Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Airport”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,243 records · Page 69

The employment of a spoken language computer applied to an air traffic control task.

Assessment of the merits of a limited spoken language (56 words) computer in a simulated air traffic control (ATC) task. An airport zone approximately 60 miles in diameter with a traffic flow simulation ranging from single-engine to commercial jet aircraft provided the workload for the controllers. This research determined that, under the circumstances of the experiments carried out, the use of a spoken-language computer would not improve the controller performance.

Laveson, J. I.↗

Toward a second-generation supersonic transport.

A number of promising avenues of research and development are considered in relation to an advanced supersonic transport which has improved range/payload characteristics and lower airport noise and sonic boom than current-generation supersonic transports. The prospects for advanced technology suggest that a high lift-to-drag-ratio configuration incorporating advanced materials and control concepts and utilizing a variable-cycle engine or perhaps an advanced dry turbojet, will yield an advanced supersonic transport which is economically viable and socially acceptable. Hydrogen fuel offers great promise for future supersonic aircraft, however, the formidable problems associated with the use of such fuel probably precludes its use on any near term second-generation supersonic transport. The state of technology in some of the areas discussed is not very far advanced and, consequently, a major effort will be required to bring these technologies to a state of readiness on a timely basis.

Loftin, L. K., Jr.↗

Runway configuration improvement programming model.

The basic objectives of the study were to subject a set of runway configurations to cost analysis and to develop a dynamic programming model which would enable an airport to economically match the ground capacity to its air traffic demand. Quantitative differences in the capacity of runway configurations result from the various aircraft/aircraft and aircraft/air-system interactions. A problem formulation and solution procedure is presented which is intended to be a meaningful technique for the long-range planning of runway expansion programs.

Yu, J. C.↗

Refan program. Phase 1: Summary report

The Refan Program is aimed at a large reduction in aircraft approach and takeoff noise in the vicinity of airports caused by the JT3D-powered 707's and DC-8's and the JT8D-powered 727's, 737's and DC-9's. These aircraft represent a major part of the existing commercial fleet. The noise reductions can be achieved by engine and nacelle modifications in the form of aircraft retrofit kits. Engine turbomachinery noise is reduced by replacing the current two-stage fan with a larger single-stage fan and by nacelle acoustic treatment. Jet noise is reduced by the reduction on jet velocity caused by additional turbine work extraction to drive the larger bypass fan. The predicted net effect of these modifications on installed performance is large noise reductions on both approach and takeoff, increased takeoff thrust, decreased takeoff field length, and maintained or improved aircraft range depending on the amount of acoustic treatment included. The Refan Program is being conducted in two phases under contracts with one engine and two airframe companies. Results of the Phase I work are summarized in this report which describes the refan nacelle configurations studied, the airplane modifications required to install the nacelles, and the resulting airplane performance and noise reductions predicted for all five aircraft.

Sams, E. W.↗

Aircraft noise reduction technology

Aircraft and airport noise reduction technology programs conducted by NASA are presented. The subjects discussed are: (1) effects of aircraft noise on individuals and communities, (2) status of aircraft source noise technology, (3) operational procedures to reduce the impact of aircraft noise, and (4) NASA relations with military services in aircraft noise problems. References to more detailed technical literature on the subjects discussed are included.

Source record↗

General aviation air traffic pattern safety analysis

A concept is described for evaluating the general aviation mid-air collision hazard in uncontrolled terminal airspace. Three-dimensional traffic pattern measurements were conducted at uncontrolled and controlled airports. Computer programs for data reduction, storage retrieval and statistical analysis have been developed. Initial general aviation air traffic pattern characteristics are presented. These preliminary results indicate that patterns are highly divergent from the expected standard pattern, and that pattern procedures observed can affect the ability of pilots to see and avoid each other.

Parker, L. C.↗

Fixed-base simulation study of decoupled controls during approach and landing of a STOL transport airplane

A fixed-base visual simulation study has been conducted to evaluate the use of decoupled controls as a means for reducing pilot workload during approach and landing of an externally blown jet-flap short take-off and landing (STOL) transport. All six rigid-body degrees of freedom were employed with the aerodynamic characteristics based on wind-tunnel data. The primary piloting task was to use a flight director to capture and maintain a two-segment glide slope, with a closed-circuit television display of a STOL airport used during simulations of the flare and landing. The decoupled longitudinal controls used constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity. The pilots were enthusiastic about the decoupled longitudinal controls but believed the decoupled concept offered no significant advantage over conventional controls in the lateral mode.

Miller, G. K., Jr.↗

Flight evaluation of two segment approaches for jet transport noise abatement

A 75 flight-hour operational evaluation was conducted with a representative four-engine fan-jet transport in a representative airport environment. The flight instrument systems were modified to automatically provide pilots with smooth and continuous pitch steering command information during two-segment approaches. Considering adverse weather, minimum ceiling and flight crew experience criteria, a transition initiation altitude of approximately 800 feet AFL would have broadest acceptance for initiating two-segment approach procedures in scheduled service. The profile defined by the system gave an upper glidepath of approximately 6 1/2 degrees. This was 1/2 degree greater than inserted into the area navigation system. The glidepath error is apparently due to an erroneous along-track, distance-to-altitude profile.

Rogers, R. A.↗

A preliminary investigation of bird classification by Doppler radar

A preliminary study of the application of Doppler radar to the classification of birds is reported. The desirability for improvements in bird classification stems primarily from the hazards they present to jet aircraft in flight and in the vicinity of airports. A secondary need exists in the study of bird migration. The wing body and tail motion of a bird in flight reflect signals which, when analyzed properly present a signature of wing beat pattern which is unique for each bird species. Although the results of this investigation did not validate the feasibility of classifying bird species, they do indicate that a more thorough investigation is warranted. Certain gross characteristics such as wing beat rates, multiple bird patterns, and bird maneuverability, were indicated clearly in the results. Large birds with slow wing beat rates appear to be the most optimum subject for further study with the X-band Doppler radar used in this investigation.

Martinson, L. W.↗

JT8D-100 turbofan engine, phase 1

The JT8D turbofan engine, widely used in short and medium range transport aircraft, contributes substantially to airport community noise. The jet noise is predominant in the JT8D engine and may be reduced in a modified engine, without loss of thrust, by increasing the airflow to reduce jet velocity. A configuration study evaluated the effects of fan airflow, fan pressure ratio, and bypass ratio on noise, thrust, and fuel comsumption. The cycle selected for the modified engine was based upon an increased diameter, single-stage fan and two additional core engine compressor stages, which replace the existing two-stage fan. Modifications were also made to the low pressure turbine to provide the increased torque required by the larger diameter fan. The resultant JT8D-100 engine models have the following characteristics at take-off thrust, compared to the current JT8D engine: Airflow and bypass ratio are increased, and fan pressure ratio and engine speed are reduced. The resultant engine is also longer, larger in diameter, and heavier than the JT8D base model, but these latter changes are compensated by the increased thrust and decreased fuel comsumption of the modified engine, thus providing the capability for maintaining the performance of the current JT8D-powered aircraft.

Source record↗

An economic assessment of STOL aircraft potential including terminal area environmental considerations, volume 1

The results of an economic and environmental study of short haul airline systems using short takeoff and landing (STOL) aircraft are presented. The STOL system characteristics were optimized for maximum patronage at a specified return on investment, while maintaining noise impact compatibility with the terminal area. Supporting studies of aircraft air pollution and hub airport congestion relief were also performed. The STOL concept specified for this study was an Augmentor Wing turbofan aircraft having a field length capability of 2,000 ft. and an effective perceived noise level of 95 EPNdB at 500 ft. sideline distance. An economic and environmental assessment of the defined STOL system and a summary of the methodology, STOL system characteristics and arena characteristics are provided.

Solomon, H. L.↗

Altitude determination and descriptive analysis of clouds on ERTS-1 multispectral photography

A simple method to determine the approximate altitude of clouds is described, with the objective of refining their classification using only marginal data from the photographs. Results of the application of this method on photographs of the Goajira Peninsula, Paraguana Peninsula and the Central Coast of Venezuela are presented. Here, the altitudes computed are used to classify clouds and to identify the genus of others without typical form. Instability of air masses through clouds vertical development, and wind direction as well as other local climatic characteristics such as moisture content, loci of condensation, area, etc. are determined using repetitive coverage for the time interval of the photography. Applications for the regional and urban planning (including airport location and flights schedule) and natural resources evaluation are suggested.

Albrizzio, C.↗

Energy impact of short-haul STOL systems

An analysis has been made to evaluate the impact on fuel requirements of a segregated short-haul system. A comparison has been made between two alternate scenarios: one with STOL, and the other without STOL. For the New York to Washington, D.C. city pair the results show: (1) the modal efficiency approach, while indicating the with STOL scenario requires more fuel than the without STOL scenario, is of questionable validity because it does not account for various effects which exist in realistic scenarios; (2) evaluation of fuel requirements based on more detailed modeling indicates that while a STOL scenario requires more fuel than without STOL when an idealized CTOL system is postulated, the STOL scenario requires less fuel than without STOL when the CTOL system has even moderate delays. These results are due to a combination of effects: the closer and more convenient locations of STOL ports to the traveler, congestion at the CTOL airports, and the impact of the through passenger traffic. Sensitivity of results to STOL aircraft block fuel and to CTOL congestion delays are considered.

Stewart, E. C.↗

Evaluation of the effects of one year's operation of the dynamic preferential runway system

The FAA introduced an experimental aircraft operations program at JFK Airport called the Dynamic Preferential Runway System (DPRS) in the summer of 1971. The program is designed to distribute air traffic as equally as possible over the surrounding communities, to limit periods of continuous overflight and to vary the same hours of overflight from day to day. After a full year's operation, an evaluation was made of the system's effectiveness. All of the operation's goals were moderately achieved with the greatest relief in reduced overflight afforded the most heavily impacted areas. Few residents, however, were aware of DPRS or felt that it had greatly reduced annoyance or represented a major effort by the aircraft authorities. Statistical analyses of reported annoyance obtained from two independent surveys in 1969 and 1972 reveal limited reductions in annoyance in 1972, with shifts from reported high annoyance to moderate annoyance.

Borsky, P. N.↗

Development and testing of laser Doppler system components for wake vortex monitoring. Volume 1: Scanner development, laboratory and field testing and system modeling

A servo-controlled range/elevation scanner for the laser Doppler velocimeter (LDV) was developed and tested in the field to assess its performance in detecting and monitoring aircraft trailing vortices in an airport environment. The elevation scanner provides a capability to manually point the LDV telescope at operator chosen angles from 3.2 deg. to 89.6 deg within 0.2 deg, or to automatically scan the units between operator chosen limits at operator chosen rates of 0.1 Hz to 0.5 Hz. The range scanner provides a capability to manually adjust the focal point of the system from a range of 32 meters to a range of 896 meters under operator control, or to scan between operator chosen limits and at rates from 0.1 Hz to 6.9 Hz. The scanner controls are designed to allow simulataneous range and elevation scanning so as to provide finger scan patterns, arc scan patterns, and vertical line scan patterns. The development and testing of the unit is discussed, along with a fluid dynamic model of the wake vortex developed in a laser Doppler vortex sensor simulation program.

Wilson, D. J.↗

Changes in the direction of sight during parabolic flights and rectilinear accelerations

Tests in which persons were subjected to a negative acceleration in an automobile are reported. The acceleration was obtained by stopping a moving car on the runway of an airport. The acceleration was found to produce a rotational movement of the subject's eyeball proportional to the degree of acceleration. Other investigations were conducted with a jet aircraft and a sports aircraft. G forces of up to 3 G were obtained during pull up of the aircraft, while values in the range from 0 to 1 G could be produced with the aid of a parabolic flight path. The effects of the flight conditions on the subject's direction of sight are discussed.

Von Baumgarten, R.↗

Putting all our noise technology to work

An assessment of the present state of the art in noise reduction technology indicates that this technology has the potential for effectively attaining this goal - a conclusion that is in apparent conflict with the frequently voiced complaints on intolerable noise levels near airports. Measures are suggested for a more vigorous implementation of available technology in practice to combat the aircraft noise problem.

Jackson, R. P.↗