Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “observable behavior”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,207 records · Page 67

Stress corrosion of high strength aluminum alloys.

An investigation has been carried out to examine the relationship of the observed chemical and mechanical properties of Al-Cu and Al-Zn-Mg alloys to the stress corrosion mechanisms which dominate in each case. Two high purity alloys and analogous commercial alloys were selected. Fundamental differences between the behavior of Al-Cu and of Al-Zn-Mg alloys were observed. These differences in the corrosion behavior of the two types of alloys are augmented by substantial differences in their mechanical behavior. The relative cleavage energy of the grain boundaries is of particular importance.

Cocks, F. H.↗

Balloon observations of galactic high-energy X-ray sources

A number of X-ray sources were observed with the Naval Research Laboratory hard X-ray observatory during balloon flights on 1976 May 11 and 1977 November 24. The primary objective of the observations was to characterize the temporal and spectral behavior of the sources in the energy range from 20 to 250 keV. Special emphasis was placed on the determination of spectrum versus phase for periodic sources and on the search for spectral features such as the reported 60 keV line in the X-ray spectrum of Her X-1. Results of the observations include: evidence for possible phase-dependent spectral variations in the emission from GX 1+4; flaring in the emission from GX 301-2; detection of unmodulated X-ray emission up to approximately 35 keV from GX 304-1; and an unexpectedly hard spectrum above 20 keV from Cyg X-2.

Maurer, G. S.↗

Basic studies of baroclinic flows

A fully nonlinear 3-dimensional numerical model (GEOSIM), previously developed and validated for several cases of geophysical fluid flow, has been used to investigate the dynamical behavior of laboratory experiments of fluid flows similar to those of the Earth's atmosphere. The phenomena investigated are amplitude vacillation, and the response of the fluid system to uneven heating and cooling. The previous year's work included hysteresis in the transition between axisymmetric and wave flow. Investigation is also continuing of the flows in the Geophysical Fluid Flow Cell (GFFC), a low-gravity Spacelab experiment. Much of the effort in the past year has been spent in validation of the model under a wide range of external parameters including nonlinear flow regimes. With the implementation of a 3-dimensional upwind differencing scheme, higher spectral resolution, and a shorter time step, the model has been found capable of predicting the majority of flow regimes observed in one complete series of baroclinic annulus experiments of Pfeffer and co-workers. Detailed analysis of amplitude vacillation has revealed that the phase splitting described in the laboratory experiments occurs in some but not all cases. Through the use of animation of the models output, a vivid 3-dimensional view of the phase splitting was shown to the audience of the Southeastern Geophysical Fluid Dynamics Conference in March of this year. A study on interannual variability was made using GEOSIM with periodic variations in the thermal forcing. Thus far, the model has not predicted a chaotic behavior as observed in the experiments, although there is a sensitivity in the wavenumber selection to the initial conditions. Work on this subject, and on annulus experiments with non-axisymmetric thermal heating, will continue. The comparison of GEOSIM's predictions will result from the Spacelab 3 GFFC experiments continued over the past year, on a 'back-burner' basis. At this point, the study (in the form of a draft of a journal article) is nearly completed. The results from GEOSIM compared very well with the experiments, and the use of the model allows the demonstration of flow mechanics that were not possible with the experimental data. For example, animation of the model output shows that the forking of the spiral bands is a transient phenomenon, due to the differential east-west propagation of convection bands from different latitudes.

Miller, Timothy L.↗

Friction, wear, and lubrication in vacuum

A review of studies and observations on the friction, wear, and lubrication behavior of materials in a vacuum environment is presented. The factors that determine and influence friction and wear are discussed. They include topographical, physical, mechanical, and the chemical nature of the surface. The effects of bulk properties such as deformation characteristics, fracture behavior, and structure are included.

Buckley, D. H.↗

Metallic ions in the equatorial ionosphere.

Four positive ion composition measurements of the equatorial E region at Thumba, India, are presented. During the day, the major ions between 90 and 125 km are NO+ and O2+. The relative concentrations are similar to those observed at midlatitudes but exhibit unusual structural behavior with altitude. A metallic ion layer centered at 92 km is found to contain Mg+, Fe+, Ca+, K+, Al+, Na+, and possibly Si+ ions. The layer is explained in terms of a similarly shaped altitude distribution of neutral atoms that are photoionized and charge exchanged with NO+ and O2+. Three-body reactions form molecular metallic ions that are rapidly lost by dissociative ion-electron recombination.

Aikin, A. C.↗

MSFC Skylab Apollo Telescope Mount thermal control system mission evaluation

The Skylab Saturn Workshop Assembly was designed to expand the knowledge of manned earth orbital operations and accomplish a multitude of scientific experiments. The Apollo Telescope Mount (ATM), a module of the Skylab Saturn Workshop Assembly, was the first manned solar observatory to successfully observe, monitor, and record the structure and behavior of the sun outside the earth's atmosphere. The ATM contained eight solar telescopes that recorded solar phenomena in X-ray, ultraviolet, white light, and hydrogen alpha regions of the electromagnetic spectrum. In addition, the ATM contained the Saturn Workshop Assembly's pointing and attitude control system, a data and communication system, and a solar array/rechargeable battery power system. This document presents the overall ATM thermal design philosophy, premission and mission support activity, and the mission thermal evaluation. Emphasis is placed on premission planning and orbital performance with particular attention on problems encountered during the mission. ATM thermal performance was satisfactory throughout the mission. Although several anomalies occurred, no failure was directly attributable to a deficiency in the thermal design.

Hueter, U.↗

CNO abundances and hydrodynamic models of the nova outburst. III - 0.5 solar mass models with enhanced carbon, oxygen, and nitrogen

Consideration of the evolution of thermonuclear runaways in the hydrogen-rich envelopes of 0.5 solar mass carbon-oxygen white dwarfs. The larger radii of these stars, compared with the 1.00 solar mass white dwarfs, results in a lesser degree of degeneracy at the same depth in the star. Four models of luminosity with .00355 solar luminosity, differing only in the initial abundances of C-12, N-14, and O-16, are presented. The degree of enhancement required to produce mass ejection, and thereby a nova-type outburst, is greater than for the 1.00 solar mass model. Nevertheless, the evolution of the 0.5 solar mass model that ejected material is very similar to that of the 1.00 solar mass models, and it also ejects significant amounts of C-13, N-15, and O-17 into the interstellar medium. The 0.5 solar mass outburst is considerably less intense than the 1.00 solar mass outburst (even under optimum conditions), and this lower mass behavior is interpreted as associated with the observed outburst of the slowest novae.

Starrfield, S.↗

Overshooting top behavior of three tornado-producing thunderstorms

The behavior of overshooting tops and jumping cirrus observed in three tornado-producing thunderstorms during the 1974 Learjet Cloud-Truth experiment is discussed. An investigation of temporal changes in the heights of overshooting domes (conglomerations of overshooting tops with diameters less than 1 km) reveals several distinctive features associated with tornadic events. There is a gradual decrease in dome height prior to tornado touchdown. Minimum dome activity occurred 5 min after, 5.5 min before, and at approximately the same time as the tornadic event in the storms observed. In all cases, dramatic dome growth at a rate of 17 to 23 m/sec immediately followed the occurrence of the minimum dome heights. There is evidence that tornado production is insensitive to the pre-touchdown maximum dome heights between 1 and 3 km.

Umenhofer, T. A.↗

Pressure transition of AlP to a conductive phase

A direct simultaneous electric resistance method of comparison with ZnS and GaP is used to show that AlP becomes conductive at a pressure equal to or less than that of ZnS, which has been shown to transform at a pressure slightly less than that for ZnS and at a pressure considerably less than that for GaP. There are two possible explanations for this behavior: (1) the conductive phase of AlP observed is not the beta-tin phase, or (2) the theoretical predictions are in error.

Wanagel, J.↗

Microwave multispectral investigations of snow

A long term observational program on microwave emission and scatter behavior under controlled conditions, was started at a high altitude alpine test site. All stages of development of snow cover during the whole season are under investigation. The study was done to achieve required knowledge on microwave radiative properties of snow for optimization of the microwave payloads of air and spaceborne snow sensors and for the interpretation of large scale snow maps obtained by these sensors. Preliminary results of the first month obtained with radiometers at 4.9, 10.5, 21 and 36 GHz are presented.

Schanda, E.↗

Annual Conference on Nuclear and Space Radiation Effects, 14th, College of William and Mary, Williamsburg, Va., July 12-15, 1977, Proceedings

Topics related to processing and hardness assurance are considered, taking into account the radiation hardening of CMOS technologies, technological advances in the manufacture of radiation-hardened CMOS integrated circuits, CMOS hardness assurance through process controls and optimized design procedures, the application of operational amplifiers to hardened systems, a hard off-the-shelf SG1524 pulse width modulator, and the gamma-induced voltage breakdown anomaly in a Schottky diode. Basic mechanisms are examined, giving attention to chemical and structural aspects of the irradiation behavior of SiO2 films on silicon, experimental observations of the chemistry of the SiO2/Si interface, leakage current phenomena in irradiated SOS devices, the avalanche injection of holes into SiO2, the low-temperature radiation response of Al2O3 gate insulators, and neutron damage mechanisms in silicon at 10 K. Other subjects discussed are related to radiation effects in devices and circuits, space radiation effects, and aspects of simulation, energy deposition, and dosimetry.

Stahl, R. H.↗

Radar Observation of Insects - Mosquitoes

Tests were conducted at several sites over the coastal lowlands of New Jersey and over a region of high plains and low mountains in Oklahoma. In one area, a salt marsh in New Jersey, extensive ground tests were combined with laboratory data on expected insect backscatter to arrive at an extremely convincing model of the insect origin of most Dot Angels. A great deal of insight was studied from radar on the buildup and dispersal of insect swarms, since radar can follow where other means of trapping and observation cannot. Data on large-scale behavior as a function of wind and topography are presented. Displayed techniques which show individual or small swarm motion within some larger cloud or mass, or which can show the overall motion over great distances were developed. The influence of wind and terrain on insect motion and dispersal is determined from radar data.

Frost, E.↗

Concepts and techniques for ultrasonic evaluation of material mechanical properties

The ultrasonic nondestructive evaluation techniques discussed in the present paper indicate potentials for material characterization and property prediction. Stress wave interaction and material transfer function concepts are examined as a basis for explaining correlations between material mechanical behavior and ultrasonically measured quantities. It is observed that the effect and criticality of any discrete flaw, such as crack, inclusion, or any other stress raiser, is definable only in terms of its material microstructural environment. This underscores the importance of ultrasonic techniques capable of characterizing the stress wave energy transfer properties of a material.

Vary, A.↗

The power spectral density of digital modulations transmitted over nonlinear channels

This paper examines by analytical methods the power spectral densities of digital modulations (in particular, staggered and unstaggered quadrature modulations) passed through band-limited nonlinear channels. Previously observed (by computer simulation or hardware measurement) behavior of such spectra with regard to the suppression or restoration of its sidelobes after passing through the nonlinearity is verified analytically. Several examples corresponding to specific quadrature modulations and filter-nonlinearity combinations are presented as illustrations of the general results.

Divsalar, D.↗

Solar calibration of stellar rotation tracers

A study of the time variability of the disk-integrated solar magnetic flux, with a view to the behavior of emission-line intensity variations observed in lower main sequence stars, has determined that solar rotation modulation of the integrated flux is present in 75% of all rotations. For observing intervals of more than twice the lifetime of the features causing rotational modulation, the correct rotation period is identified in more than 90% of all cases. The optimum time for measuring rotational modulation is the decay phase of the activity cycle, and the solar rotation period is measured with an accuracy of a few percent. The lifetime of a rotational modulation period is approximately five rotations, and a sensitivity limit of Delta S= 0.005 is found for the Vaughan et al (1981) stellar rotation measures.

Labonte, B. J.↗

A heuristic mathematical model for the dynamics of sensory conflict and motion sickness

The etiology of motion sickness is explained in terms of a qualitatively formulated sensory conflict hypothesis. By consideration of the information processing task faced by the central nervous system in estimating body spatial orientation and in controlling active body movement using an internal model referenced control strategy, a mathematical model for sensory conflict generation is developed. The model postulates a major dynamic functional role for sensory conflict signals in movement control, as well as in sensory-motor adaptation. It accounts for the role of active movement in creating motion sickness symptoms in some experimental circumstances, and in alleviating them in others. The relationship between motion sickness produced by sensory rearrangement and that resulting from external motion disturbances is explicitly defined. A nonlinear conflict averaging model is proposed which describes dynamic aspects of experimentally observed subjective discomfort sensation, and suggests resulting behaviors.

Oman, C. M.↗

A heuristic mathematical model for the dynamics of sensory conflict and motion sickness

The etiology of motion sickness is now usually explained in terms of a qualitatively formulated sensory conflict hypothesis. By consideration of the information processing task faced by the central nervous system in estimating body spatial orientation and in controlling active body movement using an internal model referenced control strategy, a mathematical model for sensory conflict generation is developed. The model postulates a major dynamic functional role for sensory conflict signals in movement control, as well as in sensory motor adaptation. It accounts for the role of active movement in creating motion sickness symptoms in some experimental circumstances, and in alleviating them in others. The relationship between motion sickness produced by sensory rearrangement and that resulting from external motion disturbances is explicitly defined. A nonlinear conflict averaging model describes dynamic aspects of experimentally observed subjective discomfort sensation, and suggests resulting behavior.

Oman, C. M.↗