plate boundary layer. Near the leading edge, the motion is governed by the unsteady boundary layer equation, while farther downstream it is governed (to lowest order) by the Orr-Sommerfeld equation with slowly varying coefficients. It is shown that there is an overlap domain where the Tollmien-Schlichting wave solutions to the Orr-Sommerfeld equation and an appropriate asymptotic solution of the unsteady boundary layer equation match, in the matched asymptotic expansion sense. The analysis leads to a set of scaling laws for the asymptotic structure of the unsteady boundary layer.
Aerodynamics of steady, inviscid transonic flows around slender bodies and wing-body combinations at free stream Mach number one
Receptivity to a model convected disturbance in the presence of localized and distributed variations in wall geometry and wall-suction velocity is examined. The model free-stream disturbance corresponds to the time-harmonic wake of a vibrating ribbon that is placed at a suitable distance above the surface of a thin airfoil. The advantages of using this disturbance for experiments on receptivity to convected disturbances are outlined. A brief parametric study is presented for a flat-plate boundary layer. The study quantifies the effect of wake position as well as wake width; in addition, it should be helpful in the choice of an optimal setting for a controlled experiment of the above type, which the above parametric study shows as feasible.
Forces and pressures on two nonaxisymmetric wedge nozzles were measured in a 16 foot transonic tunnel. Tests were conducted at static conditions and at free stream Mach numbers of 0.60, 0.80, 0.90, 0.94, and 1.20. The range of nozzle pressure ratios varied with configuration and Mach number. The internal and external geometry of the nozzles and the test model are defined in detail. Nozzle performance data are presented as discharge coefficients, internal thrust ratios, thrust minus nozzle drag ratios, and ideal thrust coefficients. Extensive internal and external pressure measurements are presented.
Performance of four 16-inch-diameter ram-jet units was determined at free-stream Mach numbers of 0.49 to 1.78 over range of gas total-temperature ratios of 1.0 to 6.1. Time histories of each flight and data on thrust, drag, diffuser efficiency, and combustion are presented. A maximum thrust coefficient of 0.88 and a maximum net acceleration of 5.13 g's were observed for the four units.
A gas turbine engine has a fairing and an air intake that includes an air inlet embedded within the fairing for supplying free stream atmospheric air to a gas generator.