SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The first demonstration of spatial light modulation in GaAs using the photorefractive effect is reported. A special configuration was employed in which polarization rotation created by beam coupling was utilized. The ability to obtain these results despite a small coupling gain coefficient demonstrates the usefulness of the polarization technique presented here for optical processing with GaAs crystals.
A compact device for spectrally combining many laser-diode beams into a single multi-wavelength beam has been developed for use in NASA's intersatellite communications programs. The prototype device combines seven 30 milliwatt beams into a single beam with 70 percent efficiency producing an output of approximately 150 milliwatts. All beams are coaxial and can be collimated with a single transmitter optical system. The combining technique is relatively insensitive to drifts in the laser-diode wavelength and provides both increased power output and laser-diode source redundancy. Combination of more than 100 laser-diodes producing an output greater than 5 watts appears feasible with this technique.
Results are presented from an experimental investigation of the normal-incidence reflectance at 58.4, 92.0, and 121.6 nm wavelength of 30- and 80-nm-thick SiC films produced by ion-beam deposition on unheated 5 x 5-cm microscope slides. The films were deposited in the 2-m evaporator described by Bradford et al. (1969) with chamber base pressure 1 microtorr, operating pressure 40 microtorr, and a 50-62-mA 750-eV Ar ion beam; the reflectance measurements were obtained in the reflector-monochromator system described by Osantowski (1974). Reflectances of over 30 percent were found at 92 and 121.6 nm, almost equal to those of polished CVD films of SiC and degrading only slightly after aging for 4 months. It is suggested that ion-beam deposition may be the best low-temperature technique for coating EUV optics for space astronomy.
The papers in these proceedings show that a major effort is under way to improve all aspects of photometry. Astronomical multichannel photometry, photodiodes, analog-to-digital converters, data reduction techniques, interference filters and optical fibers are discussed.
As part of the process of comparing Martian soils with terrestial soils, high resolution electron microscopy and associated techniques should be used to examine the finer soil particles, and various techniques of electron and optical microscopy should be used to examine the undisturbed structure of Martian soils. To examine the structure of fine grained portions of the soil, transmission electron microscopy may be required. A striking feature of many Martian soils is their red color. Although the present-day Martian climate appears to be cold, this color is reminiscent of terrestial tropical red clays. Their chemical contents are broadly similar.
The extremely energy-efficient pulse-position modulation (PPM) format is being actively developed as a basis for optical communications with deep-space probes. Attention is presently given to different modulation schemes for the efficient production of laser pulses over a broad range of repetition rates. Both Q-switching and cavity dumping modulation methods are available for the envisioned diode-pumped Nd:YAG laser source. Numerical calculation results are presented for cavity-dumping.
Optical absorption-line techniques have been applied to the study of a number of translucent molecular clouds in which the total column densities are large enough that substantial molecular abundances can be maintained. Results are presented for a survey of absorption lines of interstellar C2, CH, and CN. Detections of CN through the A 2Pi-X 2Sigma(+) (1,O) and (2,O) bands of the red system are reported and compared with observations of the violet system for one line of sight. The population distributions in C2 provide diagnostic information on temperature and density. The measured column densities of the three species can be used to test details of the theory of molecule formation in clouds where photoprocesses still play a significant role. The C2 and CH column densities are strongly correlated with each other and probably also with the H2 column density. In contrast, the CN column densities are found to vary greatly from cloud to cloud. The observations are discussed with reference to detailed theoretical models.
Interpretation of planetary methane (CH4) visible-near IR spectra, used to develop models of planetary atmospheres, has been hampered by a lack of suitable laboratory spectroscopic data. The particular CH4 spectral bands are due to intrinsically weak, high overtone-combination transitions too complex for classical spectroscopic analysis. The traditional multipass cell approach to measuring spectra of weakly absorbing species is insufficiently sensitive to yield reliable results for some of the weakest CH4 absorption features and is difficult to apply at the temperatures of the planetary environments. A time modulated form of intracavity laser spectroscopy (ILS), has been shown to provide effective absorption pathlengths of 100 to 200 km with sample cells less than 1 m long. The optical physics governing this technique and the experimental parameters important for obtaining reliable, quantitative results are now well understood. Quantitative data for CH4 absorption obtained by ILS have been reported recently. Illustrative ILS data for CH4 absorption in the 619.7 nm and 681.9 nm bands are presented. New ILS facilities at UM-St. Louis will be used to measure CH4 absorption in the 700 to 1000 nm region under conditions appropriate to the planetary atmospheres.
The influence of various melt spinning parameters and the effect of consolidation on the microstructure of melt spun NiAl and NiAl + W alloys have been examined by optical and electron microscopy techniques. It was found that the addition of 0.5 at. pct W to NiAl results in a fine dispersion of W particles after melt spinning which effectively controls grain growth during annealing treatments or consolidation at temperatures between 1523 and 1723 K. Increased wheel speeds are effective at reducing both the ribbon thickness and grain size, such that proper choice of both composition and casting parameters can produce structures with grain sizes as small as 2 microns. Finally, fabrication of continuous fiber-reinforced composites which used pulverized ribbon as the matrix material was demonstrated.
A comparative study is conducted for optical position-sensing techniques applicable to micro-G conditions sample-levitation systems. CCD sensors are compared with one- and two-dimensional position detectors used in electrostatic particle levitation. In principle, the CCD camera method can be improved from current resolution levels of 200 microns through the incorporation of a higher-pixel device and more complex digital signal processor interface. Nevertheless, the one-dimensional position detectors exhibited superior, better-than-one-micron resolution.
Numerical radiative-transfer models are used to discuss the properties of circumstellar dust grains around the premain-sequence star AB Aur (HD 31293). It is assumed that the dust consists of a silicate-graphite mixture with Draine and Lee (1984) optical properties. The modeling technique is to match the observed FUV through FIR energy distribution with the spectral energy distribution predicted for a spherical dust shell around a luminous hot star. Special attention is given to matching the observed 10-micron silicate emission feature and the observed circumstellar absorption curve at UV wavelengths, making it possible to strengthen constraints on dust-grain opacity and chemical composition. It is concluded that, although silicate grains can explain the observed 10-micron emission feature, the Draine and Lee silicate-graphite mixture cannot explain the observed FUV circumstellar absorption at the same time. The dust shell around AB Aur contains an additional population of small particles, the most likely candidate being amorphous carbon grains in a nonhydrogenated form.
To interpret the effects of aerosols and gases on the atmosphere, information on the vertical and horizontal distribution of aerosol particles, their size distributions and concentration of precursor gases is required. Measurements of aerosols and gases at frequent intervals and over vast areas of atmosphere generally involve remote sensing techniques. These techniques depend on the optical properties of the species studied. Optical properties can vary greatly with aerosol size and refractive index. Remote sensing instruments look at light scattering, extinction, depolarization, and reflection. The chemical composition, phase equilibria, surface properties, and photochemical behavior of stratospheric aerosols are not clearly understood or adequately measured by current technologies. Areas are listed which need technology development.
The Cepheus A region at 20 microns has been mapped, and a bright, unresolved central source with a peak flux of 41 Jy into a 4.0 arcsec x 4.3 arcsec beam has been detected. One-dimensional slit scans have been obtained in two perpendicular directions across Cepheus A at 50 and 100 microns using a high spatial-resolution sampling technique. The temperature and optical depth profile of the far-IR emission are determined, and a peak temperature of 46 K and peak 100 micron optical depth of 0.4 are derived. Maximum entropy deconvolution of the far-IR scans indicate that there is a bright central core with clumpy extended emission. Within errors the position of the 50/100 micron peak is the same as the 20-micron source; this is interpreted as indicating that the 20 micron radiation represents the short-wavelength emission from the core of the dust cloud seen in the far-IR. It is concluded that an embedded source provides the major source of luminosity in the Cepheus A region.
The nation's strategy for astrophysics research during the rest of this century and into the next is a coordinated, multispectral examination of the universe. NASA plans to launch a family of large orbital observatories, each tuned to a different part of the electromagnetic spectrum. They are as follows: the Gamma Ray Observatory (GRO); the Advanced X Ray Astrophysics Facility (AXAF); the Hubble Space Telescope (HST); and the Space Infrared Telescope Facility (SIRTF). To complement these sensitive space telescopes, a powerful new radio observatory system is envisioned: the Very Long Baseline Array (VLBA), an intercontinental network of radio telescopes, working with radio observatories in space to perform orbiting very long baseline interferometry (OVLBI). Observing the universe across the spectrum requires different kinds of telescopes based on quite different techniques of detection. An optical telescope has little in common with a gamma ray detector; they do not look alike, nor do they operate on the same principles. No single telescope can answer all the questions or make all the discoveries that await.
Laser Doppler radar (lidar) is widely used for remote sensing of wind velocities. Usable wavelengths for the laser are limited by the effects of atmospheric turbulence. An adaptive optical system is proposed to compensate for turbulence effects on signal power. The feasibility of an adaptive system is considered in light of the effects of speckle from the aerosol target. It is concluded that adaptive optics is a promising technique for improving the performance of a 2 micron lidar wind measurement system. The chief technical challenges are a laser that will give the required output and pulse repetition rate, a combined Hartmann sensor and heterodyne detector, and a suitable reconstruction algorithm.
An analysis of observations of 24 absorption lines produced near zero redshift by Milky Way disk and halo gas along the sight line to 3C 273 is presented. The reduced spectra have a resolution of about 20 km/s (FWHM) with broad wings and an SNR of 13 to 20. The species detected include C II, C II*, C IV, O I, Mg II, Si II, Si IV, S II, Mn II, Fe II, and Ni II. The O I absorption is blended with earth atmospheric emission, and one of the Si IV doublet lines is blended with an intergalactic Lyman-alpha line. Column densities are determined for C II*, C IV, Si II, Si IV, N V, S II, Mn II, and Ni II using standard curve-of-growth techniques and the apparent optical depth method. The column density for S II and a measure of N(H I) from FOS observations of Lyman-alpha reveal a 45-percent overabundance of sulfur compared with neutral hydrogen which is probably due to the presence of S II in ionized gas toward 3C 273.
Prescription retrieval is a technique for directly estimating optical prescription parameters from images. We apply it to estimate the value of the Hubble Space Telescope primary mirror conic constant. Our results agree with other studies that examined primary-mirror test fixtures and results. In addition they show that small aberrations exist on the planetary-camera repeater optics.
The Final Report of the Center for Applied Optics (CAO), of The University of Alabama (UAH) study entitled 'Investigation of Zerodur Material Processing' is presented. The objectives of the effort were to prepare glass samples by cutting, grinding, etching, and polishing block Zerodur to desired specifications using equipment located in the optical shop located in the Optical System Branch at NASA/MSFC; characterize samples for subsurface damage and surface roughness; utilize Zerodur samples for coating investigations; and perform investigations into enhanced optical fabrication and metrology techniques. The results of this investigation will be used to support the Advanced X Ray Astrophysics Facility (AXAF) program as well as other NASA/MSFC research programs. The results of the technical effort are presented and discussed.