Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Ships”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,207 records · Page 67

Structure and variability of the Alboran Sea frontal system

A distinct oceanic front coinciding with the jet of incoming North Atlantic water, and an associated anticyclonic gyre in the western half of the basin, were observed during a ship and aircraft survey of the physical characteristics of the Alboran Sea in the western Mediterranean in October 1977. The front was confined to the upper 200 m and was a continuous feature, extending from the Strait of Gibraltar 500 km eastward to the prime meridian. It is noted that in ten days between two surveys, the center of the gyre shifted 50 km westward. This variability of the anticyclonic gyre may correspond to changes of North Atlantic inflow strength, as inferred by local wind and the average atmospheric pressure over the western Mediterranean.

Cheney, R. E.↗

A report from the AVS Standards Committee - Comparison of ion gauge calibrations by several standards laboratories

Calibrations by four U.S. laboratories of four hot-cathode ion gauges, in the range 0.07-13 mPa, showed systematic differences among laboratories that were much larger than the expected error of any one calibration. They also suggested that any of the four gauges tested, if properly packaged and shipped, was able to serve as a transfer standard with probable error of 2%. A second comparison was made of the calibrations by two U.S. laboratories of some other gauges that had also been calibrated by the National Physical Laboratory, England. Results did not permit conclusive determination of whether differences were due to the laboratories or to changes in the gauges.

Warshawsky, I.↗

Surface wind analyses for Seasat

During the 99 days of Seasat operation, two large-scale experiments were conducted which established the satellite sensors' wind measuring capabilities: (1) the Gulf of Alaska Experiment (GOASEX), and (2) the Joint Air Sea Interaction Experiment (JASIN), which unlike GOASEX was independent of the Seasat program and undertook comprehensive air and sea investigations which furnished excellent comparison data for Seasat. Qualitative comparison windfields were also provided by several storms. The point measurements in GOASEX and JASIN were averaged in conjunction with Seasat scatterometer regions and, on the basis of comparisons between several anemometers on buoys and meteorological ships and the calculation of various averaging times, a 20-min average yields a scatterometer scale windfield accuracy of up to + or 1 m/sec and + or - 10 deg in well-behaved windfields.

Brown, R. A.↗

An assessment of the FGGE satellite observing system during SOP-1

The sensitivity of a Goddard Laboratory for Atmospheric Sciences global objective analysis cycle to the addition of FGGE level II-b data is assessed. The GOAS system comprises a predictive continuity provided by a model first-guess forecast integrated from a previous forecast and updated by data gathered in the interim. FGGE data originated in the Jan.-Mar. 1979 period and were acquired by rawinsondes, pilot balloons, surface stations, satellites, ships, and drifting buoys deployed during SOP-1. Focussing on 2-5 and 8-day forecasts, comparisons were made of the 6 hr forecast error at the 300 mb height in three experiments using all, no-satellite (NOSAT), and without rawinsondes or pilot balloons modes. Larger errors occurred in the case of NOSAT, while significant corrections to the GOAS predictions were noted using all the FGGE data. It was concluded that all forecasts were improved by inclusion of full FGGE data sets, including forecasting beyond one week.

Halem, M.↗

Outline of a multiple-access communication network based on adaptive arrays

Attention is given to a narrow-band communication system consisting of a central station trying to receive signals simultaneously from K spatially distinct mobile users sharing the same frequencies. One example of such a system is a group of aircraft and ships transmitting messages to a communication satellite. A reasonable approach to such a multiple access system may be based on equipping the central station with an n-element antenna array where n is equal to or greater than K. The array employs K sets of n weights to segregate the signals received from the K users. The weights are determined by direct computation based on position information transmitted by the users. A description is presented of an improved technique which makes it possible to reduce significantly the number of required computer operations in comparison to currently known techniques.

Zohar, S.↗

Real time prediction of marine vessel motions using Kalman filtering techniques

The present investigation is concerned with the prediction of the future behavior of a vessel within some confidence bounds at a specific instant of time, taking into account an interval of a few seconds. The ability to predict accurately the motions of a vessel can reduce significantly the probability of failure of operations in rough seas. The investigation was started as part of an effort to ensure safe landing of aircraft on relatively small vessels. However, the basic principles involved in the study are the same for any offshore operation, such as carbo transfer in the open sea, structure installation, and floating crane operation. The Kalman filter is a powerful tool for achieving the goals of the prediction procedure. Attention is given to a linear optimal predictor, the equations of motion of the vessel, the wave spectrum, rational approximation, the use of Kalman filter and predictor in an application for a ship, and the motions of a semisubmersible.

Triantafyllou, M. S.↗

SASS wind ambiguity removal by direct minimization

An objective analysis procedure is presented which combines Seasat-A satellite scatterometer (SASS) data with other available data on wind speeds by minimizing an objective function of gridded wind speed values. The functions are defined as the loss functions for the SASS velocity data, the forecast, the SASS velocity magnitude data, and conventional wind speed data. Only aliases closest to the analysis were included, and a method for improving the first guess while using a minimization technique and slowly changing the parameters of the problem is introduced. The model is employed to predict the wind field for the North Atlantic on Sept. 10, 1978. Dealiased SASS data is compared with available ship readings, showing good agreement between the SASS dealiased winds and the winds measured at the surface. Expansion of the model to take in low-level cloud measurements, pressure data, and convergence and cloud level data correlations is discussed.

Hoffman, R. N.↗

Moonport to Spaceport - The changing face at KSC

The facilities and planned operations of the Orbiter Processing Facility (OPF) at Kennedy Space Center are described, noting an eventual goal of five to six weeks turnaround for the vehicle. The dual-bay OPF is being developed to handle processing of two Orbiters in parallel. Once in the facility, all fuels are drained, parts and systems needing maintenance are removed for shipping and refurbishing or repair in-place, hazardous cargo is secured, and a thorough visual inspection is made of all accessible areas. Mobile launch platforms previously used as transports in the Apollo program have been upgraded and modernized and serve for the Shuttle launch preparations. Details of launch procedures are outlined, and the reduction of launch personnel to 45 persons is mentioned. Finally, details of payload insertion and mating with the Spacelab modules are described, along with the progress on the test flights.

Boggs, W. H.↗

Aerodynamic characteristics of a large-scale, twin tilt-nacelle V/STOL model

A subsonic tilt-nacelle V/STOL aircraft configuration is described which is powered by two turbofan engines, mounted on a single carry-through structure that is designed to maintain the thrust axis close to the center of gravity at nacelle incidences of 5-95 deg. Control during V/STOL operation, often from small ship platforms, is achieved by means of a vane assembly that is immersed in each turbofan's exhaust. Wind tunnel test data have been obtained with an 11.2-m wing span model for the vertical-to-horizontal flight transition capability of the concept. It is found that the aircraft can operate over a broad transition corridor, with sufficient maneuver capability about the trim points. The control vane exhibited linear response characteristics over a large deflection range, with little influence from power, angle of attack or ground proximity in hover. The model induced a positive ground effect in hover that increased as wheel height was approached and strake angle increased.

Falarski, M. D.↗

Passive microwave measurements of temperature and salinity in coastal zones

Experimental methods and results from the maritime remote sensing (MARSEN) experiments using dual frequency microwave radiometer detecting systems on board aircraft are described. The radiometers were operated at 1.43 and 2.65 GHz and flown above U.S. Atlantic coastal areas, Chesapeake Bay, around Puerto Rico, and over the German Bight. The advanced switched radiometers used were configured to be independent of gain variations and errors originating from front-end losses and determined the absolute brightness temperatures to within a few tenths Kelvin. Corrections to the observed brightness temperature of the ocean are analytically defined, including accounts made for roughness, the cosmic background radiation, and the solar radio source. The coastal flight data for salinity gradients and surface temperatures were compared with sea truth measured from ships and found to be accurate to within 1 C and 1 pph.

Blume, H.-J. C.↗

Improved accuracy of the remote sensing of sea surface temperature

A method is described for determining the water vapor content to within + or - 0.4 g/sq cm from remotely sensed radiances in three infrared channels, 11, 13, 18 microns. Using this method, it is possible to significantly improve the accuracy of sea surface temperature (SST) over what is obtainable with the two channel technique. A radiative computational scheme for the radiative transfer equation is used to study the manner in which the equivalent radiative temperature of the atmosphere changes as a function of wave number for different atmospheric conditions. Average climatological conditions are used to simulate the radiative response of the atmosphere. This radiative transfer simulation is used to compute brightness temperatures for radiosonde profiles obtained from oceanographic ships, which temperatures are in turn used to estimate the SST. Nimbus 4 IRIS spectral measurements corresponding to the profiles were used in the same way for purposes of comparison.

Dalu, G.↗

Winds over the ocean as measured by the scatterometer on Seasat

An analysis is presented of the relative accuracy of Seasat scatterometer measurements of the wind speeds and directions at 19.5 m altitude as compared to ground truth measurements taken by surface ships and instrumented buoys. Attention is given to the JASIN, QE II, and GOASEX surface data. The validity of 2-30 min averages taken from surface stations spread out over a wide area and serving as a basis for defining wind field averages over the 50 km resolution of SASS is examined. Satisfactory wind speeds were found to be available from SASS readings in the wind speed range 6-14 m/sec. The use of 25 SASS readings around a grid point was determined to reduce scatter to 0.25 m/sec when used in numerical weather prediction modeling. Improvements to the SASS techniques by the Seasat successor, NOSS, are discussed, and inclusion of momentum, heat, and water turbulent fluxes by NOSS is noted.

Pierson, W. J.↗

Adjustment, interpolation, and smoothing of GEOS 3 altimeter data

A computational scheme that provides a rapid method for constructing a local or regional geoid from GEOS 3 altimeter data is presented. It is shown that for an oceanic area not larger than 30 deg longitude by 30 deg latitude, an adjustment of GEOS 3 track data for the erroneous bias and tilt can reduce the data inconsistencies at track intersections to smaller than 50 cm. This makes it possible to construct a map of the geoid with the contour interval of 1 m in any local or regional areas where the altimeter data exist with reasonable density and uniformity. In addition, a formula is developed for computing an expected value of geoid height by taking a weighted average of the adjusted altimeter data. Using the data's autocovariance as a weight, the formula can give a profile of geoid height along a given traverse. The geoid data can thus be compared with other marine geophysical data that are recorded continually along a ship's track.

Horai, K.-I.↗

Improved Cattle Hauler

Better aerodynamics and ventilation increases fuel efficiency and decreases shipping losses. Trailer is ventilated and cooled by inlet ports in front of rig and outlet ports in middle and rear. Rounded cab and fairing reduce drag by creating an attached airflow.

Saltzman, E. J.↗

Fire-Resistant Composites

Resin blend produces high-char-yield, low-smoke composites. Diglycidyl Ether of Bis-(4-Hydroxyphenyl)-Fluorene is prepared by reacting epichlorohydrin and sodium hydroxide with 9,9-bis(hydroxyphenyl) fluorene. End of reaction determined by gas or liquid chromatography, mass spectroscopy or infrared techniques. Used to manufacture printed circuit boards and panels for buildings, ships and aircraft.

Kourtides, D. A.↗

Improvements in Vibration-Analysis Technique

Two reports present details of vibration-analysis technique. Technique scheme for accurate and efficient numerical integration of coupled equations of motion of vehicle and its payload(s). Applicable to large stationary structures, land vehicles, airplanes, ships, or wherever vibration analysis done repeatedly after each of many design changes.

Engels, R. C.↗

Avoidance maneuevers selected while viewing cockpit traffic displays

Ten airline pilots rates the collision danger of air traffic presented on cockpit displays of traffic information while they monitored simulated departures from Denver. They selected avoidance maneuvers when necessary for separation. Most evasive maneuvers were turns rather than vertical maneuvers. Evasive maneuvers chosen for encounters with low or moderate collision danger were generally toward the intruding aircraft. This tendency lessened as the perceived threat level increased. In the highest threst situations pilots turned toward the intruder only at chance levels. Intruders coming from positions in front of the pilot's own ship were more frequently avoided by turns toward than when intruders approached laterally or from behind. Some of the implications of the pilots' turning-toward tendencies are discussed with respect to automatic collision avoidance systems and coordination of avoidance maneuvers of conflicting aircraft.

Smith, J. D.↗