Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Radiation and Electronics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,207 records · Page 67
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Effect of blackbody radiation on the threshold for two-electron photodetachment of H/-/

The threshold law of the titled process, which is of the same form as that for electron-impact ionization of H, can experimentally be contaminated by simultaneous single photodetachment and Rydberg excitation of the residual atom, followed by ionization of the Rydberg atom by (room-temperature) blackbody photons. This gives a signal indistinguishable from direct double photodetachment. The correction is here calculated and shown to be finite at the double photodetachment threshold, and to have, possibly, an implication about the form of the threshold law itself. However, at room temperature its contribution is found to be small as it pertains to a recently initiated experiment at the Los Alamos Meson Physics Facility for available energies greater than a millivolt above threshold. The temperature dependence of the correction is shown to be large (k/B/T) to the 7/2; thus at higher temperatures the effect may be observable.

Temkin, A.↗
NASA NTRS1990

A mechanism for bursty radio emission in planetary magnetospheres

Bursty radio emissions are often observed from the polar magnetospheres of the earth, Jupiter, Saturn, and Uranus in addition to the smooth radio emissions commonly detected. It is shown that in plasma regimes in which the electron plasma frequency is less than the electron cyclotron frequency, anisotropic electron beams or gyrating electron beams can excite directly broadband electromagnetic radiation. The largest growth is for right-hand X-mode radiation with frequencies above the electron cyclotron frequency. This instability can produce bursty, broadband emission, consistent with some of the properties of the radiation observed from the magnetized planets.

Wong, H. K.↗
NASA NTRS1986

The electron-cyclotron maser instability as a source of plasma radiation

The generation of continuum bursts from the sun at dm and m wavelengths (in particular, type IV bursts) via the electron-cyclotron-maser instability is examined. The maser instability can be driven by an electron distribution with either a loss-cone anisotropy or a peak at large pitch angles. For omega(p)/Omega(e) much greater than 1, the maser emission is produced by electrons interacting through a harmonic (cyclotron) resonance and is electrostatic, being in the upper hybrid mode at frequencies approximately equal to omega(p). Coalescence processes are required to convert the electrostatic waves into transverse radiation which can escape from the source region. Whether the resultant spectrum is nearly a smooth continuum or has a zebra-stripe pattern (both of which occur in type IV bursts) depends on the form of the electron distribution, inhomogeneities in the density and magnetic field, and whether the maser reaches saturation. For at least the case of some type IV dm bursts with fine structure, comparison with observations seems to indicate that the electrons producing the emission are more likely to have a loss-cone distribution, and that the maser instability is not at saturation.

Winglee, R. M.↗
DOE OSTI2021

Characterization and Simulation of Optical Delay System for the Proof-of-Principle Experiment of Optical Stochastic Cooling at IOTA

The Optical Stochastic Cooling (OSC) experiment at Fermilab’s IOTA storage ring uses two undulators to cool the beam over many turns. The radiation emitted by electrons in the first undulator is delayed and imaged in the second undulator where it applies a corrective energy kick on the electrons. Imperfections in the manufacturing of the delay plates can lead to a source of error. This paper presents the experimental characterization of the absolute thickness of these delay plates using an interferometric technique. The measured "thickness maps" are implemented in the Synchrotron Radiation Workshop (SRW) program to assess their impact on the delayed radiation pulse.

43 PARTICLE ACCELERATORS↗
NASA NTRS2006

Capabilities of the Natural Environments Branch at NASA's Marshall Space Flight Center

The Natural Environment Branch at NASA s Marshall Space Flight Center (MSFC) has the responsibility to provide engineering support to programs and projects in natural environments. The Natural Environments Branch (EV13) is responsible for natural environments definitions, modelling, database development and effects assessments. EV13 personnel develop requirements for flight projects and provide operational support for space and launch vehicle systems. To accomplish these responsibilities, Branch . personnel have developed modelling and analytical tools which include planetary atmospheres, meteoroids, ionizing radiation, plasmas and ionospheres, magnetic and gravitational fields, spacecraft charging modelling, and radiation effects on electronic parts. NASA s Meteoroid Environment Office is operated within the EV13 and provides meteoroid engineering models and shower forecasts to spacecraft designers and operators. This paper will describe the capabilities within the Natural Environments Effects Branch including; examples of natural environment definitions, radiation transport, output from the Global Reference Atmosphere Models for Earth, Venus, Mars, Titan, and Neptune), recent NASCAP 2K results from solar sail modelling, and meteor stream models

Edwards, David L.↗
NASA NTRS1989

Production of self-absorbed synchrotron spectra steeper than nu to the 5/2

Self-absorbed synchrotron radiation produced by electrons with a power-law distribution of energies has a unique spectral shape: intensity is proportional to nu to the 5/2, where nu is the frequency, irrespective of the power law index of the electrons. It has been asserted that the measurement of a spectral index greater than 5/2 at frequencies below the 'far-IR turnovers' observed in the spectra of many radio-quiet AGN is incompatible with the physics of self-absorbed synchrotron sources. It is shown here that plausible electron energy distributions can lead to self-absorbed synchrotron spectra which are steeper than nu to the 5/2 over 1-1.5 orders of magnitude in frequency. This indicates that none of the existing observations are in fact incompatible with self-absorbed synchrotron radiation as the source.

De Kool, Martijn↗
NASA NTRS1998

HST Multi Layer Insulation Failure Review Board Findings

The mechanical and optical properties of the thermal control materials on the Hubble Space Telescope (HST) have degraded over the nearly seven years the telescope has been in orbit. Astronaut observations and photographs from the Second Servicing Mission (SM2) revealed large cracks in the metallized Teflon fluorinated ethylene propylene (FEP), the outer layer of the multi-layer insulation (MLI), in many locations around the telescope. Also, the absorptance of the bonded metallized Teflon FEP radiator surfaces of the telescope has increased over time. A Failure Review Board was established to determine the damage mechanism and to identify a replacement material. Samples of the top layer of the MLI and radiator material were retrieved during SM2, and a thorough investigation into the degradation followed in order to determine the primary cause of the damage. Mapping of the cracks on HST and the ground testing showed that thermal cycling with deep-layer damage from electron and proton radiation are necessary to cause the observed embrittlement. Further, strong evidence was found indicating that chain scission (reduced molecular weight) is the dominant form of damage to the metallized Teflon FEP. Given the damage to the outer layer of the multi-layer insulation (MLI) that was apparent during the second servicing mission (SM2), the decision was made to replace the outer layer during subsequent servicing missions. The replacement material had to meet the stringent thermal requirements of the spacecraft and maintain structural integrity for at least ten years. Ten candidate materials were exposed to simulated orbital environments and a replacement material was selected. This presentation will summarize the FRB results, in particular, the analysis of the retrieved specimens, the results of the simulated environmental exposures, and the selection of the replacement material. The NASA Space Environments and Effects community needs to hear these results because they reveal that Teflon (FEP) films should not be used in LEO as routinely as they are today.

Townsend, Jacqueline↗
DOE OSTI2022

The bands method for tabulating NLTE material properties

The use of Non-Local Thermal Equilibrium (NLTE) material properties within radiation-hydrodynamic simulations remains a major challenge. The plasma radiative and EOS properties in NLTE can depend on the detailed local radiation field and electron energy distribution. Fully characterizing each of these quantities may require 10’s to 100’s of parameters, making tabulation effectively impossible and requiring expensive calculations for each set of conditions within the simulation. In this work we present a new method that characterizes the local radiation field with a limited number of parameters. Furthermore, this permits pre-calculation and tabulation of the material properties, allowing codes to perform NLTE radiation-hydrodynamic simulations which would otherwise be computationally prohibitive.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗
NASA NTRS1983

Electromagnetic radiation from beam-plasma instabilities

A computer simulation is developed for the generation of electromagnetic radiation in an electron beam-plasma interaction. The plasma is treated as a two-dimensional finite system, and effects of a continuous nonrelativistic beam input are accounted for. Three momentum and three field components are included in the simulation, and an external magnetic field is excluded. EM radiation generation is possible through interaction among Langmuir oscillations, ion-acoustic waves, and the electromagnetic wave, producing radiation perpendicular to the beam. The radiation is located near the plasma frequency, and polarized with the E component parallel to the beam. The scattering of Langmuir waves caused by ion-acoustic fluctuations generates the radiation. Comparison with laboratory data for the three-wave interactions shows good agreement in terms of the radiation levels produced, which are small relative to the plasma thermal energy.

Pritchett, P. L.↗
NASA NTRS1972

JPL lithium doped solar cell development program

One of the most significant problems encountered in the use of silicon solar cells in space is the sensitivity of the device to electron and proton radiation exposure. The p-diffused-into-n-base solar cells were replaced with the more radiation tolerant n-diffused-into-p-base solar cells. Another advancement in achieving greater radiation tolerance was the discovery that the addition of lithium to n-base silicon resulted in what appeared to be annealing of radiation-induced defects. This phenomenon is being exploited to develop a high efficiency radiation resistant lithium-doped solar cell. Lithium-doped solar cells fabricated from oxygen-lean and oxygen-rich silicon were obtained with average initial efficiencies of 11.9% at air mass zero and 28 C, as compared to state-of-the-art n-p cells fabricated from 10 ohm cm silicon with average efficiencies of 11.3% under similar conditions. Lithium-doped cells demonstrated the ability to withstand three to five times the fluence of 1-MeV electrons before degrading to a power equivalent to state-of-the-art solar cells. The principal investigations are discussed with respect to fabrication of high efficiency radiation resistant lithium-doped cells, including starting material, p-n junction diffusion, lithium source introduction, and lithium diffusion.

Berman, P. A.↗
DOE OSTI2021

Radiation Hardening – Test Capabilities (LANSCE) [Slides]

The Los Alamos Neutron Science Center (LANSCE) has exceptional facilities for research and testing of radiation effects in electronics. We have the best terrestrial neutron source for sea-level and airplane-altitude environments. We have a thermal neutron test capability at the Lujan Center and a proton beam test capability at the “Blue Room”. LANL has the programmatic mission to develop this radiation-effects program, namely space and satellite environments, high-performance computing (silent data corruption), and weapons delivery systems. We have a strong connection to industry which continues to grow.

42 ENGINEERING↗
NASA NTRS1993

Simulations of a molecular plasma in collisional-radiative nonequilibrium

A code for the simulation of nonequilibrium plasmas is being developed, with the capability to couple the plasma fluid-dynamics for a single fluid with a collisional-radiative model, where electronic states are treated as separate species. The model allows for non-Boltzmann distribution of the electronic states. Deviations from the Boltzmann distributions are expected to occur in the rapidly ionizing regime behind a strong shock or in the recombining regime during a fast expansion. This additional step in modeling complexity is expected to yield more accurate predictions of the nonequilibrium state and the radiation spectrum and intensity. An attempt at extending the code to molecular plasma flows is presented. The numerical techniques used, the thermochemical model, and the results of some numerical tests are described.

Cambier, Jean-Luc↗
NASA NTRS1973

Generation and propagation of electromagnetic waves in the magnetosphere

Characteristics of broadband ELF, VLF, and LF emissions in the magnetosphere were calculated assuming incoherent Cerenkov radiation from magnetospheric electrons with energies from 50 eV to 50 keV. Calculations were included to determine the ray paths of the emitted waves. A diffusive equilibrium model of the magnetosphere with an ionosphere, plasmapause, and a centered dipole magnetic field was used. Ray path calculations were done in three dimensions. Using simultaneous energetic electron and VLF data, comparisons were made between calculated and observed VLF hiss. Assuming a wave normal angle six degrees from the resonance cone angle, the calculated spectral densities are both two orders of magnitude below the observed spectral densities. It seems unlikely that VLF hiss is produced by incoherent Cerenkov radiation. The observed spectral shape of V-shaped VLF hiss is similar to that calculated from incoherent Cerenkov radiation.

Taylor, W. W. L.↗
NASA NTRS2011

Optical Coating Performance for Heat Reflectors of the JWST-ISIM Electronic Component

A document discusses a thermal radiator design consisting of lightweight composite materials and low-emittance metal coatings for use on the James Webb Space Telescope (JWST) structure. The structure will have a Thermal Subsystem unit to provide passive cooling to the Integrated Science Instrument Module (ISIM) control electronics. The ISIM, in the JWST observatory, is the platform that provides the mounting surfaces for the instrument control electronics. Dissipating the control electronic generated-heat away from JWST is of paramount importance so that the spacecraft s own heat does not interfere with the infrared-light gathering of distant cosmic sources. The need to have lateral control in the emission direction of the IEC (ISIM Electronics Compartment) radiators led to the development of a directional baffle design that uses multiple curved mirrorlike surfaces. This concept started out from the so-called Winston non-imaging optical concentrators that use opposing parabolic reflector surfaces, where each parabola has its focus at the opposite edge of the exit aperture. For this reason they are often known as compound parabolic concentrators or CPCs. This radiator system with the circular section was chosen for the IEC reflectors because it offers two advantages over other designs. The first is that the area of the reflector strips for a given radiator area is less, which results in a lower mass baffle assembly. Secondly, the fraction of energy emitted by the radiator strips and subsequently reflected by the baffle is less. These fewer reflections reduced the amount of energy that is absorbed and eventually re-emitted, typically in a direction outside the design emission range angle. A baffle frame holds the mirrors in position above a radiator panel on the IEC. Together, these will direct the majority of the heat from the IEC above the sunshield away towards empty space.

Rashford, Robert A.↗