SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The Gamma Guidance Algorithm which controls the inertial upper stage is described. The results of an independent assessment of the algorithm's performance in satisfying the NASA missions' targeting objectives are presented. The results of a launch window analysis for a Galileo mission, and suggested improvements are included.
The Level C requirements for the shuttle orbiter terminal area energy management (TAEM) guidance and flight control functions to be incorporated into the Mission Control Center entry profile planning processor are defined. This processor will be used for preentry evaluation of the entry through landing maneuvers, and will include a simplified three degree-of-freedom model of the body rotational dynamics that is necessary to account for the effects of attitude response on the trajectory dynamics. This simulation terminates at TAEM-autoland interface.
The guidance of an autonomous planetary roving vehicle using a scanning laser/multidetector terrain sensor for short-range hazard detection has been simulated. The sensor data are used to model the terrain, thereby providing the information required by a path selection algorithm to control the motion of the rover. These simulation studies are providing the basis for developing both the real-time computer control software and the hardware systems for laboratory and field testing of rover.
The NASA Space Telescope (ST) is a 2.4-m aperture, f/24 Ritchey-Chretien telescope coupled to five on-board astronomical scientific packages. The very accurate line-of-sight stability required by ST during operating periods of up to 24 hours is maintained by the Pointing Control System whose optical system, the Fine Guidance Subsystem (FGS), is described. The Pointing Control System includes three identical FGSs, any two of which provide line-of-sight stabilization by tracking guide stars while the third performs astrometry. The optical system for the ST FGS performs the field aberration correction within the FGS near a pupil plane measuring only 52.7 mm. The design is simple and easily corrected, and offers substantial advantages over the traditional approach in terms of manufacturability.
Time-response simulation studies carried out in support of the development and validation of the guidance/steering subsystem of a wire-following-vehicle (WFV) are described. A lateral guidance system is outlined, field testing and simulation validation are covered, and time response simulation results are discussed.
A unique approach to onboard processing was developed that is capable of acquiring high quality image data for users in near real time. The approach is divided into two steps: the development of an onboard cloud detection system; and the development of a landmark tracker. The results of these two developments are outlined and the requirements of an operational guidance and control system capable of providing continuous estimation of the sensor boresight position are summarized.
Candidate systems were identified for evaluation of suitability in meeting specified accuracy requirements for a swath guidance system in an agriculture aircraft. Further examination reduced the list of potential candidates to a single category, i.e., transponder type systems, for detailed evaluation. Within this category three systems were found which met the basic accuracy requirements of the work statement. The Flying Flagman, the Electronic Flagging and the Raydist Director System. In addition to evaluating the systems against the specified requirements, each system was compared with the other two systems on a relative basis. The conclusions supported by the analyses show the Flying Flagman system to be the most suitable system currently available to meet the requirements.
A series of flight tests and fast-time simulations were conducted, using the augmentor wing jet STOL research aircraft and the STOLAND 4D-RNAV system to add to the growing data base of 4D-RNAV system performance capabilities. To obtain statistically meaningful data a limited amount of flight data were supplemented by a statistically significant amount of data obtained from fast-time simulation. The results of these tests are reported. Included are comparisons of the 4D-RNAV estimated winds with actual winds encountered in flight, as well as data on along-track navigation and guidance errors, and time-of-arrival errors at the final approach waypoint. In addition, a slight improvement of the STOLAND 4D-RNAV system is proposed and demonstrated, using the fast-time simulation.
This learning guide is designed to assist pilots in taking the PLATO presimulator training course on the advanced guidance and control system mode select panel. The learning guide is divided into five sections. The first section, the introduction, presents the course goals, prerequisites, definition of PLATO activities, and a suggested approach to completing the course. The remaining four sections present the purpose, learning activities and summary of each lesson of the AGCS PLATO course, which consists of (1) AGCS introduction; (2) lower order modes; (3) higher order modes; and (4) an arrival route exercise.
In 1978 a joint NASA-FAA helicopter flight test was conducted to examine the use of weather-mapping radar for IFR guidance during landing approaches to oil rig helipads. The following navigation errors were measured: total system error, radar-range error, radar-bearing error, and flight technical error. Three problem areas were identified: (1) operational problems leading to pilot blunders, (2) poor navigation to the downwind final approach point, and (3) pure homing on final approach. Analysis of these problem areas suggests improvement in the radar equipment, approach procedure, and pilot training, and gives valuable insight into the development of future navigation aids to serve the off-shore oil industry.
Two computer programs are applied to energy efficient flight operation in order to minimize aircraft operating costs. One algorithm (OPTIM) computes vertical flight profiles which optimize direct operating costs, including fuel and time costs, for an aircraft flying over a fixed range and with a fixed time-of-arrival. The second program (TRAGEN) simulates an aircraft steered to fly along a specified vertical flight trajectory, in order to examine fuel and cost penalties involved in flying nonoptimal trajectories. Constraints such as air traffic control procedures, and atmospheric and weight conditions are considered and supported by graphs and diagrams. The use of the algorithms as preflight planning tools is discussed, emphasizing OPTIM's future application for on-board energy management. Finally, research questions concerning pilot guidance and display considerations for advanced energy/flight management systems are addressed.
Guidance system for wire-following vehicles tested successfully at speeds exceeding 50 mi/h (80 km/h) on difficult 1 mile (1.6km) course. Unlike previous sensors that compare amplitudes of signals picked up from guide wire, new system compares signal phases. Array of coils is mounted in line along front bumper of vehicle and monitors electromagnetic signal radiating from wire. Guide wire on ground beneath vehicle carrier 6- to 7-kHz alternating current.
In contrast to CTOL landing operations, STOL airplanes landing on short STOLport runways typically begin the flare maneuver before reaching the runway surface. Vertical guidance procedures were developed to allow an autoland flight control system for a STOL airplane to use Microwave Landing System (MLS) signals as altitude and sink rate references for flare initiation, with a transition to radar altimeter after the airplane is over the runway. The implementation has minimum impact on the control system and landing performance. Data are presented which show validation of the concepts in a simulator.
The longwall guidance and control (G&C) system was evaluated to determine which systems and subsystems lent themselves to automatic control in the mining of coal. The upper coal/shale interface was identified as the reference for a vertical G&C system, with two sensors (the natural backgound and the sensitized pick) being used to locate and track this boundary. In order to insure a relatively smooth recession surface (roof and floor of the excavated seam), a last and present cut measuring instrument (acoustic sensor) was used. Potentiometers were used to measure elevations of the shearer arms. The intergration of these components comprised the vertical control system (pitch control). Yaw and roll control were incorporated into a face alignment system which was designed to keep the coal face normal to its external boundaries. Numerous tests, in the laboratory and in the field, have confirmed the feasibility of automatic horizon control, as well as determining the face alignment.
A theoretical analysis of a single wire magnetic leader cable system for aircraft rollout and turnoff guidance was performed to determine the errors produced by the leader cable installation geometry and aircraft attitude. It was found that errors in the measurement of lateral displacement from the cable are smaller than errors in the measurement of aircraft heading and that both errors are smallest at or near the cable.
A sun sensing guidance system for high altitude aircraft is described. The system is characterized by a disk shaped body mounted for rotation aboard the aircraft in exposed relation to solar radiation. The system also has a plurality of mutually isolated chambers; each chamber being characterized by an opening having a photosensor disposed therein and arranged in facing relation with the opening for receiving incident solar radiation and responsively providing a voltage output. Photosensors are connected in paired relation through a bridge circuit for providing heading error signals in response to detected imbalances in intensities of solar radiation.
It is desirable that the landing approach of helicopters and V/STOL aircraft into a congested airport equipped with a microwave landing system (MLS) can take place essentially independent of CTOL traffic. The helical approach has been proposed as one way to provide aircraft separation while requiring minimum airspace. A helical descent makes it possible for the helicopter to lose altitude in a confined airspace without descending along an excessively steep glide slope. This avoids helicopter handling problems which occur at slow airspeeds. Preliminary flight-test data are presented regarding the operational feasibility of the helical approach under IFR conditions where the primary guidance information is from an MLS.
Aerocapture is a concept for inserting a spacecraft into orbit about a target planet. The energy required for orbit insertion is obtained from natural resources present at or near the target body, thereby reducing the amount of propellant which must be carried onboard. Specifically, the transfer from a hyperbolic flyby trajectory to a desired bound orbit is effected by aerodynamic lift and drag forces acting on the spacecraft during controlled flight through the atmosphere of either the target planet or a nearby satellite. A survey is provided of the trajectory guidance, navigation, and control aspects of aerocapture, and a summary is given of the results of a number of preliminary studies concerning certain of these aspects. The investigation has additional significance in connection with the current interest in aeroassisted orbital transfer vehicles, which may be used in conjunction with the Space Shuttle.